风向变化对城市大气污染的影响及试验分析

针对城市大气污染的复杂多变状况，在理论分析的基础上，通过风洞实验对城市大气污染扩散模型进行了模拟试验研究，建立了适合一定条件下城市大气污染物扩散的数学和物理模型，并对城市大气污染状况的影响因素进行了分析，在得到特定条件下城市大气污染扩散普遍规律的同时，重点讨论了风向变化对城市大气污染的影响，该方法同时还可以应用于城市大气污染物扩散浓度的估算。     

Starch- polyvinyl alcohol crosslinked film— performance and biodegradation

Starch-PVOH cast films were prepared with and without crosslinking agent (hexamethoxymethylmelamine) in the absence of plasticizer. Moisture absorption in films without crosslinking agent at a low relative humidity was similar to that of PVOH and increased as the relative humidity increased. Films with crosslinking agent showed moisture absorption linearly proportional to the relative humidity. Significant improvement in resistance to water disintegration for crosslinked starch-PVOH films was observed. While the tensile strength decreased with increased relative humidity, crosslinking significantly improved the tensile strength. Increased PVOH content improved elongation of films even when the relative humidity was 80% or higher. Biodegradation studies revealed that the degradation rate was negatively correlated with the PVOH content in films and crosslinking generated more converged degradation curves. Names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product, and the use of the name by USDA implies no approval of the product to the exclusion of others that may also be suitable.     

大气环境影响评价工作分级要求要点

根据大气环境影响评价工作的分级要求,提出了针对性的工作要点,以满足大气环境评价工作的需要.     

液固比对含重金属水泥熟料制品中重金属释放的影响

通过模拟煅烧试验制取水泥熟料,参照JGJ 55-2000（《普通混凝土配比设计规程》）制取混凝土样品,参考SR003.1和NEN 7375浸出试验,分别研究液固比对粒状及块状混凝土样品中重金属（Cr、Ni和As）释放的影响。结果表明,在不同液固比条件下粒状混凝土中的重金属浸出浓度为Cr>Ni>As,Cr、As浸出浓度基本保持不变,分别为2 500 μg/L左右和5～6 μg/L,Ni在液固比（L∶S）<6时,浸出浓度随着液固比的增加而降低,在L∶S>6时,浸出浓度较稳定,为35.7～41.5 μg/L;浸出量均随着液固比的增加而增大。液固比（L∶S）<10时,块状混凝土中重金属累积释放量及扩散系数均随液固比的增加而增大,当L∶S>10时两者基本保持不变。     

农药对农田蜘蛛生态效应的研究进展

农药对农田蜘蛛的生态效应是进行农田害虫综合防治的生态学基础.本文综述了农田蜘蛛接触和吸收农药的主要途径、农药对蜘蛛的生态效应、蜘蛛对农药的抗性以及农药对蜘蛛的致死效应等研究现状.关于农药对农田蜘蛛亚致死效应的研究,特别是分子、生化、生理、行为等方面的异常,国内外报道不多,因此这方面的研究工作有待于进一步加强.参47     

中空纤维微滤膜污染及阻力分析

选用0．1μm的PVDF中空纤维内压式微滤膜组件，在死端微滤工况下，研究了酵母（平均粒径5．3μm）和高岭土（平均粒径0．7μm）体系在浓度和压力变化时的污染机理及过滤阻力、膜渗透通量的变化规律性。通过恒压堵塞定律积分式的具体形式与实验数据的拟合及根据堵塞过滤定律计算的结果都表明：死端微滤时，酵母体系和高岭土体系均符合滤饼过滤机理。     

