废醋酸锌催化剂回收醋酸锌工艺研究

对从废醋酸锌催化剂中浸取醋酸锌进行了实验研究,考察了废催化剂颗粒大小,浸取剂种类和用量、温度和浸取时间等因素对醋酸锌浸取率的影响。     

The influence of degree of substitution on blend miscibility and biodegradation of cellulose acetate blends

In this account, we report our findings on blends of cellulose acetate having a degree of substitution (DS) of 2.49 (CA2.5) with a cellulose acetate having a DS of 2.06 (CA2.0). This blend system was examined over the composition range of 0–100% CA2.0 employing both solvent casting of films (no plasticizer) and thermal processing (melt-compressed films and injection molding) using poly(ethylene glycol) as a common plasticizer. All thermally processed blends were optically clear and showed no loss in optical quality after storage for several months. Thermal analysis and measurement of physical properties indicate that blends in the middle composition range are partially miscible, while those at the ends of the composition range are miscible. We suggest that the miscibility of these cellulose acetate blends is influenced primarily by the monomer composition of the copolymers. Bench-scale simulated municipal composting confirmed the biodestructability of these blends and indicated that incorporation of a plasticizer accelerated the composting rates of the blends.In vitro aerobic biodegradation testing involving radiochemical labeling conclusively demonstrated that both the lower DS CA2.0 and the plasticizer significantly enhanced the biodegradation of the more highly substituted CA2.5.While this work was in progress, Robert Gardner was struck with cancer and died on June 6, 1995. This paper is dedicated to his memory and to his contributions as a friend and colleague.     

β-环糊精/醋酸纤维素纳米纤维的制备及对染料废水的处理

制备了不同β-环糊精(β-CD)含量的醋酸纤维素(CA)纳米纤维膜,并对纤维膜的结构形貌、尺寸分布、孔隙率、比表面积以及纤维膜的力学性能进行表征分析。随后研究了不同β-CD含量、初始浓度、吸附时间下,纳米纤维膜对甲基红染料的截留性能和吸附性能。结果表明:过量(≥30%)的β-环糊精会使纳米纤维产生珠节,纤维的形貌和力学性能变差;吸附试验表明,β-CD的加入提高了CA纳米纤维膜对染料的吸附,MR吸附率可达93.48%,最大平衡吸附量可达181.74 mg/g,比纯CA纳米纤维膜提高了将近40%;此外,染料的截留实验表明,纳米纤维膜对染料的截留效果较差,最大截留率为50.35%。     

系列混合碳源在EBPR系统颗粒化进程中的影响研究

在SBR反应器中接种富含聚磷菌的活性污泥,以一系列不同比例的丙酸与乙酸混合为碳源条件,进行了EBPR系统颗粒化培养,考察了混合碳源中丙酸所占质量分数(以COD质量浓度计)的提高对EBPR系统颗粒化进程中颗粒粒径生长、污泥沉降性能、系统除磷效率等宏观特性的影响规律.结果表明,EBPR系统污泥颗粒生长速率随碳源中丙酸所占质量分数的增加而提高;碳源中丙酸所占质量分数较高的反应器污泥SVI值相对较高.经90 d培养,碳源中丙酸所占质量分数分别为0%、25%、50%、75%及100%的系统中成熟颗粒体积平均粒径分别为550.64、599.41、642.38、680.99和745.08μm,污泥SVI值分别稳定在30、40、50、60及75 mL.g-1左右.在相同的磷处理负荷下,各试验系统除磷性能产生了显著性差异.0%、25%、50%、75%及100%丙酸碳源系统平均净除磷能力(以MLSS计)分别为0.78、2.29、2.96、3.23及3.77 mg.g-1,平均除磷效率分别为31.5%、56.5%、77.4%、85.9%及97.0%.     

电子供体对地下水中高氯酸盐生物去除的影响研究

通过静态实验,考察了电子供体类型及用量对厌氧条件下微生物去除地下水中高氯酸盐的影响.结果表明,电子供体醋酸盐和H₂的加入,可以明显提高ClO₄^-的去除率,驯化后的微生物去除ClO₄^-的速率比未加入电子供体时提高约1.4~3倍.Monod动态模型能很好地拟合两种电子供体环境下ClO₄^-的微生物去除过程,分别以醋酸盐和H₂作为电子供体时,基质半饱和常数K_s为12.6 mg·L^-1和2.2 mg·L^-1,最大比基质消耗速率V_m为0.45 d^-1和0.08 d^-1.动力学参数表明,本实验条件下,异养型混合菌去除ClO₄^-的效果明显优于自养型混合菌;在少数受高浓度ClO₄^-污染的地下水环境中,为了提高ClO₄^-的去除速率只有通过增加菌体浓度或提高微生物酶的活性来实现.随着电子供体醋酸盐用量增加,ClO₄^-的(比)消耗速率逐渐增大.当初始CH₃COO^-与ClO₄^-的比例为3.80 mg(COD)/mg(ClO₄^-)时,比消耗速率v最大(0.27 d^-1).     

