大气连续自动采样中的质量保证

大气连续自动采样中的质量保证赵柳生（乌鲁木齐市环境科研监测中心站８３００００）在大气环境监测中的质量保证工作，由于监测手段，方法及气体的特性，决定了它较水质监测的质量保证有较大的难度。《环境监测技术规范》（简称规范）主要针对实验室内的操作提出了大气监...     

空气质量周报二氧化硫采样过程影响因素的探讨

文章通过对空气质量周报连续采样过程有关影响因素进行探讨 ,分析了影响大气二氧化硫监测结果的一些原因或可能 ,首次对甲醛吸收液连续采样稳定性提出疑问 ,强调周报质量保证的重心要从实验室环节转到现场采样等环节上来     

大气连续采样在乌鲁木齐应用分析

对乌鲁木齐市大气连续采样方法试运行实验进行总结，比较了以往的定时采样方法后认为，连续采样方法更准确反映本地大气污染物的状况。     

大气监测质量保证的探索

大气手工采样的质量保证系统的研究工作在国内尚少进行。本文比较完整地介绍了一个大气监测质量保证系统的实例,计划分两期刊出,供各地监测站探讨。     

环境空气手工采样的质量保证

本文通过全程序空白试验、平行样试验及加标回收等试验,对大气手工采样的质量保证问题进行了探讨。     

大气环境监测的质量保证杂谈

大气环境监测的质量保证工作,在“空气和废气监测分析方法”,“环境监测技术规范──大气部分”、“环境空气监测质量保证手册”等书中,有了比较详细的规定,如仪器的校准,流量计的校准,空白值的测定、校准曲线的制作以及采样、布点等.本文就采样和分析中一些不易被人们注意,而又是与质量保证有关的问题,谈一点看法。     

大气连续采样的质量保证工作——兼论《大气环境质量考核实施细则》执行中的有关问题

本文对与大气24小时连续采样(夜体吸收法)有关的吸收瓶质量检查、采样系统气密性检验、流量校准等提出了操作要求:用实验说明了采样单元及限流孔单元的温控与流量稳定性的关系;简要分析了大气监测亭采气管叶测值的影响并对生产结构简化、性能可靠的大气连续采样仪器提出了具体意见     

大气连续采样的质量保证工作——兼论《大气环境质量考核实施细则》执行中的有关问题(二)

本文简要分析颗粒物及空气湿度对大气24小时连续采样的影响。重点阐明在我国东南部地区的湿热季节大气采样时,应在《大气环境质量考核实施细则》规定的采样仪器基础上,增加过滤除湿单元以提高大气待测成分的吸入效率。     

金昌市环境空气质量评价及污染特征分析

对１９９７年金昌市大气（２４ｈ连续采样）环境空气质量进行了评价，简单分析了空气污染特征及原因，以便为大气污染防治提供依据。     

大气连续采样中有关质量保证几点体会

大气监测的质量主要包括两部分:采样质量和实验室分析质量.后一部分已有很多成功的经验和方法,而前一部分由于方法不统一,影响因素多,加之重视程度不够等,一直是个薄弱环节,《环境监测技术规范》(以下简称规范)已开始实施,要求将间断采样改为连续采样.本文就连续采样实验室分析法测定大气中SO_2、NOx     

Analyzing SO 2 concentrations and wind directions during a short monitoring campaign at a site far from the industrial pole of La Plata, Argentina

