实际污水与模拟污水活性污泥系统的特性差异

实验中经常采用人工配置的模拟生活污水,为了研究其与实际生活污水活性污泥系统的特性差异,采用2个序批式间歇反应器(SBR)进行平行实验(厌氧、好氧方式运行),系统地考察了在进水主要组分和运行参数相同的情况下,不同原水对活性污泥系统脱氮、除磷、比好氧速率、污泥絮体形态和出水水质等方面的影响。结果表明,模拟污水系统的硝化活性强于实际污水系统,两者的平均硝化速率分别为7.43 mg NH4+-N/(L.h)和5.55 mg NH4+-N/(L.h)。在前置厌氧段,模拟污水系统的释磷量比实际污水系统高出36.45%。两者在后续好氧阶段都能够充分吸磷。模拟污水系统的平均比好氧速率(SOUR)高达64.54 mg O2/(g MLSS.h),而实际污水系统的则只有32.81 mg O2/(g MLSS.h)。模拟污水系统的污泥絮体疏松,粒径小,形状不规则,沉降性差,沉后出水平均悬浮物浓度(SS)为20 mg/L;而实际污水系统的污泥絮体则密实、粒径大,沉降性好,沉后水十分清澈,SS几乎检测不出。     

焦化废水泡沫分离液的Fenton催化氧化预处理

以焦化废水处理过程产生的泡沫分离液为研究对象，对其进行Fenton催化氧化处理实验，考察H₂O₂用量、Fe²⁺浓度、pH和反应时间4个因素对处理效果的影响，并结合GC/MS方法比较处理前后泡沫分离液中有机物的种类及其生物降解性的变化。结果表明，采用［H₂O₂］=100 mmol/L、［Fe²⁺］=100 mg/L、pH=3、反应时间为30 min的Fenton催化氧化反应条件，可以使分离液的COD去除率达到68%以上；经Fenton处理后，分离液的B/C值由0.12提高至0.38，生物降解性明显改善；通过GC/MS的分析，基本明确分离液中含有的有机物主要为酚、胺、腈、酯类有机物及喹啉、吡啶等杂环化合物，大多数属于难降解且生物毒性较强的有机物。针对这些复杂组分共存的泡沫分离液，利用Fenton试剂较强的氧化能力能够将其含有的有毒/难降解有机物转化为低毒或无毒的小分子有机物，为其后续的生物处理创造良好的条件。     

养猪场废水处理工艺研究

采用接触氧化－水解－两段接触氧化－混凝工艺处理高浓度养殖废水,通过试验得到最佳工艺参数,在最佳试验条件下,进水ＣＯＤｃｒ小于５０００ｍｇ／Ｌ,经处理后出水ＣＯＤｃｒ平均去地９７％,ＢＯＤ５去除率大于９８％,氨氮去除率大于９６％,各项主要指标可达污水综合排放标准一级标准。     

Phosphate recovery from greenhouse wastewater

A study was conducted to investigate the suitability of phosphate recovery from greenhouse wastewaters by using precipitation/crystallization process. More than 90% of the phosphate could be removed from the greenhouse wastewater. Various calcium phosphate salts were obtained in the process; hydroxyapatite [Ca5(PO4)3OH] could be the main product from the precipitates. Phosphate removal was affected by the presence of magnesium ion in wastewaters. An increase of magnesium concentrations in wastewaters decreased phosphate removal rates. The chemical contents of precipitates in terms of calcium, magnesium and phosphate were affected by calcium to magnesium molar ratio. Higher calcium contents were obtained at wastewaters with high calcium to magnesium molar ratio. An addition of magnesium did not affect the potassium contents in the precipitates. K-struvite, MgKPO4 x 6H2O, was not the major product in the precipitate, even with addition of a large quantity of magnesium.     

生物-生态联合污水处理系统

传统的污水处理采用生物处理方法的居多,其中以二级活性污泥法为主。而生态处理系统有其固有的优势,如低费用、低能耗、运行管理维护简单。两者在一定方式下相结合处理污水,会实现技术、经济和环境效益三丰收。国内外的应用实例可以对其进行进一步说明。     

含铜酞菁染料废水及树脂废水的处理工艺研究及应用

采用逆流洗涤方式有效减轻酸污染。含铜酞菁废水采用铁炭微电解预处理技术 ,树脂废水采用物化预处理技术 ,再通过厌氧水解———SBR好氧生化处理技术的工艺流程 ,成功地治理了该有机化工废水 ,出水达到国家排放标准     

城市污水厂污水污泥的热值测定分析方法研究

建立热力学指标是污水生物处理过程热力学分析的基础工作，目前仍缺乏污水污泥化学能测试的标准方法。采用IKA C5000型自动热量计对某城市二级污水处理厂进水、出水、初沉污泥、剩余污泥、混合污泥和脱水污泥进行了热值测定，样品前处理采用103～105℃烘干获得干燥基，用苯甲酸进行加标回收。参照煤的发热量测定方法得到样品的高位热值。试验结果显示：出水干燥基的热值为05 kJ/g，进水干燥基的热值为4 kJ/g以上，各工艺段的污泥干燥基热值较高，基本都在12 kJ/g以上，接近右江褐煤水平。测定结果的标准偏差≤±0.452%，相对标准偏差≤±0.136%。通过同一批样品的元素分析及Dulong公式理论推算，发现2种方法可得到相似的结果。     

