Reasons for Child Passenger Nonrestraint in Motor Vehicles

Objective: Although child passenger restraint use in motor vehicles has increased, there is an important minority of children who remain unrestrained. The goal of this study was to identify the frequency of and under what circumstances parents keep their children unrestrained.

Methods: A cross-sectional, online survey was distributed to parents and caregivers of children 10 years old and younger. Survey participants were asked about child restraint practices, including frequency of and reasons for nonuse of restraints. Parents were specifically asked how acceptable it would be to keep their child unrestrained in certain situations.

Results: One thousand two hundred eighty-five parents and guardians responded to the survey and 1,002 completed it; 23.8% (95% confidence interval [CI], 21.3–26.6%) of respondents said they had driven with their child not fully restrained on at least one occasion. Approximately 1 in 5 parents strongly or somewhat agreed that it would be acceptable to keep their child unrestrained in certain situations, including a short drive, in a rush, an inadequate number of restraints, riding in a taxi, if somebody was holding the child, and as a reward for a child. Parents were more likely to agree that it was acceptable to keep their child unrestrained under nearly all circumstances listed if they were male, ages 18–29, with a graduate school education, in the $100,000+ income bracket, or Latino.

Conclusions: There are certain situations for which parents find it acceptable to leave their children unrestrained. This has implications for targeted child passenger safety efforts designed to maximize consistent restraint use.     

Design and Construction of a Simple,Continuous Flow Sulfur Dioxide Exposure Chamber

ABSTRACT

The use of street sweepers to clean paved roads, particularly after high-wind events, has been proposed as a PM₁₀ control method. Using an artificial tunnel, the emission rates for several street sweepers were quantified under actual operating conditions. The tunnel was a tent enclosure, 6.1 × 4.3 × 73 m, open on both ends. PM₁₀ concentrations were measured at the inlet and outlet while a sweeper removed sand deposited along the length. Measurements were made using a specialized low-volume filter sampler and an integrating nephelometer. The volume of air passing through the tunnel was measured by releasing an inert tracer, sulfur hexafluoride, at the inlet and measuring its concentration at the outlet. A large difference in emission rates between vacuum-type sweepers was observed, with rates varying from 5 to 100 mg m^-1 swept. For the cleanest sweepers, the background rates (collected by sweeping clean pavement) were about half of the total PM₁₀ emission rate. These background emission rates likely were from diesel exhaust; background rates for the single gasoline-powered sweeper were below detection. Particle light scattering data confirmed the filter collection results. The artificial tunnel approach would be useful in measuring total emissions from other mobile and stationary sources.     

Measurement of particle concentrations in a dental office

Particles in a dental office can be generated by a number of instruments, such as air-turbine handpieces, low-speed handpieces, ultrasonic scalers, bicarbonate polishers, polishing cups, as well as drilling and air sprays inside the oral cavity. This study examined the generation of particles during dental drilling and measured particle size, mass, and trace elements. The air sampling techniques included both continuous and integrated methods. The following particle continuous measurements were taken every minute: (1) size-selective particle number concentration (Climet); (2) total particle number concentration (PTRAK), and; (3) particle mass concentration (DustTrak). Integrated particle samples were collected for about 5 h on each of five sampling days, using a PM_2.5 sampler (ChemComb) for elemental/organic carbon analysis, and a PM₁₀ sampler (Harvard Impactor) for mass and elemental analyses. There was strong evidence that these procedures result in particle concentrations above background. The dental procedures produced number concentrations of relatively small particles (<0.5 μm) that were much higher than concentrations produced for the relatively larger particles (>0.5 μm). Also, these dental procedures caused significant elevation above background of certain trace elements (measured by X-ray fluorescence) but did not cause any elevation of elemental carbon (measured by thermal optical reflectance). Dental drilling procedures aerosolize saliva and products of drilling, producing particles small enough to penetrate deep into the lungs. The potential health impacts of the exposure of dental personnel to such particles need to be evaluated. Increased ventilation and personal breathing protection could be used to minimize harmful effects.     

Some Applications of Microscopy to Air Pollution

The microscope as it has been and is now applied to air pollution work is discussed. A summary of the most common particulate sampling equipment is presented and distinctions as to the area of usage (suspended, or settled particulates) are made in each instance. Actual cases are discussed in which the polarizing microscope was used to determine identities and source of particulate pollutants. Particles from such sources as power plants, feed mills, and combustion sources are discussed and photomicrographs of known samples and unknown particles causing complaints are presented and compared as part of the discussion. References are given which deal with sampling equipment and microscopic analysis of various particulates.     

