Thermal destruction of wastes containing polychlorinated naphthalenes in an industrial waste incinerator

A series of verification tests were carried out in order to confirm that polychlorinated naphthalenes (PCNs) contained in synthetic rubber products (Neoprene FB products) and aerosol adhesives, which were accidentally imported into Japan, could be thermally destroyed using an industrial waste incinerator. In the verification tests, Neoprene FB products containing PCNs at a concentration of 2800 mg/kg were added to industrial wastes at a ratio of 600 mg Neoprene FB product/kg-waste, and then incinerated at an average temperature of 985 °C. Total PCN concentrations were 14 ng/m³N in stack gas, 5.7 ng/g in bottom ash, 0.98 ng/g in boiler dust, and 1.2 ng/g in fly ash. Destruction efficiency (DE) and destruction removal efficiency (DRE) of congener No. 38/40, which is considered an input marker congener, were 99.9974 and 99.9995 %, respectively. The following dioxin concentrations were found: 0.11 ng-TEQ/m³N for the stack gas, 0.096 ng-TEQ/g for the bottom ash, 0.010 ng-TEQ/g for the boiler dust, and 0.072 ng-TEQ/g for the fly ash. Since the PCN levels in the PCN destruction test were even at slightly lower concentrations than in the baseline test without PCN addition, the detected PCNs are to a large degree unintentionally produced PCNs and does not mainly stem from input material. Also, the dioxin levels did not change. From these results, we confirmed that PCNs contained in Neoprene FB products and aerosol adhesives could be destroyed to a high degree by high-temperature incineration. Therefore, all recalled Neoprene FB products and aerosol adhesives containing PCNs were successfully treated under the same conditions as the verification tests.     

Condition-dependent sex allocation by clones of a galling aphid

Local mate competition (LMC) has been postulated to be the primary factor of female-biased sex allocation. In animals such as aphids that exhibit seasonal alternations of clonal and sexual reproduction, there is a high possibility of intra-clonal mating and LMC. This possibility is more plausible for more fecund clones, but outbreeding is predicted for less fecund clones. We hypothesize that clones that are more fecund will gain higher fitness returns by reducing investment in males because of more intense LMC among clonal males. We tested this hypothesis by elucidating the clonal sex allocation patterns of the galling aphid Kaltenbachiella japonica, in which inbreeding and LMC appear to be common. Winged mothers that emerge from a gall, belonging to the same clone, produced males and sexual females asexually on a branch, without dispersing to other trees. The heavier the gall, the more winged mothers were produced from the gall. Individual mothers produced a constant number of males and a variable number of females. The clonal sex allocation to males was 39.8?%, on average, and decreased with increasing gall weight. This result showed that clones that were more fecund exhibited more female-biased sex allocation and thus supported our hypothesis. Furthermore, our results corroborated Stubblefield and Seger’s hypothesis for sex allocation in patch structure rather than Yamaguchi’s constant male hypothesis. We conclude that K. japonica clones are able to adjust their sex allocation patterns adaptively depending on the quality of resources in the galls.     

In-use polybrominated diphenyl ether (PBDE) stocks and atmospheric emissions in Japan

We estimated the in-use stocks of polybrominated diphenyl ethers (PBDEs) in Japan using a population balance model. The estimation is based on the domestic demand of PBDEs and the assumed survival rate of these products. Two cases relevant to the future regulation of commercial deca-BDE are considered, namely (1) deca-BDE declines at the same rate as the current rate of decline, and (2) deca-BDE is discontinued after 2020. The estimates of the decreasing rates of in-use penta-, octa-, and deca-BDE stocks were proportional with the measured decreases in the atmospheric concentrations of these substances. The in-use penta- and octa-BDE stocks could be depleted in the near future (500 and 60 tonne in 2013, and an estimated 20 and <1 tonne in 2020, respectively). Relevant to case 1, the in-use stocks of deca-BDE-containing products would be 28,000 tonne in 2013 and an estimated 1900 tonne in 2040, providing an ongoing source of deca-BDE emission to the environment. On the other hand, relevant to case 2, most of the deca-BDE would be phased out by 2040. The atmospheric emissions of deca-BDE were predicted at 84–841 kg/year in 2013 and an estimated 43–425 kg/year in 2020.     

Waste prevention for sustainable resource and waste management

Although the 2Rs (reduce and reuse) are considered high-priority approaches, there has not been enough quantitative research on effective 2R management. The purpose of this paper is to provide information obtained through the International Workshop in Kyoto, Japan, on 11–13 November 2015, which included invited experts and researchers in several countries who were in charge of 3R policies, and an additional review of 245 previous studies. It was found that, regarding policy development, the decoupling between environmental pressures and economy growth was recognized as an essential step towards a sustainable society. 3R and resource management policies, including waste prevention, will play a crucial role. Approaches using material/substance flow analyses have become sophisticated enough to describe the fate of resources and/or hazardous substances based on human activity and the environment, including the final sink. Life-cycle assessment has also been developed to evaluate waste prevention activities. Regarding target products for waste prevention, food loss is one of the waste fractions with the highest priority because its countermeasures have significant upstream and downstream effects. Persistent organic pollutants and hazardous compounds should also be taken into account in the situation where recycling activities are globally widespread for the promotion of a material-cycling society.     

