水体及沉积物氮磷水平对附植藻类的影响

为了探讨湖泊富营养化过程中沉积物及水体氮、磷浓度对附植藻类的影响,通过室内模拟实验,研究了水体及沉积物氮、磷升高对苦草(Vallisnerianatans(Lour.) Hara)上附植藻类生长、群落组成及其体内氮、磷含量的影响.结果表明,在实验条件下,随着水中氮、磷含量升高,附植藻类生物量及附植藻类氮、磷含量均呈极显著增加(p0.01).随着水体可获得的氮、磷浓度升高,附植藻类的相对丰度有所变化,舟形藻(Navicula)、小球藻(Chlorella)及微囊藻(Microcystis)相对丰度随着氮、磷水平的升高而下降,直链藻(Melosira)则相反,但舟形藻、直链藻、微囊藻、小环藻(Cyclotella)和小球藻均为群落的优势属种.沉积物氮、磷含量升高对附植藻类生物量、优势种丰度及群落氮、磷含量影响较小,均未达到显著水平(p0.05).在实验条件下,沉积物氮、磷含量对附植藻类影响不大,而水体氮、磷浓度升高显著地促进了附植藻类生长.研究结果也为解释富营养化湖泊沉水植物衰退及消亡提供了一定的科学依据.     

表面活性剂增强修复地下水中PCE的砂箱实验及模拟

在石英砂充填的二维砂箱中开展表面活性剂（Tween 80）冲洗四氯乙烯（PCE）的修复实验,基于图像分析技术监测不同污染源区结构条件下NAPL相的去除过程.由于实验条件限制,实验中缺乏溶解相浓度数据.为此进一步基于UTCHEM数值模拟方法来理解NAPL相和溶解态之间的质量传输过程,并探讨表面活性剂浓度、注入速率等因素对修复效率的影响.综合砂箱实验和数值模拟结果表明：介质均质和非均质条件下会形成不同类型DNAPL污染源区结构,表现为离散状PCE与池状PCE体积比（GTP）差异.由于离散状污染物与表面活性剂的接触面积更大,更易被优先去除;初始GTP值越高,污染物的修复速率和修复效率也越高.增大表面活性剂浓度或提高表面活性剂的注入速率,虽然能提高DNAPL的修复速率,但会明显降低表面活性剂的修复效率,实验过程中修复效率降幅可达93%.线性驱动溶解模型可以有效地模拟表面活性剂修复DNAPLs过程,基于数值模拟方法选择合适的表面活性剂配比可有效的节省实际污染场址修复经费和时间成本.     

某型飞机外翼5—8肋损伤原因分析及修复探讨

目的 分析某型飞机外翼5—8肋油箱区结构不同程度损伤的原因,制定修复方案。方法采用受载分析、有限元仿真计算、静力试验数据分析等强度计算方法分析损伤产生的原因,采用扫描电子显微镜和光学显微镜对磨痕形貌进行观测等失效分析,对损伤结构件开展失效模式分析,根据损伤原因及失效模式制定科学简便的修复方案,同时对损伤长桁采取的修补措施进行强度校核。结果 通过对外翼油箱充压破坏理论分析、有限元仿真计算、静力试验数据反推,并结合飞机实际损伤情况,得出油箱破坏理论分析危险薄弱部位与真实破坏情况一致的结论。有限元仿真计算最危险结构部位与实际结构首先发生破坏部位吻合,可作为深入制定修复方案及推测实际加载压力的依据。通过静力试验数据反推、结构实际损伤及有限元仿真计算结论得出,外翼5—8肋结构出现损伤时油箱施加压力约0.5 MPa,针对损伤制定了更换外翼油箱内部第5—8肋损伤结构和贴补加强损伤长桁的修理方案,经结构强度校核,满足设计要求。结论 分析认为外翼5—8肋油箱区结构损伤原因为油箱压力超过设计值导致结构过载断裂,采用贴补加强修理损伤长桁和更换第5—8肋损伤结构的修复方案能够满足强度设计要求,可指导同类飞机类似结构损伤故障的原因分析和修理,提醒同类飞机维修人员在飞机维护时应关注外翼油箱压力超压问题。     

Multi-objective, decision-based assessment of a water quality monitoring network in a river system

