Carbamazepine degradation by photolysis and titanium dioxide photocatalysis

We investigated the degradation of carbamazepine by photolysis/ultraviolet (UV)-C only and titanium dioxide photocatalysis. The degradation of carbamazepine by UV-only and titanium-dioxide-only (adsorption) reactions were inefficient, however, complete degradation of carbamazepine was observed by titanium dioxide photocatalysis within 30 min. The rate of degradation increased as initial carbamazepine concentration decreased, and the removal kinetics fit well with the Langmuir-Hinshelwood model. The addition of methanol, a radical scavenger, decreased carbamazepine removal, suggesting that the hydroxide radical played an important role during carbamazepine degradation. The addition of oxygen during titanium dioxide photocatalysis accelerated hydroxide radical production, thus improving mineralization activity. The photocatalytic degradation was more efficient at a higher pH, whereas the removal of carbamazepine and acridine (a major intermediate) were more efficient under aerobic conditions. The mineralization of carbamazepine during photocatalysis produced various ionic by-products such as ammonium and nitrate by way of nitrogen dioxide.     

Photodegradation of monochlorobenzene in titanium dioxide aqueous suspensions

The photocatalytic degradation of monochlorobenzene using titanium dioxide aqueous suspensions was performed under solar-simulated irradiation. The effects of concentration of monochlorobenzene, amount of titanium dioxide and pH of solution on the degradation were examined. The intermediates identified were three monochlorophenols, chlorohydroquinone and hydroxy-hydroquinone.     

二氧化钛/碳纳米管/壳聚糖薄膜的制备及对苯的降解性能

研究了光催化降解挥发性有机化合物过程中催化剂二氧化钛/碳纳米管/壳聚糖薄膜的制备以及该催化剂对苯的光催化性能。首先采用溶胶-凝胶法制备纳米复合材料二氧化钛/碳纳米管,然后利用壳聚糖作为交联剂,制得二氧化钛/碳纳米管/壳聚糖复合材料催化薄膜。通过傅立叶红外光谱(FT-IR)、X射线衍射(XRD)透射电镜扫描(TEM)和紫外-可见光漫反射(UV-Vis)等技术分析了复合材料薄膜的组成、结构、形貌和对光的吸收性能,然后使用该催化剂对室内常见的污染物苯进行降解,并在同样的实验条件下,使用催化剂二氧化钛(P25)/壳聚糖对苯进行降解,对两者催化性能进行对比,结果表明,二氧化钛/碳纳米管/壳聚糖对苯有更强的吸附能力和更高的催化活性。     

Photoactive titanium dioxide nanoparticles modify heterotrophic microbial functioning

Environmental Science and Pollution Research - Nanoparticulate titanium dioxide (nTiO2) is frequently applied, raising concerns about potential side effects on the environment. While various...     

纳米TiO2光催化剂负载技术研究

纳米TiO2光催化剂在废水处理、空气净化等环保领域具有诱人的应用前景,将其负载于一定的载体上,并设计出高效的光反应器是其实用化的关键之一.本文对纳米TiO2光催化剂负载所用载体、固定方法及其效果、相关光催化化学反应器作了综合评述.     

Light-induced degradation of perfluorocarboxylic acids in the presence of titanium dioxide

The UV-photon-induced degradation of heptafluorobutanoic acid was investigated in acidic aqueous solutions in the presence of titanium dioxide. Heptafluorobutanoic acid could be degraded with this photocatalyst in a light-induced reaction generating carbon dioxide and fluoride anions. Carbon dioxide evolution in a significant amount occurred only in the presence of molecular oxygen and the photocatalyst. The light-induced degradation of trifluoroacetic acid, pentafluoropropanoic acid, nonafluorobutanoic acid, pentadecafluorooctanoic acid, nonafluorobutanesulfonic acid, and heptadecafluorooctanesulfonic acid in the presence of titanium dioxide was also studied. The perfluorocarboxylic acids under investigation are degraded to generate CO(2) and fluoride anions while both perfluorinated sulfonic acids are persistent under the experimental conditions employed in this study. For all compounds photonic efficiencies of the mineralization reaction were estimated to be smaller than 1x10(-5). To increase the photocatalytic activity mixed systems containing homogeneous phosphotungstic acid and heterogeneous titanium dioxide catalysts were also investigated. In the mixtures of these two photocatalysts, the formation rate of CO(2) increased with illumination time.     

