Evaluating the fish safety level of river water and wastewater with a larval medaka assay

A larval medaka (Oryzias latipes) assay was proposed to evaluate the fish safety level of river waters and wastewaters. Organic toxicants were 10-100 times concentrated with adsorption cartridges from 4 l of river water or 1-10 times concentrated from 400 ml of wastewater. Toxicity of these concentrated solutions was determined by exposing 48-72 h post-hatch age larvae for 48 h. The method effectively revealed a variation of the median lethal concentration ratio (LCR50) from 13 to >100 in 125 river water samples, and from <1 to >10 in five typical wastewater samples. Ayase River, which takes water mostly from agricultural or household discharge, showed significantly (P<0.001) lower LCR50 than Sagami River that takes natural water as the source. Safety Levels in both Sagami River and Ayase River were influenced by the irrigation activity, LCR50 at some sites showing a seasonal-specific decrease in winter. Pollution from pulp and paper industries contributed to the low LCR50 in several tributaries of Ayase River. Required little manpower in sampling, pretreatment and testing, the proposed larval medaka assay was proved as an efficient tool for screening those high risk sites for priority management.     

Removal of aqueous lead by poorly-crystalline hydroxyapatites

The use of a phosphorus amendment in altering Pb to a chemically less mobile phase is a promising strategy based on minimizing ecotoxicological risk and improving time and cost efficiency. This study evaluated crystalline and poorly-crystalline hydroxyapatite sorbents on removal of aqueous Pb in response to reaction time, solution pH, and Pb concentration. Batch experiments were conducted using a commercially-available crystalline hydroxyapatite (HA), and two poorly-crystalline hydroxyapatites synthesized from gypsum waste (CHA) and incinerated ash of poultry waste (MHA). Poorly-crystalline hydroxyapatites had greater capacity for Pb removal from a solution with a wider pH range as compared to a crystalline hydroxyapatite. The maximum sorption capacity of Pb determined by the Langmuir model was 500 mg g⁻¹ for CHA, 277 mg g⁻¹ for MHA and 145 mg g⁻¹ for HA. Removal of aqueous Pb by CHA was not dependent on solution pH, with a 98.8% reduction throughout the solution pH range of 2–9, whereas aqueous Pb removal by HA and MHA was pH-dependent with less removal in the neutral solution pH. Poorly-crystalline hydroxyapatites may provide an effective alternative to existing remediation technologies for Pb-contaminated sites.     

Human intake of PCDDs, PCDFs, and dioxin like PCBs in Japan, 2001 and 2002

PCDDs, PCDFs, and dioxin like PCBs (dioxin) surveillance results derived from regular environmental monitoring as well as other dioxin surveys by national and local governmental bodies in Japan were collected and analyzed. Several thousand data for air and soil in fiscal year 2001 (from 01/04/2001 to 31/03/2002) and 2002, water (from the sea, rivers and lakes), sediment (from the sea, rivers and lakes), ground water, aquatic organisms, purified water from water purification plants, raw water from water purification plants, human breast milk, and human blood in fiscal 2001, and total diet study (TDS) and various kinds of foodstuff in fiscal 1998-2002 were collected. Average human uptake of dioxin in Japan in fiscal 2001 was estimated at 1.68 pg-TEQ/kg-bw/day, while uptake in fiscal 2002 was estimated at 1.52 pg-TEQ/kg-bw/day. Diet accounted for more than 90% of the total intake. Contributions of inhalation and soil ingestion were relatively small. Age-group-specific contribution of various foodstuff to total dietary intake was also estimated. The estimates of intake through fish and shellfish accounted for approximately 45-70% of total dietary intake in each age group. Monte Carlo simulation was conducted, using the data of the air and soil concentrations in fiscal 2001 and the total diet study data in fiscal 1998-2001, in order to obtain information on the variability of dioxin intake; The estimated average, median, 5th percentile and 95th percentile of the intake distribution were 1.78, 1.69, 0.95 and 2.91 pg-TEQ/kg-bw/day, respectively. This study found that the average total intake estimates in Japan in both fiscal 2001 and 2002 were estimated to be below tolerable daily intake level (TDI) defined by the Ministry of Health, Labour and Welfare, Japan (i.e. 4 pg-TEQ/kg-bw/day). The 95th percentile of the dioxin intake distributions estimated with Monte Carlo simulation using the data of the air and soil concentrations in fiscal 2001 and TDS data in fiscal 1998-2001 was also below the Japanese TDI.     

