首页 | 官方网站   微博 | 高级检索  
     

2 000 m超深水水下分离器泄漏油气扩散特性研究
引用本文:李新宏,李秀美,陈国明,朱红卫.2 000 m超深水水下分离器泄漏油气扩散特性研究[J].中国安全生产科学技术,2016,12(1):38-43.
作者姓名:李新宏  李秀美  陈国明  朱红卫
作者单位:(中国石油大学<华东> 海洋油气装备与安全技术研究中心,山东 青岛 266580)
摘    要:深水水下分离器服役过程中由于腐蚀、地质灾害和环境高压作用,存在失效泄漏风险。针对2 000 m超深水水下分离器可能存在的失效泄漏问题,基于计算流体动力学CFD方法,建立分离器失效泄漏后果数值仿真分析模型,对分离器泄漏场景进行模拟与分析,研究2 000 m水深条件下分离器泄漏油气扩散规律,并考虑不同泄漏位置对油气扩散行为的影响。结果表明:水下分离器泄漏包括压力扩散和自由扩散两个阶段,压力扩散阶段历时极短,自由扩散阶段耗时较长;泄漏口位置对泄漏结果有较为明显的影响,分离器上部泄漏,油气全部溢出,分离器中下部泄漏,大部分油气保留于分离器内部,最终形成分明的油气水界面;分离器内部压力随时间迅速上升,t=0.25 s左右接近于20 MPa,后期在20 MPa左右呈极微小波动,泄漏速率随分离器内部压力增大迅速减小,达到最低点之后,呈微小波动状变化。

关 键 词:深水  水下分离器  失效泄漏  油气扩散  数值仿真

Study on dispersion characteristics of leaking oil and gas from subsea separator in 2 000 m ultra deepwater
LI Xinhong,LI Xiumei,CHEN Guoming,ZHU Hongwei.Study on dispersion characteristics of leaking oil and gas from subsea separator in 2 000 m ultra deepwater[J].Journal of Safety Science and Technology,2016,12(1):38-43.
Authors:LI Xinhong  LI Xiumei  CHEN Guoming  ZHU Hongwei
Affiliation:(Center for Offshore Engineering and Safety Technology, China University of Petroleum, Qingdao Shandong 266580, China)
Abstract:There exists the risk of failure leakage for subsea separator due to corrosion, geological disaster and high environmental pressure. Aiming at the possible failure leakage of subsea separator in 2 000 m ultra deepwater, a numerical simulation model on leakage consequence of separator was established based on CFD method to simulate and analysis the leakage scenarios of separator. The dispersion characteristics of leaking oil and gas from subsea separator in 2 000 m ultra deepwater were studied with considering the influence of different leakage location on the dispersion behavior of oil and gas. The results showed that subsea separator leakage involves 2 stages, that is pressure diffusion and free diffusion. The duration of pressure diffusion stage is very short, while that of free diffusion stage is relatively long. The leakage location has an obvious impact on the leakage results, all the oil and gas in separator spills out when leakage occurs in the top of separator, but most of oil and gas remains inside of the separator when the leakage occurs in the middle or bottom of separator, and the apparent interfaces between oil, gas and water appear finally. The internal pressure of separator rises rapidly over time and reaches 20 MPa after 0.25 s, then fluctuate slightly around 20 MPa. The leakage rate decreases rapidly with the increasing internal pressure of separator, and presents tiny fluctuation change after reaching the lowest point.
Keywords:deepwater  subsea separator  failure leakage  dispersion of oil and gas  numerical simulation
本文献已被 CNKI 等数据库收录!
点击此处可从《中国安全生产科学技术》浏览原始摘要信息
点击此处可从《中国安全生产科学技术》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司    京ICP备09084417号-23

京公网安备 11010802026262号