Interlaboratory evaluation of endotoxin analyses in agricultural dusts--comparison of LAL assay and mass spectrometry

Endotoxin exposure is associated with wheeze and asthma morbidity, while early life exposure may reduce risk of allergy and asthma. Unfortunately, it is difficult to compare endotoxin results from different laboratories and environments. We undertook this study to determine if lipopolysaccharide (LPS) extraction efficiency could account for differences among laboratories. We generated and collected aerosols from chicken and swine barns, and corn processing. We randomly allocated side-by-side filter samples to five laboratories for Limulus assay of endotoxin. Lyophilized aliquots of filter extracts were analyzed for 3-hydroxy fatty acids (3-OHFAs) as a marker of LPS using gas chromatography-mass spectrometry. There were significant differences in endotoxin assay and GC-MS (LPS) results between laboratories for all dust types (p < 0.01). Patterns of differences between labs varied by dust type. Relationships between assay and GC/MS results also depended on dust type. The percentages of individual 3-OHFA chain lengths varied across labs (p < 0.0001) suggesting that each lab recovered a different fraction of the LPS available. The presence of large amounts of particle associated LPS and absence of a freezing thawing cycle were associated with lower correlations between LPS and bioactivity, consistent with an absence of Limulus response to cell-bound endotoxin. These data suggest that extraction methods affect endotoxin measurements. The LAL methods may be most suitable when comparing exposures within similar environments; GC-MS offers additional information helpful in optimizing sample treatment and extraction. GC-MS may be of use when comparing across heterogeneous environments and should be considered for inclusion in future studies of human health outcomes.     

Influence of environmental parameters on the accuracy of nitrogen dioxide passive diffusion tubes for ambient measurement

Two studies at three sites in the UK provided confirmation that systematic positive bias in NO2 diffusion tube measurement occurred because of changes to "within-tube" chemistry, rather than eddy diffusion at the mouth of the tube. In the first study in Cambridge, UK, sampler overestimation for 1 and 2 week exposures was compared to corresponding time-averaged monitor measurements (NO-NO2-NOx, O3) and weather variables. Noninearity between sampler and monitor NO2 measurements was interpreted in terms of spatial and temporal variations in relative and absolute availability of NO, NO2 and O3 at the site. A maximum overestimation occurred for an exposure mean NO2/NOx approximately 0.5. The separate contributions of reduced NO2 photolysis and eddy diffusion were compared in Study II using samplers of two materials, acrylic and quartz, and of different lengths (40, 55, 71 and 120 mm) at three sites: Norwich background, Cambridge intermediate, London kerbside. For compared sites, NO2 measured by acrylic samplers was significantly higher than for equivalent quartz samplers. For quartz samplers [NO2]mean was only just above the monitor at Norwich and London; sampler/monitor NO2 = 1.04 (P = 0.59) and 1.01(P = 0.76), respectively. For acrylic samplers the order of [NO2]mean was 40 mm > 120 mm > 71 mm > or = 55 mm. Excepting 40 mm samplers, this accords with a chemical bias where co-diffusing NO and 03 molecules in longer tubes have more time to react to form excess NO2. Bias in 40 mm samplers is discussed. Eddy diffusion is negligible for standard samplers because [NO2]mean was equivalent for 55 mm and 71 mm acrylic samplers and close to monitor NO2 for 71 mm quartz tubes. Both studies showed that sampler accuracy was dependent on location. Significantly, overestimation was greatest (approximately 3-4 ppb) where the NO2 annual mean was approximately 20 ppb, close to the UK and EU air quality standard of 21 ppb.     

A framework for assessment and monitoring of arthropods in a lowland tropical forest

By applying principles of adaptive management, and by using the valuable information that arthropods provide from assessment and monitoring programs, managers can identify and reduce possible impacts on biodiversity in development projects. In 1996, the Smithsonian Institution's Monitoring and Assessment of Biodiversity program worked together with Shell Prospecting and Development Peru to establish an adaptive management program to protect biodiversity in a natural gas exploration project in a Peruvian rainforest. In this paper, we outlined the conceptual steps involved in establishing an assessment and monitoring program for arthropods, including setting objectives, evaluating the results and making decisions. We also present the results of the assessment using some of groups of arthropods, and summarize the steps taken to identify appropriate groups for monitoring.     

