Influence of environmental parameters on the accuracy of nitrogen dioxide passive diffusion tubes for ambient measurement

Two studies at three sites in the UK provided confirmation that systematic positive bias in NO2 diffusion tube measurement occurred because of changes to "within-tube" chemistry, rather than eddy diffusion at the mouth of the tube. In the first study in Cambridge, UK, sampler overestimation for 1 and 2 week exposures was compared to corresponding time-averaged monitor measurements (NO-NO2-NOx, O3) and weather variables. Noninearity between sampler and monitor NO2 measurements was interpreted in terms of spatial and temporal variations in relative and absolute availability of NO, NO2 and O3 at the site. A maximum overestimation occurred for an exposure mean NO2/NOx approximately 0.5. The separate contributions of reduced NO2 photolysis and eddy diffusion were compared in Study II using samplers of two materials, acrylic and quartz, and of different lengths (40, 55, 71 and 120 mm) at three sites: Norwich background, Cambridge intermediate, London kerbside. For compared sites, NO2 measured by acrylic samplers was significantly higher than for equivalent quartz samplers. For quartz samplers [NO2]mean was only just above the monitor at Norwich and London; sampler/monitor NO2 = 1.04 (P = 0.59) and 1.01(P = 0.76), respectively. For acrylic samplers the order of [NO2]mean was 40 mm > 120 mm > 71 mm > or = 55 mm. Excepting 40 mm samplers, this accords with a chemical bias where co-diffusing NO and 03 molecules in longer tubes have more time to react to form excess NO2. Bias in 40 mm samplers is discussed. Eddy diffusion is negligible for standard samplers because [NO2]mean was equivalent for 55 mm and 71 mm acrylic samplers and close to monitor NO2 for 71 mm quartz tubes. Both studies showed that sampler accuracy was dependent on location. Significantly, overestimation was greatest (approximately 3-4 ppb) where the NO2 annual mean was approximately 20 ppb, close to the UK and EU air quality standard of 21 ppb.     

Forest Area in Costa Rica: A Comparative Study of Tropical Forest Cover Estimates over Time

Forest area figures, at a given point in time and for a given region of interest, differ considerably, affecting the calculation of deforestation rates and thus confuse the political and scientific discussion on the state and change of the resource forest. This article discusses the variation of published forest cover figures, using Costa Rica as an example. A list of published figures on the forest cover of Costa Rica from 1940 onwards is analyzed. Reasons for the differences are hypothesized and discussed. These differences are mainly in the definition of forest and forest classes included, in the type of the studies conducted (mapping and/or sampling), in the precision of the estimates, and in the information sources used. It is concluded that part of the problem is inherent in the nature of the resource `forest'. Quality and completeness of the presentation of the forest cover estimates are a clue to their correct understanding and interpretation. The latter point being especially relevant, as forest cover data have both a technical-scientific and a political meaning and are used as relevant arguments in many discussions. In the example of Costa Rica, a general downward trend is observed up to about 1985/1990, whereas after that forest area figures are on the average at a markedly higher level. Some hypotheses for this change in the trend are discussed.     

A framework for assessment and monitoring of arthropods in a lowland tropical forest

By applying principles of adaptive management, and by using the valuable information that arthropods provide from assessment and monitoring programs, managers can identify and reduce possible impacts on biodiversity in development projects. In 1996, the Smithsonian Institution's Monitoring and Assessment of Biodiversity program worked together with Shell Prospecting and Development Peru to establish an adaptive management program to protect biodiversity in a natural gas exploration project in a Peruvian rainforest. In this paper, we outlined the conceptual steps involved in establishing an assessment and monitoring program for arthropods, including setting objectives, evaluating the results and making decisions. We also present the results of the assessment using some of groups of arthropods, and summarize the steps taken to identify appropriate groups for monitoring.     