This article presents and discusses SO2 air quality concentrations (ppbv) together with wind velocities and directions measurements carried out between September 1st and December 21st 2005 at a site located 8.5 km away from the Industrial Pole of La Plata area. As the city and its surroundings have no official monitoring network, the current work enlarges the air quality information available from the zone and sets some initial considerations to the future siting of monitoring stations. The statistical analysis of the data was performed using techniques of tests for outliers and trends, dissimilarity measures and robust regression. In relation to SO2 concentrations, low values were found during this short campaign considering daily averages (with a maximum of 8.5 ppbv) and hourly averages (with a maximum of 25.9 ppbv); World Health Organization guidelines were never surpassed. Nevertheless, a strong dependence between wind directions carrying air pollutants from the Industrial Pole and hourly concentration peaks were found. Due to low monthly SO2 concentrations and because a decreasing time trend was found, the authors propose, as an example, the implementation of an alternative discontinuous method to the continuous analyzer used in the current campaign. Our results state that sampling every 7 days at 13:00-13:59 hours (local time) would be enough to get representative values of the air quality. As a general remark it is possible to highlight that longer and systematic studies should be encouraged to confirm the seasonal wind pattern and to evaluate the air quality.     

Continuous, intermittent and passive sampling of airborne VOCs

Long sampling periods are often advantageous or required for measuring air quality and characterizing exposures. However, sampling periods exceeding 8 to 24 h using thermally desorbable adsorbent tube (TDT) samplers for the measurement of airborne volatile organic compounds (VOCs) face several challenges, including maintaining stable and low flow rates, and avoiding breakthrough of the adsorbent. These problems may be avoided using intermittent sampling; however, the literature contains few if any reports that have evaluated this technique in environmental, occupational or other applications. The purpose of this study is to evaluate continuous, intermittent and passive sampling methods using both laboratory and real-world tests. Laboratory tests compared continuous and intermittent (active) samplers in a controlled dynamic test gas generation system. Field tests used side-by-side active and passive samplers in an office, home workshop and four smokers' homes. All samples were analyzed for a wide range of VOCs by GC-MS. In most instances, intermittent sampling yielded better reproducibility (duplicate precision of 10 +/- 6%) than continuous low-flow sampling (18 +/- 5%), in part due to difficulty maintaining low flows. Concentrations obtained using intermittent sampling agreed with those for continuous sampling, with downward biases resulting primarily from errors in flow rate measurements. In the field, more VOC species were detected using active rather than passive sampling. Passive measurements were 12% lower than continuous measurements, a difference attributed to declining uptake rates at higher concentrations over the 3 to 4 d sampling period. Overall, most measurements obtained using the three sampling methods agreed within 20% for a wide range of concentrations (0.1 to 230 microg m(-3)). Both passive and intermittent sampling approaches are suitable for long sampling periods, but intermittent sampling provides greater flexibility with respect to sampling period, and permits the use of multi-bed adsorbents that can capture a wider range of VOCs.     

环境空气中多环芳烃的采样与分析技术

文章对环境空气中多环芳烃的采样与分析方法进行了概述,侧重介绍了样品的采集、净化、采样效率的评估方法和采样分析全过程的质量控制.     

气相和颗粒物中邻苯二甲酸酯的采样与检测技术

对邻苯二甲酸酯的性质及其在环境空气中的存在状态、样品采集技术与分析方法进行了综述,侧重介绍了样品的采集、净化、采样效率和采样与分析全过程的质量控制。     

自动监测站第三方运维管理的思考

随着自动监测技术的不断发展,其连续、稳定的监测优势正在逐步代替手工监测,各地监测部门投入了大量的资源和精力建成了大量的空气、水质自动站,在灰霾监测、河道水质监管、大环境预警方面等都起到了积极作用。由于自动站数量多,工作任务复杂繁重,因此大部分地区都采用第三方托管模式进行自动站日常运维管理。如何有效的进行权责分配、提高工作效率、减少管理摩擦等成为业主方不可回避和亟待解决的问题。根据实际管理实践,结合一些实用的管理经验,提出了一系列相关措施。     

Air quality impact assessment

Air quality impact assessment (AQIA) is an important technique for determining the relative contribution to ground level pollutant concentrations of specific current or future source emissions at receptor sites. The principal activities in AQIA are air quality modelling and monitoring techniques. The choice of techniques which are applicable to a particular situation is intimately related to the problem to be assessed. A review of relevant modelling techniques has been presented, with emphasis placed on Gaussian plume models because of their ease of use and broad applicability. Alternative modelling techniques have been suggested when departures from the Gaussian form in the atmosphere occurs or when more detailed information on atmospheric chemistry, deposition or long range transport is required. The objectives and techniques of ambient air quality monitoring have been examined and the siting of instruments, duration and frequency of sampling, choice of monitoring rationale (fixed or mobile), minimization of sampling errors, data storage and analysis are discussed. Modelling and monitoring are essential to successful AQIA. An orderly approach to the principles and procedures involved in performing AQIA studies, using these two techniques in conjunction, has been presented.     

