The influence of sewage sludge properties on sludge-borne metal availability

With the advent of more stringent controls on wastewater treatment, sewage sludge production in Europe and many parts of the world is increasing. With this increase comes the problem of sludge disposal, and recycling to land arguably offers an economically and environmentally sustainable option. However, a major limitation of sewage sludge reuse is the potential release of heavy metals from the sludge and heavy metal accumulation to toxic levels in topsoils. The properties of the sludge play a crucial role in determining the initial release and subsequent availability of heavy metals in amended soils. Bioavailable forms of heavy metals in recently amended soils are most likely to be those that are bioavailable in the sewage sludge. In this paper, published research on the importance of sewage sludge characteristics on metal release and bioavailability will be reviewed and contrasted with original research. A selection of sludges from around Australia has been collected for this purpose. Through the use of incubation studies, isotope dilution techniques, ion-selective electrode measurements and ¹³C-NMR spectroscopy, the importance of a range of sludge properties on heavy metal behaviour in sludges and sludge-amended soils is addressed.     

厌氧升流式污泥层反应器内污泥颗粒化对固液分离效果的影响

厌氧升流式污泥层反应器在较高的COD容积负荷和水力负荷下稳定运行的关键是要有良好的固液分离,而固液分离的必要条件是污泥的沉降速度大于混合液在三相分离器的沉降区的最小断面上的向上流速。通过小型装置的试验表明,污泥的沉降速度与污泥的性状和浓度有关,使反应器内的污泥颗粒化能改善污泥沉降性、提高固液分离效果,使反应器能在相当高的COD容积负荷(20—30kgCOD/m~3·d)和水力负荷(0.8m~3/m~2·h)下稳定运行。本文叙述了厌氧升流式污泥层反应器内的污泥颗粒化过程,并简要地讨论了培养颗粒污泥的基本条件。     

活性污泥生长的控制

在污水处理过程中，针对不同的运行环境，我们选择适当的运行工艺和参数。通过控制菌胶团细菌和丝状菌平衡生长，或者是使固着型原生动物占优势，来获得良好的活性污泥，保证出水达标排放。     

转炉污泥干法脱硫新技术应用

采用转炉污泥取代铸铁屑配制焦炉煤气脱硫剂,转炉污泥与稻壳体积配比为1∶2,水分30%～40%,pH值8～10。经过生产实践证明,脱硫效率达到996%～998%。既降低了煤气生产成本,减轻工人劳动强度,又提高了民用煤气质量,具有可观的环境效益与经济效益。     

二沉池漂泥原因及控制措施

二级污水处理厂二沉池漂泥有反硝化漂泥、活性污泥老化漂泥、生物泡沫导致的漂泥。最终的解决办法是：分析漂泥原因、对症下药、改善工艺运行状况、采取有效的控制措施.     

加压活性炭生物膜法处理DSD有机废水

采用加压活性炭生物膜法处理以对硝基甲苯磺酸盐为主的难降解的有机废水的研究,是在活性炭生物膜法处理有机废水基础上发展起来的新技术。本实验结果表明,在加压9.8×10~4Pa(1kgt/cm~2)的条件下,COD_(Cr)去除率为62％～70％,比常压活性炭生物膜法高20％～25％;其容积负荷Nv=1.7～2.9kgCOD/m~3·d,比一般活性污泥法高3～6倍。     

Possible Utilization of Silica Gel Sludge for the Removal of Phenol from Aqueous Solutions: Laboratory Studies

This paper discusses the adsorption capacity of silica gel sludge for phenol removal from aqueous solution. Kinetic experiments showed that phenol adsorption was completed after 2 h. Adsorption isotherms were measured for phenol from aqueous solution onto silica gel sludge under various pHs and temperatures. Results showed that the adsorption capacities for phenol was increased as pH decreased from 6.5 to 2. Temperature also was found to affect the adsorption isotherm. As temperature increases from 30 to 50°C, the adsorption capacity increases. The adsorption equilibrium of phenol on silica gel sludge was described by the linear Freundlich and Langmuir models. Furthermore, results showed that the isotherm parameters fit both linearized Langmuir and Freundlich adsorption isotherms. The Freundlich and Langmuir parameters at optimum pH was found as K _f=2.89, 1/n=0.23 and K _d=22.0, q _m=7.98, respectively. Whereas, for those at optimum temperature it was observed as K _f=2.87, 1/n=0.16 and K _d=20.93, q _m=7.91, respectively.     

炼油厂"三泥"离心脱水处理研究

通过对目前炼油厂“三泥”性状的调查，利用已有污泥处理设施进行了炼油厂“三泥”离心分离的现场试验，并分析了影响“三泥”离心分离处理工艺的主要因素，发现了离心机转速和絮凝剂投加量对“三泥”离心分离的有关规律和最佳操作条件，在此基础上，提出了适合炼油厂“三泥”处理系统的优化方案。     

活性污泥吸附重金属Cr6+的研究

以活性污泥为材料，采用不同时间、温度、pH进行吸附重金属Cr^6 的研究。实验结果表明，当吸附时间为15min，吸附温度为28℃，吸附pH=7时具有较好吸附效果。在此条件下，当重金属Cr^6 浓度为50mg/L，其吸附率可达97．2％。     

混合接种PN与PN/A颗粒污泥快速启动连续流自养生物脱氮反应器

在连续流条件下,快速培养亚硝化-厌氧氨氧化（PN/A）颗粒污泥是实现污水高效生物脱氮处理的关键技术. 与PN/A污泥相比,亚硝化（PN）颗粒污泥具有生长周期短、易于批量化培养的优点,并可作为富集厌氧氨氧化菌（AMX）的载体. 在3个完全混合流反应器（R1~R3）中,分别按照质量比3∶1、1∶1和1∶3混合接种PN/A和PN颗粒污泥,并通过设置高氨氮负荷、短水力停留时间和强水力剪切条件,成功启动了连续流自养生物脱氮工艺. 结果表明,尽管R3的启动时长较R1和R2更长,但污泥接种比并未显著影响连续流反应器在稳定状态下的脱氮性能,总氮去除负荷均可达到2.6 kg·（m³·d）^-1以上. 接种的PN颗粒污泥通过提供好氧氨氧化菌种（AOB）,为AMX生长供给了充足的亚硝态氮基质,充分发挥了培养PN/A颗粒污泥的前驱体作用. 由高通量测序结果可知,R1~R3中成熟颗粒的微生物丰度和多样性指数均明显高于接种污泥. AOB（Nitrosomonas属）和AMX（Candidatus Kuenenia和Brocadia属）与Chloroflexi、Bacteroidetes和Chlorobi等异养菌门是驱动自养生物脱氮和维持颗粒结构稳定的关键菌群. 总之,PN与PN/A颗粒污泥的混合接种是快速启动连续流自养脱氮工艺的可行策略,对工程应用具有指导意义.