Transport and retention of fullerene nanoparticles in natural soils

Commercial production and use of fullerene (C60) nanomaterials will inevitably lead to their release into the environment, where knowledge of C60 fate and transport is limited. In this study, a series of one-dimensional column experiments was conducted to assess the transport and retention of nanoscale fullerene aggregates (nC60) in water-saturated soils. Under the experimental conditions, complete retention of nC60 was observed in columns (2.5 cm inside diameter x 11 cm length) packed with Appling or Webster soil, which contain 0.75 and 3.33% organic carbon by weight, respectively. When the volume of aqueous nC60 suspension (approximately 4.5 mg L(-1)) applied to Appling soil was increased from 5 to 65 pore volumes, the travel distance increased from 3 to 8 cm, and the retention capacity approached a limiting value of 130 microg g(-1), although nC60 was not detected in the column effluent. The addition of 20 mg C L(-1) Suwannee River humic acid to the influent suspension increased the nC60 transport in Appling soil but did not resul in breakthrough. Attempts to simulate the experimental data using clean-bed filtration theory were not satisfactory, yielding retention profiles that failed to match observed data. Subsequent incorporation of a limiting retention capacity expression into the mathematical model resulted in accurate predictions of the measured nC60 retention profiles and transport behavior. The sizable retention capacities observed in this study suggest that transport of nC60 is limited in relatively fine-textured soils containing appreciable amounts of clay minerals and organic matter, with substantial accumulation of nC60 aggregates near the point of release.     

Why farmers adopt best management practice in the United States: a meta-analysis of the adoption literature

This meta-analysis of both published and unpublished studies assesses factors believed to influence adoption of agricultural Best Management Practices in the United States. Using an established statistical technique to summarize the adoption literature in the United States, we identified the following variables as having the largest impact on adoption: access to and quality of information, financial capacity, and being connected to agency or local networks of farmers or watershed groups. This study shows that various approaches to data collection affect the results and comparability of adoption studies. In particular, environmental awareness and farmer attitudes have been inconsistently used and measured across the literature. This meta-analysis concludes with suggestions regarding the future direction of adoption studies, along with guidelines for how data should be presented to enhance the adoption of conservation practices and guide research.     

Support for Hawaiian humpback whales

News And Comments

Support for Hawaiian humpback whales     

Regional multiresource models in a national framework

The design and integration of models projecting the effects of management on environmental systems is one step in the environmental planning process. Interactions between resources produced on the same unit of land under current and future management can be examined only when assumptions and processes of these dynamic environmental systems are quantified. Multiresource interaction models have generally been large and cumbersome while also suffering from an inadequate amount of detail. This article presents a conceptual framework for integrating individual resource models to project multiresource interactions at a regional scale. Land management impact projections require common definitions of the total land base and common definitions of management activities applied to the same land unit. A case example focusing on the resources of timber, forage, wildlife, fish, and water for the southern United States is presented.     

Degradation of N,N'-dibutylurea (DBU) in soils treated with only DBU and DBU-fortified benlate fungicides

N,N'-dibutylurea (DBU) is a breakdown product of benomyl [methyl 1-(butylcarbamoyl)-2-benzimidazole carbamate], the active ingredient in Benlate fungicides, and has been proposed to cause crop damage after the use of Benlate 50 DF fungicide (DuPont, Wilmington, DE). Our research focused on DBU persistence after application into soil. We assessed DBU persistence on direct application of DBU (carbonyl-(14)C) at two concentrations (0.08 and 0.8 microg DBU kg(-1)) to seven soils and two potting mixes in soil microcosms incubated at various combinations of soil water potential (-0.03 or -0.1 MPa) and temperature (23, 33, 44 degrees C). For two soils at a subset of treatment variables we assessed DBU persistence in the presence of Benlate DF and SP fungicide formulations. Parent compounds, metabolites, and (14)CO(2) were tracked using chromatographic analysis with radioassay and UV detection, liquid scintillation counting, and post-extraction oxidation of the soil. DBU degradation was primarily microbial and for most soil-treatment combinations, half-lives were less than 2 wk. DBU degradation was retarded at the lower soil water potential and enhanced at 33 degrees C. In the presence of the formulation, DBU degradation was slower for one soil type. The longest half-life observed in any case was less than 7 wk; therefore, long-term persistence of DBU applied to soils through a Benlate application is very unlikely.     

Preparation, certification and interlaboratory analysis of workplace air filters spiked with high-fired beryllium oxide

Occupational sampling and analysis for multiple elements is generally approached using various approved methods from authoritative government sources such as the National Institute for Occupational Safety and Health (NIOSH), the Occupational Safety and Health Administration (OSHA) and the Environmental Protection Agency (EPA), as well as consensus standards bodies such as ASTM International. The constituents of a sample can exist as unidentified compounds requiring sample preparation to be chosen appropriately, as in the case of beryllium in the form of beryllium oxide (BeO). An interlaboratory study was performed to collect analytical data from volunteer laboratories to examine the effectiveness of methods currently in use for preparation and analysis of samples containing calcined BeO powder. NIST SRM(?) 1877 high-fired BeO powder (1100 to 1200 °C calcining temperature; count median primary particle diameter 0.12 μm) was used to spike air filter media as a representative form of beryllium particulate matter present in workplace sampling that is known to be resistant to dissolution. The BeO powder standard reference material was gravimetrically prepared in a suspension and deposited onto 37 mm mixed cellulose ester air filters at five different levels between 0.5 μg and 25 μg of Be (as BeO). Sample sets consisting of five BeO-spiked filters (in duplicate) and two blank filters, for a total of twelve unique air filter samples per set, were submitted as blind samples to each of 27 participating laboratories. Participants were instructed to follow their current process for sample preparation and utilize their normal analytical methods for processing samples containing substances of this nature. Laboratories using more than one sample preparation and analysis method were provided with more than one sample set. Results from 34 data sets ultimately received from the 27 volunteer laboratories were subjected to applicable statistical analyses. The observed performance data show that sample preparations using nitric acid alone, or combinations of nitric and hydrochloric acids, are not effective for complete extraction of Be from the SRM 1877 refractory BeO particulate matter spiked on air filters; but that effective recovery can be achieved by using sample preparation procedures utilizing either sulfuric or hydrofluoric acid, or by using methodologies involving ammonium bifluoride with heating. Laboratories responsible for quantitative determination of Be in workplace samples that may contain high-fired BeO should use quality assurance schemes that include BeO-spiked sampling media, rather than solely media spiked with soluble Be compounds, and should ensure that methods capable of quantitative digestion of Be from the actual material present are used.     

Boundaries and Corridors as a Continuum of Ecological Flow Control: Lessons from Rivers and Streams

Abstract: Landscape boundaries and corridors are areas of small spatial extent relative to their large effects on ecological flows. The trend in ecological literature is to treat corridors and boundaries as separate phenomena on the landscape. This approach, however, misses a fundamental aspect they have in common: their strong influence on ecological flows. Corridors and boundaries exist at opposite ends of a permeability gradient, differing in their effects on rates and direction of flow. The position of landscape structures along this permeability gradient depends on attributes of both the flow and of the structure itself. We discuss boundaries and corridors in terms of mover specificity, scale, and effects on different levels of ecological organization, using rivers and streams to illustrate our points. We predict which structures will act as boundaries or corridors and at what spatial and temporal scales they are likely to be relevant. Considering the function of landscape structures across the boundary-corridor continuum will provide researchers and managers with a more complete, holistic viewpoint and will allow better strategies to attain conservation goals.