Beyond selectivity: Are behavioral avoidance and hormesis likely causes of pyrethroid-induced outbreaks of the southern red mite Oligonychus ilicis?

Secondary pest outbreak is a counterintuitive ecological backlash of pesticide use in agriculture that takes place with the increase in abundance of a non-targeted pest species after pesticide application against a targeted pest species. Although the phenomenon was well recognized, its alternative causes are seldom considered. Outbreaks of the southern red mite Oligonychus ilicis are frequently reported in Brazilian coffee farms after the application of pyrethroid insecticides against the coffee leaf miner Leucoptera coffeella. Selectivity favoring the red mite against its main predatory mites is generally assumed as the outbreak cause, but this theory has never been tested. Here, we assessed the toxicity (and thus the selectivity) of deltamethrin against both mite species: the southern red mite and its phytoseid predator Amblyseius herbicolus. Additionally, behavioral avoidance and deltamethrin-induced hormesis were also tested as potential causes of red mite outbreak using free-choice behavioral walking bioassays with the predatory mite and life-table experiments with both mite species, respectively. Lethal toxicity bioassays indicated that the predatory mite was slightly more susceptible than its prey (1.5×), but in more robust demographic bioassays, the predator was three times more tolerant to deltamethrin than its prey, indicating that predator susceptibility to deltamethrin is not a cause of the reported outbreaks. The predator did not exhibit behavioral avoidance to deltamethrin; however insecticide-induced hormesis in the red mite led to its high population increase under low doses, which was not observed for the predatory mite. Therefore, deltamethrin-induced hormesis is a likely cause of the reported red mite outbreaks.     

Organochlorine compounds in bovine milk from the state of Mato Grosso do Sul – Brazil

Organochlorines are highly hydrophobic, synthetic organic pollutants that accumulate in the environment and in food webs. The primary route of human exposure to organochlorines is through food-mainly fat-rich food of animal origin such as meat, fish, and dairy products. Here we determined the presence and concentration of organochlorine residues in pasteurized milk from Mato Grosso do Sul, Brazil, to monitor consumer exposure to these contaminants. Organochlorine pesticides in milk samples were analyzed using solid phase extraction in octadecyl silica-prepacked columns and identified by gas chromatography using an electron capture detector. Of the 100 composite samples analyzed, more than 90% contained residues of organochlorine pesticides: aldrin was present in 44% of the samples, followed by ∑DDT (36%), mirex (34%), endosulfan (32%), chlordane (17%), dicofol (14%), heptachlor (11%) and dieldrin (11%). Compared to the values established by law, the concentration of the compounds in some samples was above the reference values. Given the importance that milk and its products have in the human diet, it is essential to know whether the levels of pesticide residues are kept well below the recommended levels to minimize the risk to human health.     

Phytostabilization of semiarid soils residually contaminated with trace elements using by-products: sustainability and risks

We investigated the efficiency of various by-products (sugarbeet lime, biosolid compost and leonardite), based on single or repeated applications to field plots, on the establishment of a vegetation cover compatible with a stabilization strategy on a multi-element (As, Cd, Cu, Pb and Zn) contaminated soil 4-6 years after initial amendment applications. Results indicate that the need for re-treatment is amendment- and element-dependent; in some cases, a single application may reduce trace element concentrations in above-ground biomass and enhance the establishment of a healthy vegetation cover. Amendment performance as evaluated by % cover, biomass and number of colonizing taxa differs; however, changes in plant community composition are not necessarily amendment-specific. Although the translocation of trace elements to the plant biotic compartment is greater in re-vegetated areas, overall loss of trace elements due to soil erosion and plant uptake is usually smaller compared to that in bare soil.     