Identification of relevant micropollutants in Austrian municipal wastewater and their behaviour during wastewater treatment

The European Union has defined environmental quality standards (EQSs) for surface waters for priority substances and several other pollutants. Furthermore national EQSs for several chemicals are valid in Austria. The study investigated the occurrence of these compounds in municipal wastewater treatment plant (WWTP) effluents. In a first screening of 15 WWTPs relevant substances were identified, which subsequently were monitored in 9 WWTPs over 1 year (every 2 months). Out of 77 substances or groups of substances (including more than 90 substances) 13 were identified as potentially relevant in respect to water pollution and subjected to the monitoring, whereas most other compounds were detected in concentrations far below the respective EQS for surface waters and therefore not further considered. The preselected 13 compounds for monitoring were cadmium (Cd), nickel (Ni), copper (Cu), selenium (Se), zinc (Zn), diuron, polybrominated diphenyl ethers (PBDEs), di(ethyl-hydroxyl)phthalate (DEHP), tributyltin compounds (TBT), nonylphenoles (NP), adsorbable organic halogens (AOX) and the complexing agents ethylenediaminetetraacetic acid (EDTA) as well as nitrilotriacetic acid (NTA). In the effluents of WWTPs the concentrations of the priority substances Cd, NP, TBT and diuron frequently exceeded the respective EQS, whereas the concentrations for DEHP and Ni were below the respective EQS. The effluent concentrations for AOX, EDTA, NTA, Cu, Se and Zn frequently are in the range or above the Austrian EQS for surface waters. Besides diuron and EDTA all compounds are removed at least partially during wastewater treatment and for most substances the removal via the excess sludge is the major removal pathway. For the 13 compounds which were monitored in WWTP effluents population equivalent specific discharges were calculated. Since for many compounds no or only few information is available, these population equivalent specific discharges can be used to assess emissions from municipal WWTPs to surface waters as well as to make a first assessment of the impact of a discharge on surface waters chemical status. Comparing discharges and river pollution on a load basis, the influence of diffuse sources becomes obvious and therefore should also be taken into consideration in river management.     

Food-service establishment wastewater characterization.

Food-service establishments that use on-site wastewater treatment systems are experiencing pretreatment system and/or drain field hydraulic and/or organic overloading. This study included characterization of four wastewater parameters (five-day biochemical oxygen demand [BOD5]; total suspended solids [TSS]; food, oil, and grease [FOG]; and flow) from 28 restaurants located in Texas during June, July, and August 2002. The field sampling methodology included taking a grab sample from each restaurant for 6 consecutive days at approximately the same time each day, followed by a 2-week break, and then sampling again for another 6 consecutive days, for a total of 12 samples per restaurant and 336 total observations. The analysis indicates higher organic (BOD5) and hydraulic values for restaurants than those typically found in the literature. The design values for this study for BOD5, TSS, FOG, and flow were 1523, 664, and 197 mg/L, and 96 L/day-seat respectively, which captured over 80% of the data collected.     

生物-生态联合污水处理系统

传统的污水处理采用生物处理方法的居多,其中以二级活性污泥法为主.而生态处理系统有其固有的优势,如低费用、低能耗、运行管理维护简单.两者在一定方式下相结合处理污水,会实现技术、经济和环境效益三丰收.国内外的应用实例可以对其进行进一步说明.     

Photo-oxidation of cork manufacturing wastewater

Several photo-activated processes have been investigated for oxidation of a cork manufacturing wastewater. A comparative activity study is made between different homogeneous (H2O2/UV-Vis and H2O2/Fe2+/UV-Vis) and heterogeneous (TiO2/UV-Vis and TiO2/H2O2/UV-Vis) systems, with degradation performances being evaluated in terms of total organic carbon (TOC) removal. Results obtained in a batch photo-reactor show that photo-catalysis with TiO2 is not suitable for this kind of wastewater while the H2O2/UV-Vis oxidation process, for which the effect of some operating conditions was investigated, allows to remove 39% of TOC after 4 h of operation (for C(H2O2)=0.59 M, pH=10 and T=35 degrees C). The combined photo-activated process, i.e., using both TiO2 and H2O2, yields an overall TOC decrease of 46% (for C(TiO2)=1.0 gl(-1)). The photo-Fenton process proved to be the most efficient, proceeds at a much higher oxidation rate and allows to achieve 66% mineralization in just 10 min of reaction time (for C(H2O2)=0.31 M, T=30 degrees C, Fe2+:H2O2=0.12 (mol) and pH=3.2).     

废水中硫化物的去除技术

含硫化物的废水常见于染料、医药、农药以及石油化工的生产过程中,对环境影响很大,必须经处理达标才能排放。介绍回收利用法、汽提法、混凝沉淀法、氧化法、生化法和树脂法等六种去除废水中硫化物技术的特点、原理以及局限性,可根据具体废水水质状况选用。