Behavior and prediction of photochemical degradation of chlorinated polycyclic aromatic hydrocarbons in cyclohexane

The photochemical degradation of 11 chlorinated polycyclic aromatic hydrocarbons (ClPAHs) and the corresponding 5 parent PAHs was examined to simulate the compound’s fate on aerosol surfaces. All the ClPAHs and PAHs decayed according to the first-order reaction rate kinetics. The photolysis rates of ClPAHs varied greatly according to the skeleton of PAHs; the rates of chlorophenanthrenes (ClPhes) and 1-chloropyrene were higher than those of corresponding parent PAHs, whereas chlorofluoranthenes, 7-chlorobenz[a]anthracene and 6-chlorobenzo[a]pyrene were more stable under irradiation compared to respective parent PAH. Considering the photoproducts of ClPhes detected, the oxidation could occur immediately at positions of the highest frontier electron density. Finally, the quantitative structure-property relationship models were developed for direct photolysis half-lives and average quantum yields of the ClPAHs and parent PAHs, in which the significant factors affecting photolysis were E_LUMO+1, total energy and surface area, and E_LUMO, E_LUMO − E_HOMO and total energy, respectively.     

Field monitoring of volatile organic compounds using passive air samplers in an industrial city in Japan

Highly portable, sensitive, and selective passive air samplers were used to investigate ambient volatile organic compound (VOC) levels at multiple sampling sites in an industrial city, Fuji, Japan. We determined the spatial distributions of 27 species of VOCs in three campaigns: Mar (cold season), May (warm season), and Nov (mild season) of 2004. In all campaigns, toluene (geometric mean concentration, 14.0microg/m3) was the most abundant VOC, followed by acetaldehyde (4.76microg/m3), and formaldehyde (2.58microg/m3). The spatial distributions for certain VOCs showed characteristic patterns: high concentrations of benzene and formaldehyde were typically found along major roads, whereas high concentrations of toluene and tetrachloroethylene (PCE) were usually found near factories. The spatial distribution of PCE observed was extremely consistent with the diffusion pattern calculated from Pollutant Release and Transfer Register data and meteorological data, indicated that passive air samplers are useful for determining the sources and distributions of ambient VOCs.     

Preparation of alginate-chitosan hybrid gel beads and adsorption of divalent metal ions

Naturally occurring polysaccharides such as alginic acid and chitosan have been recognized as one of the most effective adsorbents to eliminating low levels of heavy metal ions from waste water stream. The present study intended to use alginic acid and chitosan simultaneously, which are expected to form a rigid matrix structure of beads due to electrostatic interaction between carboxyl groups on alginic acid and amino groups on chitosan, and to prepare alginate-chitosan hybrid gel beads. This could be achieved for the first time by using water-soluble chitosan, which was obtained by deacetylating chitin to 36-39% degree. The water-soluble chitosan dissolved in water could remain in solution in the presence of sodium alginate, and the homogeneous solution of chitosan and alginate was dispensed into a CuCl2 solution to give gel bead particles. The resultant beads were then reinforced by a cross-linking reaction of aldehyde groups on glutaraldehyde with amine groups on the chitosan. The cross-linking reaction made the beads durable under acidic conditions. The adsorption of Cu(II), Co(II), and Cd(II) on the beads was significantly rapid and reached at equilibrium within 10 min at 25 degrees C. Adsorption isotherms of the metal ions on the beads exhibited Freundlich and/or Langmuir behavior, contrary to gel beads either of alginate or chitosan showing a step-wise shape of adsorption isotherm.     

Studies on automated survey system of environmental chemicals by gas chromatography-mass spectrometry-computer II. Three dimensional mass chromatography

A three dimensional mass chromatography (TDMC), which is the extended method of mass chromatography, has been developed for the analysis of environmental chemicals. A considerable performance was suggested by the combination of TDMC to gas chromatography-mass spectrometry-computer system.