Pesticide dissipation curves in peach, pear and tomato crops in Uruguay

Dissipation curves of azoxystrobin and of the neonicotinoids acetamiprid and thiacloprid in peach; azinphos-methyl and carbaryl in pear and azoxystrobin, chlorfenapyr and chlorpyrifos in high-tunnel tomato crops were studied in the Southern region of Uruguay. An analytical methodology based on solid phase extraction (SPE) and detection by High Performance Liquid Chromatography with Diode Array Detector (HPLC/DAD) was used for acetamiprid and thiacloprid. Coupled SPE and detection by Gas Chromatography with Mass Selective Detector (GC/MSD) was used for the detection of azinphos-methyl, azoxystrobin, carbaryl, chlorfenapyr and chlorpyrifos residues. Curves were modeled mathematically with Solver program of Microsoft Excel. The best fit for acetamiprid and thiacloprid in peach was achieved with the exponential model (r(2)=0.961 and 0.944, respectively). In the case of peach fruits there is not a Maximum Residue Limit (MRL) for acetamiprid in the Codex Alimentarius, while 0.5 mg/kg is the value rated for thiacloprid. The MRLs accepted by the European Union (EU) are 0.1 mg/kg for acetamiprid and 0.3 mg/kg for thiacloprid. According to the curves determined in these experiments, thiacloprid residues 10 to 12 days after application (daa) were below the MRLs established by both sources. In the case of acetamiprid, 25 daa would be required, according to the exponential mathematical model, to get residues levels below the MRL values established by the EU. For azinphos methyl in pear, the residues detected were mathematically fitted to an exponential model (r(2)=0.999). According to it, residue levels under the MRL established by the EU (0.05 mg/kg) are gotten in our conditions in 20 daa. In plastic tunnel tomato chlorfenapyr residues were not detected from 16 daa, having the dissipation curve an exponential trend. In the same condition, there was not a decay of the azoxystrobin concentration during a 24-day trial, being it around 0.40 ± 0.05 mg/kg.     

Post-flooding disaster crop diversity recovery: a case study of Cowpea in Mozambique

To restore food security to a traditional African cropping system following a sudden loss of seed, genetic diversity must be re-established. This study examines the extent to which Cowpea diversity was reinstated two years after a flood disaster in Gaza Province, Mozambique. The contribution that seed from various sources made to the recovery was assessed using semi-structured interviews and morphological and molecular data. Data suggest that diversity had recovered to some extent yet there was evidence of a narrowing of the genetic base, with fewer rare alleles and differences in the distribution of allele frequencies. Although the main channels for accessing seed after the flood were seed relief and markets, these sources contributed to minimal and different diversity. It appears that diversity was regained primarily through social networking in the form of loans or gifts of seed from friends and relatives. The results of the study are discussed in relation to seed relief approaches.     

Acceleration of the Fe(III)EDTA(-) reduction rate in BioDeNO(x) reactors by dosing electron mediating compounds

BioDeNO(x), a novel technique to remove NO(x) from industrial flue gases, is based on absorption of gaseous nitric oxide into an aqueous Fe(II)EDTA(2-) solution, followed by the biological reduction of Fe(II)EDTA(2-) complexed NO to N(2). Besides NO reduction, high rate biological Fe(III)EDTA(-) reduction is a crucial factor for a succesful application of the BioDeNO(x) technology, as it determines the Fe(II)EDTA(2-) concentration in the scrubber liquor and thus the efficiency of NO removal from the gas phase. This paper investigates the mechanism and kinetics of biological Fe(III)EDTA(-) reduction by unadapted anaerobic methanogenic sludge and BioDeNO(x) reactor mixed liquor. The influence of different electron donors, electron mediating compounds and CaSO(3) on the Fe(III)EDTA(-) reduction rate was determined in batch experiments (21mM Fe(III)EDTA(-), 55 degrees C, pH 7.2+/-0.2). The Fe(III)EDTA(-) reduction rate depended on the type of electron donor, the highest rate (13.9mMh(-1)) was observed with glucose, followed by ethanol, acetate and hydrogen. Fe(III)EDTA(-) reduction occurred at a relatively slow (4.1mMh(-1)) rate with methanol as the electron donor. Small amounts (0.5mM) of sulfide, cysteine or elemental sulfur accelerated the Fe(III)EDTA(-) reduction. The amount of iron reduced significantly exceeded the amount that can be formed by the chemical reaction of sulfide with Fe(III)EDTA(-), suggesting that the Fe(III)EDTA(-) reduction was accelerated via an auto-catalytic process with an unidentified electron mediating compound, presumably polysulfides, formed out of the sulfur additives. Using ethanol as electron donor, the specific Fe(III)EDTA(-) reduction rate was linearly related to the amount of sulfide supplied. CaSO(3) (0.5-100mM) inhibited Fe(III)EDTA(-) reduction, probably because SO(3)(2-) scavenged the electron mediating compound.     