Current strategies in nitrite detection and their application to field analysis

The various analytical protocols that have been developed to aid the measurement of nitrite within environmental samples have been critically appraised and their applicability to field measurement assessed. The present communication presents a perspective on current techniques and technologies encompassing spectroscopic, electrochemical and chromatographic methodologies and highlights those that are liable to emerge in the near future. Commercial devices have been included and where appropriate the advantages and limitations posed by their operation within field contexts have been described.     

Should foliar cadmium concentrations be expressed on a dry weight or dry ash weight basis?

Foliar analysis is a valuable tool for evaluating the pollution status of forests. However, the use of foliar diagnosis in large-scale surveys is a complicated process owing to the high variability within the crown. The method used to express foliar concentrations has often been found to diminish the variability. The effect of the method used to express element concentrations on the spatial variability of cadmium (Cd) in the leaves of crack willow (Salix fragilis L.) was investigated by sampling the leaves of one willow at 292 locations in the crown, each sampling location having a volume of 0.027 m3 (0.3 m x 0.3 m x 0.3 m). Cadmium showed a distinct spatial trend in the crown of the tree. Concentrations as low as 2.4 mg kg(-1) dry weight (DW) or 23.1 mg kg(-1) dry ash weight (DAW) were obtained in the top of the crown, and 10.6 mg kg(-1) DW or 73.0 mg kg(-1) DAW in the bottom of the crown. The lower relative standard deviation and weaker correlation with the sampling height support the use of DAW in large-scale surveys especially. The lower variability of the DAW Cd concentration makes this variable less sensitive to fluctuations caused by differences in growing conditions and sampling methodology. However, the majority of publications in this field report metal concentrations on a DW basis. Therefore, the restrictions set on the use of results expressed on a DAW basis in large-scale surveys of foliar metal concentrations have to be offset against the advantages offered by a reduction of the variability in metal concentrations.     

Preliminary air pollution monitoring in San Miguel, Buenos Aires

Passive diffusion samplers were employed in San Miguel(Buenos Aires Metropolitan Area) for a preliminary airpollution monitoring. The highest loads were observedin downtown, compared with an urban background site.Total suspended particulate matter (TSPM) varied from0.257 to 0.033 mg cm^-2 month^-1; dust was examinedfor particle nature and size distribution. A similartrend was observed for nitrogen dioxide (NO₂) andTSPM spatial distribution, suggesting that traffic isthe major pollution source. Sulphur dioxide (SO₂)values were low and rather homogeneous. Levels for theinvestigated pollutants are below EPA's guide linevalues. Geographic (flat area, near to Rio de LaPlata) and climatologic factors (rainfalls andvariable wind directions) contribute to disperse pollutants.     

Measurements of fractionated gaseous mercury concentrations over northwestern and central Europe, 1995-99

Although it makes up only a few per cent. of total gaseous mercury (TGM) in the atmosphere, the fraction of oxidised (divalent) mercury plays a major role in the biogeochemical cycle of mercury due to its high affinity for water and surfaces. Quantitative knowledge of this fraction present in mixing ratios in the parts-per-10(15) (ppq) range is currently very scarce. This work is based on approximately 220 data for divalent gaseous mercury (DGM) collected during 1995-99 in ambient air. Over the course of the measurements, the sampling and analytical methods were modified and improved. This is described here in detail and includes transition from wet leaching and reduction procedures to thermo-reductive desorption, the use of annular as well as tubular denuders and adoption of an automated sampling system. The concentration of DGM exhibited a strong seasonal behaviour in contrast to atomic gaseous mercury, with low values in winter and maximum values in summer. The DGM/TGM ratios were frequently found to be below the detection limit (< or = 1%) and in the range 1-5%. A trend of diurnal DGM patterns was observed and implies photolytically induced sources. Scavenging of DGM during rain events was also noticed.     

Air pollution exposure monitoring and estimation. Part VI. Ambient exposure of adults in an industrialised region

This paper presents methodology and results of a dynamic individual air pollution exposure model (DINEX) that calculates the hourly exposure for each adult in a panel study. Each of over 260 participants, through the use of a diary, provided information used in the model to calculate his/her personal, individualised exposure. The participants filled out the diary daily, hour by hour, over two, two month periods. The exposure assessment model coupled the diary information and results of an indoor/outdoor measurement program, with the results of dispersion modelling on an hourly basis for an industrial area in Norway. The estimated air pollution concentrations from the dispersion model, based on continuous meteorological measurements, were calibrated with air pollutant concentrations measured continuously.     

