Treatability studies of naphthalene in soil,water and air with persulfate activated by iron(Ⅱ)

Chemical oxidation was applied to an artificially contaminated soil with naphthalene (NAP). Evaluation of NAP distribution and mass reduction in soil, water and air phases was carried out through mass balance. Evaluation of NAP distribution and mass reduction in soil, water and air phases was carried out through mass balance. The importance of the air phase analysis was emphasized by demonstrating how NAP behaves in a sealed system over a 4 hr reaction period. Design of Experiments method was applied to the following variables: sodium persulfate concentration [SP], ferrous sulfate concentration [FeSO₄], and pH. The system operated with a prefixed solid to liquid ratio of 1:2. The following conditions resulted in optimum NAP removal [SP] = 18.37 g/L, [FeSO₄] = 4.25 g/L and pH = 3.00. At the end of the 4 hr reaction, 62% of NAP was degraded. In the soil phase, the chemical oxidation reduced the NAP concentration thus achieving levels which comply with Brazilian and USA environmental legislations. Besides the NAP partitioning view, the monitoring of each phase allowed the variabilities assessment over the process, refining the knowledge of mass reduction. Based on NAP distribution in the system, this study demonstrates the importance of evaluating the presence of semi-volatile and volatile organic compounds in the air phase during remediation, so that there is greater control of the system as to the distribution and presence of the contaminant in the environment. The results highlight the importance of treating the contaminant in all its phases at the contaminated site.     

表面活性剂增强修复地下水中PCE的砂箱实验及模拟

在石英砂充填的二维砂箱中开展表面活性剂（Tween 80）冲洗四氯乙烯（PCE）的修复实验,基于图像分析技术监测不同污染源区结构条件下NAPL相的去除过程.由于实验条件限制,实验中缺乏溶解相浓度数据.为此进一步基于UTCHEM数值模拟方法来理解NAPL相和溶解态之间的质量传输过程,并探讨表面活性剂浓度、注入速率等因素对修复效率的影响.综合砂箱实验和数值模拟结果表明：介质均质和非均质条件下会形成不同类型DNAPL污染源区结构,表现为离散状PCE与池状PCE体积比（GTP）差异.由于离散状污染物与表面活性剂的接触面积更大,更易被优先去除;初始GTP值越高,污染物的修复速率和修复效率也越高.增大表面活性剂浓度或提高表面活性剂的注入速率,虽然能提高DNAPL的修复速率,但会明显降低表面活性剂的修复效率,实验过程中修复效率降幅可达93%.线性驱动溶解模型可以有效地模拟表面活性剂修复DNAPLs过程,基于数值模拟方法选择合适的表面活性剂配比可有效的节省实际污染场址修复经费和时间成本.     

土壤对六价铬的还原容量初步研究

提出并讨论了土壤的潜在还原容量、有效还原容量和条件还原容量等概念，通过对采用北京和唐山地下水饮用水源区３个包气带土壤样品的土柱淋滤实验，研究了土壤对水溶液中六价铬的还原作用，研究了上述土壤各种还原容量之间的关系及影响因素，探讨了向土壤中投加适量常见，无毒，价廉的还原性物质以提高土壤还原能力的方法和将其应用于去除灌溉用污染地下水中六价铬的可能性，实验结果表明，在正常环境条件下，土壤的有效还原容量比土     

VOC removal from contaminated groundwater through membrane pervaporation. (Ⅱ): 1,1,1-trichloroethane-SDS surfactant solution system

IntroductionTheconventionalmethodforsubsurfaceremediationofgroundwatercontaminationwithVOCsistheso called“pump and treat”technology .Thelimitationofthisapproachistheprohibitivelylongtreatmenttimeforremediatingthegroundwatercontaminatedwithcommonchlorinatedsolventsthathavedensitiesgreaterthanthatofwater(classifiedasDNAPLs densenon aqueousphaseliquids) .Thisislargelyduetotheverylowwatersolubilityandlowbiodegradabilityofthisclassofsolventsandthetendencyofthesolventssettlinginthebottomofanaqu…     

医疗废物焚烧残余物固化技术初探

根据对医疗废物焚烧残余物中有毒有害物质的化验分析结果,确定焚烧残余物中有毒有害成分含量仍较高,部分指标超出标准值,必须对其进行稳定化/固化处理,避免对土壤及地下水环境造成污染.本文阐述了稳定化/固化处理原理及处理工艺,使医疗废物无害化、减量化和资源化的处理原则得以全面实现.     

超深厌氧塘的技术特性

超深厌氧塘是一种稳定塘新工艺。与常规厌氧塘相比，具有ＢＯＤ５容积负荷大、占地面积小，受温度影响小的优点。探讨了它的工作机理，本研究确定了负荷、水深和去除率之间的定量关系以供实际应用。     

受污染地表水体生物修复技术研究进展

主要介绍了受污染地表水体生物修复技术的类型及特点,综述了国内外关于受污染地表水体生物修复技术研究及应用的现状,并对生物修复技术的研究及应用进行了展望.     

湖泊富营养化的防治对策与展望

由于工业化的发展和人类生产活动的加剧,大量有机污染物不断排入湖泊并在其中积累,致使湖泊产生了富营养化现象,已成为日益突出的环境问题.文中论述了湖泊富营养化的现状及危害,分析了产生的原因,并概括和比较了现有的国内外的防治措施,指出生态修复是治理的最佳出路.结合国内外湖泊的治理经验,并对今后的发展方向进行了展望.     

TVS／TFS去除率在ATAD污泥稳定评价的应用

在ATAD(Autothermal Thermophilic Aerobic Digestion,自升温高温好氧消化)工艺污泥稳定评价中引入TFS．提出“TVS/ TFS去除率”的概念,得出“TVS/TFS去除率”可以代替“VS(g)去除率”而成为一种新的污泥稳定指标的结论;采用数学微分的方法分析了“TVS/TFS去除率”和“VS(g)去除率”的数据误差问题,进泥TS为60g/L,TVS/TS为56％的运行条件下,前者的最大数据误差仅为3．16％,远小于后者的误差最大值15．45％,即引入TFS解决了“VS(g)去除率”数据波动大的问题;TFS的引入还节约了污泥稳定研究所需的时间和工作量。