陆浑水库沉积物重金属空间分布特征及风险评价

为了解洛阳市饮用水水源地陆浑水库沉积物中重金属污染程度,采集32个点位的表层沉积物,分析6种重金属（Cd、Cr、Cu、Ni、Pb和Zn）的空间分布特征,并运用地累积指数法、潜在生态风险指数和聚类分析等方法对研究区重金属污染程度进行评价、生态风险评价及源解析.结果表明：Cd、Cu、Pb和Zn含量超过黄河流域河南段重金属土壤背景值,分别是其8.8、2.0、6.5、2.3倍,重金属存在明显富集,且主要污染集中于坝前区域.地累积指数法评价结果显示,Cd为强污染,Pb为中-强污染.潜在生态风险指数表明,陆浑水库沉积物重金属风险呈自上游至下游逐渐增强的趋势,总体处于高度生态危害,潜在生态风险指数均值达到312.94,其中Cd为主要贡献因子.富集系数法和聚类分析结果显示：Cd、Cu、Pb和Zn主要为人为源,Cr和Pb以自然源为主.总体而言,陆浑水库沉积物中重金属Cd和Pb污染相对较重,可能会对水库水环境构成威胁.     

悬浮填料投加对AnMBR性能及膜污染的影响

研究了悬浮填料投加对分置式厌氧膜生物反应器（AnMBR）的COD去除效果、污泥混合液特性及膜污染的影响。试验结果表明:在反应器有机负荷为2.09 kg/（m3·d）,污泥负荷为0.54 kg/（kg·d）,水力停留时间（HRT）为48 h,温度为（35±2）℃的条件下,与未投加悬浮填料阶段比较,投加填料后AnMBR的COD总去除率由96.6%提高至97.9%,甲烷产率提高16.0%。同时投加悬浮填料后AnMBR混合液污泥平均粒径增大,滤饼层阻力、总阻力、滤饼层阻力在总阻力中的占比较未投加悬浮填料时分别降低7.8、6.5和1.3百分点,溶解性胞外聚合物（SEPS）和结合性胞外聚合物（BEPS）浓度分别降低了20.5%和29.4%,跨膜压差（TMP）线性增长速率降低,膜污染速率明显减缓。因此,投加悬浮填料可在不增加能耗的情况下改善污泥混合液特性,起到强化AnMBR处理效果和控制膜污染的作用。     

北方湖库沉积物重金属区域特征及生态风险评价

以白洋淀、衡水湖、于桥水库、松花湖、大伙房水库和小兴凯湖沉积作为研究对象,通过对北方六湖库沉积物中Cu、Zn、Pb、Cr、Ni等重金属元素进行分析,并与国内外其他水域重金属污染情况进行多因素比较,探讨了六湖库主要重金属污染源的差异性,区域分布特征以及与国内外其他水域污染的相似性和区别.结果表明,六湖库沉积物重金属污染处于中等偏下水平.六湖库之间主要重金属污染源存在差别.沉积物重金属含量未出现明显上升的趋势.其中Zn、Pb存在富集现象,但Pb含量与历史数据相比出现下降,Zn的含量与其他地区相比整体偏高.大伙房水库沉积物重金属污染较重,Cu、Zn、Pb、Cr、Ni含量平均值分别为56.28,142.3,17.44,97.9,44.44mg/kg.小兴凯湖沉积物重金属含量最低,Cu、Zn、Pb、Cr、Ni含量平均值分别为2.41,63.90,13.37,56.36,26.09mg/kg.六湖库综合风险评价结果为大伙房水库>于桥水库>白洋淀>衡水湖>松花湖>小兴凯湖,重金属整体潜在生态风险指数为低.     

海绵城市透水砖铺装系统雨水入渗及重金属污染物迁移模拟

海绵城市透水砖铺装系统（PBPS）入渗特征是产流控制及径流污染物去除的重要影响因素之一。通过渗流实验,构建系统土壤层土水特征曲线,建立降雨入渗及径流重金属污染物迁移数学模型,以阐明找平层土壤粒径、基层与垫层厚度比对产流时间及径流重金属污染物去除的影响。研究表明:综合考虑延迟产流与径流重金属去除能力,中砂作为找平层介质最佳;依据结构层出水重金属污染物浓度,基层与垫层厚度比为15∶4时,PBPS对径流中重金属污染物吸附效率最高、去除效果较好。     

人工调水回灌和海绵城市促渗补给地下水方案比较

随着城市化快速发展和城市人口急剧增加,城市需水量急剧增加,导致许多城市地下水被过量开采。与此同时,随着城市建设用地的增加,不透水面积比例逐年升高,阻断了雨水下渗通道,导致地下水补给量逐年减小。地下水资源的过量开采引起了地面不均匀沉降、地下水污染、海水入侵等一系列问题。针对上述问题,以某市为例,从水量、水质、工程可靠性等方面比较了人工调水回灌与海绵城市促渗补给地下水方案的综合效益。结果表明:人工调水方案地下水补给量约为779万m3/年,海绵城市建设方案地下水补给量为339万m3/年,2种方案补给水水质中污染物种类相似,但雨水径流污染物浓度波动较大。因此,人工调水具有补水量易于控制、水质相对稳定,但调水水量受可利用水源的制约。海绵城市建设在保证地下水补给效果的同时,还具有雨水径流污染控制、洪涝缓解等多重效益,综合效益相对较高,且更符合城市可持续发展的理念。     

