Identification and leaching characteristics of sludge generated from metal pickling and electroplating industries by Toxicity Characteristics Leaching Procedure (TCLP)

One of India's major concerns is the increasing level of land pollution largely due to the uncontrolled disposal of industrialsolid and hazardous waste. With rapid industrialization, thegeneration of industrial solid and hazardous waste has increasedappreciably and the nature of waste generated has become complex.Their impacts on the ecological bodies are noticeable. The article describes the details of studies conducted using Toxicity Characteristics Leaching Procedure, to estimate the toxicity effects of the metals viz., chromium, zinc, manganese,iron, nickel, cobalt and copper by the Zero Headspace Extractorfor the sludges generated from effluent treatment plant of steeltube, wire and plating industries on environment constituentslike groundwater, surface water and land. Toxicity Characteristics Leaching Procedure determines the mobility of organic and inorganic analytes of liquid, solid or multiphase waste from hazardous solid wastes in the form of primary and secondary extracts. These extracts are mixed in equal volumeproportion and analyzed by Direct Reading 2000 spectrophotometer.The amount of heavy metals observed during the studies in theleachates were found and the results were compared with HazardousWaste categories as per Indian Standards, TCLP regulatory limitsgiven by United States Environment Protection Agency (USEPA) andGermany Leachate Quality Standards and it was observed that theywere on higher side, needing a proper preventive concept of sludge management including handling, treatment, recovery and disposal.     

“十三五”以来中国工业危废产生处理情况及管理对策建议

“十三五”以来,中国工业危废产生量逐年增加,利用处置率总体呈上升趋势。废酸等11类工业危废的产生量累计占比接近85%,化工、有色金属冶炼、焦化和钢铁等行业危废产生量较高,且主要集中在四川、河北等10个省(区、市),呈行业、区域高度集中的特点。工业危废主要由工业企业和危险废物集中处理厂处理,其处理比例约为2∶1。工业企业对工业危废的处理方式主要为再循环(再利用);危险废物集中处理厂主要处理方式为综合利用、焚烧和填埋。除云南、天津等少数省(区、市)工业危废利用或处置潜力不足外,大部分省(区、市)仍有较大潜力。建议高度重视工业危废安全处理和定期风险排查,降低生态环境风险。加强工业危废利用处置技术研发,进一步挖掘工业危废集中处理潜力,不断提高工业危废处理质量效益。     

Artemia salina as test organism for assessment of acute toxicity of leachate water from landfills

Artemia salina has, for the first time, been used as test organism for acute toxicity of leachate water from three landfills (the municipal landfills at Kristianstad, Sweden and Siauliai, Lithuania, and an industrial landfill at Stena fragmenting AB, Halmstad, as well as for leachate from Kristianstad treated in different ways in a pilot plan). Artemia can tolerate the high concentrations of chloride ions found in such waters. Large differences in toxicities were found, the leachate from Siauliai being the most toxic one. To increase the selectivity in the measurements, a fractionation was done by using ion exchange to separate ammonium/ammonia and metal ions from the leachate, and activated carbon adsorbents for organic pollutants. The influence of some metals and phenol compounds on the toxicity was investigated separately. It was found that most of the toxicity emanated from the ammonium/ammonia components in the leachate. However, there was also a significant contribution from organic pollutants, other than phenol compounds, since separate experiments had in this latter case indicated negligible impact. The concentrations of metals were at a level, shown by separate experiments, where only small contribution to the toxicity could be expected.     

Characterization of the Leachate in an Urban Landfill by Physicochemical Analysis and Solid Phase Microextraction-GC/MS

The aim of this study is to evaluate extensively the characterization and identification of major pollutant parameters by paying attention to the organic chemical pollution for unregulated dumping site leachate in Eskişehir/Turkey. The study that is first and only one research has been very important data related with before new sanitary landfill site in Eskişehir city. For this purpose, in this study leachate samples were collected in-situ at monthly interval for a period of 8 months. Firstly, thirty three physicochemical parameters were monitored. Secondly, SPME technique was used for identification of organic pollutants. Meteorological data were also recorded for the same sampling period to correlate meteorological data and physicochemical parameters. Mean values are used in the correlation analysis. Correlation is shown only for the relationship between air temperature and NO₃ ⁻. No correlation has been found between rain and leachate quality parameters since the amount of rain was very low during the sampling period. However, analysis results were generally decreased in winter season when each parameter and each sampling point are examined separately. According to correlation between every parameter, especially solid content and dissolved oxygen concentration of leachate is affecting to other parameters. Also, sodium and potassium are changing proportionally with same parameters (suspended solids, fixed solids, dissolved oxygen) and high correlation between chloride and heavy metal concentration is showing. The results were statistically evaluated by use of SPSS 10.0 program. Second part of the study, the leachate was extracted by Solid Phase Microextraction (SPME) technique and then analyzed. Of the methodologies tested in this study, the best one selected was based on 100 μ m polydimethylsiloxane coated fiber (PDMS), headspace with heating (Δ HS) sampling mode and an extraction time of 15 min. at a temperature of 50 ^o C. Thirty three organic compounds in leachate were identified by GC/MS.     

