Evaluation of metal contents of household detergent samples from Turkey by flame atomic absorption spectrometry

The concentrations of cadmium, copper, chromium, cobalt, iron, lead, manganese, nickel, and zinc in detergent samples from Kayseri, Turkey were determined by flame atomic absorption spectrometry. HClO₄ (10 mL)/HNO₃ (10 mL) mixture was used for the digestion of household detergent samples. The correctness of the analytical procedures was checked with standard addition–recovery tests in different detergent samples for the investigated metal ions. The concentration ranges of the elements in the detergent samples were found as 17.2–60.1, 11.1–40.1, 2.5–32.3, 8.1–10.5, 7.2–21.6, 9.8–17.9, 1.7–3.8, 12.5–22.5, and 2.0–5.8 μg/g for iron, manganese, zinc, copper, lead, cobalt, cadmium, nickel, and chromium, respectively. The values found in this work were compared with some other studies around the world conducted on detergent samples.     

Concentrations and bioaccessibility of metals in vegetation and dust near a mining haul road, Cape Krusenstern National Monument, Alaska

Vegetation, sub-surface peat, and road dust were sampled near the Delong Mountain Transportation System (DMTS) haul road in northwest Alaska in 2005-2006 to document aluminum, barium, cadmium, lead, and zinc concentrations, and to evaluate bioaccessibility of these metals. The DMTS haul road is the transport corridor between Red Dog Mine (a large-scale, lead-zinc mine and mill) and the coastal shipping port, and it traverses National Park Service lands. Compared to reference locations, total metal concentrations in four types of vegetation (birch, cranberry, and willow leaves, and cotton grass blades/stalks) collected 25 m from the haul road were enriched on average by factors of 3.5 for zinc, 8.0 for barium, 20 for cadmium, and 150 for lead. Triple rinsing of vegetation with a water/methanol mixture reduced metals concentrations by at most 50%, and cadmium and zinc concentrations were least affected by rinsing. Cadmium and zinc bioaccessibility was greater in vegetation (50% to 100%) than in dust (15% to 20%); whereas the opposite pattern was observed for lead bioaccessibility (<30% in vegetation; 50% in dust). Barium exhibited low-to-intermediate bioaccessibility in dust and vegetation (20% to 40%), whereas aluminum bioaccessibility was relatively low (<6%) in all sample types. Our reconnaissance-level study indicates that clean-up and improvements in lead/zinc concentrate transfer activities have been effective; however, as of 2006, metal dispersion from past and/or present releases of fugitive dusts along the DMTS road still may have been contributing to elevated metals in surface vegetation. Vegetation was most enriched in lead, but because bioaccessibility of cadmium was greater, any potential risks to animals that forage near the haul road might be equally important for both of these metals.     

应用化学质量平衡模型解析西宁大气PM2.5的来源

为研究影响西宁市大气环境PM_(2.5)污染水平的主要来源,于2014年采暖季、风沙季和非采暖季依托西宁市大气地面观测网络在11个监测点采集大气PM_(2.5)样品,对其化学组分(元素、离子和碳)进行分析。研究同步采集了4类固定源、14类移动源和4类开放源的PM_(2.5)样品,并构建源排放成分谱。应用化学质量平衡受体模型(CMB)开展源解析研究。源解析结果表明,观测期间西宁市PM_(2.5)主要来源包括城市扬尘(分担率为26.4%)、燃煤尘(14.5%)、机动车尾气(12.8%)、二次硫酸盐(9.0%)、生物质燃烧(6.6%)、二次硝酸盐(5.7%)、钢铁尘(4.7%)、锌冶炼尘(3.4%)、建筑尘(4.4%)、土壤尘(4.4%)、餐饮排放(2.9%)和其他未识别的来源(5.2%)。大力开展城市扬尘为主的开放源污染控制,严格控制本地燃煤、机动车等污染源的PM_(2.5)排放,是改善西宁市空气质量的重要途径。     

Water-soluble species and heavy metal contamination of the petroleum refinary area,Jordan

The levels of lead, cadmium, copper, zinc, aluminum, chromium, and iron in street dust, soil, and plants in the Jordanian petroleum refinery were determined using flame and graphite-furnace atomic absorption spectrophotometry. Major cations (Li+, Na+, NH4+, K+, Mg2+, and Ca2+) and anions (F-, Cl-, NO3-, SO4(2-), and Br-) were also determined using suppression mode ion chromatography. Generally, higher levels of the heavy metals studied were found in street dust samples than in soil samples. On the other hand, except Cl-, and Li+ ions, other anions and cations showed higher concentrations in soil than in street dust samples. For plant samples, unwashed samples showed higher levels of heavy metals than their washed counterparts, indicating that dust fall is a source of heavy metal contamination.     

