深圳市饮用水源中CODMn与TOC的相关性研究

通过对深圳市饮用水源中CODMn和TOC测定结果的相关性分析,结果表明,水库内监测点位及监测区域CODMn与TOC相关性良好,水库外监测点位及监测区域CODMn与TOC相关性不显著,而整个监测区域的CODMn与总有机碳相关性令人满意。因此,提出了TOC值可直接作为饮用水源在线监测有机污染物的综合评价指标,同时也实现了湿式氧化法测定TOC在地表水监测中的应用。     

城镇污水处理厂TOC与COD相关性分析及应用

通过在线TOC水质自动分析仪方法与实验室COD方法比对，建立TOC-COD一元线性回归方程，且将其应用到上海市44家污水处理厂出水中TOC与COD值的转换，并在污水处理厂进行在线TOC水质自动分析仪及在线COD水质自动分析仪监测值比对实验。结果表明,TOC-COD一元线性回归方程相关系数r为 0.963，废水中TOC与COD值线性显著相关，通过上述回归方程将在线TOC水质自动分析仪监测值转化COD监测值与在线COD水质自动仪监测值进行相对误差比较，88.4％的数据满足《水污染源在线监测系统安装技术规范（试行）》（HJ/T 355－2007）规范要求；用上述转换方程换算上海市44家污水处理厂TOC值得到的COD值与实验室COD值进行误差计算， 87.3%的数据满足上述规范要求，验证了在线TOC值转换COD值在污水行业的适用性。     

化学需氧量和总有机碳在水质在线监测中的比较

化学需氧量（COD）和总有机碳（TOC）是定量表示水体受有机物污染的2个重要代表性指标。传统的COD在线监测方法在监测有机污染物方面存在一定的挑战，系统比较了COD和TOC在线监测方法在特殊水质中的应用。结果显示：TOC对难氧化有机物的氧化效率高达98%，高氯离子和无机还原性离子对TOC测量误差影响分别约为10%和7%。TOC可更直接、更准确地反映出水体受有机物污染的情况，最后对TOC指标在水质在线监测中的推广应用提出建议。     

水体中TOC与COD相关性研究

针对不同地区的地表水、生活污水和工业废水的TOC和COD进行了测试,对测定值进行线性回归分析。结果表明,不同类型的水体其TOC与COD均具有一定的相关性,尤其是生活污水和工业废水,TOC与COD相关性比较显著,在一定条件下可由测定的TOC值推算出COD值。     

大庆城市生活污水处理厂TOC与COD的相关性分析

总有机碳（TOC）相对于COD能够更全面地反映水体中有机物的污染程度，用TOC监测代替COD监测有利于实现监测仪器化、自动化．以大庆市东城区污水处理厂进水与出水为研究对象，建立了二者之间的线性回归方程     

革基布废水中TOC和COD的相关研究

通过对革基布企业废水中CODcr和TOC测定结果相关性分析,结果表明,革基布企业的CODcr和TOC相关性良好,为污水中有机污染物的TOC监测代替COD监测提供了实践依据。     

总有机碳的测定及其在染料废水监测中的应用

总有机碳能够完全反映水中有机污染程度,已被许多国家所采用,我国也将它列入“污水综合排放标准”中。文章采用德国耶那仪器有限公司的Multi N/C TOC分析仪,用燃烧氧化-非分散红外吸收法分别测定直接染料、活性染料、分散染料、还原染料废水的TOC,并测定相关废水的COD值。实践证明在同类特定染料废水中,TOC与COD之间具有较好的相关性,因此可用TOC监测染料废水污染程度,该方法快速、简便、准确度高。     

COD与TOC测定方法的比较

系统地对比了 COD和 TOC 两种水中有机污染指标测定方法原理，得出了 TOC 在直接代表水质有机污染、氧化有机物完全、产生二次污染物少、测定时间短和消耗劳动力少等方面优于 COD 的结论，并分析了 TOC 取代 COD 的难点和趋势。     

基于常规给水处理工艺COD和TOC相关性研究

本文通过对平山头自来水厂中各处理单元中水体有机物的COD与TOC监测数据的研究,建立两者之间的线性回归方程,结果表明两者存在良好的线性关系,为平山头自来水厂水体中有机物的TOC监测代替COD监测提供了依据。     

地表水环境质量评价数据有效性探讨

通过对上海某区一年地表水手工常规监测与自动监测数据比较,对地表水环境质量评价的数据有效性进行分析,提出在丰水期(非威潮影响期)每月需监测8次(隔3日采样),在枯水期(成潮影响期)每月监测1次.定量解决了上海某区地表水环境质量评价数据有效性争议问题.     

COD and TOC analysis of leachate from a solidified organic waste

Several combinations of binders and absorbent additives were utilized to solidify a typical organic waste, API Separator sludge. The effectiveness of the materials was based on the waste leachability from the solidified samples. COD and TOC analyses were used to determine the organic content of the leachate samples.The ability of the COD and TOC analyses to assess waste leachability was limited. The inability of the COD and TOC tests to differentiate between organic compounds made the results difficult to interpret. This was due to organic contaminants from the solidification materials contributing to the COD and TOC contents of the leachates. Also, the COD test may have be influenced by reduced inorganic compounds contained in the flyash binder and the sludge. Representative samples for the TOC analysis were difficult to obtain for the leachates containing oils or suspended particles. It is recommended that the COD and TOC tests only be used as a screening method for determining solidified organic waste leachability and other methods need to be employed to obtain more accurate results.     

