Improving the Fenton process by visible LED irradiation

The effect of irradiation with visible light-emitting diode (LED) light on the efficiency of Fenton oxidation is investigated using phenol as the target compound (100 mg/L). The H₂O₂ dose and temperature are tested as operating variables with the aim of minimizing consumption of the reagents. At 50 °C, 10 mg/L Fe²⁺, and 60 % of the stoichiometric H₂O₂ amount, phenol was completely oxidized into CO₂, H₂O, and short chain organic acids, with oxalic acid completely degraded. Up to 95 % mineralization was achieved. This high efficiency can be attributed to the effect of LED radiation on the quinones/Fe²⁺/Fe³⁺/H₂O₂ cycle, which significantly increases the reaction rate, as well as on the photodecomposition of the iron complexes formed along the oxidation process, which also enhanced mineralization.     

Air Quality Management in Los Angeles: Perspectives on Past and Future Emission Control Strategies

The 1988 Air Quality Management Plan was approved by the Board of the California South Coast Air Quality Management District in March 1989. The District comprises the counties of Los Angeles, Orange, and Riverside, and the non-desert portion of San Bernardino county. Emissions reductions in the past have lead to significant improvement in air quality despite large increases in growth. However, the District, largely because of continuous growth, currently violates the air quality standards for ozone, carbon monoxide, nitrogen dioxide, and respirable particulate matter (PM₁₀). Based upon the AQMP, reduction of approximately 80 percent in emissions of oxides of nitrogen and volatile organic compounds is required to bring the District into compliance with all air quality standards in the next twenty years.

Achieving compliance will necessitate the use of advanced technologies, as well as some changes in lifestyle and management practices. Advanced technologies, including the use of electric vehicles powered by batteries or fuel cells, the use of cleaner burning fuels and advanced combustion modifications, and treatment of surface coatings and solvents are included in the AQMP. The Technology Advancement Office in the District was created to work with industry, universities, research institutes, and other local, state and federal agencies to identify, evaluate, and promote low emitting fuels and technologies. In addition to electricity, fuels burning cleaner than conventional gasoline or diesel are being tested to obtain emissions and durability data so that rational choices can be made for the future. Compressed natural gas, methanol and liquefied petroleum gas are considered to be cleaner burning fuels for current applications. Ethanol, butane, and various oxygenated blends are being evaluated, and the broader application of solar energy and hydrogen are being investigated.

The impact of various cleaner burning fuels on air quality is being addressed. To date, methanol is the only fuel for which results are available. These results indicate that methanol use in vehicles—with control of formaldehyde emissions below 15 mg/mile for light-duty vehicles—can provide air quality benefits for all criteria pollutants and certain air toxics. These benefits are greater for M₁₀₀ than M₈₅.

Several District advanced technology programs are described, including a reduction in emissions from paints and coatings, and the demonstration of electric vehicles.     

Female choice over short and long distances: neighbour effects

Fiddler crabs live at high densities and mate-searching females encounter many males at varying distances. Who is the ideal neighbour for a male? There could be a trade-off if having neighbours that invest more in sexual signals increases the rate at which females initially move towards a focal male, but thereafter decrease the likelihood that he is chosen rather than his neighbour. We used robotic crabs to test whether female choice for focal males (identical claw size/courtship wave rate) varied depending on the relative investment in sexual signals of their two neighbours and the distance at which she first saw the males. The neighbours’ phenotype did not affect which of two focal males she initially approached from long-range (50 cm). When a female initially saw a trio of males at a close-range (20 cm), she preferentially chose the focal male over neighbours that invested less in sexual signals (smaller claw/slower wave rate), but did not show a preference for the focal male over neighbours that invested more in sexual signals (larger claw/faster wave rate). However, a female that started to approach a focal male with neighbours that invest more in sexual signals from 50 cm was significantly less likely to choose the focal male than when she first saw the trio at 20 cm. Our results suggest that the initial distance at which males are seen partly determines how neighbours’ sexual signals affect male mating success. In general, if larger males can retain smaller neighbours they might therefore increase their mating success.     

