Proposing of new building scheme and composite towards global warming mitigation for Malaysia

The building sector has been regarded as a potential sector where there is large capacity to reduce the climate change effect. This study has proposed solutions to mitigate environmental impacts and achieve low CO₂ emission from residential sector. Therefore, full life cycle assessment (LCA) has been run to assess the CO₂ emission and its effect on the atmosphere and climate change. Based on the result, timber scheme is the best choice due to releasing less CO₂ emissions to the atmosphere. However, house builders in Malaysia have almost completely neglected timber as a building material, with timber use as building components reduced to 5%. In this study, LCA Software was used to assess CO₂ emissions from different wall construction. The alternative building scheme has been made by reinforce steel stud, wooden beam and timber wall (S8) to improve the scheme deficiency while releasing less CO₂ emissions compared to other schemes. Therefore, S8 has a decreased CO₂ effect by 85% less than precast concrete frame and 90% less than brick over their lifetime. (S8) increased the load bearing compared to conventional timber beam. Thus, new scheme S8 could be replaced by current scheme and promote more adjustable scheme for Malaysian housing.     

Anti-oviposition activities of used sock media against a dengue vector: prospects of eco-friendly control and solutions to pollution

Yearly, huge amounts of sock refuse are discarded into the environment. Socks contain many molecules, and worn ones, which are rich in smell-causing bacteria, have a strong influence on animals’ behaviors. But the impacts of sock odor on the oviposition behavior of dengue vectors are unknown. We assessed whether Aedes albopictus changes its oviposition activity in response to the presence of used socks extract (USEx) in potential breeding grounds, using choice and no-choice bioassays (NCB). When furnished even chances to oviposit in two sites holding USEx and two others containing water (control), Ae. albopictus deposited significantly less eggs in USEx than in water sites. A similar pattern of oviposition preference was also observed when there were more oviposition options in water. When there were greater oviposition opportunities in USEx sites, Ae. albopictus oviposited preferentially in water. Females laid significantly more eggs during the NCB involving water than USEx. Also, significantly more mature eggs were retained by females in the NCB with USEx than in that with water. These observations strongly suggest the presence of molecules with either repellent or deterrent activities against Ae. albopictus females and provide an impetus to advocate the integration of used socks in dengue control programs. Such applications could be a realistic end-of-life recourse to reroute this waste from landfills.

     

Development and characterization of cell line from the gill tissue of Catla catla (Hamilton, 1822) for toxicological studies

Catla gill cell line (ICG) was established from gill tissue of Indian major carp (Catla catla), a freshwater fish cultivated in India. The cell line was maintained in Leibovitz’s L-15 supplemented with 10% fetal bovine serum. These cells have been sub-cultured more than 55 passages over a period of 2 years. The ICG cell line consists predominantly of epithelial-like cells. The cells were able to grow at a wide range of temperatures from 24 °C to 32 °C with an optimum temperature of 28 °C. The growth rate of gill cells increased as the fetal bovine serum (FBS) proportion increased from 2% to 20% at 28 °C with optimum growth at the concentrations of 10% or 15% FBS. Amplification of mitochondrial gene 12s rRNA using primers specific to C. catla confirmed the origin of this cell line from C. catla. The cells were successfully cryopreserved and revived at passage numbers 25, 35, 45 and 55. The cytotoxicity of three metal salts (ZnCl₂, CuSO₄ and CdCl₂) was assessed in ICG cell line using multiple endpoints such as MTT, Neutral Red assay, Alamar Blue assay and Coomassie Blue protein assay. Acute toxicity assay on fish were conducted by exposing C. catla for 96 h to three metal salts under static conditions. Statistical analysis revealed good correlation with r² = 0.908–0.985 for all combinations between endpoints employed. Linear correlations between each in vitro EC₅₀ and the in vivo LC₅₀ data were highly significant.     