Effect of biosolid incorporation to mollisol soils on Cr, Cu, Ni, Pb, and Zn fractionation, and relationship with their bioavailability

Biosolid application to soil may be a supply of nutrients and micronutrients but it may also accumulate toxic compounds which would be absorbed by crops and through them be incorporated to the trophic chain.

The present study deals with the effect of biosolid application on Cr, Cu, Pb, Ni, and Zn in agricultural soils. The procedure used is sequential extraction so that the availability of those metals may be estimated and related to their bioavailability as determined through two indicator plants grown in greenhouse: ryegrass (Lolium perenne L.) and red clover (Trifolium pratense). Results showed that biosolid application to soil increased total Cu and Zn content. Sequential extraction showed that the more labile Zn fractions increased after biosolid application to soil. This was confirmed when assessing the total content of this metal in shoot and root of the plants under study, since a higher content was found in plant tissues, while no significant differences were found for Cu, Cr, Ni, and Pb.     

Processing and Properties of Mixtures of PHB-V with Post-consumer LDPE

Mixtures of poly-β-(hydroxybutyrate-co-valerate) PHB-V with virgin and post-consumer low density polyethylene (LDPE) were prepared by melt mixing in proportions of 100/0, 90/10, 80/20, 70/30 and 0/100 (wt/wt%). The mixtures were analysed by infrared spectroscopy, differential scanning calorimetry (DSC), dynamic mechanical thermal analysis (DMTA), melting flow index (MFI), tensile tests, scanning electron microscopy (SEM) and biodegradation in simulated soil. The DMTA and DSC curves of post-consumer LDPE suggested that this polymer was a mixture of LDPE and linear low density polyethylene (LLDPE). Virgin and post-consumer LDPE had lower MFI than PHB-V, but the blends showed higher index as the content of LDPE increased. The addition of LDPE reduced the tensile strength and Young’s modulus of the mixtures compared with PHB-V. SEM indicated poor interfacial adhesion between PHB-V and LDPE. PHB-V degraded slow and gradually, while both LDPE showed virtually no degradation under the conditions studied. The biodegradability of the blends depended on their composition and of the type of LDPE. LDPE improved the biodegradability of the mixtures.     

Genotoxicity detected in wild mice living in a highly polluted wetland area in south western Spain

A field study was carried out in the south of the Iberian Peninsula in an industrial area in the neighbourhood of Huelva city, SW Spain, and in a natural area (Do?ana National Park) for comparison, to estimate the genetic risk induced by environmental pollution in wild mice. Genotoxic effects in a sentinel organism, the Algerian mice (Mus spretus) free living in the industrial area were compared with animals of the same species living in the natural protected area. The single cell gel electrophoresis, or Comet assay, was performed as a genotoxicity test in peripheral blood of mice. Our results clearly show that mice free living in the contaminated area bear a high burden of genetic damage as compared with control individuals. The results suggest that the assessing of genotoxicity levels by the Comet assay in wild mice can be used as a valuable test in pollution monitoring and environmental conservation.     

Coupled infrared extinction spectra and size distribution measurements for several non-clay components of mineral dust aerosol (quartz, calcite, and dolomite)

Simultaneous size distributions and Fourier transform infrared (FTIR) extinction spectra have been measured for several representative components of mineral dust aerosol (quartz, calcite, and dolomite) in the fine particle size mode (D=0.1–1 μm). Optical constants drawn from the published literature have been used in combination with the experimentally determined size distributions to simulate the extinction spectra. In general, Mie theory does not accurately reproduce the peak position or band shape for the prominent IR resonance features in the 800–1600 cm⁻¹ spectral range. The resonance peaks in the Mie simulation are consistently blue shifted relative to the experimental spectra by 20–50 cm⁻¹. Spectral simulations, derived from a simple Rayleigh-based analytic theory for a “continuous distribution of ellipsoids” particle shape model, better reproduce the experimental spectra, despite the fact that the Rayleigh approximation is not strictly satisfied in these experiments. These results differ from our previous studies of particle shape effects in silicate clay mineral dust aerosols where a disk-shaped model for the particles was found to be more appropriate.