Air Quality Assessment in Delhi: Before and After CNG as Fuel

A number of policy measures have been activated in India in order to control the levels of air pollutants such as particulate matter, sulphur dioxide (SO₂) and nitrogen dioxide (NO₂). Delhi, which is one of the most polluted cities in the world, is also going through the implementation phase of the control policies. Ambient air quality data monitored during 2000 to 2003, at 10 sites in Delhi, were analyzed to assess the impact of implementation of these measures, specifically fuel change in vehicles. This paper presents the impact of policy measures on ambient air quality levels and also the source apportionment. CO and NO₂ concentration levels in ambient air are found to be associated with the mobile sources. The temporal variation of air quality data shows the significant effect of shift to CNG (Compressed Natural Gas) in vehicles.     

Air quality assessment of Estarreja, an urban industrialized area, in a coastal region of Portugal

Despite the increasing concern given to air quality in urban and industrial areas in recent years, particular emphasis on regulation, control, and reduction of air pollutant emissions is still necessary to fully characterize the chain emissions–air quality–exposure–dose–health effects, for specific sources. The Estarreja region was selected as a case study because it has one of the largest chemical industrial complexes in Portugal that has been recently expanded, together with a growing urban area with an interesting location in the Portuguese coastland and crossed by important road traffic and rail national networks. This work presents the first air quality assessment for the region concerning pollutant emissions and meteorological and air quality monitoring data analysis, over the period 2000–2009. This assessment also includes a detailed investigation and characterization of past air pollution episodes for the most problematic pollutants: ozone and PM10. The contribution of different emission sources and meteorological conditions to these episodes is investigated. The stagnant meteorological conditions associated with local emissions, namely industrial activity and road traffic, are the major contributors to the air quality degradation over the study region. A set of measures to improve air quality—regarding ozone and PM10 levels—is proposed as an air quality management strategy for the study region.     

江苏省区域空气质量多模式预报预警系统研究与设计

围绕江苏省大气污染日益严峻的形势,设计了江苏省区域空气质量多模式预报预警系统,系统主要由数据中心、计算中心、分析展示中心、预报中心4个部分构成,运用了多模式集合预报、数据仓储联机分析处理、数据挖掘及智能关联等关键技术。系统的建成将为江苏省各级政府和相关单位决策层制定区域联动的大气污染防控措施,采取针对性的应急处置措施提供科学、及时的技术支撑。     

基于环境监测数据的APEC会议空气质量保障环境改善效果评估

在简要回顾APEC期间的空气质量情况的基础上,从多方面较系统的分析了APEC期间北京市空气质量的变化特征,包括各项污染物浓度水平的同比分析、不同区域不同类别站点小时浓度的百分数分布及变化情况分析、污染物日变化规律变化特征分析、空气质量改善效果的空间分布特征分析、颗粒物组分变化特征分析、污染来源解析模型、数值污染模型等方法,力求从多个方面深入了解APEC控制措施对北京市污染水平、污染特征造成的影响,并利用组分、模型等方法定性定量的评估主要空气质量影响因素、不同的污染控制措施对APEC期间空气质量改善的作用及贡献。结果表明,APEC期间,北京市空气质量得到明显改善,空气质量基本处于优良级别,各项污染物浓度大幅下降,APEC污染控制期各项污染物的百分位数浓度与无控制期出现明显分离特征,污染物的日变化低浓度持续时间更长且增长更缓慢。