Leachate Characterization and Assessment of Groundwater Pollution Near Municipal Solid Waste Landfill Site

Leachate and groundwater samples were collected from Gazipur landfill-site and its adjacent area to study the possible impact of leachate percolation on groundwater quality. Concentration of various physico-chemical parameters including heavy metal (Cd, Cr, Cu, Fe, Ni, Pb and Zn) and microbiological parameters (total coliform (TC) and faecal coliform (FC)) were determined in groundwater and leachate samples. The moderately high concentrations of Cl⁻, NO⁻ ₃, SO²⁻ ₄, NH⁺ ₄, Phenol, Fe, Zn and COD in groundwater, likely indicate that groundwater quality is being significantly affected by leachate percolation. Further they proved to be as tracers for groundwater contamination. The effect of depth and distance of the well from the pollution source was also investigated. The presence of TC and FC in groundwater warns for the groundwater quality and thus renders the associated aquifer unreliable for domestic water supply and other uses. Although some remedial measures are suggested to reduce further groundwater contamination via leachate percolation, the present study demand for the proper management of waste in Delhi.     

生活垃圾与危险废物的焚烧工艺及污染防治措施比较

比较、归纳、总结了生活垃圾和工业危废焚烧项目在生产工艺、污染源产生及治理、污染物排放标准等方面的异同点,提出必须重视废气排污口设施与在线监测仪器的安装,应完善事故防范措施与应急预案等检查要求,为环保部门验收监测、监督管理工作提供技术支持.     

北京市废弃物处理温室气体排放特征

基于《2006年IPCC国家温室气体清单指南》推荐的方法,结合《省级温室气体清单编制指南（试行）》和《城市温室气体核算工具指南》的部分数据与核算范围,针对固体废弃物填埋、焚烧和废水处理等过程,核算了北京市2005-2014年废弃物处理过程中温室气体总排放量。结果表明：2005-2014年北京市废弃物处理过程温室气体总排放量呈逐渐上升趋势,2014年温室气体总排放量比2005年增长98%。10年间,固体废弃物填埋过程一直是最主要的温室气体排放源,到2014年排放量达到最大,为416.3×10⁴t二氧化碳当量（CO₂e）。废弃物填埋、废水处理和废弃物焚烧过程占总排放量的比例分别为78.5%（CO₂e质量分数,下同）、13.5%和8%。结合已有研究,系统优化国内7个典型城市废弃物处理温室气体排放因子,核算7个城市排放情况,并对比分析了北京市排放情况。     

危险废物集中处置项目竣工环保验收监测中存在的问题及解决对策

简述了我国危险废物（含医疗废物）处置项目的状况,分析了该类项目竣工环保验收监测工作面临的压力,通过实践总结出了存在的问题和难题,主要包括监测期间工况监督内容及方法、焚毁去除率的测定方法、填埋场建设和运行情况的考核手段以及此类项目潜在环境风险的防范手段等,在进行分析的基础上提出了一些解决对策和方法,为监测人员做好验收监测工作提供了很好的借鉴,同时也提出了目前相关标准规范尚未规定但需引起管理部门重视的内容。     

Assessment of Ground Water Vulnerability and its Application to the Development of Protection Strategy for the Water Supply Aquifer in Owerri, Southeastern Nigeria

Pollution vulnerability of theOwerri regional water supply aquifer wasevaluated as a basis for developing appropriateprotection strategy for the groundwaterresource. The assessment was accomplished usingLegrand, GOD, Siga and DRASTIC models.Techniques of the models generally involvedparameters rating and point count systems, whichare based on the evaluation of various parameterin relation to their capacity for enhancing orattenuating contaminants in the groundwatersystem. Field and laboratory evaluations of theparameters indicate that the Owerri areagenerally occupies a nearly, flat topographywith a relatively high groundwater recharge. Thearea is underlain by predominantly sandyfacies in the Northern area which grades intogravelly sequences towards the southwest. TheSoutheastern area is distinguished by thickclayey facies that thin westwards towards theOwerri metropolis. Effective hydraulicconductivity (Kz) in the downward directionranges from 1.44 × 10^-3 to 5.6 × 10^-9 m s^-1; with the upper limits reflecting coarsesands and gravelly units. The amount of clay andclay-size particles in the sandy and gravellyunits is negligible, suggesting that thesorptive capacity of the units is low. Depth towater table decreases southwards while hydraulichead gradients vary between 0.09 and 0.22.Groundwater occurs in unconfined conditions inmost places except in the southeastern zonewhere it is semi-confined due to the presence ofa clayey unit. The groundwater vulnerabilitymap developed on the basis of the models andseveral other thematic maps shows that theOwerri metropolis and the southwest area ofOwerri have high vulnerability, indicatinggroundwater pollution. The existing wastedisposal sites in these sub-areas should beabandoned and rehabilitated to forstall furtherpollution of the groundwater system. Areas tothe North and Southeast of Owerri have moderateand low vulnerabilities, respectively,indicating the relatively lower sensitivity ofthe groundwater system in the sub-areas tocontamination. The lower sensitivity couldfurther be matched with properly engineeredsanitary landfills in the event of choice ofsites, as an additional protective strategy forthe groundwater system.     

电石法生产聚氯乙烯行业危险废物判定要点分析

聚氯乙烯树脂是用途极广的热塑性高分子材料,然而,电石法生产聚氯乙烯树脂（PVC）的过程中会产生大量的危险废物,如处置不当会对环境造成严重污染。本文对电石法生产聚氯乙烯树脂（PVC）过程中产生危险废物的类型、环节和产生特性进行了分析,以供环保部门和相关企业作为针对危险废物环境管理的判定依据。