首页 | 本学科首页   官方微博 | 高级检索  
相似文献
 共查询到10条相似文献,搜索用时 156 毫秒
1.
Physical characteristics and quantitative elemental composition of PM and residual ash produced from sugarcane leaves (SCL) combustion were investigated using TEM-EDS compared with forest leaves (FRL). SEM-EDS was used to analyze the microstructure and chemical composition of biomass raw leaves and PM. XRD analysis was also performed to investigate the characterization of the crystalline nanostructure, structure of PM, and residual ash compared to the TEM image processing method. The oxidation kinetics of biomass raw materials, PM, and residual ash were investigated by TGA. The morphology of fine and ultrafine agglomerate structure of SCL soot and residual ash are not significantly different from the FRL soot and residual ash. The average diameter sizes of single primary nanoparticles of SCL and FRL soot are approximately 37 nm and 35 nm, while the sizes of residual ash are about 18 nm and 22 nm, respectively. The single primary nanoparticles of soot are mainly composed of curve line crystallites of carbon fringes, while residual ash is composed of straight-line lattice fringes. The average fringe lengths of SCL and FRL soot are about 1.25 nm and 1.04 nm from the outer shell and 0.89 nm and 0.74 nm from the inner core. The interlayer spacing of curve line carbon fringes of SCL and FRL soot is approximately 0.359 nm and 0.362 nm by the TEM image analysis and it was matched with XRD analysis. The biomass PMs are mainly composed of soot, Si, Ca, and K compounds: SiO2, CaCO3, and KCl.  相似文献   

2.
Aiming to investigate the impacts of n-octanol addition on the oxidation reactivity, morphology and graphitization of diesel exhaust particles, soot samples were collected from a four-cylinder turbocharged diesel engine fueled with D100(neat diesel fuel), DO15(85% diesel and 15% n-octanol, V/V) and DO30(70% diesel and 30% n-octanol, V/V). All tests were conducted at two engine speeds of 1370 and 2150 r/min under a fixed torque of 125 N ·m. The soot properties were characterized by thermogravimet...  相似文献   

3.
为降低柴油机颗粒物排放,探讨了柴油机燃用柴油/碳酸二甲酯混合燃料燃烧颗粒微观结构和分形特征的变化规律. 采用扫描电镜、透射电镜和SAXS(同步辐射小角X射线散射)相结合的方法,针对DMC(碳酸二甲酯)添加量(以w计)对柴油机燃烧颗粒微观结构和分形特征参数的影响规律进行了研究. 结果表明:与柴油燃烧颗粒相比,D10〔w(DMC)为10%〕、D20〔w(DMC)为10%〕燃烧颗粒的碳粒子平均层面间距分别增加了5.3%、15.1%,弯曲度平均值分别增加了4.0%和10.3%,表明燃烧颗粒的氧化活性增加;与柴油相比,D10、D20燃烧颗粒的质量分形维数分别增加了0.44和0.52,下限均升高了0.2,SAXS与电镜图像对燃烧颗粒的质量分形维数的分析结果相一致,即质量分形维数随DMC添加量的增加而升高,表明燃烧颗粒的团聚程度提高;与柴油燃烧颗粒相比,D10、D20燃烧颗粒表面分形维数的下限分别升高了0.1和0.2,表明其燃烧颗粒表面的粗糙程度和不规则程度提高;与柴油燃烧颗粒相比,D10、D20燃烧颗粒的活化能分别降低了3.9和7.9 kJ/mol,表明燃烧颗粒的氧化活性随着DMC添加量的增加而增强,验证了燃烧颗粒微观尺寸结构和分形特征的研究结果. 研究显示,柴油中添加DMC能够提高燃烧颗粒的氧化活性,燃烧颗粒的氧化活性越强,其在后处理过程中就越易被氧化,有助于降低柴油机的颗粒物排放.   相似文献   

4.
发动机燃料组分生烟特性的研究   总被引:3,自引:0,他引:3  
本文采用火焰高度测定仪系统地评价了构成发动机燃料的单体烃和单体醇的生烟特性,提出并应用碳烟生成的烃正离子概念解释了单体烃和单体醇的生烟规律,为正确调整发动机燃料构成提供了实践基础,也为研究和开发消烟助燃剂奠定了理论基础。  相似文献   

5.
为了解四川盆地大气中单颗粒气溶胶理化特征,分别在该区域典型城市(成都市)和背景地区(峨眉山)进行了大气单颗粒样品采集.基于带能谱的透射电子显微镜(TEM-EDS)对两地累计3923个单颗粒的化学组成、形貌特征及混合状态等进行了全面观测和分析,并对两地颗粒物差异性进行了对比分析.结果发现:两地气溶胶颗粒主要包括有机物、富硫、矿物、烟尘和飞灰/金属颗粒,除了以单独的外混形式存在外,大多数颗粒以两种及两种以上颗粒类型混合(即内混)形式存在.通过对成都市不同污染状况下单颗粒特征对比发现,"污染天"的内混颗粒占比高于"清洁天",分别为74.2%和68.6%;相比"清洁天","污染天"颗粒物粒径分布范围更广且峰值区间更大,表明污染过程中颗粒物的大气混合趋于更强.对比成都市与峨眉山分析结果得知,成都市以内混的有机物-硫颗粒为主导(占比为50.2%),而峨眉山以外混的有机物颗粒为主导(占比为50.5%);成都市含硫类颗粒物(如有机物-硫颗粒)贡献高于峨眉山,而峨眉山两种含碳类颗粒(如烟尘和有机物-烟尘颗粒)占比高于成都市;此外,成都市与峨眉山两地大气颗粒物粒径分布范围及峰值区间均存在一定差异,进一步体现了两地颗粒物来源和老化混合的差异.在峨眉山,与非降雨天相比,一些易溶于水的颗粒物(如含硫类颗粒)在降雨天占比明显降低,而源自当地燃烧过程、粒径较小且疏水性强的颗粒物(如烟尘和有机物-烟尘颗粒)占比相应升高.  相似文献   

