Farmers’ perception and adaptations to climate change: findings from three agro-ecological zones of Punjab,Pakistan

Environmental Science and Pollution Research - The main objective of this study was to capture farmers’ perceptions and adaptations to climate change in agriculture sector. Along with this,...     

Sorption kinetics of atrazine and diuron in soils from southern Brazil

Sorption kinetics of atrazine and diuron was evaluated in soil samples from a typical landscape in Paraná. Samples were collected (0-20 cm) in a no-tillage area from Mamborê, PR, which has been cultivated under a crop rotation for the last six years. Six sampling points of the slope were selected to represent a wide range of soil chemical and physical properties found in this area. Radiolabeled tracers (14C-atrazine and 14C-diuron) were used and the radioactivity was detected by liquid scintillation counting (LSC). Sorption was accomplished for increasing equilibration periods (0.5, 1.5, 3, 6, 12, 24, and 48 h). Kinetics data fitted adequately well to Elovich equation, providing evidences that soil reaction occurs in two distinct stages: a fast, initial one followed by a slower one. During the fast phase, 34-42 and 71-79% of total atrazine and diuron applied were sorbed to soil samples. No important differences were found among combinations of soil and herbicide sorption during the slow phase. The unrealistic conditions under batch experiments should be overestimating sorption in the fast phase and underestimating diffusion in the slow phase. Sorption of both herbicides was positively correlated to organic carbon and clay contents of soils, but atrazine was much less sorbed than diuron, showing its higher potential to contaminate groundwater, specially in sandy, low organic carbon soils.     

An assessment of the concentrations of particulate polycyclic aromatic hydrocarbons (PAHs) in the aftermath of a chemical store fire incident

PM10 airborne particles and soot deposit collected after a fire incident at a chemical store were analyzed in order to determine the concentrations of polycyclic aromatic hydrocarbons(PAHs). The samples were extracted with 1 : 1 hexane-dichloromethane by ultrasonic agitation. The extracts were then subjected to gas chromatography-mass spectrometric(GC-MS) analysis. The total PAHs concentrations in airborne particles and soot deposit were found to be 3.27 1.55 ng/m^3 and 12.81 24.37 μg/g, respectively. Based on the molecular distributions of PAHs and the interpretation of their diagnostic ratios such as PHEN/(PHEN ANTH), FLT/(FLT PYR) and BeP/(BeP BaP), PAHs in both airborne particles and soot deposit may be inferred to be from the same source. The difference in the value of IP/(IP BgP) for these samples indicated that benzo[ g, h, i] perylene and coronene tend to be attached to finer particles and reside in the air for longer periods. Comparison between the molecular distributions of PAHs and their diagnostic ratios observed in the current study with those reported for urban atmospheric and roadside soil particles revealed that they are of different sources.     

Modelling of BP Texas City refinery accident using dynamic risk assessment approach

Process industries involve handling of hazardous substances which on release may potentially cause catastrophic consequences in terms of assets lost, human fatalities or injuries and loss of public confidence of the company. In spite of using endless end-of-the-pipe safety systems, tragic accidents such as BP Texas City refinery still occur. One of the main reasons of such rare but catastrophic events is lack of effective monitoring and modelling approaches that provide early warnings and help to prevent such event. To develop a predictive model one has to rely on past occurrence data, as such events are rare, enough data are usually not available to better understand and model such behavior. In such situations, it is advisable to use near misses and incident data to predict system performance and estimate accident likelihood. This paper is an attempt to demonstrate testing and validation of one such approach, dynamic risk assessment, using data from the BP Texas City refinery incident.Dynamic risk assessment is a novel approach which integrates Bayesian failure updating mechanism with the consequence assessment. The implementation of this methodology to the BP Texas City incident proves that the approach has the ability to learn from near misses, incident, past accidents and predict event occurrence likelihood in the next time interval.     

Methodology for computer aided fuzzy fault tree analysis

Probabilistic risk assessment (PRA) is a comprehensive, structured and logical analysis method aimed at identifying and assessing risks of complex process systems. PRA uses fault tree analysis (FTA) as a tool to identify basic causes leading to an undesired event, to represent logical dependency of these basic causes in leading to the event, and finally to calculate the probability of occurrence of this event.To conduct a quantitative fault tree analysis, one needs a fault tree along with failure data of the basic events (components). Sometimes it is difficult to have an exact estimation of the failure rate of individual components or the probability of occurrence of undesired events due to a lack of sufficient data. Further, due to imprecision in basic failure data, the overall result may be questionable. To avoid such conditions, a fuzzy approach may be used with the FTA technique. This reduces the ambiguity and imprecision arising out of subjectivity of the data.This paper presents a methodology for a fuzzy based computer-aided fault tree analysis tool. The methodology is developed using a systematic approach of fault tree development, minimal cut sets determination and probability analysis. Further, it uses static and dynamic structuring and modeling, fuzzy based probability analysis and sensitivity analysis.This paper also illustrates with a case study the use of a fuzzy weighted index and cutsets importance measure in sensitivity analysis (for system probabilistic risk analysis) and design modification.     

Effects of dam on temperature,humidity and precipitation of surrounding area: a case study of Gomal Zam Dam in Pakistan

Environmental Science and Pollution Research - Dams are studied not only for potential advantages but also for possible environmental repercussions. The objective of this case study is to see the...     

A methodology for calculating sample size to assess localized corrosion of process components

This paper proposes a methodology to estimate the required sample size to assess, with a specified precision, the localized corrosion of process components. The proposed methodology uses the extreme value and bootstrap methods. The results of estimated sample size ensure that the predicted maximum localized corrosion with the extreme value method is within an acceptable margin of error at a specified confidence level. Using the results of the proposed methodology, an equation is introduced to calculate sample size as a function of the acceptable margin of error, the population size, the standard deviation of corrosion data and the required confidence level. The probability of exceedance of critical limit of localized corrosion is also estimated. The methodology is explained through a case study of localized corrosion in process piping.     

Do governance indicators interact with technological innovation and income inequality in mitigating CO2 emissions in Belt and Road Initiative countries?

Environmental Science and Pollution Research - Environmental degradation is being studied by linking with various factors depending upon the interest of researchers. Our interest is in...     

Human and ecological risk assessment of heavy metals in different particle sizes of road dust in Muscat,Oman

Environmental Science and Pollution Research - Heavy metal contamination of Hg, As, Cu, Cr, Zn, and Pb was investigated in three different fractions 45, 125, and 200 μm of road dust...     

Optimization of microwave treatment for dewaterability enhancement of electroplating sludge

Journal of Material Cycles and Waste Management - In this study, the dewaterability characteristics of electroplating sludge have been investigated after treatment with microwave irradiation. While...