市级生态保护红线生态补偿框架初探——以济南市为例

生态补偿对于协调经济发展和环境保护具有重要意义,不同层次的生态补偿都急需探索。其中市级生态补偿因为具有"利益相关者明确、涉及范围小、行政管理方便"等优点,更容易优先推进。文章以济南市为研究案例,探索分析了市级生态保护红线生态补偿的利益相关者和资金框架结构,确定了各区县间生态保护红线的生态补偿分配比例,为其他城市乃至省级生态保护红线的生态补偿提供借鉴。     

降水和风对大气PM2.5、PM10的清除作用分析

对合肥2015—2017年的降水、风和PM_(2.5)、PM_(10)浓度观测数据统计研究发现,降水对PM_(2.5)、PM_(10)有一定的清除作用,尤其在秋冬季节.秋冬季节小雨、中雨分别导致PM_(2.5)和PM_(10)浓度降低23.1%、40.4%和32.0%、63.7%.雨日PM_(2.5)/PM_(10)比例上升8.4%,表明降水对PM_(10)清除作用更显著.降水前后PM_(2.5)浓度变化与降水前PM_(2.5)浓度、降水强度、降水时长密切相关.当降水强度大于4 mm·h~(-1)或PM_(2.5)初始浓度高于115μg·m~(-3)时,降水对PM_(2.5)产生明显清除作用;而降水强度小于1 mm·h~(-1)或PM_(2.5)初始浓度低于115μg·m~(-3)时由于吸湿增长作用极易造成PM_(2.5)浓度反弹升高;且持续3 h以上雨强介于1～4 mm·h~(-1)的降水也对PM_(2.5)产生清除作用.降水前后PM_(10)浓度变化与初始浓度密切相关,而与雨强相关性较弱.当PM_(10)初始浓度大于50μg·m~(-3),降水就对PM_(10)产生明显清除作用,且PM_(10)初始浓度越高,降水后PM_(10)浓度下降越多.风速大于2 m·s~(-1)可显著降低PM_(2.5)浓度,因此,当风速大于4 m·s~(-1)时合肥较少出现中度及以上污染,但易造成地面起尘,使PM_(10)浓度不降反升.合肥冬季严重污染主要出现在西北风向,夏季中度以上污染天气较少,主要出现在风速低于3 m·s~(-1)的东南风向.     

预磁化强化ZnO@Fe3O4活化PMS降解AO7

为了研究预磁化对ZnO@Fe_3O_4活化过一硫酸盐(PMS)去除水中酸性橙7(AO7)性能的影响,考察了预磁化强度、ZnO@Fe_3O_4投量、PMS投量及初始pH对Mag-ZnO@Fe_3O_4/PMS体系降解AO7效果的影响.结果表明,当预磁化强度由0 T逐渐增大至2 T时,催化剂去除AO7的表观速率常数由0.0463 min~(-1)逐渐增大至0.1832 min~(-1),反应速率提高倍数达到1.4～4.0倍; Mag-ZnO@Fe_3O_4和PMS投量的增加对AO7的去除率均有提升效果,在最优条件下反应20 min后AO7的去除率达92%;体系初始pH对AO7降解有显著影响, pH为6～8条件下有利于Mag-ZnO@Fe_3O_4催化PMS氧化反应的进行.通过投加不同种类的猝灭剂,证实了AO7的降解主要是各种自由基共同作用的结果.经过预磁化处理后的催化剂产生感应磁场,从而影响了反应体系中自由基的复合概率,使得污染物被自由基氧化的速率提高.     

辽东湾潜在褐潮生物时空分布及环境关联

以18S rDNA V4区作为目标基因,利用自行设计的真核浮游植物鉴定引物V4（F/R）,结合高通量测序技术,对辽东湾2014年四季海水中真核浮游植物多样性进行了检测.结果发现了8种潜在褐潮生物：抑食金球藻、金牛微球藻、微拟球藻、颗粒微拟球藻、细小微胞藻、密球藻、普通小球藻、钙质角毛藻,其中前2种生态风险较高,主要分布在辽东湾西南、东南两侧.除抑食金球藻和细小微胞藻为混合营养型外,其他6种均为自养型.细小微胞藻丰度最高（平均161445个/L）,主要分布在秋季;其次是抑食金球藻、金牛微球藻（平均13912,13717个/L）,主要分布在春季;之后为钙质角毛藻、普通小球藻（平均5498,5234个/L）,主要分布在秋季;密球藻（平均1345个/L）,主要分布在夏季;微拟球藻、颗粒微拟球藻最少（平均56,44个/L）,冬季无分布.辽东湾潜在褐潮生物丰度与水温、水深、无机氮、N/P显著相关,其群落结构演替与环境因子关联性有待于进一步研究.     