6.
复合氧化物催化材料上碳颗粒物的催化燃烧   总被引:3,自引:1,他引:3  
针对柴油车排放碳颗粒物的控制 ,研制可应用于柴油车排放碳颗粒物催化再生复合氧化物催化材料 .通过运用热分析仪 (TGA)和程序升温氧化反应装置 (TPO)对复合氧化物催化材料的活性进行评价 ,研究了催化材料的组成、原子配比、催化材料与碳颗粒物质量比、H2O的加入、焙烧温度对催化活性的影响 .实验结果表明 :双组分金属氧化物催化剂中 ,Cu-Mo-O有较好的活性 ;多组分金属氧化物催化剂中 ,Cu-K-Mo-O在原子比Cu∶K∶Mo =1∶1∶2 ,催化剂与碳颗粒物质量比为 5∶1时活性最好 ,其碳颗粒物起燃温度为 32.7℃ ,同时H2O和焙烧温度对该催化剂的影响较小 ,是能够应用于柴油车排放碳颗粒物控制催化再生的良好催化材料 .  相似文献   

7.
Fine particles associated with haze pollution threaten the health of over 400 million people in China. Owing to excellent non-destructive fingerprint recognition characteristics, Raman and surface-enhanced Raman scattering (SERS) are often used to analyze the composition of fine particles to determine their physical and chemical properties as well as reaction mechanisms. However, there is no comprehensive Raman spectral library of fine particles. Furthermore, various studies that used SERS for fine-particle composition analysis showed that the uniqueness of the SERS substrates and different excitation wavelengths can produce a different spectrum for the same fine-particle component. To overcome this limitation, we conducted SERS experiments with a portable Raman spectrometer using two common SERS substrates (silver (Ag) foil and gold nanoparticles (Au NPs)) and a 785 nm laser. Herein, we introduced three main particle component types (sulfate-nitrate-ammonium (SNA), organic material, and soot) with a total of 39 chemical substances. We scanned the solid Raman, liquid Raman, and SERS spectra of these substances and constructed a fine-particle reference library containing 105 spectra. Spectral results indicated that for soot and SNA, the differences in characteristic peaks mainly originated from the solid-liquid phase transition; Ag foil had little effect on this difference, while the Au NPs caused a significant red shift in the peak positions of polycyclic aromatic hydrocarbons. Moreover, with various characteristic peak positions in the three types of spectra, we could quickly and correctly distinguish substances. We hope that this spectral library will aid in the future identification of fine particles.  相似文献   

8.
澳门夏季大气颗粒物单颗粒微观形貌分析   总被引:7,自引:0,他引:7       下载免费PDF全文
应用高分辨率场发射扫描电镜(FESEM)和图像分析技术,研究了澳门地区夏季(2007年7月)大气可吸入颗粒物的形貌特征以及不同种类颗粒物的数量-粒度和等效体积-粒度分布.结果表明,澳门可吸入颗粒物中,烟尘集合体和矿物颗粒普遍存在;矿物颗粒为不规则状,烟尘集合体有链状、蓬松状等形态;烟尘集合体在数量上平均分别约占30%~40%,矿物颗粒在数量上平均分别约占20%,烟尘集合体颗粒较多说明澳门夏季受机动车尾气影响较重.澳门大气PM10的等效粒径主要分布在0.2~0.4 μm范围内,主要为较细粒子.颗粒物种类有明显的地点差异,交通繁忙的高士德马路路口以烟尘集合体居多(平均47%),且其粒径在较宽范围内都有分布(0.1~0.8 μm);隧道内亦以烟尘集合体的比例较大,可高达59%;货运码头采样点以矿物颗粒较多.  相似文献   

9.
Pt/Al2O3 catalysts with mean Pt particle size ranged from 2.7 to 7.1 nm were synthesized by chemical reduction method, and the sulfated counterparts were prepared by impregnation of sulfuric acid. The turnover frequency of platinum for soot oxidation under loose contact conditions in a feed flow containing NO and O2 are positively correlated with the size of platinum. The sulfated Pt/Al2O3 exhibits higher catalytic activity for soot oxidation in the presence of NO despite their reduced ability for NO2 production. Such a contradiction is more significant for those catalysts with smaller platinum particles. Herein, the catalysts were characterized by X-ray diffraction (XRD), Brunauer-Emmett-Teller (BET), transmission electron microscopy (TEM), inductive coupled plasma (ICP) emission spectrometry, CO chemisorption, thermogravimetric analysis (TGA), NH3 temperature-programmed desorption (NH3-TPD), NO temperature-programmed oxidation (TPO) and NOx temperature-programmed desorption (TPD). Possible effect of Pt particle size for the catalytic oxidation of soot in the presence of NO was presented based primarily on the promoted NO2 transfer efficiency onto the soot pushed by the acidic catalysts.  相似文献   

10.
利用水热方法,无需模板一步合成3D介孔TiO2光催化剂.然后采用X射线衍射(XRD)、透射电子显微镜(TEM)、高分辨电子显微镜(HRTEM)和N2吸附-解吸BET技术对其组织结构进行表征,以双酚A为目标物对比介孔TiO2光催化剂和市售P25的光催化性能,并研究了不同温度下TiO2的相变及热重分析(TGA).结果表明,...  相似文献   

设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号