Comparative cytotoxicity of nanoparticles and ions to Escherichia coli in binary mixtures

The objective of this study was to understand toxicity of mixture of nanoparticles (NPs) (ZnO and TiO₂) and their ions to Escherichia coli. Results indicated the decrease in percentage growth of E. coli with the increase in concentration of NPs both in single and mixture setups. Even a small concentration of 1 mg/L was observed to be significantly toxic to E. coli in binary mixture setup (exposure concentration: 1 mg/L ZnO and 1 mg/L TiO₂; 21.15% decrease in plate count concentration with respect to control). Exposure of E. coli to mixture of NPs at 1000 mg/L (i.e., 1000 mg/L ZnO and 1000 mg/L TiO₂) resulted in 99.63% decrease in plate count concentration with respect to control. Toxic effects of ions to E. coli were found to be lesser than their corresponding NPs. The percentage growth reduction was found to be 36% for binary mixture of zinc and titanium ions at the highest concentration (i.e., 803.0 mg/L Zn and 593.3 mg/L Ti where ion concentrations are equal to the Zn ions present in 1000 mg/L ZnO NP solution and Ti^+ 4 ions present in 1000 mg/L TiO₂ NP solution). Nature of mixture toxicity of the two NPs to E. coli was found to be antagonistic. The alkaline phosphatase (Alp) assay indicated that the maximum damage was observed when E. coli was exposed to 1000 mg/L of mixture of NPs. This study tries to fill the knowledge gap on information of toxicity of mixture of NPs to bacteria which has not been reported earlier.     

Inhibition factors and Kinetic model for ammonium inhibition on the anammox process of the SNAD biofilm

The aim of the present work was to evaluate the anaerobic ammonium oxidation (anammox) activity of simultaneous partial nitrification, anammox and denitrification (SNAD) biofilm with different substrate concentrations and pH values. Kaldnes rings taken from the SNAD biofilm reactor were incubated in batch tests to determine the anammox activity. Haldane model was applied to investigate the ammonium inhibition on anammox process. As for nitrite inhibition, the NH₄⁺-N removal rate of anammox process remained 87.4% of the maximum rate with the NO₂⁻-N concentration of 100 mg/L. Based on the results of Haldane model, no obvious difference in kinetic coefficients was observed under high or low free ammonia (FA) conditions, indicating that ammonium rather than FA was the true inhibitor for anammox process of SNAD biofilm. With the pH value of 7.0, the r_max, Ks and K_I of ammonium were 0.209 kg NO₂⁻-N/kg VSS/day, 9.5 mg/L and 422 mg/L, respectively. The suitable pH ranges for anammox process were 5.0 to 9.0. These results indicate that the SNAD biofilm performs excellent tolerance to adverse conditions.     

Enhanced catalytic complete oxidation of 1,2-dichloroethane over mesoporous transition metal-doped γ-Al2O3

High-surface-area mesoprous powders of γ-Al₂O₃ doped with Cu^2 +, Cr^3 +, and V^3 + ions were prepared via a modified sol–gel method and were investigated as catalysts for the oxidation of chlorinated organic compounds. The composites retained high surface areas and pore volumes comparable with those of undoped γ-Al₂O₃ and the presence of the transition metal ions enhanced their surface acidic properties. The catalytic activity of the prepared catalysts in the oxidation of 1,2-dichloroethane (DCE) was studied in the temperature range of 250–400°C. The catalytic activity and product selectivity were strongly dependent on the presence and the type of dopant ion. While Cu^2 +- and Cr^3 +-containing catalysts showed 100% conversion at 300°C and 350°C, V^3 +-containing catalyst showed considerably lower conversion. Furthermore, while the major products of the reactions over γ-alumina were vinyl chloride (C₂H₃Cl) and hydrogen chloride (HCl) at all temperatures, Cu- and Cr-doped catalysts showed significantly stronger capability for deep oxidation to CO₂.     

Bio-remediation of acephate–Pb(II) compound contaminants by Bacillus subtilis FZUL-33