Cytotoxicity and histopathological analysis of titanium nanoparticles via Artemia salina

Environmental Science and Pollution Research - The consumption trend of nanoparticles by industry in this moment pays attention to titanium nanoparticles (TiNPs), due to their various applications:...     

TiO_2晶体的微波水热法制备及光催化性能研究

以TiSO4和尿素为主要原料,EDTA为控制剂,采用微波水热法制备纳米TiO2光催化剂,并分析了纳米TiO2晶粒的最佳形成条件。利用XRD、TEM等技术对制备产物进行表征。结果表明,TiSO4和尿素混合物在微波水热条件下晶化150 min后,产物为锐钛矿型TiO2,且产物粒径小、大小均匀。在紫外光照射下,以自制的锐钛矿型纳米TiO2为催化剂,酸性橙为降解目标物,进一步研究了其光催化性能。结果表明,该TiO2在紫外光照射下表现出稳定的光催化活性。     

Iron content and its relations to the sulphur and titanium contents of epiphytic and terricolous lichens and pine bark in Finland

The iron content was studied in the epiphytic lichens Hypogymnia physodes (L.) Nyl. and Pseudevernia furfuracea (L.) Zopf, in the terricolous lichens Cladina sp. and Peltigera aphthosa (L.) Willd., and in pine bark collected from 31 sites in Finland. There appeared to be differences between lichen species, epiphytes having generally higher concentrations. The iron content of H. physodes was highly significantly correlated (p<0.001) with its sulphur content, reflecting the relations of these elements in precipitation. The highly significant correlations between the iron and titanium contents indicated differences of the phorophytes. The iron/sulphur ratio of H. physodes on pine was 1.3 and on birch 1.4 and iron/titanium ratios were 10.4 and 11.3 respectively. The iron content of Cladina sp. showed highly significant parallel correlations (p<0.001) with its sulphur and titanium contents. The iron/titanium ratio decreased from 9.6 to 8.2 when the iron content increased by 95%, the sulphur content being equal. The iron/titanium ratio of Cladina sp. was nearly identical to that of P. furfuracea. The relation between iron and sulphur, and the fraction of soluble and insoluble iron in precipitation versus lichens and pine bark were considered. Special attention was paid in the discussion to differences in substrate: pine and birch bark for H. physodes, and soil for Cladina sp.     

超细TiO2粒子的超滤分离及回用特性

针对TiO2超细粒子的超滤分离特性进行了试验研究,探讨了操作压力、膜面流速、TiO2投量、pH、电解质等参数条件对膜通量的影响规律及作用机理,证实了浓差极化及滤饼层阻力是影响通量变化的主导因素,在此基础上确定了适宜的超滤工艺条件及膜清洗方式.以甲基橙为降解基质分别测试了经混凝与超滤分离后的TiO2光催化活性,结果表明,超滤不仅可实现TiO2粒子与水的彻底分离,且分离后TiO2催化活性与初次使用相当.研究表明超滤用于悬浮光催化体系的固液分离及催化剂再用是可行的.     

Electrospun nanofibers of polyvinylidene fluoride incorporated with titanium nanotubes for purifying air with bacterial contamination

Environmental Science and Pollution Research - Polyvinylidene fluoride (PVDF) blended with varying concentrations of titanium nanotubes (TNT) was electrospun to result in a nanocomposite filter...     

Photocatalytic degradation of amoxicillin from aqueous solutions by titanium dioxide nanoparticles loaded on graphene oxide

Environmental Science and Pollution Research - The photocatalytic degradation of amoxicillin (AMX) by titanium dioxide nanoparticles loaded on graphene oxide (GO/TiO2) was evaluated under UV light....     

Electrocatalytic dechlorination of 2,3,5-trichlorophenol on palladium/carbon nanotubes-nafion film/titanium mesh electrode

Environmental Science and Pollution Research - Palladium/carbon nanotubes-nafion film-modified titanium mesh electrode (Pd/CNTs-nafion film/Ti electrode) was prepared and used for catalytic...     