Seasonal variations in nickel and vanadium in Mont Blanc snow and ice dated from the 1960s and 1990s

Ni and V have been determined in snow and ice collected at a high altitude location (Col du D?me) near the summit of Mont Blanc on the French-Italian border; dated from the 1960s and 1990s. Ni and V were simultaneously determined by inductively coupled plasma sector field mass spectrometry. Measured concentrations range from 6 to 700 pg g(-1) and 4 to 1,100 pg g(-1) for Ni and V, respectively. The results show pronounced seasonal variations in the concentrations of both metals, with high concentration values in summer layers and much lower values for winter layers. These seasonal variations are linked especially with the existence of inversion layers during winter months. Ni and V concentrations in excess of the contributions from rock and soil dust (Ni(excess), V(excess)) appear to be mainly associated with anthropogenic inputs, with pronounced seasonal variations. Large variations in the V(excess)/Ni(excess) ratio are observed, with a higher ratio in summer than in winter. This shows differences in anthropogenic inputs at Col du D?me during the different parts of the year. The above ratio was compared with the corresponding ratios for oil combustion from stationary sources and the exhaust from gasoline and diesel engines. It appears that Ni and V concentrations at Col du D?me are probably the result of changing combinations of contributions from oil combustion for power generation, industrial and residential uses, on one side, and automobile and truck traffic, on the other side, with possibly a significant contribution from Ni smelters in Russia during winter months.     

Pollen allergy related to the area of residence in the city of Córdoba,south-west Spain

The aim of this study was to analyse the relationship between the distribution of hay-fever patients in the city of Córdoba, south-western Iberian Peninsula, and the specific atmospheric biological content originating from local sources. Four different districts were established in the metropolitan area of the city, according to vegetational and urbanistic characteristics. Air samples were taken in each area using portable Hirst-type samplers (Lanzoni VPPS 1000) and the spectrum of biological content was defined. Patients attending the Allergy Unit at Córdoba Teaching Hospital in 2000 with allergic rhinitis and/or asthma, and displaying a positive reaction to aeroallergen extracts, were distributed within the areas as a function of their district of residence. Aerobiological results revealed differences in pollen content between areas, in terms of both quantity and number of pollen types recorded. These differences were largely due to proximity to rural areas, prevalence of pollen from typically urban species and the possible effect of urban architecture as a barrier to the dispersal/ concentration of particles and other pollutants. Patients were not uniformly distributed within the city. The majority lived in districts in which pollen from rural species was mixed with pollen from ornamentals. Patients living in typically urban districts displayed a higher prevalence of allergy to pollen from ornamentals. It is concluded that a high degree of exposure to the same environment may influence the development of sensitisation to the particular pollen load associated with that area.     

Should foliar cadmium concentrations be expressed on a dry weight or dry ash weight basis?

Foliar analysis is a valuable tool for evaluating the pollution status of forests. However, the use of foliar diagnosis in large-scale surveys is a complicated process owing to the high variability within the crown. The method used to express foliar concentrations has often been found to diminish the variability. The effect of the method used to express element concentrations on the spatial variability of cadmium (Cd) in the leaves of crack willow (Salix fragilis L.) was investigated by sampling the leaves of one willow at 292 locations in the crown, each sampling location having a volume of 0.027 m3 (0.3 m x 0.3 m x 0.3 m). Cadmium showed a distinct spatial trend in the crown of the tree. Concentrations as low as 2.4 mg kg(-1) dry weight (DW) or 23.1 mg kg(-1) dry ash weight (DAW) were obtained in the top of the crown, and 10.6 mg kg(-1) DW or 73.0 mg kg(-1) DAW in the bottom of the crown. The lower relative standard deviation and weaker correlation with the sampling height support the use of DAW in large-scale surveys especially. The lower variability of the DAW Cd concentration makes this variable less sensitive to fluctuations caused by differences in growing conditions and sampling methodology. However, the majority of publications in this field report metal concentrations on a DW basis. Therefore, the restrictions set on the use of results expressed on a DAW basis in large-scale surveys of foliar metal concentrations have to be offset against the advantages offered by a reduction of the variability in metal concentrations.     

Measurements of fractionated gaseous mercury concentrations over northwestern and central Europe, 1995-99

Although it makes up only a few per cent. of total gaseous mercury (TGM) in the atmosphere, the fraction of oxidised (divalent) mercury plays a major role in the biogeochemical cycle of mercury due to its high affinity for water and surfaces. Quantitative knowledge of this fraction present in mixing ratios in the parts-per-10(15) (ppq) range is currently very scarce. This work is based on approximately 220 data for divalent gaseous mercury (DGM) collected during 1995-99 in ambient air. Over the course of the measurements, the sampling and analytical methods were modified and improved. This is described here in detail and includes transition from wet leaching and reduction procedures to thermo-reductive desorption, the use of annular as well as tubular denuders and adoption of an automated sampling system. The concentration of DGM exhibited a strong seasonal behaviour in contrast to atomic gaseous mercury, with low values in winter and maximum values in summer. The DGM/TGM ratios were frequently found to be below the detection limit (< or = 1%) and in the range 1-5%. A trend of diurnal DGM patterns was observed and implies photolytically induced sources. Scavenging of DGM during rain events was also noticed.     