Removal of Pb~(2+)and biodegradation of organophosphorus have been both widely investigated respectively. However, bio-remediation of both Pb~(2+)and organophosphorus still remains largely unexplored. Bacillus subtilis FZUL-33, which was isolated from the sediment of a lake, possesses the capability for both biomineralization of Pb~(2+)and biodegradation of acephate. In the present study, both Pb~(2+)and acephate were simultaneously removed via biodegradation and biomineralization in aqueous solutions.Batch experiments were conducted to study the influence of p H, interaction time and Pb~(2+)concentration on the process of removal of Pb2+. At the temperature of 25°C, the maximum removal of Pb~(2+)by B. subtilis FZUL-33 was 381.31 ± 11.46 mg/g under the conditions of p H 5.5, initial Pb~(2+)concentration of 1300 mg/L, and contact time of 10 min. Batch experiments were conducted to study the influence of acephate on removal of Pb~(2+)and the influence of Pb2+on biodegradation of acephate by B. subtilis FZUL-33. In the mixed system of acephate–Pb2+, the results show that biodegradation of acephate by B. subtilis FZUL-33 released PO43+, which promotes mineralization of Pb2+. The process of biodegradation of acephate was affected slightly when the concentration of Pb2+was below 100 mg/L. Based on the results, it can be inferred that the B. subtilis FZUL-33 plays a significant role in bio-remediation of organophosphorus-heavy metal compound contamination.     

New insight into adsorption characteristics and mechanisms of the biosorbent from waste activated sludge for heavy metals

The adsorption characteristics and mechanisms of the biosorbent from waste activated sludge were investigated by adsorbing Pb2+and Zn2+in aqueous single-metal solutions. A p H value of the metal solutions at 6.0 was beneficial to the high adsorption quantity of the biosorbent. The optimal mass ratio of the biosorbent to metal ions was found to be 2. A higher adsorption quantity of the biosorbent was achieved by keeping the reaction temperature below 55°C. Response surface methodology was applied to optimize the biosorption processes, and the developed mathematical equations showed high determination coefficients(above 0.99 for both metal ions) and insignificant lack of fit(p = 0.0838 and 0.0782 for Pb2+and Zn2+, respectively). Atomic force microscopy analyses suggested that the metal elements were adsorbed onto the biosorbent surface via electrostatic interaction. X-ray photoelectron spectroscopy analyses indicated the presence of complexation(between –NH2,-CN and metal ions) and ion-exchange(between –COOH and metal ions). The adsorption mechanisms could be the combined action of electrostatic interaction, complexation and ion-exchange between functional groups and metal ions.     

Biodegradation of indole by a newly isolated Cupriavidus sp. SHE

Indole, a typical nitrogen heterocyclic aromatic pollutant, is extensively spread in industrial wastewater. Microbial degradation has been proven to be a feasible approach to remove indole, whereas the microbial resources are fairly limited. A bacterial strain designated as SHE was isolated and found to be an efficient indole degrader. It was identified as Cupriavidus sp. according to 16S rRNA gene analysis. Strain SHE could utilize indole as the sole carbon source and almost completely degrade 100 mg/L of indole within 24 hr. It still harbored relatively high indole degradation capacity within pH 4–9 and temperature 25°C–35°C. Experiments also showed that some heavy metals such as Mn^2 +, Pb^2 + and Co^2 + did not pose severe inhibition on indole degradation. Based on high performance liquid chromatography–mass spectrum analysis, isatin was identified as a minor intermediate during the process of indole biodegradation. A major yellow product with m/z 265.0605 (C₁₅H₈N₂O₃) was generated and accumulated, suggesting a novel indole conversion pathway existed. Genome analysis of strain SHE indicated that there existed a rich set of oxidoreductases, which might be the key reason for the efficient degradation of indole. The robust degradation ability of strain SHE makes it a promising candidate for the treatment of indole containing wastewater.     

Modeling of acute cadmium toxicity in solution to barley root elongation using biotic ligand model theory

Protons（H⁺）as well as different major and trace elements may inhibit cadmium（Cd）uptake in aquatic organisms and thus alleviate Cd toxicity.However,little is known about such interactions in soil organisms.In this study,the independent effects of the cations calcium(Ca²⁺),magnesium(Mg²⁺),potassium（K⁺）,H+and zinc(Zn²⁺)on Cd toxicity were investigated with 5-day long barley root elongation tests in nutrient solutions.The tested concentrations of selected cations and trace metal ions were based on the ranges that occur naturally in soil pore water.The toxicity of Cd decreased with increasing activity of Ca²⁺,Mg²⁺,H⁺and Zn²⁺,but not K⁺.Accordingly,conditional binding constants were obtained for the binding of Cd²⁺,Ca²⁺,Mg²⁺,H⁺,and Zn²⁺ with the binding ligand:log K_CdBL5.19,logK_CaBL2.87,logK_MgBL2.98,logK_HBL5.13 and logK_ZnBL5.42,respectively.Furthermore,it was calculated that on average 29% of the biotic ligand sites needed to be occupied by Cd to induce a 50% decrease in root elongation.Using the estimated constants,a biotic ligand model was successfully developed to predict the Cd toxicity to barley root elongation as a function of solution characteristics.The feasibility and accuracy of its application for predicting Cd toxicity in soils were discussed.     