HISTORICAL AND ESTIMATED GROUND WATER LEVELS NEAR WINNIPEG,CANADA, AND THEIR SENSITIVITY TO CLIMATIC VARIABILITY1

ABSTRACT: Long term well hydrographs and estimated ground water levels derived from hydroclimatic and biological data were used to evaluate trends within the Upper Carbonate Aquifer (UCA) near Winnipeg, Canada, during the 20th Century. Ground water records from instruments have been kept since the early 1960s and are derived from piezometers in the overlying sediments and in open boreholes in the UCA. Some boreholes extend into an underlying Paleozoic carbonate sequence. Shallow well hydrographs show no obvious long term trends but do exhibit variations on the order of three to four years that are correlated with changes in annual temperature and precipitation at lags up to 24 months. Trends observed in deeper wells appear to be largely related to ground water usage patterns and show little correlation with climate over the past 35 years. Stepwise multiple regression modeled average annual hydraulic head in the shallow wells as a function of regional temperature, precipitation, and tree ring variables. Estimated hydraulic heads had a slightly greater range prior to the 1960s, most prominently during an interval of lowered ground water levels between 1930 and 1942. Regression results demonstrate that moisture sensitive tree ring data are viable predictors of past ground water levels and may be useful for studies of aquifers in regions that lack long, high quality precipitation records.     

Development and laboratory performance evaluation of a personal cascade impactor

This paper presents the design and laboratory evaluation of a personal cascade impactor. The system is compact, lightweight, and uses a single battery-operated sampling pump. It operates at a flow rate of 5 L/min and consists of four impaction stages, each equipped with slit-shaped acceleration nozzles, and a backup filter. The impactor was calibrated using polydisperse particles. The 50% cut points of the four stages were 9.6, 2.6, 1.0, and 0.5 microm, respectively. The backup filter is placed downstream of the fourth stage and is used to collect the particles with an aerodynamic diameter smaller than 0.5 microm (dp < 0.5 microm). The major feature of this novel sampler is its ability not only to fractionate the particles with an aerodynamic diameter smaller than 10 microm to the various size fractions, but also to collect them onto relatively small polyurethane foam substrates without using adhesives. Although the impaction substrates are not coated with adhesives such as grease or mineral oil, particle bounce and re-entrainment losses were found to be insignificant. Interstage losses of particles smaller than 0.5 microm were less than 10%; for fine particles, less than 5%; and for coarse particles, less than 12%. The pressure drop across the four stages and the backup filter were 0.015 kPa (0.153 cm H2O),0.025 kPa (0.255 cm H2O), 0.274 kPa (2.794 cm H2O), 0.323 kPa (3.294 cm H2O), and 0.370 kPa (3.773 cm H2O), respectively. Particles can be easily recovered from the foam substrates using aqueous extraction.     

ANSI X12: Data standards for TQEM

One key development in environmental software is the adoption of a common electronic language for exchanging EH&S data. The ANSIX12-based data management tools offer compatibility across platforms within the company as well as between different companies. The X12 syntax makes it easy for environmental managers to integrate functions more closely with either materials management or quality management systems.     

Sixteen-year-old drivers in fatal crashes, United States, 2003

OBJECTIVE: Key features of graduated licensing were introduced in 46 states and the District of Columbia between 1993 and 2003. State evaluations consistently have reported positive overall effects and positive effects of nighttime and passenger restrictions. Sixteen year-olds are the main target of graduated licensing, and the present study investigated changes in their fatal crash involvement and crash characteristics that have taken place nationally during 1993-2003. By looking at 16 year-olds nationally, the study does not constitute a direct test of the effect of graduated licensing laws per se. METHODS: Data on fatal crashes were obtained from the Fatality Analysis Reporting System. Sixteen year-olds were compared with older drivers. RESULTS: During these years, the extent to which 16-year-old drivers were in fatal crashes decreased substantially compared with older age groups. The drop in the per capita crash rate for 16 year-olds was 26%. The major change was a reduction in crashes involving transporting young passengers, especially in jurisdictions with restrictions that target these crashes. There was no change in the proportion of fatal late-night crashes even in states restricting this activity. CONCLUSIONS: There has been some progress nationally in reducing the crash problem for 16 year-olds, but this still is a big problem. To achieve further progress, the gaps and weaknesses in present graduated licensing laws will need to be addressed.     

Manure sampling for nutrient analysis: variability and sampling efficacy

Reliable estimation of nutrient concentrations is required to manage animal manure for protecting waters while sustaining crop production. This study was conducted to investigate sample variability and reliable nutrient analysis for several manure types and handling systems. Serial samples were collected from dairy, swine, and broiler poultry operations while manure was being loaded onto hauler tanks or spreaders for field application. Samples were analyzed for total solids (TS), total nitrogen (N), ammoniacal nitrogen (NH4-N), total phosphorus (P), and potassium (K). The least number of samples needed for reliable testing of total N and P, defined as +/- 10% of the experimental means with 99% probability, was obtained for each farm using a computer-intensive random resampling technique. Sample variability within farms, expressed as the coefficient of variation (CV), was mostly 6 to 8% for farms that used agitation of manure storages but several times higher (20-30%) on farms where no agitation was applied during the sampling period. Results from the random resampling procedure indicated that for farms that used agitation, three to five samples were adequate for a representative composite for reliable testing of total N and P; whereas for farms without agitation, at least 40 samples would be required. Data also suggest that using book values for manure nutrient estimations could be problematic because the discrepancies between book standards and measured farm data varied widely from a small amount to several fold.