新型厌氧多级喷动床及其厌氧氨氧化脱氮性能分析

为改善厌氧反应器内的流态,加快污泥的颗粒化和形成具有生态梯度的微生物生态系统,设计并制作了新型厌氧多级喷动床,实验测试了反应器的水力喷动、气体喷涌和污泥分层分级现象。在常温下,利用新型厌氧多级喷动床接种混合污泥,经过42 d的培养,成功启动厌氧氨氧化反应器,稳定运行18 d后,NH₄+-N、NO₂--N去除率均达到90%以上。启动60 d后,反应器底部出现大量粒径2 mm左右的颗粒污泥,且污泥具有良好的稳定性和沉降性能,沉降速度达到70 m/h。结果表明:厌氧多级喷动床因其特殊的水力结构,可有效加快污泥的颗粒化。     

除Cd (Ⅱ)重金属吸附剂——巯基乙酰化玉米秸秆的制备

以玉米秸秆（CS）、巯基乙酸（TGA）为原料,通过化学反应制备出重金属吸附剂——巯基乙酰化玉米秸秆（MACS）,考察MACS对水样中Cd （Ⅱ）的去除性能,采用单因素实验法对MACS的制备条件进行优化研究。结果表明,MACS的优化制备条件为:CS粒径为0.20 mm （80目）,m（催化剂NHS）:m（EDC·HCl）为0.5:1,m（CS）:V（TGA）为1:5,反应介质pH值为5.0,反应温度25℃,反应时间2 h。在此条件下制备的MACS对水样中Cd （Ⅱ）的吸附效率可达到61.57%。红外分析表明,CS分子链中成功引入了巯基。     

Aerosol optical properties under different pollution levels in the Pearl River Delta (PRD) region of China

To clarify the aerosol hygroscopic growth and optical properties of the Pearl River Delta(PRD)region,integrated observations were conducted in Heshan City of Guangdong Province from October 19 to November 17,2014.The concentrations and chemical compositions of PM_(2.5),aerosol optical properties and meteorological parameters were measured.The mean value of PM_(2.5) increased from less than 35(excellent) to 35-75 μg/m~3(good) and then to greater than 75 μg/m~3(pollution),corresponding to mean PM_(2.5) values of 24.9,51.2,and 93.3 μg/m~3,respectively.The aerosol scattering hygroscopic growth factor(f(RH = 80%)) values were 2.0,2.12,and 2.18 for the excellent,good,and pollution levels,respectively.The atmospheric extinction coefficient(σext)and the absorption coefficient of aerosols(σ_(ap)) increased,and the single scattering albedo(SSA)decreased from the excellent to the pollution levels.For different air mass sources,under excellent and good levels,the land air mass from northern Heshan had lower f(RH) and σ_(sp) values.In addition,the mixed aerosol from the sea and coastal cities had lower f(RH) and showed that the local sources of coastal cities have higher scattering characteristics in pollution periods.     

Development of a static test apparatus for evaluating the performance of three PM2.5 separators commonly used in China

PM_(2.5) separator directly affects the accuracy of PM_(2.5) sampling.The specification testing and evaluation for PM_(2.5) separator is particularly important,especially under China's wide variation of terrain and climate.In this study,first a static test apparatus based on polydisperse aerosol was established and calibrated to evaluate the performance of the PM_(2.5) separators.A uniform mixing chamber was developed to make particles mix completely.The aerosol concentration relative standard deviations of three test points at the same horizontal chamber position were less than 0.57%,and the particle size distribution obeyed logarithmic normal distribution with an R~2 of 0.996.The flow rate deviation between the measurement and the set point flow rate agreed to within ± 1.0% in the range of -40 to 50℃.Secondly,the separation,flow and loading characteristics of three cyclone separators(VSCC-A,SCC-A and SCC112) were evaluated using this system.The results showed that the 50% cutoff sizes(D_(50)) of the three cyclones were 2.48,2.47 and 2.44 μm when worked at the manufacturer's recommended flow rates,respectively.The geometric standard deviation(GSD) of the capture efficiency of VSCCA was 1.23,showed a slightly sharper than SCC-A(GSD = 1.27),while the SCC112 did not meet the relevant indicator(GSD = 1.2 ± 0.1) with a GSD = 1.44.The flow rate and loading test had a great effect on D_(50),while the GSD remained almost the same as before.In addition,the maintenance frequency under different air pollution conditions of the cyclones was summarized according to the loading test.     

Synergistic effects of Cu species and acidity of Cu-ZSM-5 on catalytic performance for selective catalytic oxidation of n-butylamine

In this work, a series of Cu-ZSM-5 catalysts with different SiO₂/Al₂O₃ ratios (25, 50, 100 and 200) were synthesized and investigated in n-butylamine catalytic degradation. The n-butylamine can be completely catalytic degradation at 350°C over all Cu-ZSM-5 catalysts. Moreover, Cu-ZSM-5 (25) exhibited the highest selectivity to N₂, exceeding 90% at 350°C. These samples were investigated in detail by several characterizations to illuminate the dependence of the catalytic performance on redox properties, Cu species, and acidity. The characterization results proved that the redox properties and chemisorption oxygen primarily affect n-butylamine conversion. N₂ selectivity was impacted by the Brønsted acidity and the isolated Cu²⁺ species. Meanwhile, the surface acid sites over Cu-ZSM-5 catalysts could influence the formation of Cu species. Furthermore, in situ diffuse reflectance infrared Fourier transform spectra was adopted to explore the reaction mechanism. The Cu-ZSM-5 catalysts are the most prospective catalysts for nitrogen-containing volatile organic compounds removal, and the results in this study could provide new insights into catalysts design for VOC catalytic oxidation.