Potential of secondary aerosol formation from Chinese gasoline engine exhaust

Light-duty gasoline vehicles have drawn public attention in China due to their significant primary emissions of particulate matter and volatile organic compounds(VOCs). However,little information on secondary aerosol formation from exhaust for Chinese vehicles and fuel conditions is available. In this study, chamber experiments were conducted to quantify the potential of secondary aerosol formation from the exhaust of a port fuel injection gasoline engine. The engine and fuel used are common in the Chinese market, and the fuel satisfies the China V gasoline fuel standard. Substantial secondary aerosol formation was observed during a 4–5 hr simulation, which was estimated to represent more than 10 days of equivalent atmospheric photo-oxidation in Beijing. As a consequence, the extreme case secondary organic aerosol(SOA) production was 426 ± 85 mg/kg-fuel, with high levels of precursors and OH exposure. The low hygroscopicity of the aerosols formed inside the chamber suggests that SOA was the dominant chemical composition. Fourteen percent of SOA measured in the chamber experiments could be explained through the oxidation of speciated single-ring aromatics. Unspeciated precursors, such as intermediate-volatility organic compounds and semi-volatile organic compounds, might be significant for SOA formation from gasoline VOCs. We concluded that reductions of emissions of aerosol precursor gases from vehicles are essential to mediate pollution in China.     

Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer

Solid phase reactions of Cr(Ⅵ) with Fe(0) were investigated with spherical-aberration-corrected scanning transmission electron microscopy(Cs-STEM) integrated with X-ray energy-dispersive spectroscopy(XEDS). Near-atomic resolution elemental mappings of Cr(Ⅵ)–Fe(0) reactions were acquired. Experimental results show that rate and extent of Cr(Ⅵ) encapsulation are strongly dependent on the initial concentration of Cr(Ⅵ) in solution. Low Cr loading in nZⅥ(1.0 wt%) promotes the electrochemical oxidation and continuous corrosion of n ZⅥ while high Cr loading(1.0 wt%) can quickly shut down the Cr uptake. With the progress of iron oxidation and dissolution, elements of Cr and O counter-diffuse into the nanoparticles and accumulate in the core region at low levels of Cr(Ⅵ)(e.g., 10 mg/L). Whereas the reacted n ZⅥ is quickly coated with a newly-formed layer of 2–4 nm in the presence of concentrated Cr(Ⅵ)(e.g., 100 mg/L). The passivation structure is stable over a wide range of pH unless pH is low enough to dissolve the passivation layer. X-ray photoelectron spectroscopy(XPS) depth profiling reconfirms that the composition of the newly-formed surface layer consists of Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxides with Cr(Ⅵ) adsorbed on the outside surface. The insoluble and insulating Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxide layer can completely cover the n ZⅥ surface above the critical Cr loading and shield the electron transfer. Thus, the fast passivation of nZⅥ in high Cr(Ⅵ) solution is detrimental to the performance of nZⅥ for Cr(Ⅵ) treatment and remediation.     

Long-term effects of sliver nanoparticles on the abundance and activity of soil microbiome

正Silver nanoparticles(Ag NPs)are among the most extensively used engineered nanomaterials because of their wellestablished antimicrobial and unique physicochemical properties(Yin et al.,2015).Applications of AgNPs have now been     

Relationship between physicochemical properties and dewaterability of hydrothermal sludge derived from different source

Sewage sludge (SS) and deinking sludge (DS) were used to comparatively study the hydrothermal dewatering of sludge with different components. For a better overview, an insight into the relationship between physicochemical properties and dewaterability of hydrothermal sludge was provided. Results found that not all kinds of sludge were suitably conditioned by hydrothermal treatment (HT) in term of the elevation of dewaterability. Higher hydrothermal temperature tended to enhance the dewaterability of SS rather than DS, which was supported by the variation of their physicochemical properties (including water distribution, bonding energy, extracellular polymeric substance (EPS), particles size, acid functional groups and zeta potential in this study). In addition, the changes in surface morphology suggested that the reverse effect of HT on sludge dewaterability was mainly due to their dewatering behavior. For SS, the destruction of EPS structure leaded to the release of bound water, thereby strengthening sludge dewatering. Conversely, “Bridging effect” generated by lignocellulose in DS was beneficial for sludge dewatering; however, the increasing hydrothermal temperature degraded part of lignocellulose and weakened “bridging effect”, finally resulting in worse dewaterability of DS.