Sorption-Desorption of Atrazine and Diuron in Soils from Southern Brazil

The objective of this study was to investigate the behavior of sorption and desorption of the herbicides atrazine (6-chloro-N ²-ethyl-N ⁴-isopropyl-1,3,5-triazine-2,4-diamine) and diuron [3-(3,4-dichlorophenyl)-1,1-dimethyleurea] in soil samples from a typical lithosequence located in the municipality of Mamborê (PR), southern Brazil. Five concentrations of ¹⁴C-atrazine and ¹⁴C-diuron were used for both herbicides (0.48, 0.96, 1.92, 3.84, and 7.69 mg L^?1). Sorption of both herbicides correlated positively with the organic carbon and clay content of the soil samples. Sorption isotherms were well described by the Freundlich model. The slope values of the isotherm (N) ranged from 0.84 to 0.90 (atrazine) and from 0.75 to 0.79 (diuron) for the lithosequence samples. Sorption of diuron was high regardless of the soil texture or the concentration added. The desorption isotherms for atrazine and diuron showed good fit to the Freundlich equation (R ² ≥ 0,87). Atrazine slope values for the desorption isotherms were similar for the different concentrations and were much lower than those observed for the sorption isotherms. Significant hysteresis was observed in the herbicide desorption. When the two herbicides were compared, it was found that diuron (N = 0.06–0.22) presented more pronounced hysteresis than atrazine. The results showed that, quantitatively, a greater atrazine fraction applied to these soils remains available to be leached in the soil profile, as compared to diuron.     

Report on International Affairs Committee

This is a report on Meetings of Representatives of National Air Pollution Preventions Associations to Consider the Establishment of an International Union, held in Washington, D. C, June 18–19, 1964 and Houston, Texas, June 21–22, 1964.     

The Effect of Fuel Composition on Atmospheric Aerosol Due to Auto Exhaust

Aerosols attributable to automobile exhaust can be classified as two types—primary aerosol (initially present in the exhaust) and secondary aerosol (generated photochemically from hydrocarbons and nitrogen oxides in the exhaust). In this study, investigation was made of possible effects of motor-fuel composition on the formation of these aerosols. Secondary aerosol, of principal interest in this work, was produced by irradiating auto exhaust in Battelle-Columbus’ 610 ft³ environmental chamber. A limited number of determinations of primary aerosol in diluted auto exhaust was made at the exit of a 36 ft dilution runnel. Determination of both primary and secondary aerosol was based on light-scattering measurements.

Exhaust was generated with seven full-boiling motor gasolines, both leaded and nonleaded, in a 1967 Chevrolet which was not equipped with exhaust-emission control devices. Changes in fuel composition produced a maximum factor of three difference in light scattering due to primary aerosol. Aerosol yields, for consecutive driving cycles on the same fuel, vary considerably; as a result, ranking the fuels on the basis of average primary aerosol yield was not very meaningful. In addition to fuel composition, the more important independent variables are initial SO₂ concentration, relative humidity and initial hydrocarbon concentration. Statistical analysis of the data indicates that the seven test fuels can be divided into two arbitrary groups with regard to secondary aerosol-forming potential. The fuels in the lower light-scattering group had aromatic contents of 15 and 21%, while those in the higher light-scattering group had aromatic contents of 25, 48, and 55%. Although the fuels can be grouped on the basis of a compositional factor, the grouping of fuels with aromatic content ranging from 25 to 55% indicates that this compositional factor cannot be equated simply with aromatic content. In an associated study of the aerosol-forming potential of individual hydrocarbons prominent in auto exhaust, it was observed that aromatics produce substantially more photochemical aerosol than olefins and paraffins. However, experiments with binar/hydrocarbon mixtures containing aromatjcs, as well as in these exhaust experiments, a strong dependence of aerosol yield on the aromatic components is is not observed. Thus, the data indicate that the dependence of secondary aerosol formation on fuel factors is a complex one and cannot be predicted solely on the basis of a sirigle hydrocarbon component reactivity scale.

The two types of automobile aerosol did not have the same dependence on fuel, composition. The variation in total light scattering attributable to primary plus secondary aerosol was less than that due to either component alone. It therefore was concluded that the light scattering due to automobile exhaust emissions in these experiments was not significantly affected by changing fuel composition.     