A ten channel fibre-optic device for distributed sensing of underground hydrocarbon leakage

With millions of fuel storage tanks and oil pipelines installed around the world, there is inevitably frequent leakage of potentially hazardous hydrocarbons. As many of these installations are below ground, it can often be many years before the extent of the leak is discovered. We have previously reported the development of a sensor for the detection of such subterranean leaks, using infrared reflectometry to interrogate a hydrocarbon sensitive membrane. However, a single sensor cannot provide any information about the flow rate or direction of the leak. This paper describes the extension of the technology to a multi-channel distributed sensing system, using optical fibres capable of distributing the sensors over large subterranean areas. Results are reported from the evaluation of the device, which consisted of monitoring the movement of different hydrocarbons (gasoline, diesel and insulating oil) through a vertical sand-filled vessel.     

Study of the relationships between bone lead levels and its variation with time and the cumulative blood lead index, in a repeated bone lead survey

The study aims were to: (i) investigate long term human lead metabolism by measuring the change of lead concentration in the tibia and calcaneus; and (ii) assess whether improved industrial hygiene was resulting in a slow accumulation of lead in an exposed workforce. 109Cd excited K X-ray fluorescence was used to measure tibia lead and calcaneus lead concentrations in 101 workers in a secondary lead smelter. 51 subjects had had similar bone lead measurements 5 years previously. Most of the other subjects had been hired since the first survey. Measurements of whole blood lead were available for the large majority of subjects. Tibia lead concentrations fell significantly (p<0.001) in the 51 subjects with repeated bone lead measurements, from a mean of 39 microg Pb (g bone mineral)(-1) to 33 microg Pb (g bone mineral)(-1). The change correlated negatively with the initial tibia lead concentration, producing an estimate for an overall half-life of 15 years, with a 95% confidence interval of 9 to 55 years. Adding continuing lead exposure and recirculation of bone lead stores to the regression models produced half-life estimates of 12 and 9 years, respectively, for release of lead from the tibia. The repeat subjects showed no net change in calcaneus lead (64 microg Pb (g bone mineral)(-1) initially, 65 microg Pb (g bone mineral)(-1) 5 years later). Subjects not measured previously had average lead concentrations of 15 microg Pb (g bone mincral)(-1) in the tibia and 13 microg Pb (g bone mineral)(-1) in the calcaneus. The rate of clearance of lead from the tibia (9 to 15 years) is towards the more rapid end of previous estimates. The lack of a significant fall in the calcaneus lead was surprising. Attempts should be made to repeat this observation. If confirmed, it would have implications for models of lead metabolism. The relatively low lead concentrations in the non-repeat subjects are reassuring. However, observation after a longer period of employment would be desirable.     

Detecting and characterising sources of persistent organic pollutants (PAHs and PCBs) in surface sediments of an industrialized area (harbour of Trieste, northern Adriatic Sea)

A sediment sampling based on a two-dimensional mapping was performed in the harbour of Trieste (northern Adriatic Sea), considering 28 sites exposed to pollutant inputs from harbour and industrial activities. Polycyclic aromatic hydrocarbons (PAHs) and polychlorinated biphenyls (PCBs) were determined in surface sediments, because these very persistent pollutants seem to be responsible for the depletion of benthic populations observed in this area. The correlation matrix indicates that PAHs and PCBs are non-correlated, and probably have different sources. Both cluster analysis performed on the sampling sites and graphical drawing of the PAH sediment contents make it possible to locate along the shoreline a band of more polluted sediments, clustered around a site facing a steelmaking factory, to be considered as the main source point for PAHs. The evaluation of phenanthrene to anthracene (P/AN) and fluoranthene to pyrene (FL/PY) ratios permits the assessment of the pyrolytic, industrial origin of these PAHs, rejecting a second possible source of hydrocarbons (i.e., an oil-pipeline terminal, situated near the steelmaking factory). Graphical drawing of the total PCB iso-concentrations reveals a different source-point for this other category of very persistent pollutants.