How changing grain size affects the land surface temperature pattern in rapidly urbanizing area: a case study of the central urban districts of Hangzhou City,China

Environmental Science and Pollution Research - Urbanization has led to the rapid and large-scale changes in land use and land cover and has affected the spatial distribution of land surface...     

Synthesis of Ni-doped anatase TiO2 single crystals loaded on wood-based activated carbon for enhanced photodegradation of triphenylmethane dyes

Environmental Science and Pollution Research - In this work, the Ni-doped anatase TiO2 single crystals loaded on activated carbon (Ni-T/AC) were synthesized by a sol–gel method. The chemical...     

红色非硫光合细菌的生长特性研究

红色非硫光合细菌菌种从城市污水处理厂活性污泥中分离得到,对红色非硫光合细菌的生长规律及其影响因素进行研究,试验表明在进行污水处理时所用的红色非硫光合细菌的最佳培养条件为接种量2%,pH7～8,光照强度为1500lx,光照厌氧条件下培养3～5d。这为红色非硫光合细菌应用于染料有机化工废水处理的进一步研究提供了理论依据。     

Comparison on surface properties and desulfurization of MnO2 and pyrolusite blended activated carbon by steam activation

In this study, MnO₂ and pyrolusite were used as the catalysts to prepare modified activated carbon, that is, AC-Mn and AC-P, respectively, from coals by blending method and steam activation. The Brunauer–Emmett–Teller (BET) results indicated that the AC-P had higher surface areas and micropore volumes than the AC-Mn with the same blending ratio. The relative contents of basic functional groups (i.e., C = O, π-π*) on AC-P were slightly lower than those on AC-Mn, while both contained the same main metal species, namely, MnO. The desulfurization results showed that with 3 wt% of blending ratio, AC-Mn3 and AC-P3 had higher sulfur capacities at 220 and 205 mg/g, respectively, which were much higher than for the blank one (149.6 mg/g). Moreover, the AC-P had relatively higher sulfur capacity than the AC-Mn with the same contents of Mn, which might be attributed to the existence of other metals in pyrolusite. After the desulfurization process, MnO were gradually transferred into MnSO₄, and the relative contents of basic functional groups decreased evidently for both AC-Mn3 and AC-P3. The results demonstrated that pyrolusite could be one good alternative to MnO₂ to prepare modified activated carbon for desulfurization.

Implications: MnO₂ and pyrolusite were used as the additives to prepare modified activated carbon from coals by a blending method and by steam activation, that is, AC-Mn and AC-P, respectively. The AC-P had higher surface areas and micropore volumes than the AC-Mn with the same blending ratio. The AC-Mn and AC-P had higher sulfur capacities than a blank one. Moreover, the AC-P had relatively higher sulfur capacity than the AC-Mn with the same contents of Mn. The results demonstrated that pyrolusite could be one good alternative to MnO₂ to prepare modified activated carbon for desulfurizatio.     

氧化锰共生矿烟气脱硫的机理及影响因素

利用南非的氧化锰共生矿进行烟气脱硫,研究了共生锰矿烟气脱硫性能及其机理,并考察了锰矿粒径、反应温度、液固比、进气流量、进口SO2浓度等因素对脱硫率的影响。结果表明,氧化锰共生矿中主要的锰化合物是MnO2、Mn2O3和MnCO3,烟气脱硫过程主要存在4种方式：MnO2与SO2发生氧化还原反应生成硫酸锰;液相中Mn2+催化氧化SO2产生硫酸;MnCO3与硫酸反应生成硫酸锰;Mn2O3与硫酸反应后生成的MnO2可以继续与SO2进行脱硫反应,但是Mn2O3与SO2直接反应的活性较差。氧化锰共生矿烟气脱硫的最佳工艺参数为：锰矿粒径200目、反应温度80 ℃、液固比10:1以及进气流量600 mL?min-1     