Characterization and Identification of the Sources of Chromium, Zinc, Lead, Cadmium, Nickel, Manganese and Iron in Pm10 Particulates at the Two Sites of Kolkata, India

Monitoring of ambient PM₁₀ (particulate matter which passes through a size selective impactor inlet with a 50% efficiency cut-off at 10 μm aerodynamic diameter) has been done at residential (Kasba) and industrial (Cossipore) sites of an urban region of Kolkata during November 2003 to November 2004. These sites were selected depending on the dominant anthropogenic activities. Metal constituents of atmospheric PM₁₀ deposited on glass fibre filter paper were estimated using Inductively Coupled Plasma Atomic Emission Spectrometer (ICP-AES). Chromium (Cr), zinc (Zn), lead (Pb), cadmium (Cd), nickel (Ni), manganese (Mn) and iron (Fe) are the seven toxic trace metals quantified from the measured PM₁₀ concentrations. The 24 h average concentrations of Cr, Zn, Pb, Cd, Ni, Mn and Fe from ninety PM₁₀ particulate samples of Kolkata were found to be 6.9, 506.1, 79.1, 3.3, 7.4, 2.4 and 103.6 ng/m³, respectively. The 24 h average PM₁₀ concentration exceeded national ambient air quality standard (NAAQS) as specified by central pollution control board, India at both residential (Kasba) and industrial (Cossipore) areas with mean concentration of 140.1 and 196.6 μg/m³, respectively. A simultaneous meteorology study was performed to assess the influence of air masses by wind speed, wind direction, rainfall, relative humidity and temperature. The measured toxic trace metals generally showed inverse relationship with wind speed, relative humidity and temperature. Factor analysis, a receptor modeling technique has been used for identification of the possible sources contributing to the PM₁₀. Varimax rotated factor analysis identified four possible sources of measured trace metals comprising solid waste dumping, vehicular traffic with the influence of road dust, road dust and soil dust at residential site (Kasba), while vehicular traffic with the influence of soil dust, road dust, galvanizing and electroplating industry, and tanning industry at industrial site (Cossipore).     

The occurrence of heavy metals in irrigated and non-irrigated arable soils,NW Albania

The study analysed the content of heavy metals in surface soil and sediment samples from the Bregu i Matit Plain in NW Albania in relation to irrigation in order to evaluate the soil pollution and the potential risk to human health. Evaluation of soil pollution was performed using the enrichment factor and geo-accumulation index. Contents of cadmium, chromium and nickel of irrigated soils were significantly higher than those of non-irrigated soil, while contents of lead (in three of the irrigated locations), zinc and arsenic (in one of the irrigated locations) were significantly lower. Correlation analysis (CA) and principal component analysis (PCA) indicated that the primary source of the first three metals was irrigation, and the last three metals were originated from other anthropic sources, like the use of chemicals, etc. Enrichment factor (E _f) calculation showed that irrigated soils were most enriched in cadmium, chromium, copper and nickel. Index of geo-accumulation (I _geo) revealed that arable soils of Bregu i Matit are unpolluted to moderately polluted with cadmium, chromium, copper and zinc and moderately to strongly polluted with nickel and arsenic. The presence of heavy metals in the studied soils indicates a potential risk of transfer of these elements in the food chain. Therefore, further studies on the speciation of heavy metals in the studied soils in order to evaluate their mobility are needed.     

杭州市大气PM2.5和PM10污染特征及来源解析

2006年在杭州市两个环境受体点位采集不同季节大气中PM_2.5和PM₁₀样品,同时采集了多种颗粒物源类样品,分析了其质量浓度和多种化学成分,包括21种无机元素、5种无机水溶性离子以及有机碳和元素碳等,并据此构建了杭州市PM_2.5和PM₁₀的源与受体化学成分谱;用化学质量平衡(CMB)受体模型解析其来源。结果表明,杭州市PM_2.5和PM₁₀污染较严重,其年均浓度分别为77.5μg/m³和111.0μg/m³;各主要源类对PM_2.5的贡献率依次为机动车尾气尘21.6%、硫酸盐18.8%、煤烟尘16.7%、燃油尘10.2%、硝酸盐9.9%、土壤尘8.2%、建筑水泥尘4.0%、海盐粒子1.5%。各主要源类对PM₁₀贡献率依次为土壤尘17.0%、机动车尾气尘16.9%、硫酸盐14.3%、煤烟尘13.9%、硝酸盐粒8.2%、建筑水泥尘8.0%、燃油尘5.5%、海盐粒子3.4%、冶金尘3.2%。     