The Removal of Particulate Matter from Fluid Bed Catalytic Cracking Unit Stack Gases

The application of a high-efficiency centrifugal type of separator to fluid bed catalytic cracking units is described in which most of the catalyst particles often lost to the atmosphere are concentrated into a small part of the stack gas (2%). A further separation can then be made on this small stream by an auxiliary separator which further concentrates the catalyst particle into 0.1% of the initia stream. Performance of the main and auxiliary separators are such as to reduce the loss of catalyst particles in the stack gas from 800 ppm to less than 60 ppm in a typical unit. Large amounts of power can be recovered by application of expander turbines to catalytic cracking plants employing this system of separation.     

Kinetics study of fermentative hydrogen production from liquid swine manure supplemented with glucose under controlled pH

Kinetics of H₂ production from liquid swine manure supplemented with glucose by mixed anaerobic cultures was investigated using batch experiments under four different pH conditions (4.4, 5.0, 5.6, and uncontrolled). The temperature for the experiments was controlled at 37 ± 1°C and the length of experiments varied between 50 and 120 hours, depending upon the time needed for completion of each individual experiment. The modified Gompertz model was evaluated for its suitability for describing the H₂ production potential, H₂ production rate, and substrate consumption rate for all the experiments. The results showed that the Gompertz model could adequately fit the experimental results. The effect of pH was significant on all kinetic parameters for H₂ production including yield, production rate and lag time, and the substrate utilization rate. The optimal pH was found to be 5.0, at which a maximum H₂ production rate (0.64 L H₂/h) was obtained, and deviation from the optimal pH could result in substantial reductions in H₂ production rate (0.32 L H₂/h for pH 4.0 and 0.43 L H₂/h for pH 5.6). The results also showed that if pH was not controlled for the batch fermentation process, the substrate utilization efficiency could steeply decrease from 98.8% to 33.7%.     

Selection and application of a rainbow trout toxicity testing procedure for screening Sacramento River Watershed, California samples

A number of procedures have been developed to assess toxic effects on the early life stages of salmonid fish. In this study 13 rainbow trout embryo development relatively short-term (7 to 90 day) procedures were reviewed. Three 7-day methods from the published literature and three modifications developed at AQUA-Science (A-S) were evaluated in the laboratory. Based on that evaluation, A-S methods were selected for screening surface water samples (A-S 1) collected in the Sacramento River watershed (California) and for conducting toxicity identification evaluations (TIE) to identify cause(s) of toxicity. Test control performance, test sensitivity, and reference toxicant response variability in the A-S 1 were superior to those in commonly used freshwater toxicity testing methods. The incidence of Sacramento River watershed samples resulting in a notable decrease in embryo development was very low. Of 260 samples screened only 16 (6%) resulted in statistically significant inhibition of embryo development. Of the 16 toxic samples, nine caused minimal (less than 20% abnormal development) and four marginal (less than 30%) toxicity. Samples collected from the agriculture-dominated Colusa Basin Drain and rangeland/forest-dominated Battle Creek on June 16, 2005 caused significant toxicity. TIE procedures indicated that cationic chemicals were the primary cause of toxicity. Metals analysis did not reveal concentrations sufficient to inhibit embryo development, so the most probable cause of toxicity in the two samples was cationic chemicals (perhaps surfactants?) or metals that were not included in the analytical screening.     

Genetic, morphological, and chemical divergence in the sponge genus Latrunculia (Porifera: Demospongiae) from New Zealand