不锈钢板式热沉传热特性的实验与模拟研究

目的 研究流量、胀高及焊点排布方式对不锈钢板式热沉传热特性的影响。方法 搭建实验平台,加工出结构参数不同的板式热沉实验件,同时采用静力隐式算法建立相应的几何模型,通过实验与数值模拟相结合的方法,研究流量、胀高和焊点排布方式的变化对板式热沉热阻的影响规律,并分析热沉流道内部流场状态。结果 首先计算了6个工况下的热阻,发现实际换热量为540 W时,数值模拟与实验结果的最大相对误差不大于25%。然后分析了误差来源,最后得到了热沉全流道速度场与温度场的分布情况。结论 实验与模拟结果有较好的符合程度,证明了数值模拟方法的可靠性。在换热量相同时,板式热沉的热阻随流量与胀高的增大而减小,焊点为菱形排布的热沉传热性能相对更好。板式热沉内部的流场具有周期性,焊点使流体扰动增强,并形成射流和旋涡,起到了强化传热的效果。     

过电位抛光增材制造双极板流道结构及性能研究

目的 研究过电位抛光对不锈钢异形截面微流道内壁成形性及双极板性能的影响。方法 采用电化学实验、扫描电子显微镜（SEM）、粗糙度测试分别对激光粉末床熔融技术成形异形截面微流道进行测试分析,研究抛光时间对微流道内壁表面形貌、典型缺陷、表面粗糙度及双极板耐腐蚀性的影响。结果 在抛光前10 min,微流道内壁的质量得到有效提升,随着抛光时间的延长,其表面粗糙度达到稳定值,同时典型缺陷也由黏粉、半熔金属颗粒等局部缺陷逐渐变化到球化、挂渣、阶梯效应等大范围缺陷,直至出现点蚀现象。抛光时间在5～15 min内,LPBF成形316L不锈钢表面质量提升,随着抛光时间的增加,其耐腐蚀性下降。结论 采用过电位抛光工艺并选择适当的过电位抛光时间,能有效提升微流道内壁成形质量及双极板耐腐蚀性能。     

基于BP神经网络的矿车运行时矿井摩擦阻力的预测*

为了快速有效地确定矿车等运输设备在巷道内运行时矿井摩擦阻力的变化情况,克服模拟软件计算量和现场实测工作量大的问题,以巷道风流速度、矿车运行速度、阻塞比、矿车长度4个矿车运行时巷道摩擦阻力的影响因素作为切入点,采用动网格技术模拟得到矿车在巷道内运行时有关矿井摩擦阻力的数据,以此为样本构建基于BP神经网络的矿井摩擦阻力预测模型,运用MATLAB软件进行网络训练,并将BP神经网络预测值与FLUENT模拟值进行对比。研究结果表明:BP神经网络结构比较简单,能以较快速度收敛,预测值与模拟值最大误差在7%以内,该神经网络模型用于求解矿车等运输设备在巷道内运行时摩擦阻力的变化情况是可行的。     

Impact of leakage location and downwind storage tank on the gas dispersion in a typical chemical tank storage area

Toxic gas leakage in a tank area can have catastrophic consequences. Storage tank leakage location (particularly for high leakage) and downwind storage tanks potentially influence gas diffusion in tank areas. In this study, we developed a numerical and experimental method to investigate the impact of a high leakage location and downwind storage tank on gas diffusion based on three (1.05H, 0.90H, and 0.77H, H was the tank height, 22m) leakage field experiments on the leeward side of storage tank, which have been not conducted before. The experiments revealed an unexpected phenomenon: the maximum ground concentration first decreased and then increased with increasing leakage height. The simulations illustrated that the differences in micrometeorological conditions caused the maximum ground concentration of gas emitted from the roof to be higher than that emitted from the tank wall near the storage tank height. The downwind storage tank 1) had little influence on the entire diffusion direction but altered the local diffusion pattern; 2) reduced the maximum ground concentration (∼18.7%) and the distance from the emission source (approximately a storage tank diameter); and 3) had strong influences on the concentration, velocity, turbulence, and pressure on the leeward side. The concentration negatively correlated with the velocity, pressure, and turbulence in the middle of the two storage tanks on wind centerline. Our results can improve understanding of gas dispersion in tank areas and provide references for mitigating loss and protecting lives during emergency response processes.