Ti/Ru/SnO2+Sb2O5电极的制备及其对垃圾渗滤液的电催化氧化

通过实验探究了不同Ru掺杂量对 Ti/Ru/SnO2+Sb2O5电极电化学性能及表面结构的影响。结果表明：Sb含量10%,溶胶涂覆6层,煅烧温度600 ℃,煅烧时间1 h条件下,Ru掺杂量为10%的涂层电极的加速寿命最长,为50 min;该条件下制备的电极涂层表面金属氧化物 SnO2的特征峰强度较大,峰形窄;涂层表面光滑,无裂缝。同时用Ti/Ru/SnO2+Sb2O5电极处理垃圾渗滤液MBR出水,Ru掺杂为10%的电极对废水COD去除率最高,为93.33%,电解出水芳香化程度大幅降低,对腐殖质和芳香族化合物的去除效果良好。研究对Ti/Ru/SnO2+Sb2O5电极在实际工业生产中的应用具有指导意义。     

纳米TiO2光催化-超滤法处理模拟二级出水

采用纳米TiO2光催化-超滤对模拟二级出水进行处理。分别考察了纳米TiO2光催化剂的投加量、光催化反应时间、光催化过程曝气量、膜出水通量以及回流比对废水中污染物去除率的影响。结果表明:光催化反应最优处理工况,纳米TiO2投加量250 mg/L、反应时间150 min、曝气量为1.0 L/min、膜出水通量为115 L/(m2·h)、错流过滤的回流比200%;在此工况条件下,出水的UV254和TOC的去除率分别为96%和84%。     

不同工况条件混合赤泥力学特性变化规律

在利用常规土工实验和XRF、XRD、SEM等微观测试手段分析了刚出厂混合赤泥化学成分、矿物组成、微观结构的基础上,通过无侧限抗压强度实验和固结排水三轴剪切实验对自然风干、浸水饱和、非饱和-饱和干湿循环3种工况条件下混合赤泥不同龄期力学特性的变化规律进行了研究。结果表明,自然风干试样的无侧限抗压强度和粘聚力要明显大于相同龄期浸水饱和试样和干湿循环试样,说明混合赤泥的强度形成与滤水过程有一定联系,且其强度的增长均主要集中在脱水龄期前70天内;混合赤泥在3种不同工况条件下无侧限抗压强度和粘聚力均有一定程度的增长,说明混合赤泥可在浸水环境下生成不可逆增长的具有水硬性的胶结矿物,使其在水环境中不发生崩解,可保证混合赤泥堆体在自然堆存过程中其力学特性满足安全堆载要求。     

中和共沉淀—铁氧体法处理含镍、铬废水的实验研究

利用中和共沉淀—铁氧体法处理甘肃某稀有金属生产企业产生的含镍、铬废水,同时对该废水的处理工艺条件进行了实验研究。经测定,废水中Ni 2+质量浓度为50mg/L,Cr(Ⅲ)质量浓度为87mg/L。通过实验得到处理工艺的最佳条件:投料摩尔比(Fe2+/(Ni 2++Cr2O2-7))为9,pH=9,温度为70℃。出水中镍、铬均可达到《污水综合排放标准》(GB 8978—1996)中第一类污染物最高允许排放浓度的要求,为中和共沉淀—铁氧体法处理混合重金属废水的工艺条件研究提供了参考。     

APSFZn在富营养化湖泊型水体中的应用

采用复合共聚法制备一种新型无机高分子絮凝剂凹凸棒-聚硅酸铁锌(APSFZn),并应用于富营养化湖泊型原水的实验研究。考察了水体p H、投加量、搅拌强度影响因素对絮凝效果的影响。研究表明,APSFZn具有较宽的p H使用范围。当p H为7.6、投加量为20 mg/L、搅拌强度为快搅速度200 r/min,快搅时间2 min,慢搅速度50 r/min,慢搅时间15 min时,APSFZn絮凝剂对Chl-a、CODMn、TP和TN的去除率分别为91.57%、87.11%、93.48%和48.98%。与传统絮凝剂PAC、PFS、PSFZn对比,APSFZn的絮凝效果明显优于传统絮凝剂。该絮凝剂制备简单、具有良好的稳定性和絮凝特性、工艺无二次污染,将APSFZn应用于富营养化湖泊型原水具有良好的絮凝效果。