Determination of Ni(CO)4, Fe(CO)5, Mo(CO)6, and W(CO)6 in sewage gas by using cryotrapping gas chromatography inductively coupled plasma mass spectrometry

Evidence for the occurrence of Ni(CO)4 in addition to Mo(CO)6 and W(CO)6 in fermentation gases from a municipal sewage treatment plant is presented for the first time. The gases were sampled at the top of the sewage sludge digester using Tedlar bags, and were analysed using cryotrapping followed by gas chromatography coupled with inductively coupled mass spectrometry (GC-ICP-MS). The use of an ICP-MS as an element-specific detector gives sufficiently low detection limits for metals and was coupled to a packed column gas chromatograph. This method provides information about the speciation of volatile transition metals in contrast to previously used methods for the determination of Ni(CO)4 in gas samples. The element-specific detection of three different isotopes (m/z 58, 60, 62) and the correspondence of the samples' retention times with those of the standard provided convincing evidence that Ni(CO)4 is present in the fermentation gas. The concentrations found were in the sub-ppb level, which is at least one order of magnitude lower than the threshold level of 1 ppb (v/v). In addition, Mo(CO)6 and W(CO)6 were also measured in the sub-ppb range in contrast to the absence of Fe(CO)5. The stabilities of Ni(CO)4, Fe(CO)5, and Mo(CO)6 were tested in a carbon monoxide atmosphere. In the presence of distilled water, the following order of stability was found after 11 weeks: Fe(CO)5 < Ni(CO)4 < Mo(CO)6. In the presence of an aqueous solution containing nickel, molybdenum, tungsten and iron, however, only Fe(CO)5 was significantly decomposed (< 0.3% recovery); Ni(CO)4 and Mo(CO)6 were stable after 11 weeks. No W(CO)6 was formed. The low stability of Fe(CO)5 in the presence of water could be the reason why no volatile iron compound was found in sewage gas. This study showed that GC-ICP-MS can be employed to identify species-specific traces of metal carbonyls in process gases such as sewage gas.     

The application of HPLC-F and GC-MS to the analysis of selected hydroxy polycyclic hydrocarbons in two certified fish bile reference materials

Four selected hydroxy polycyclic aromatic hydrocarbons (OH-PAHs), 2-hydroxy-naphthalene (2-OH-NPH), 1-hydroxy-phenanthrene (1-OH-PHE), 1-hydroxy-pyrene (1-OH-PYR) and 3-hydroxy-benzo[a]pyrene (3-OH-BaP) have been analysed in two certified fish bile reference materials (CRMs) for exposure monitoring of PAHs in the aquatic environment. The two materials, BCR 720 and BCR 721, consist of bile from fish exposed to contaminated sediment and dispersed crude oil, respectively. Both bile samples have been analysed by two different analytical techniques, gas chromatography-mass spectrometry (GC-MS) and high performance liquid chromatography-fluorescence detection (HPLC-F), and the separation performance, detection limits, recoveries and reproducibility for the four target compounds were evaluated. HPLC-F requires a simple sample preparation and the separation capacity is adequate for quantification of 1-OH-PYR and 3-OH-BaP. Detection limits are excellent for 1-OH-PYR (6 pg injected) and 3-OH-BaP (3 pg injected) and generally improved with increasing molecular size. Recoveries ranged from 48 to 99% for the four selected compounds, depending on compound and concentration. Sample preparation prior to GC-MS analysis was more demanding, as reflected by the obtained recoveries for 2-OH-NPH, 1-OH-PHE and 1-OH-PYR (35 to 61%). The sensitivity improved with decreasing molecular size, 2-OH-NPH (1.2 pg injected), 1-OH-PHE (2.4 pg injected) and 1-OH-PYR (6 pg injected). Because of the superior separation power of GC and the extra selectivity of MS detection, GC-MS was the method of choice for the determination of 2-OH-NPH and 1-OH-PHE in both CRMs. In fish bile samples these two compounds are more likely to suffer from chromatographic overlap, and HPLC-F was not sufficiently selective. Determination of 1-OH-PYR was performed with success by both methods, but HPLC-F would be preferred because of the simpler and less time-consuming sample preparation. Detectable concentrations of 3-OH-BaP were present in BCR 720 and could only be determined by HPLC-F. The present work aims to present HPLC-F and GC-MS as complementary methods for the quantitative analysis of OH-PAHs in fish bile.