可张孔曝气器曝气能耗试验研究

通过试验研究，总结出可张孔曝气阻力损失的影响因素，以优化产品的结构设计参数，降低产品在工程应用中的能耗，获取更好的经济效益。     

Determination of organophosphorus pesticides and related compounds in water samples by membrane extraction and gas chromatography

A membrane extraction-gas chromatography method was developed fordetermination of organophosphorus pesticides and related compounds including methamidophos, DDVP, dimethoate, methyl parathion, parathion, thiophosphoric acid trimethyl ester, and thiophosphoramidic acid dimethyl ester in water samples. In thismethod, surface-modified acetic cellulose membranes were used to extract the target analytes in water samples, the extracted analytes were back-extracted into a small amount of methanol, andgas chromatography with pulsed flame photometric detector (GC-PFPD) was used to determine the concentrations of targetanalytes in the extracts. The recoveries obtained for thetarget analytes spiked into the water samples ranged from 66to 94%. The method detection limit for each target analyte was 0.05 g L^-1. The method developed in this study had shown the advantages of being cheap, simple, fast, and reliable. It had been used successfully to determine the concentrations of target analytes in river water samples.     

BOD微生物膜的再利用研究初探

对失去大部分活性的微生物膜进行再培养,以研究膜再利用的可能性。试验结果初部表明:在1/2MS培养基中加入一定量的植物激素,不仅可以使膜的电位值(I0)显著升高,且活性强,稳定性好,可使膜重复利用。     

均质滤料过滤截污模型研究

对均质滤料过滤进行了分析，采用毛细管模型研究过滤水流，给出毛细管中剪切应力的分布，通过毛细管中颗粒物的受力分析，求得颗粒与毛细管壁间的物理化学作用力。对颗粒在毛细管在毛细管中运动的受力平衡进行分析简化，得到了截污饮和时滤床中孔隙率的计算公式，由此可以计算出均质滤床的最大截污能力，即：清洁滤床的孔隙率与孢和孔隙率之差乘以滤床的体积。     

生物质气化洗焦废水的预处理和微生物降解

为了对生物质气化洗焦废水进行深度处理,达到废水排放标准,采用物理过滤和微生物降解相结合的方法,对洗焦废水的原液进行处理。实验结果表明,用木屑、颗粒活性碳、微生物降解的连续步骤处理生物质气化洗焦废水,可达到理想的生物质气化洗焦废水COD的去除效果。     

H酸综合废水治理工艺试验研究及工程应用

针对H酸母液及T酸一次洗水高含盐量有机废水进行系统的实验研究，结果表明：废水经冷却、结晶、过滤后，用铁屑过滤，石灰乳、PAM处理．使废水COD去除率为50％，脱色率为7O％，BOD／CODcr提高到0．2以上，预期COD去除率达60％以上，BOD去除率达85％以上，NH3—N去除率达80％以上．     

轴承生产废水处理工艺的选择与实践

采用絮凝气浮 过滤工艺处理轴承生产废水。工程实践表明,该工艺处理效果稳定、耐冲击负荷、工艺组合合理。预处理后的废水经气浮 过滤工艺处理后,COD、SS、油的去除率分别为80.62%～84.31%、81.00%～84.39%、89.37%～96.45%,出水完全能达到排放标准。     

Membrane fouling control by ultrasound in an anaerobic membrane bioreactor

In this study, ultrasound was used to control the membrane fouling online in an anaerobic membrane bioreactor (AMBR). Short-term running experiments were carried out under different operating conditions to explore feasible ultrasonic parameters. The experimental results indicated that when the crossflow velocity was more than 1.0 m/s, membrane fouling could be controlled effectively only by hydrodynamic methods without ultrasound. When ultrasound was applied, an ultrasonic power range of 60–150 W was suitable for the membrane fouling control in the experimental system. The experimental results showed that the membrane fouling was controlled so well that membrane filtration resistance (ΣR) could stay at 5 × 10¹¹ m⁻¹ for more than a week with the crossflow velocity of 0.75 m/s, which equaled the effect of crossflow velocity of more than 1.0 m/s without ultrasound. Translated from Techniques and Equipment for Environmental Pollution Control, 2006, 7(4): 25–29 [译自: 环境污染治理技术与设备]     

A／O-化学除磷工艺中DMBR动态膜成膜条件研究

根据动态膜原理，将0．1mm孔径无纺布为膜材的动态膜反应器（Dynamic Membrane BioReactor，DMBR）应用于A／O-化学除磷工艺之中，在动态膜反应器内完成泥水分离。试验测试了曝气强度、初始膜通量和污泥浓度对动态膜成膜的影响。结果表明，曝气强度和初始膜通量是影响成膜的关键性参数。当曝气强度≥60m^3／m^2·h或初始膜通量≥70L／m^2·h，2h内均不能形成截留性能良好的动态膜。在VSS／SS较低的污泥系统中，适宜的成膜条件为：曝气强度≤40m^3／m^2·h；初始膜通量≤40L/m^2·h。     

生物膜反应器处理洗涤污水的试验

介绍了采用生物膜反应器处理洗涤污水的试验研究方法，研究了COD、LAS和NH3-N的去除效果。试验结果表明：整个系统出水稳定，水质良好（COD〈38．7mg／L、NH3-N〈1．1mg／L、LAS〈0．9mg／L，且无色无味、无SS），符合国家建设部生活杂用水回用水质标准，且具有较强的抗冲击负荷能力。在生物膜反应器中，微生物对污染物的去除起主要作用，而中空纤维膜对维持系统的稳定出水起重要作用。