Occurrence of ectoparasitic arthropods associated with rodents in Hail region northern Saudi Arabia

Ectoparasitic arthropods are a diverse element of the Saudi fauna. Due to this, a survey of ectoparasites associated with rodents was conducted as a preliminary study in five districts of Hail region of northern Saudi Arabia for the first time. Ectoparasites extracted from 750 rodents were sampled and identified by recording their frequency of appearance. Results revealed that 1,287 ectoparasites infested 316 of the captured rodent hosts. These ectoparasites parasitized on four species of rodents including three species of rats Rattus rattus rattus, Rattus rattus frugivorus, and Rattus rattus alexandrinus and one species of mouse Acomys dimidiatus (Rodentia: Muridae). The ectoparasites belong to four different groups: ticks, fleas, lice, and mites. Ticks were the highest in the number, while fleas were the lowest among all the extracted ectoparasite groups. The collected ectoparasitic arthropods consisted of seven species. Ticks were of two species: Rhipicephalus turanicus and Rhipicephalus sanguineus (Acari: Ixodidae), fleas were of two species: Xenopsylla cheopis and Xenopsyllus conformis mycerini (Siphonaptera: Pulicidae), lice was a single species: Polyplax serrata (Anoplura: Hoplopleuridae), and mites were of two species: Laelaps nuttali and Laelaps echidninus (Mesostigmata: Laelapidae). The findings of the study showed that the intensity of infestation was varied between rodent host sexes, wherein females had the highest rate of parasitic infestation, and the parasitic index of appearance was very high for one group of parasites (i.e., ticks). The parasitic prevalence was 42.13 % on rodents, and mites were the most prevalent parasite species. Overall, this study was carried out to establish baseline data for ectoparasite-infested rodents in Hail region, Saudi Arabia, and may help for appropriate planning to control zoonotic diseases in this area.     

Renewable energy in Australia: a wider policy discourse

ABSTRACT

This paper assesses the evolution of generation technology-mix in Australia, with specific emphasis on understanding how such evolution has been shaped by wider political and socio-economic influences. This assessment is predicated on the argument that the contemporary, quintessentially techno-economic, policy discourse on renewable energy is deficient, as it ignores climacteric political and socio-economic influences on generation technology-mix. The methodological framework employed in this paper is informed by the core tenets of technological change theory. The assessment suggests that generation technology-mix in Australia has historically been overwhelmingly influenced by the underlying technological paradigm of the electricity industry; and that this technological paradigm essentially draws its imprimatur from the wider political and socio-economic contexts. By implication, it suggests that a rapid uptake of renewables will have widespread ramifications, extending into political, socio-economic and cultural realms of a society. Clearly, existing policy discourse – that tends to focus on technical potentials, cost competitiveness, externalities and risks of various renewable technologies – is deficient. A much broader discourse is needed. This paper also made an attempt to develop a basis for such a discourse by reviewing broader aspects of the Australian society that would be affected by a rapid uptake of renewables.     

Performance of Cow Dung Reinforced Biodegradable Poly(Lactic Acid) Biocomposites for Structural Applications

In this work, performance of cow dung (CD) reinforced poly(lactic acid) (PLA) biocomposites was investigated for the potential use in load bearing application. CD of average 4 mm size was blended with PLA at different CD ratios (0–50 wt%) and their effects on the biocomposite properties were studied. The results showed an improvement in the flexural properties, while the tensile and impact strength dropped by 20 and 28% with the addition of 50% CD. The decline in the tensile and impact strength was due to micro-cracking and voids formation at higher CD content. Also, the incorporation of CD slightly decreased the thermal stability of the biocomposite. However, dynamic mechanical properties of the biocomposites generally improved. SEM analysis of tensile and impact fractured surfaces indicated that the CD had a reasonable adhesion with matrix. Moreover, the SEM micrographs of soil burial studies showed an accelerated degradation of higher CD wt% biocomposites.     