Cu(II), Fe(III) and Mn(II) combinations as environmental stress factors have distinguishing effects on Enterococcus hirae

Pollution by various heavy metals as environmental stress factors might affect bacteria. It was established that iron (Fe(III)), manganese (Mn(II)) and copper (Cu(II)) ion combinations caused effects on Enterococcus hirae that differed from the sum of the effects when the metals were added separately. It was shown that the Cu^2 +–Fe^3 + combination decreased the growth and ATPase activity of membrane vesicles of wild-type E. hirae ATCC9790 and atpD mutant (with defective F_oF₁-ATPase) MS116. Addition of Mn^2 +–Fe^3 + combinations within the same concentration range had no effects on growth compared to control (without heavy metals). ATPase activity was increased in the presence of Mn^2 +–Fe^3 +, while together with 0.2 mmol/L N,N′-dicyclohexylcarbodiimide (DCCD), ATPase activity was decreased compared to control (when only 0.2 mmol/L DCCD was present). These results indicate that heavy metals ion combinations probably affect the F_OF₁-ATPase, leading to conformational changes. Moreover the action may be direct or be mediated by environment redox potential. The effects observed when Fe^3 + was added separately disappeared in both cases, which might be a result of competing processes between Fe^3 + and other heavy metals. These findings are novel and improve the understanding of heavy metals ions effects on bacteria, and could be applied for regulation of stress response patterns in the environment.     

Fluoride removal by Al, Ti, and Fe hydroxides and coexisting ion effect

Batch experiments were conducted to evaluate fluoride removal by Al,Fe,and Ti-based coagulants and adsorbents,as well as the effects of coexisting ions and formation of aluminum–fluoride complexes on fluoride removal by co-precipitation with alum(Al_2(SO_4)_3·18H_2O).Aluminum sulfate was more efficient than the other coagulants for fluoride removal in the pH range between 6 and 8.Nano-crystalline TiO_2 was more effective for fluoride removal than Al and Fe hydroxides in a pH range of 3–5.Coexisting anions in water decreased the removal of fluoride in the order:phosphate(2.5 mg/L) arsenate(0.1 mg/L) bicarbonate(200 mg/L) sulfate(100 mg/L) = nitrate(100 mg/L) silicate(10 mg/L) at a pH of 6.0.The effect of silicate became more significant at pH 7.0.Calcium and magnesium improved the removal of fluoride.Zeta-potential measurements determined that the adsorption of fluoride shifted the PZC of Al(OH)_3 precipitates from 8.9 to 8.4,indicating the chemical adsorption of fluoride at the surface.The presence of fluoride in solution significantly increased the soluble aluminum concentration at pH 6.5.A Visual MINTEQ modeling study indicated that the increased aluminum solubility was caused by the formation of AlF~(2+),AlF~(+2),and AlF_3complexes.The AlF_x complexes decreased the removal of fluoride during co-precipitation with aluminum sulfate.     

Biodegradation of pendimethalin by Bacillus subtilis Y3

A bacterium strain Y3,capable of efficiently degrading pendimethalin,was isolated from activated sludge and identified as Bacillus subtilis according to its phenotypic features and 16 S rRNA phylogenetic analysis.This strain could grow on pendimethalin as a sole carbon source and degrade 99.5%of 100 mg/L pendimethalin within 2.5 days in batch liquid culture,demonstrating a greater efficiency than any other reported strains.Three metabolic products,6-aminopendimethalin,5-amino-2-methyl-3-nitroso-4-(pentan-3-ylamino) benzoic acid,and 8-amino-2-ethyl-5-(hydroxymethyl)-1,2-dihydroquinoxaline-6-carboxylic acid,were identified by HPLC-MS/MS,and a new microbial degradation pathway was proposed.A nitroreductase catalyzing nitroreduction of pendimethalin to 6-aminopendimethalin was detected in the cell lysate of strain Y3.The cofactor was nicotinamide adenine dinucleotide phosphate(NADPH) or more preferably nicotinamide adenine dinucleotide(NADH).The optimal temperature and pH for the nitroreductase were 30℃ and 7.5,respectively.Hg~(2+),Ni~(2+),Pb~(2+),Co~(2+),Mn~(2+) Cu~(2+),Ag~+,and EDTA severely inhibited the nitroreductase activity,whereas Fe~(2+),Mg~(2+),and Ca~(2+) enhanced it.This study provides an efficient pendimethalin-degrading microorganism and broadens the knowledge of the microbial degradation pathway of pendimethalin.