陶瓷废水处理原理及常用固液分离方法比较

本文就陶瓷废水的产生来源及废水处理原理进行了分析，对佛山市该行业废水处理常用的固液分离方式进行了处理效果及技术经济比较，指出将常用于给水处理工艺的水力循环澄清池应用在陶瓷废水处理工艺中，与其它分离方法相比，不仅占地面积小，效率高，而且易于操作和控制，可实现废水的全部回用，并建议对这种高悬浮物、高浊度水的混凝反应过程进行自动控制以提高水处理的稳定性。     

基于废陶瓷的多孔陶瓷研制及其对Ni2+的吸附性能

通过SEM、XRD、FT-IR表征及多孔陶瓷对废水中镍的去除能力,确定多孔陶瓷的制备条件:原料中田菁粉掺杂质量分数为4%,焙烧温度为800℃.SEM和孔结构表征说明,焙烧使多孔陶瓷形貌、结构发生变化;随着焙烧温度的升高,多孔陶瓷的比表面积和孔容呈现降低的趋势,而孔径呈现增大的趋势;EDS分析能表明,原废瓷粉和多孔陶瓷的主要元素组成均为Si、Al、O.SEM、XRD和FT-IR分析表明,多孔陶瓷吸附前后结构稳定.吸附Ni2+的系列实验表明,多孔陶瓷用量为10 g·L-1,吸附时间为60 min,进水pH值为6.32,进水Ni2+浓度在100 mg.L-1以内.在此条件下废水的Ni2+去除率可达89.7%,多孔陶瓷对废水中镍有较好的去除效果.以制备的多孔陶瓷处理含镍废水,考察多孔陶瓷对废水中Ni2+的吸附动力学和吸附等温线,结果表明,多孔陶瓷对Ni2+的吸附过程符合准二阶动力学模型(R2=0.999 9),Qe为9.09 mg·g-1;吸附过程可用Freundlich方程和Langmuir方程来描述,温度由20℃升高至40℃,最大吸附量Qm由14.49 mg·g-1上升至15.38 mg·g-1.     

Potential concerns related to using octadecyltrichlorosilane (OTS) in rendering soils and porous ceramics hydrophobic

The treatment of hydrophilic porous ceramics to render them hydrophobic and wetting to non-aqueous phase liquids (NAPLs) is frequently needed in multiphase flow experiments to control the flow or to measure the pressure of the NAPL. In addition, research dealing with soil wettability implies a need for hydrophobic or NAPL-wet soils. The traditional procedure, which has been widely used in literature, to render hydrophilic porous ceramics and soils hydrophobic is achieved by placing the hydrophilic solid in a 5% (by volume) octadecyltrichlorosilane (OTS) solution in ethanol followed by rinsing in ethanol. This research assesses the use of this procedure as it was found that this treatment procedure resulted in excess OTS on the surface of treated hydrophobic solids which can dissolve in an organic phase and in turn alter the wettability condition of adjacent hydrophilic soils. A modified procedure, which results in hydrophobic solids free of excess OTS, is presented.     

Coupling effects of foam ceramics on the flame and shock wave of gas explosion

The coupling of gas explosion flame and shock wave is analyzed. In the gas explosion process, shock wave is affected by the flame directly, and shock wave also induces the flame. Inhibiting explosion can be achieved by the interference between the flame and shock wave propagation. If the coupling effects can be damaged, the adverse effects caused by the explosion should be mitigated and controlled. According to the structure characteristics of foam ceramics, the coupling effects mechanism of ceramic foam on gas explosion flame and shock wave is researched. When the explosion goes through the structure of foam ceramics, the flame can be quenched and the shock wave be attenuated. After the flame is quenched, the supply of precursor shock wave energy is cut off. Due to lack of energy supply, the destructive effects of blast wave will be reduced effectively. Coupling effects of the flame and shock wave can be damaged by the special structure of foam ceramics. Studies suggest that a certain function to represent the structure characteristics of foam ceramics must exist. For a certain material of foam ceramics, the sure porosity δ and the pore diameter d also can be get, which is the key to research and develop foam ceramic suppression technology of gas explosion.     

建筑陶瓷行业SO2污染物评价及总量控制实用方法

采用高斯点源模型对建陶生产造成的SO2地面浓度增量进行计算.利用比例下降模型计算建陶业的SO2允许排放总量,并根据企业的设备生产能力进行了总量分配,在方法上具有较强的可操作性,计算结果表明,可有效降低所在地区的SO2地面浓度.     

曝气生物滤池工艺处理废旧物加工小区废水

曝气生物滤池(BAF)是近年来国外发展起来的一项废水好氧生物处理的新工艺.根据该工程废水水质,采用曝气生物滤池工艺处理丰城废旧物收购加工区的废水,经过一段时间的运行,取得了良好的效果,系统出水达到<污水综合排放标准>(GB8978-1 996)一级排放标准,整个废水处理工程具有处理能力强、处理效果好、启动快、受气温影响小、耐冲击负荷、不需二沉池、工艺流程简单和菌群简单等优点,说明该工艺在我国具有广阔的应用前景.     

导电泡沫陶瓷过滤柴油机排气微粒的研究

柴油机排气微粒对环境危害严重,研究开发排气过滤技术是解决问题的有效措施之一.利用表面密集排列短纤维的导电泡沫陶瓷作为微粒过滤器的滤芯,对柴油机排气微粒的过滤效率可达90%,并可进行原位通电加热再生,再生后过滤效率不下降.同时,对表面纤维化导电泡沫陶瓷的过滤机理进行了初步探讨.     

废陶瓷的表面改性及其吸附性能

以十八烷基三甲氧基硅烷为改性剂,对废陶瓷进行表面改性,使改性后的废陶瓷粒具有疏水性表而.考察了改性废陶瓷粒对工业废水的有机物去除作用以及对染料废水的脱色作用.实验结果表明,在改性废陶瓷粒径为1 -4 mm、改性废陶瓷加入量为500 g/L、吸附时间为30 min的条件下,造纸废水的COD去除率可达42％,亚甲基蓝溶液的...     

陶瓷负载Ag、Ce共掺杂TiO2光催化剂降解甲基橙的研究

以陶瓷为载体,采用溶胶-凝胶法制备了银离子和铈离子共掺杂TiO2的负载型光催化剂——T-AC/陶瓷,研究了pH值、双氧水用量、催化剂用量、紫外灯强度、废水的初始浓度等因素对T-AC/陶瓷光催化剂降解甲基橙染料废水的影响。结果表明,当pH为2、双氧水用量为0.5 mL/100 mL、催化剂用量为3 g/L、紫外灯功率为20 W、废水初始浓度为10mg/L时,甲基橙的降解率可达85.9%,并且甲基橙的光催化降解属于一级动力学方程,T-AC/陶瓷催化剂有较高的活性和稳定性,在废水处理中具有较好的应用前景。     

曝气生物滤池处理农村污水的中试研究

采用研制的曝气生物滤池对农村污水进行处理，研究其性能特点和影响因素。结果表明：在气水比为5∶1，水力停留时间（HRT）为15 h，进水COD浓度在250 mg/L以下时，COD和氨氮的去除率分别在80％和90％以上，出水COD和氨氮值达到国家《城镇污水处理厂污染物排放标准》一级A标准；反应器在冬季水温12℃以上运行时出水COD和氨氮值比在夏季运行时有所上升，但去除率仍在80%和90%以上，可以达到排放标准。