Determination of road dust loadings and chemical characteristics using resuspension

The contribution of fugitive dust from traffic to air pollution can no longer be ignored in China. In order to obtain the road dust loadings and to understand the chemical characteristics of PM₁₀ and PM_2.5 from typical road dust, different paved roads in eight districts of Beijing were selected for dust collection during the four seasons of 2005. Ninety-eight samples from 28 roads were obtained. The samples were resuspended using equipment assembled to simulate the rising process of road dust caused by the wind or wheels in order to obtain the PM₁₀ and PM_2.5 filter samples. The average road dust loading was 3.82 g m^− 2, with the highest of 24.22 g m^− 2 being in Hutongs in the rural–urban continuum during winter. The road dust loadings on higher-grade roads were lower than those on lower-grade roads. Attention should be paid to the pollution in the rural–urban continuum areas. The sums of element abundances measured were 16.17% and 18.50% for PM₁₀ and PM_2.5 in road dust. The average abundances of OC and EC in PM₁₀ and PM_2.5 in road dust were 11.52%, 2.01% and 12.50%, 2.06%, respectively. The abundance of elements, water-soluble ions, and OC, EC in PM₁₀ and PM_2.5 resuspended from road dust did not change greatly with seasons and road types. The soil dust, construction dust, dust emitted from burning coal, vehicle exhaust, and deposition of particles in the air were the main sources of road dust in Beijing. Affected by the application of snow-melting agents in Beijing during winter, the amount of Cl⁻ and Na⁺ was much higher during that time than in the other seasons. This will have a certain influence on roads, bridges, vegetations, and groundwater.     

Air quality and deposition of trace elements in Didouche Mourad, Algeria

Total suspended particulate matter and deposition fluxes of particles were investigated in the town of Didouche Mourad which is located 13 km north of Constantine. Samples of air particulate matter were collected at one site located in the heart of the town and situated 3 km north of a cement plant. Samples were collected from 2 November 2002 to 28 April 2003 every 3 days using a high volume air sampler. Sampling intervals were 24 h in all cases. During the same period, samples of dust fallout were collected at the same site. Samples were collected at 30-day intervals. Lead, chromium, manganese, nickel, copper, cobalt and cadmium deposition fluxes were measured and both the soluble and insoluble fractions were determined. Furthermore, the information gathered by this study was correlated with the corresponding hourly weather data provided by a weather station installed at the study station. The possible sources for dust and trace metals were analyzed by comparing average contributions of wind aspects to the concentrations and depositions of mass and chemical species with the average frequencies of wind direction. The mean concentration was 300 μg/m³. The average dust deposition rate through the period of study was 221 mg/(m².day). Results indicate that anthropogenic sources contribute greatly to trace elements. An exposure assessment to the heavy metals taking into account the inhalation route and soil dust ingestion was carried out and allowed direct comparison of trace metal intakes via these routes.     

Monitoring of trace amounts of heavy metals in different food and water samples by flame atomic absorption spectrophotometer after preconcentration by amine-functionalized graphene nanosheet

We are introducing graphene oxide modified with amine groups as a new solid phase for extraction of heavy metal ions including cadmium(II), copper(II), nickel(II), zinc(II), and lead(II). Effects of pH value, flow rates, type, concentration, and volume of the eluent, breakthrough volume, and the effect of potentially interfering ions were studied. Under optimized conditions, the extraction efficiency is >97 %, the limit of detections are 0.03, 0.05, 0.2, 0.1, and 1 μg L^?1 for the ions of cadmium, copper, nickel, zinc, and lead, respectively, and the adsorption capacities for these ions are 178, 142, 110, 125, and 210 mg g^?1. The amino-functionalized graphene oxide was characterized by thermogravimetric analysis, transmission electron microscopy, scanning electron microscopy, and Fourier transform infrared spectrometry. The proposed method was successfully applied in the analysis of environmental water and food samples. Good spiked recoveries over the range of 95.8–100.0 % were obtained. This work not only proposes a useful method for sample preconcentration but also reveals the great potential of modified graphene as an excellent sorbent material in analytical processes.