浙江典型海湾潮间带沉积物污染及生态风险评价

基于浙江4个典型海湾潮间带表层沉积物重金属元素Cu、Zn、Pb、Cr、Cd、Hg、As和多氯联苯（PCB）的调查结果,探究其污染特征、潜在生态风险和来源.结果表明,海湾潮间带表层沉积物Cd、Hg、As、PCB含量均符合国家海洋沉积物质量Ⅰ类标准;42%、9%、3%、12%站位的Cu、Zn、Pb、Cr符合国家海洋沉积物质量II类标准,1%站位的Cu和Zn符合国家海洋沉积物质量III类标准.区域污染程度（PLI_zone）依次为乐清湾 > 三门湾 > 象山港 > 杭州湾,乐清湾潮间带沉积环境为中等污染,杭州湾、象山港和三门湾潮间带沉积环境无污染.区域生态风险（RI）依次为乐清湾 > 杭州湾 > 三门湾 > 象山港,乐清湾和杭州湾潮间带沉积物为中潜在生态风险,三门湾和象山港潮间带沉积物为低潜在生态风险.Cd是首要的潜在生态风险因子,Cd对杭州湾、象山港、三门湾、乐清湾潜在生态风险指数（RI）的贡献分别为63%、54%、58%和55%.生活污水、工农业和交通污染是浙江典型海湾潮间带重金属和PCB的主要来源.     

pH值对亚硝酸盐氧化菌动力学及功能基因的影响

为探究pH值对亚硝酸盐氧化菌（NOB）活性动力学影响,本试验采用序批式活性污泥（SBR）反应器,以富含NOB的活性污泥为对象,基于Monod模型考察不同pH值对NOB活性动力学的影响并进行统计学分析.结果表明,Monod方程可较好地反映不同pH值条件下基质底物浓度对NOB比亚硝态氮氧化速率（SNiOR）的影响,且pH=7.0时动力学参数Ks为（6.167mg/L）,r_max为[1.134g/（g·d）],此时NOB活性最好.利用钟形经验模型进行非线性回归拟合,最大比降解速率（r_max）随pH值的增大呈钟形变化,本试验NOB的最佳pH值为（6.9±0.1）,其中r_max维持在r_opt一半以上的pH值范围（ω）为（3.26±0.4）.以亚硝酸盐氧化还原酶类基因（nxrA、nxrB）为引物,基于荧光定量PCR技术分析结果显示,在不同pH值条件下nxrA基因和nxrB基因拷贝数的变化趋势均与动力学参数（Ks、r_max）的规律一致,且nxrA和nxrB基因在系统的降解过程中起协同作用.     

Fas/FasL途径在氟暴露致PC12细胞凋亡中的作用

为了探讨Fas/FasL途径在氟暴露致PC12细胞凋亡中的作用及其机制,采用含20、40、80、160mg/L NaF培养液处理PC12细胞.结果表明,所有剂量NaF处理12、24、36、48h,PC12细胞活性升高;上述不同剂量NaF处理24h后,与对照组比,PC12细胞的活性氧水平、细胞凋亡率、细胞内Fas/FasL信号转导通路Fas和FasL、Caspase8、FADD、Caspase3基因和蛋白表达水平均呈显著上升（P < 0.05）,而Bid基因和蛋白表达水平显著下降（P < 0.05）,且呈氟暴露剂量依赖性.结果提示Fas/FasL途径在氟暴露致PC12细胞凋亡中起重要作用,其中FADD可能是Fas/FasL凋亡途径中的重要靶分子.     

悬浮填料投加对AnMBR性能及膜污染的影响

研究了悬浮填料投加对分置式厌氧膜生物反应器（AnMBR）的COD去除效果、污泥混合液特性及膜污染的影响。试验结果表明:在反应器有机负荷为2.09 kg/（m3·d）,污泥负荷为0.54 kg/（kg·d）,水力停留时间（HRT）为48 h,温度为（35±2）℃的条件下,与未投加悬浮填料阶段比较,投加填料后AnMBR的COD总去除率由96.6%提高至97.9%,甲烷产率提高16.0%。同时投加悬浮填料后AnMBR混合液污泥平均粒径增大,滤饼层阻力、总阻力、滤饼层阻力在总阻力中的占比较未投加悬浮填料时分别降低7.8、6.5和1.3百分点,溶解性胞外聚合物（SEPS）和结合性胞外聚合物（BEPS）浓度分别降低了20.5%和29.4%,跨膜压差（TMP）线性增长速率降低,膜污染速率明显减缓。因此,投加悬浮填料可在不增加能耗的情况下改善污泥混合液特性,起到强化AnMBR处理效果和控制膜污染的作用。     