Polycyclic aromatic hydrocarbons and trace metals in mosque’s carpet dust of Riyadh,Saudi Arabia,and their health risk implications

The main objectives of this work were to identify and determine the concentrations of polycyclic aromatic hydrocarbons (PAHs) and trace metals in carpet dust samples from various mosques of the city of Riyadh and to assess the health risks associated with the exposure to these pollutants. Therefore, 31 samples of mosque’s carpet dust from Riyadh were collected. The results showed that 14 PAHs were present in the dust samples with concentrations ranged from 90 to 22,146 ng g^?1 (mean = 4096 ± 4277 ng g^?1) where low molecular weight compounds were dominant. The presence of PAHs were in the order of naphthalene > chrysene and benzo(b)fluoranthene > benzo(a)pyrene > acenaphthene and benzo(k)fluoranthene > pyrene and the absence of indeno(1,2,3-cd)pyrene and dibenz(a,h)anthracene. The diagnostic ratio coupled with principle component analysis (PCA) revealed mix sources of petrogenic from traffic, stack emission, and pyrogenic inputs from essence and perfumed wood burning. Trace metals were significant in the dust samples, and their concentrations decrease in the order of Zn, Mn, Cu, Cr, Pb, Ni, and V where Zn being the highest (94.4 ± 91.5 μg g^?1) and indium was the lowest (1.9 ± 9.3 μg g^?1). The trace metals were major in southern and central parts of Riyadh and followed the order of central Riyadh > southern Riyadh > western Riyadh > eastern Riyadh > northern Riyadh. Estimated risk based on the total PAHs was found to be 4.30 × 10^?11 for adult and 1.56 × 10^?11 for children. Elemental non-cancer risk for adults ranged from 7.9 × 10^?4 for Co to 7.58 × 10^?1 for Li and for children ranged from 3.70 × 10^?3 for Co to 3.54 for Li. Policy implication and mitigations of PAHs in Riyadh and Saudi Arabia were highlighted.     

The potentials of internalising social banking among the Malaysian Islamic banks

Islamic banking has established for the last 40 years, yet only recently researchers acknowledge social failures of Islamic banking and finance. This has led to a proposition of forming new forms of banking and non-banking institutions that include social banking. It is argued that in considering the developmentalist needs of the Muslim societies in Malaysia, there is a need to go back to fundamentals of Islamic finance in realising the aspirational Islamic moral economy that emphasises on the social good, capacity development at the individual and social levels. This paper aims to explore the concept of social banking and search for the possibilities for internalisation in Malaysian Islamic banking. To gain understanding on this pertinent issue, an empirical investigation was conducted at 17 Islamic banks in Malaysia. A mixed method was employed. For the primary data collection, 477 respondents of Islamic banks clients and employees participated in a self-administrated survey, and 11 respondents from the executive and managerial level of eight Islamic banks involved in a semi-structured interview survey. The integrated analysis implies that Islamic banking significantly contributes to socio-economic development. On the contrary, financial and economic practices in everyday life do not reflect the social economic justice. The result further illustrates that the Islamic banks lack social contributions as they prone to practice efficiency-oriented institutions. Hence, a social banking model is needed to solve the lack of socio-economic development issue in the current practice of Islamic bank.     

Arsenic in shallow aquifer in the eastern region of Bangladesh: insights from principal component analysis of groundwater compositions

Probable sources and mechanisms of arsenic (As) release in shallow aquifer in eastern Bangladesh are evaluated using statistical analysis of groundwater compositions. Dissolved As in 39 samples ranged from 8.05 to 341.5 μg/L with an average of 95.14 μg/L. Ninety seven percent of wells exceed the WHO limit (10 μg/L) for safe drinking water. Principal component analysis is applied to reduce 16 measured compositional variables to five significant components (principal components—PCs) that explain 86.63% of the geochemical variance. Two component loadings, namely PC 1 and PC 2 (45.31% and 23.05%) indicate the natural processes within the aquifers in which organic matter is a key reactant in the weathering reactions. Four groups of wells are defined by the PCA and each group of wells represents distinct physicochemical characteristics. Among them, group III groundwater shows higher As concentration together with high concentrations of Fe, Mn, dissolved organic carbon, $\text{PO}_{4}^{3-}$ and $\text{HCO}_{3}^{-}$ than groups I and II. Speciation calculations suggest that only wells of group III are saturated with respect to siderite, and all groups of samples are supersaturated with respect of rhodochrosite. The relationship of As with these parameters in the different groups of wells of the study area suggests that reductive dissolution of Fe–Mn oxyhydroxides with microbially mediated degradation of organic matter is considered to be the dominant processes to release As in groundwater.