An analysis of variables influencing the material composition of automobiles

The use of materials is studied broadly, because of the environmental problems related to extraction, production, consumption and waste treatment. The use and substitution of materials in products is therefore a relevant issue for environmental policy making. Studies have been done to describe the material flow or to measure the impact of materials or products on the environment. However, these studies do not often consider economic, substitution and dynamic aspects of material flows. Other studies on material flows analyse the relationship between the use of materials and economic growth, but they do not consider substitution between materials. For environmental policy making economic, technological and environmental aspects of the use of materials need to be considered. Especially, substitution of materials is important. In various countries material and product policies are imposed on a variety of materials and products. For evaluation of these policies their environmental and economic effects need to be examined in detail. This study aims to analyse the economic and technological factors influencing the use of materials and the substitution between different materials dynamically. The goal is to obtain an insight in the effect that material levies may have on the use and substitution of materials. The statistical analysis is performed on a specific product-group because decisions on the use of materials are taken on a product-level. The case study is performed on automobiles. The results show that the material use is largely an autonomous development. The price of aluminium has a positive, significant effect on the use of that material. The price of plastics has a positive, but not significant effect on the use of plastics. Reasons may be that the costs of a raw material are small relative to the processing costs, and that the production process can only be changed slowly. Other factors, like competitiveness and consumers' tastes, may be more important for substitution. This implies that levies or subsidies on certain materials is not a promising policy to change the use of materials. Besides time, there are two other factors that have a positive and significant relationship with the use of aluminium and plastics: the fuel efficiency, which is the distance driven divided by the energy used; and, the road tax, which depends on the weight of a car. However, these effects are caused by their positive relationship with time. The main conclusion of the case study is that imposing a levy on materials may not have the desired or expected effect of reduction in material use.     

Trace Gases and Particulate Matter Emissions from Wildfires and Agricultural Burning in Northeastern Mexico during the 2000 Fire Season

Abstract

An inventory of air pollutants emitted from forest and agricultural fires in Northeastern Mexico for the period of January to August of 2000 is presented. The emissions estimates were calculated using an emissions factor methodology. The inventory accounts for the emission of carbon monoxide (CO), methane, nonmethane hydrocarbons, ammonia, nitrogen oxides, and particulate matter (PM). Particulate matter emissions include estimates for fine PM and coarse PM. A total of 2479 wildfires were identified in the domain for the period of interest, which represented ~810,000 acres burned and 621,130 short tons emitted (81% being CO). The main source of information used to locate and estimate the extent of the fires came from satellite imagery. A geographic information system was used to determine the type of vegetation burned by each fire. More than 54% of the total area burned during the period of study was land on the State of Tamaulipas. However, >58% of the estimated emissions came from the State of Coahuila. This was because of the mix of vegetation types burned in each state. With respect to the temporal distribution, 76.9% of the fires occurred during the months of April and May consuming almost 78% of the total area burned during the period of study. Analysis of wind forward trajectories of air masses passing through the burned areas and 850-mb wind reanalyses indicate possible transboundary transport of the emissions from Mexico to the United States during the occurrence of the major wildfires identified.     

Comparing the effectiveness of education and technology in reducing wood smoke pollution: A field experiment

This study describes a field experiment assessing the effectiveness of education and technological innovation in reducing air pollution generated by domestic wood heaters. Two-hundred and twenty four households from a small regional center in Australia were randomly assigned to one of four experimental conditions: (1) Education only – households received a wood smoke reduction education pack containing information about the negative health impacts of wood smoke pollution, and advice about wood heater operation and firewood management; (2) SmartBurn only – households received a SmartBurn canister designed to improve combustion and help wood fires burn more efficiently, (3) Education and SmartBurn, and (4) neither Education nor SmartBurn (control). Analysis of covariance, controlling for pre-intervention household wood smoke emissions, wood moisture content, and wood heater age, revealed that education and SmartBurn were both associated with significant reduction in wood smoke emissions during the post-intervention period. Follow-up mediation analyses indicated that education reduced emissions by improving wood heater operation practices, but not by increasing health risk perceptions. As predicted, SmartBurn exerted a direct effect on emission levels, unmediated by wood heater operation practices or health risk perceptions.     