Water quality monitoring network design has historically tended to use experience, intuition and subjective judgement in locating monitoring stations. Better design procedures to optimize monitoring systems need to simultaneously identify significant planning objectives and consider a number of social, economic and environmental constraints. The consideration of multiple objectives may require further decision analysis to determine the preference weights associated with the objectives to aid in the decision-making process. This may require the application of an optimization study to extract such information from decision makers or experts and to evaluate the overall effectiveness of locating strategies. This paper assesses the optimal expansion and relocation strategies of a water quality monitoring network using a two-stage analysis. The first stage focuses on the information retrieval of preference weights with respect to the designated planning objectives. With the aid of a pre-emptive goal programming model, data analysis is applied to obtain the essential information from the questionnaire outputs. The second stage then utilizes a weighted multi-objective optimization approach to search for the optimal locating strategies of the monitoring stations in the river basin. Practical implementation is illustrated by a case study in the Kao-Ping River Basin, south Taiwan.     

塔里木油田环境空气质量状况及评价

根据塔里木油田１９９３－１９９６年环境空气监测数据，对其环境空气质量状况进行了分析和评价。     

气相色谱-质谱法测定废酸油渣中的16种多环芳烃

建立了废酸油渣中16种多环芳烃超声萃取、Florisil萃取柱净化、气相色谱-质谱测定的方法。笔者对提取方式、提取剂类型和体积、提取时间和次数、净化方式等进行研究,采用无水硫酸钠分散,二氯甲烷作为提取剂超声40 min,提取液经纯水清洗、离心后取适量有机相经过3 g Florisil萃取柱净化,采用气相色谱-质谱选择离子模式(SIM),加入内标进行定量分析。结果表明:二氯甲烷提取效率比正己烷好,丙酮可能引起酸性样品中多环芳烃的降解,丙酮超声萃取时加入无水硫酸钠能在一定程度上防止目标物降解,但萃取效率不可控制,宜采用二氯甲烷作为萃取剂。分散提取能有效减少提取时间,超声清洗仪超声40 min提取效率为86.2%～104%。3g Florisil萃取柱净化比1 g Florisil萃取柱净化和GPC净化效果略好。方法检出限为0.4～1.3 mg/kg,6次空白加标的相对标准偏差为2.3%～15.3%,6个实际样品测定结果的相对标准偏差为1.2%～27.3%,基体加标回收率为51.3%～126%,连续校准稳定。该方法适用于废酸油渣样品中16种多环芳烃的检测,比直接溶解有效,比加速溶剂萃取、索氏提取、微波萃取和超声探头萃取简单、快捷,能有效减少设备污染和腐蚀,净化方法有效,测定结果准确可靠,是实现大批量样品检测的可行方法。     

工业纤维废渣利用的生物技术研究

用平板分离法从树皮中选育出“５０８８号菌种”，使麻纺厂的废弃下脚料转化成可替代饲料中玉米成份的“媲谷菌饲”。并利用造纸厂白泥，粘胶纤维厂废水处理产生的污泥作饲料钙，锌元素添加剂获成功。     

高等院校教育技术的发展思路探讨

本文阐述了高等院校教育技术的发展现状,分析了高等院校教育技术发展的特点,对高等院校教育技术的发展进行理性思考。认为高等院校应该在重视教育技术实践性和支持性研究的基础上,立足现实,更全面审视机构整合、教育信息化、信息资源库建设和教师培训这些热点问题。     

Preparation of rare-earth metal complex oxide catalysts for catalytic wet air oxidation

Catalytic wet air oxidation (CWAO) is one of the most promising technologies for pollution abatement. Developing catalysts with high activity and stability is crucial for the application of the CWAO process. The Mn/Ce complex oxide catalysts for CWAO of high concentration phenol-containing wastewater were prepared by coprecipitation. The catalyst preparation conditions were optimized by using an orthogonal layout method and single-factor experimental analysis. The Mn/Ce serial catalysts were characterized by Brunauer-Emmett-Teller (BET) analysis and the metal cation leaching was measured by inductively coupled plasma torch-atomic emission spectrometry (ICP-AES). The results show that the catalysts have high catalytic activities even at a low temperature (80°C) and low oxygen partial pressure (0.5 MPa) in a batch reactor. The metallic ion leaching is comparatively low (Mn<6.577 mg/L and Ce<0.6910 mg/L, respectively) in the CWAO process. The phenol, COD_Cr, and TOC removal efficiencies in the solution exceed 98.5% using the optimal catalyst (named CSP). The new catalyst would have a promising application in CWAO treatment of high concentration organic wastewater. Translated from Techniques and Equipment for Environmental Pollution Control, 2005, 6(2): 40–44 [译自: 环境污染治理技术与设备]