Microfibrous mesh coated with titanium dioxide: a self-sterilizing,self-cleaning filter

The utility of metal microfibrous mesh coated with titanium dioxide as a self-sterilizing, self-cleaning filter for air is explored. The low-cost mesh is produced via a roll-to-roll process similar to paper manufacturing. The titanium dioxide is applied by spraying an aqueous suspension of the photocatalyst on the surface of the mesh using an airbrush. Photocatalytic activity comparable to a powder layer is achieved at one quarter of the mass loading. The coating enhanced the separation of Escherichia coli (E. coli) from aqueous suspension, but also led to an increase in pressure drop in an air stream flowing through the mesh. The self-cleaning property of the coated mesh is established by recovery of pressure drop performance lost due to biofilm buildup. This is accomplished via a photocatalytic regeneration process involving exposing the mesh to ultraviolet light in air. Oxidation is confirmed by monitoring CO2 evolution during the regeneration. Scanning electron photomicrographs also provide visual evidence of successful regeneration via photocatalysis.     

Toxic effect of different types of titanium dioxide nanoparticles on Ceriodaphnia dubia in a freshwater system

Environmental Science and Pollution Research - In the current study, the effect of different types of titanium dioxide (TiO2) nanoparticles (NPs) (rutile, anatase, and mixture) was analyzed on...     

Photocatalytic oxidation of gaseous chlorinated organics over titanium dioxide

The photocatalytic oxidation of high levels of volatile chlorinated organic compounds in gas phase has been studied using a specially designed photoreactor. The influence of light intensity, initial water vapour concentration, temperature, inlet contaminant concentration and flow rate on destruction efficiency has been investigated. The performance of the titanium catalyst was strongly affected by the presence of water in the air stream. Experiments have been most successfully conducted at room temperature, low initial contaminant concentrations, low flow rates and high light intensities. Several by-products have been detected performing photocatalytic degradation of trichloroethylene (TCE) and tetrachloroethylene (PCE). No catalyst deactivation was observed.     

High infrared radiance glass-ceramics obtained from fly ash and titanium slag

A new glass–ceramic was synthesized by crystal growth from a homogenous glass obtained by melting a mixture of fly ash collected from a power plant in Hebei province of China, titanium slag collected from a titanium factory in Sichuan province of China, and MgCO₃ as an additive. According to the measurement results of differential thermal analysis, a thermal treatment of nucleating at 850 °C for 2 h and crystallizing at 985 °C for 1.5 h was used to obtain the crystallized glass. X-ray diffraction and scanning electron microscopy measurements showed that the main crystalline phase of this material was iron-ion substituted cordierite, (Mg,Fe)₂Al₄Si₅O₁₈, which is homogeneously dispersed within the parent glass matrix. The infrared radiance and thermal expansion coefficient of this material have been examined, and the results demonstrate that this glass–ceramic material has potential for application in a wide range of infrared heating and drying materials.     

TiO2晶体的微波水热法制备及光催化性能研究

以TiSO4和尿素为主要原料，EDTA为控制剂，采用微波水热法制备纳米TiO2光催化剂，并分析了纳米TiO2晶粒的最佳形成条件。利用XRD、TEM等技术对制备产物进行表征。结果表明，TiSO4和尿素混合物在微波水热条件下晶化150min后，产物为锐钛矿型TiO2，且产物粒径小、大小均匀。在紫外光照射下，以自制的锐钛矿型纳米TiO2为催化剂，酸性橙为降解目标物，进一步研究了其光催化性能。结果表明，该TiO2在紫外光照射下表现出稳定的光催化活性。     

5-fluorouracil and curcumin with pectin coating as a treatment regimen for titanium dioxide with dimethylhydrazine-induced colon cancer model

Environmental Science and Pollution Research - Colorectal cancer was inducted in Wister rats using titanium dioxide nanoparticles (TiO2NPs) and dimethylhydrazine (DMH) and treatment using...     

Could curcumin ameliorate titanium dioxide nanoparticles effect on the heart? A histopathological,immunohistochemical, and genotoxic study

Environmental Science and Pollution Research - The evaluation of the toxicological effects of titanium dioxide nanoparticles (TiO2NPs) is increasingly important due to their growing occupational...