The potential leaching and mobilization of trace elements from FGD-gypsum of a coal-fired power plant under water re-circulation conditions

Experimental and geochemical modelling studies were carried out to identify mineral and solid phases containing major, minor, and trace elements and the mechanism of the retention of these elements in Flue Gas Desulphurisation (FGD)-gypsum samples from a coal-fired power plant under filtered water recirculation to the scrubber and forced oxidation conditions. The role of the pH and related environmental factors on the mobility of Li, Ni, Zn, As, Se, Mo, and U from FGD-gypsums for a comprehensive assessment of element leaching behaviour were also carried out. Results show that the extraction rate of the studied elements generally increases with decreasing the pH value of the FGD-gypsum leachates. The increase of the mobility of elements such as U, Se, and As in the FGD-gypsum entails the modification of their aqueous speciation in the leachates; UO₂SO₄, H₂Se, and HAsO₂ are the aqueous complexes with the highest activities under acidic conditions. The speciation of Zn, Li, and Ni is not affected in spite of pH changes; these elements occur as free cations and associated to SO₄² in the FGD-gypsum leachates. The mobility of Cu and Mo decreases by decreasing the pH of the FGD-gypsum leachates, which might be associated to the precipitation of CuSe₂ and MoSe₂, respectively. Time-of-Flight mass spectrometry of the solid phase combined with geochemical modelling of the aqueous phase has proved useful in understanding the mobility and geochemical behaviour of elements and their partitioning into FGD-gypsum samples.     

The potential leaching and mobilization of trace elements from FGD-gypsum of a coal-fired power plant under water re-circulation conditions

Experimental and geochemical modelling studies were carried out to identify mineral and solid phases containing major, minor, and trace elements and the mechanism of the retention of these elements in Flue Gas Desulphurisation (FGD)-gypsum samples from a coal-fired power plant under filtered water recirculation to the scrubber and forced oxidation conditions. The role of the pH and related environmental factors on the mobility of Li, Ni, Zn, As, Se, Mo, and U from FGD-gypsums for a comprehensive assessment of element leaching behaviour were also carried out. Results show that the extraction rate of the studied elements generally increases with decreasing the pH value of the FGD-gypsum leachates. The increase of the mobility of elements such as U, Se, and As in the FGD-gypsum entails the modification of their aqueous speciation in the leachates; UO₂SO₄, H₂Se, and HAsO₂ are the aqueous complexes with the highest activities under acidic conditions. The speciation of Zn, Li, and Ni is not affected in spite of pH changes; these elements occur as free cations and associated to SO₄ ² in the FGD-gypsum leachates. The mobility of Cu and Mo decreases by decreasing the pH of the FGD-gypsum leachates, which might be associated to the precipitation of CuSe₂ and MoSe₂, respectively. Time-of-Flight mass spectrometry of the solid phase combined with geochemical modelling of the aqueous phase has proved useful in understanding the mobility and geochemical behaviour of elements and their partitioning into FGD-gypsum samples.     

Evaluating Terrestrial Carbon Sequestration Options for Virginia

Changes in forest and agricultural land management practices have the potential to increase carbon (C) storage by terrestrial systems, thus offsetting C emissions to the atmosphere from energy production. This study assesses that potential for three terrestrial management practices within the state of Virginia, USA: afforestation of marginal agricultural lands; afforestation of riparian agricultural lands; and changing tillage practices for row crops; each was evaluated on a statewide basis and for seven regions within the state. Lands eligible for each practice were identified, and the C storage potential of each practice on those lands was estimated through a modeling procedure that utilized land-resource characteristics represented in Geographic Information System databases. Marginal agricultural lands’ afforestation was found to have the greatest potential (1.4 Tg C yr⁻¹, on average, over the first 20 years) if applied on all eligible lands, followed by riparian afforestation (0.2 Tg C yr⁻¹ over 20 years) and tillage conversion (0.1 Tg C yr⁻¹ over 14 years). The regions with the largest potentials are the Ridge and Valley of western Virginia (due to extensive areas of steep, shallow soils) and in the Mid-Atlantic Coastal Plain in eastern Virginia (wet soils). Although widespread and rapid implementation of the three modeled practices could be expected to offset only about 3.4% of Virginia’s energy-related CO₂ emissions over the following 20 years (equivalent to about 8.5% of a Kyoto Treaty–based target), they could contribute to achievement of C-management goals if implemented along with other mitigation measures.