We undertook a comprehensive study of Latrunculia in New Zealand to determine the relationship between taxonomic, environmental, and chemical variation within the genus. Sponges were collected from five locations around New Zealand: Three Kings Islands, Tutukaka, Wellington, Kaikoura, and Doubtful Sound. Allozyme electrophoresis at nine polymorphic loci indicated that sponges from each geographic location were genetically distinct, and that they displayed genetic differences of the magnitude usually associated with reproductively isolated species (Nei's D between locations =0.375-2.476). Additionally, the comparisons revealed that the green and brown colour morphs of Latrunculia that are sympatric at Three Kings Islands and Kaikoura are distinct from each other, and that there are two genetic groups within the green sponges in Doubtful Sound. On the basis of genetic data we conclude that there are at least eight species of Latrunculia in New Zealand waters, not one to four as had been previously thought. Morphological comparisons of the eight genetic species based on skeletal characters (i.e. skeletal organisation of the choanosome, spicule composition, size, and geometry) indicated that the eight Latrunculia species fell into only two morphological groups that could be easily diagnosed on the basis of discorhabd type. Within these two primary morphological groups, skeletal characteristics among the eight species largely overlap and are not diagnostic. These findings emphasise the limitations of traditional taxonomic methods based solely on skeletal characters for distinguishing species of Latrunculia. However, multivariate analysis (MANOVA and CDA) based on six measured skeletal variables did reveal significant morphological variation among the species (Pillai's Trace=3.28, F=6.90, P<0.0001), supporting the division of the genus into eight species. Comparisons of chemical extracts from Latrunculia also showed that the amounts of five different bioactive compounds (discorhabdins A, B, C, D, and J) varied predictably among the eight species. This finding suggests that discorhabdin variation within Latrunculia, previously thought to be associated with intra-specific environmental variability, is more likely to reflect differences among species rather than phenotypic plasticity. Our results also highlight the importance of thorough taxonomic studies associated with marine natural products research to understand fully the variation in bioactive properties among individuals. The potential processes underlying the unusually high speciation rates in New Zealand Latrunculia that are indicated in our study are discussed.     

Evaluation of Tire-Derived Fuel for Use in Nitrogen Oxide Reduction by Reburning

ABSTRACT

Tire-derived fuel (TDF) was tested in a small-scale (44 kW or 150,000 Btu/hr) combustor to determine its feasibility as a fuel for use in reburning for control of nitrogen oxide (NO). TDF was gravity-fed into upward flowing combustion gases from a primary natural gas flame doped with ammonia to simulate a high NO combustion process. Emissions of NO, oxygen, carbon dioxide, carbon monoxide, and particulate matter were measured. The tests varied the nominal primary NO level from 600 to 1,200 ppm and the primary stoichiometry from 1.1 to 1.2, and used both natural gas and TDF as reburn fuels. The reburn injection rate was varied to achieve 8–20% of the total heat input from the reburn fuel. NO emissions reductions ranged between 20 and 63% when using TDF, depending upon the rate of TDF injection, primary NO, and primary stoichiometry. NO emission reductions when using natural gas as the reburn fuel were consistently higher than those when using TDF. While additional work remains to optimize the process and evaluate costs, TDF has been shown to have the potential to be a technically viable reburning fuel.     

Investigation of an Escherichia coli environmental benchmark for waterborne pathogens in agricultural watersheds in Canada

Canada's National Agri-Environmental Standards Initiative sought to develop an environmental benchmark for low-level waterborne pathogen occurrence in agricultural watersheds. A field study collected 902 water samples from 27 sites in four intensive agricultural watersheds across Canada from 2005 to 2007. Four of the sites were selected as reference sites away from livestock and human fecal pollution sources in each watershed. Water samples were analyzed for Campylobacter spp., Salmonella spp., Escherichia coli O157:H7, Cryptosporidium spp., Giardia spp., and the water quality indicator E. coli. The annual mean number of pathogen species was higher at agricultural sites (1.54 ± 0.07 species per water sample) than at reference sites (0.75 ± 0.14 species per water sample). The annual mean concentration of E. coli was also higher at agricultural sites (491 ± 96 colony-forming units [cfu] 100 mL(-1)) than at reference sites (53 ± 18 cfu 100 mL(-1)). The feasibility of adopting existing E. coli water quality guideline values as an environmental benchmark was assessed, but waterborne pathogens were detected at agricultural sites in 80% of water samples with low E. coli concentrations (<100 cfu 100 mL(-1)). Instead, an approach was developed based on using the natural background occurrence of pathogens at reference sites in agricultural watersheds to derive provisional environmental benchmarks for pathogens at agricultural sites. The environmental benchmarks that were derived were found to represent E. coli values lower than geometric mean values typically found in recreational water quality guidelines. Additional research is needed to investigate environmental benchmarks for waterborne pathogens within the context of the "One World, One Health" perspective for protecting human, domestic animal, and wildlife health.