Evaluation of the water quality of the Hakata River based on diatoms

We investigated the epilithic diatom assemblage of samples collected from three sites of the Hakata River, Fukuoka, Japan, on November 26, 2008. Each taxon was photographed and identified. The 1747 diatom frustules collected were classified into 33 taxa belonging to 17 genera. Nitzschia fonticola was abundant at all sites. The DAIpo (the diatom assemblage index to organic water pollution) values for sites 1, 2, and 3 were 50.2, 44.1 and 48.0, respectively, indicating that the water quality of the Hakata River was at β-mesosaprobic level.     

Demonstration study of high temperature melting for asbestos-containing waste (ACW)

The service life of many buildings and houses built using asbestos-containing materials is coming to an end and their demolition will lead to a great deal of asbestos-containing waste (ACW). Conventionally, the disposal of such waste is conducted by isolation under controlled landfill procedures; however problems with this method exist, such as the risk at the time of re-utilization of landfill sites and the depletion of lands to be reclaimed. Melting treatment is a promising technology that could be used to solve these problems; a thermal process involving temperatures exceeding the melting points of asbestos, it transforms them into non-hazardous minerals. This technology may be applicable not only for friable ACW but also for nonfriable ACW. We performed a demonstration test of melting treatment of nonfriable ACW using a gasification and melting furnace of the shaft furnace type, which is a typical method for high temperature melting. Detailed observation using transmission electron microscopy as well as general analyses verified that the same level of asbestos remained in the slag obtained by high temperature melting as that of the background soil. In addition, the asbestos concentration in the exhaust gas and the dust from the facility were at sufficiently low levels, and it was thus verified that the asbestos concentration in the atmosphere in the vicinity of the facility during the melting treatment was comparable to that of Japan’s background level reported by the Ministry of the Environment in 2007.     

Advanced sensing technology in environmental field

Before the introduction of advanced sensing technology in environmental fields, environmental issues were discussed as several categories, such as local environmental issues in the 1970s, global environmental issues in the 1980s, living environmental issues in the 2000s and environmental stress issues in near future, which are of increasing interest in Japan. Using advanced sensing technologies, such as electrochemical sensors, chemically-sensitive field-effect transistors (ChemFETs) based on micro-electro mechanical system (MEMS) micromachining technology and subsequently electrophoretic separation and microfluidic Lab-on-a-Chip using MEMS technology, we have steered several kinds of environmental monitoring projects timely in response to the environmental issues for over the last 25 years. Among the local environmental issues, the global environmental issues and the living environmental issues, some fruits of R&D project will be introduced. Finally, our latest concern of the environmental stress monitoring was discussed and preliminary results were also introduced.     

Unit-charging programs for municipal solid waste in Japan

Unit-charging programs known as pay-as-you-throw (PAYT) for municipal solid waste in Japan were surveyed. The number of municipalities that have implemented PAYT for combustible waste totaled 954 (30%) in 2003. The introduction of PAYT programs peaked in the early 1970s and again in the 1990s. PAYT has tended to be adopted by municipalities with small populations (less than 30,000). PAYT charging systems can be roughly divided into two groups: simple unit-pricing programs and two-tiered pricing programs. It is difficult to see the relationship between PAYT and waste reduction by simple inspection of the overall changes throughout Japan. Case studies of four municipalities showed that the implementation of PAYT programs reduced the amount of residual waste generated by 20% to 30%. In combination with other measures, especially the recycling of containers and packaging, PAYT programs can bring about a dramatic reduction in waste.     

Abiotic reduction of antimony(V) by green rust (Fe(4)(II)Fe(2)(III)(OH)(12)SO(4).3H(2)O)

Green rust (Fe(4)(II)Fe(2)(III)(OH)(12)SO(4).3H(2)O) is an intermediate phase in the formation of iron (oxyhydr)oxides such as goethite, lepidocrocite, and magnetite. It is widely considered that green rust occurs in many soil and sediment systems. Green rust has been shown to reduce sorbed Se(VI), Cr(VI), and U(VI). In addition, it is also reported that green rust does not reduce As(V) to As(III). In this study, we have investigated for the first time the interaction between Sb(V) and green rust using XAFS and HPLC-ICP-MS. Most of the added Sb(V) was adsorbed on green rust, and Sb(III), a reduced form, was observed in both solid and liquid phases. Thus, it was shown that green rust has high affinity for Sb(V), and that Sb(V) was reduced to more toxic Sb(III) by green rust despite the high stability of the Sb(V) species even under reducing condition as reported in previous studies. Therefore, green rust can be one of the most important reducing agents for Sb(V), which can influence the Sb mobility in suboxic environments where green rust is formed.     

Temporal trends and sources of PCDD/Fs, pentachlorophenol and chlornitrofen in paddy field soils along the Yoneshiro River basin, Japan

In order to understand the long-term behaviors of polychlorinated dibenzo-p-dioxins (PCDDs), polychlorinated dibenzofurans (PCDFs), pentachlorophenol (PCP), and 2,4,6-trichlorophenyl-4′-nitrophenyl ether (chlornitrofen, CNP) in paddy soil, we measured their concentrations in paddy soil samples collected in 1982 and 1984 (1980s) and in 2000 and 2002 (2000s) from the Yoneshiro River basin, Japan. The concentrations of PCP and CNP decreased from the 1980s to the 2000s, whereas the concentrations of PCDD/Fs and their toxic equivalency (WHO2006-TEQ) remained. The major sources of PCDD/Fs in the paddy soil samples were attributed to impurities in PCP and CNP as a result of comparisons of homologue and congener profiles and principal component analysis. Based on the results of comparison of total input and remaining amount, it is estimated that more than 99% of PCP and CNP applied to the paddy fields had disappeared, whereas most of the applied PCDD/Fs and TEQ remained.