浅谈TOC与CODCr的关系

介绍了TOC和CODCr的含义，比较了TOC与CODCr测定方法、使用仪器的不同和各自的优缺点，并从理论上和实际水样测定中论述了TOC和CODCr的相关性。对于不同的废水，TOC 与CODCr的相关性不一样，必须先实验求出二者之间的关系。     

Total organic carbon analysis as a precursor to disinfection byproducts in potable water: oxidation technique considerations

In recent years, an increasing number of regulations and methodologies have begun to utilize total organic carbon (TOC) analysis for monitoring microbial contamination and/or disinfectant byproduct (DBP) precursors. This paper highlights some analytical differences and similarities between the two widely used TOC oxidation techniques: UV persulfate and high temperature combustion (HTC). Previous papers have come to different and sometimes contradictory conclusions on this subject. However, these studies either compared instruments with significantly different flow paths or TOC systems from different eras. Unlike previous studies, this paper compares two modern TOC analyzers with nearly identical flow paths for sample recovery, detection limits, and analysis of real world samples. On average, both persulfate and HTC oxidation yielded good recoveries for 10 hard to oxidize compounds and potable water samples from 5 different locations across the USA. In general, persulfate yielded more precise results because of its lower background response relative to sample response while HTC gave slightly higher results (roughly 2% to 3%) for surface water samples.     

富营养化湖泊叶绿素a时空变化特征及其影响因素分析

基于内蒙古乌梁素湖区20个监测点5、7、9、11月的监测数据,分析水体中叶绿素a浓度时空变化情况。同时,分析水体中总氮、总磷、氨氮、硝酸盐氮、COD、p H、总有机碳与叶绿素a的相关性。结果显示,叶绿素a浓度呈现由西北向东南逐渐减少的趋势,而浓度峰值出现在7月下旬,低值出现在11月下旬。相关因素与叶绿素a的相关性呈复杂性,线性拟合结果显示,与COD没有明显相关性;与总有机碳呈弱负相关性,与p H呈负相关性;而与总磷、总氮、氨氮、硝酸盐氮呈正相关性。期望该研究为干旱区湖泊水体富营养化控制和水资源管理提供科学依据。     

The use of sensor arrays for environmental monitoring: interests and limitations

Continuous, in situ monitoring of air, water and land quality is fundamental to most environmental applications. Low cost and non-invasive chemical sensor arrays provide a suitable technique for in situ monitoring. Their ability and performance under realistic conditions is discussed in this paper. Published studies report promising results despite a number of limitations that are associated with both the technology itself and its application in ever changing ambient conditions. Early investigations include the analysis of single substances as well as odour and wastewater organic load monitoring. Reported applications typically highlight the sensitivity of the currently available sensors to changes in temperature, humidity and flow rate. Two types of approaches are recommended to deal with these effects: either working under fixed experimental conditions or measuring the external parameters to numerically compensate for their change. The main challenge associated with the use of non-specific sensor arrays lies in establishing a relationship between the measured multivariate signals and the standards metrics that are traditionally used for quality assessment of gas mixtures. For instance, odour monitoring requires calibration against olfactometric measurements while investigations of wastewater samples still need to be correlated with organic pollution parameters such as BOD, COD or TOC. On the other hand, results obtained in the field have demonstrated how sensor arrays can be readily used as simple alarm devices or as early warning systems based on a general air/water quality index.     

Assessing the feasibility of wastewater recycling and treatment efficiency of wastewater treatment units

Wastewater reuse can significantly reduce environmental pollution and save the water sources. The study selected Cheng-Ching Lake water treatment plant in southern Taiwan to discuss the feasibility of wastewater recycling and treatment efficiency of wastewater treatment units. The treatment units of this plant include wastewater basin, sedimentation basin, sludge thickener and sludge dewatering facility. In this study, the treatment efficiency of SS and turbidity were 48.35–99.68% and 24.15–99.36%, respectively, showing the significant removal efficiency of the wastewater process. However, the removal efficiencies of NH₃–N, total organic carbon (TOC) and chemical oxygen demand (COD) are limited by wastewater treatment processes. Because NH₃–N, TOC and COD of the mixing supernatant and raw water are regulated raw water quality standards, supernatant reuse is feasible and workable during wastewater processes at this plant. Overall, analytical results indicated that supernatant reuse is feasible.     

Total organic carbon analyzers as tools for measuring carbonaceous matter in natural waters

For some utilities, new US drinking water regulations may require the removal of disinfection byproduct (DBP) precursor material as a means of minimizing DBP formation. The Environmental Protection Agency's Stage 1 DBP Rule relies on total organic carbon (TOC) concentrations as a measure of the effectiveness of treatment techniques for removing organic material that could act as DBP precursors. Accordingly, precise and accurate methods are needed for the determination of TOC and dissolved organic carbon (DOC) concentrations in raw and finished potable water supplies. This review describes the current analytical technologies and summarizes the key factors affecting measurement quality. It provides a look into the fundamental principles and workings of TOC analyzers. Current peroxydisulfuric acid wet ashing methods and combustion methods are discussed. Issues affecting quality control, such as non-zero blanks and preservation, are covered. Some of the difficulties in analyzing water for TOC and DOC that were identified up to 20 years ago still remain problematic today. Limitations in technology, reagent purity, operator skill and knowledge of natural organic matter (NOM) can preclude the level of precision and accuracy desirable for compliance monitoring.