气相色谱法测定大气中乙酸乙酯和甲基丙烯酸甲酯

建立了用气相色谱法测定大气中乙酸乙酯和甲基丙烯酸甲酯的方法。大气中乙酸乙酯和甲基丙烯酸甲酯活性炭吸附,二硫化碳解吸,DB-200毛细管柱分离,直接进样分析,氢火焰离子化检测器检测,时间定性,峰面积定量。本方法前处理简便,分离度好,分析灵敏度高,满足环境分析要求。     

Residual dynamics of thiacloprid in medical herbs marjoram, thyme, and camomile and in soil

Thiacloprid is a new insecticide of the chloronicotinyl family. To assess its risk after application, residual characteristics of thiacloprid in marjoram, thyme, and camomile and in soil were studied under field conditions. The active ingredient was extracted from the plant material using a mixture of acetone-water. After filtration, the extract was concentrated to the aqueous phase, diluted with water, and portioned against ethyl acetate on a matrix solid phase dispersion column. Thiacloprid was extracted from soil using a mixture of methanol-water, filtered, and re.extracted （clean up） with dichloromethane. The residues were quantified using HPLC-MS-MS. The methods were validated by recovery experiments. Thiacloprid residues in marjoram, thyme, and camomile and in soil persisted beyond 10, 14, 14, and 21 d but no residues were detected after 14, 21, 21, and 28 d, respectively. The data obtained in this study indicated that the biexponential model is more suitable than the first-order function to describe the decline of thiacloprid in fresh marjoram, fresh thyme, and dried camomile flowers with half-life （t1/2） of 1.1, 0.7, and 1.2 d, respectively. However, both the first-order function and biexponential model were found to be applicable for dissipation of thiacloprid in soil with almost the same t1/2 values of 3.5 and 3.6 d. The results indicated that thiacloprid dissipates rapidly and does not accumulate in the tested herbs and in soil.     

Effects of metal and acidic sites on the reaction by-products of butyl acetate oxidation over palladium-based catalysts

Catalytic oxidation is widely used in pollution control technology to remove volatile organic compounds. In this study, Pd/ZSM-5 catalysts with different Pd contents and acidic sites were prepared via the impregnation method. All the catalysts were characterized by means of N2 adsorption- desorption, X-ray fluorescence （XRF）, HE temperature programmed reduction （H2-TPR）, and NH3 temperature programmed desorption （NH3-TPD）. Their catalytic performance was investigated in the oxidation of butyl acetate experiments. The by-products of the reaction were collected in thermal desorption tubes and identified by gas chromatography/mass spectrometry. It was found that the increase of Pd content slightly changed the catalytic activity of butyl acetate oxidation according to the yield of CO2 achieved at 90%, but decreased the cracking by-products, whereas the enhancement of strong acidity over Pd-based catalysts enriched the by-product species. The butyl acetate oxidation process involves a series of reaction steps including protolysis, dehydrogenation, dehydration, cracking, and isomerization. Generally, butyl acetate was cracked to acetic acid and 2- methylpropene and the latter was an intermediate of the other by-products, and the oxidation routes of typical by-products were proposed. Trace amounts of 3-methylpentane, hexane, 2-methylpentane, pentane, and 2-methylbutane originated from iso4merization and protolysis reactions.     

煤气脱硫废料综合利用新工艺

针对煤气脱硫废料（简称废料）的成分（硫、碳、萘及少量其他有机物），提出了一种处理废料的新工艺，先用乙酸乙酯提取废料中的萘和少量其他有机物，再用复合溶剂B加热溶解废料，热过滤得碳粉，最后将溶液冷却结晶分离出硫。实验结果表明：在乙酸乙酯与废料的质量比（R1）为3.75，提取温度为60℃，提取时间为4h的条件下，萘回收率为98%，纯度大于等于70%，在复合溶剂B与提取剩余物的质量比（R2）为2.69，过滤温度为100℃的条件下，硫回收率接近100%，纯度大于等于99%，碳回收率和纯度为100%。     

微生物光电还原CO2合成乙酸对外电压的响应机制

以TiO₂光阳极结合自养型生物阴极,构建双室微生物光电合成（MPES）系统,以光能作为主要的能量来源,探究MPES还原CO₂合成乙酸的性能及其限制因素.结果表明,光阳极取代纯电化学阳极显著降低了MPES生物阴极对外电压的需求.MPES能持续稳定运行,平均产乙酸速率为（1.18 ±0.11） mmol/（L·d）,法拉第效率为45.75%±3.97%.光阳极驱动阴极产生氢气,推测阴极微生物倾向于利用氢转移的方式来进行电子传递.外加电压通过影响光阳极的给电子能力从而对MPES的性能产生显著的影响,当外电压从0.4V升高至0.6V时,MPES的电流,乙酸产量和法拉第效率都显著提高,系统的性能主要受限于阳极.当外电压高于0.6V,系统电流,乙酸产量的增速减缓,法拉第效率在外加电压0.8V时达到最大值,随后下降,表明生物阴极的得电子能力已经达到饱和,此时MPES的性能主要受限于阴极.作为电子传递中间体,H₂的不完全利用是法拉第效率没有随着外电压的增加进一步提升的原因.