Preparation of hydrophobic hierarchical pore carbon–silica composite and its adsorption performance toward volatile organic compounds

Carbon–silica materials with hierarchical pores consisting of micropores and mesopores were prepared by introducing nanocarbon microspheres derived from biomass sugar into silica gel channels in a hydrothermal environment.The physicochemical properties of the materials were characterized by nitrogen physical adsorption(BET),scanning electron microscopy(SEM),and thermogravimetric(TG),and the adsorption properties of various organic waste gases were investigated.The results showed that microporous carbon materials were introduced successfully into the silica gel channels,thus showing the high adsorption capacity of activated carbon in high humidity organic waste gas,and the high stability and mechanical strength of the silica gel.The dynamic adsorption behavior confirmed that the carbon–silica material had excellent adsorption capacity for different volatile organic compounds(VOCs).Furthermore,the carbon–silica material exhibited excellent desorption characteristics:adsorbed toluene was completely desorbed at 150℃,thereby showing superior regeneration characteristics.Both features were attributed to the formation of hierarchical pores.     

基于全过程治理的环境规制减排机制研究——来自长江经济带数据的实证检验

基于2007~2017年长江经济带11个省市的面板数据,利用中介效应模型探究全过程治理视域下政府主导型和市场激励型2类环境规制的减排机制.研究发现,政府主导型环境规制和市场激励型环境规制对SO₂排放均具有显著的抑制作用,其影响系数分别为-0.154和-0.209.其中政府主导型环境规制在源头防控、过程控制和末端治理的全过程都起到显著的减排效应,而市场激励型环境规制只通过末端治理实现减排.因此,尽管市场激励型环境规制具有低成本、高效率的优点,但考虑到源头防控和过程控制在生态环境保护中发挥的根本性作用,对于经济结构和经济发展方式较为落后的地区和行业,仍要重视以政府为主导的环境规制,通过因地制宜、合理科学地运用环境规制工具以实现高效的全过程污染治理.     

土壤环境中微塑料的污染现状及其影响研究进展

微塑料作为一种持久性污染物,对土壤生态系统具有严重影响,土壤中微塑料的污染已愈加受到国内外学者的广泛关注。当前关于土壤环境中微塑料的研究较少,针对当前土壤中微塑料的来源、分布、降解迁移、生态效应及污染防治等方面进行综述。主要包括以下几个方面:1）概括土壤生态系统中微塑料的来源、分布特点和迁移降解规律,确定了土壤环境中微塑料的赋存状态;2）总结土壤生态系统中微塑料与其他污染物的复合效应;3）分析了微塑料对土壤理化性质、动物、植物、微生物的影响,并揭示了微塑料对于土壤生态系统的影响;4）根据土壤微塑料的分布特点、降解迁移及生态效应提出污染防治措施。最后,对今后土壤微塑料的研究重点进行了展望。     

Acceleration of floc-water separation and floc reduction with magnetic nanoparticles during demulsification of complex waste cutting emulsions

Waste cutting emulsions are difficult to treat efficiently owing to their complex composition and stable emulsified structure. As an important treatment method for emulsions, chemical demulsification is faced with challenges such as low flocs–water separation rates and high sludge production. Hence, in this study, Fe₃O₄ magnetic nanoparticles (MNPs) were used to enhance chemical demulsification performance for treating waste cutting emulsions under a magnetic field. The addition of MNPs significantly decreased the time required to attain sludge–water separation and sludge compression equilibrium, from 210 to 20 min. In addition, the volume percentage of sludge produced at the equilibrium state was reduced from 45% to 10%. This excellent flocculation–separation performance was stable over a pH range of 3–11. The magnetization of the flocculants and oil droplets to form a flocculant–MNP–oil droplet composite, and the magnetic transfer of the composite were two key processes that enhanced the separation of cutting emulsions. Specifically, the interactions among MNPs, flocculants, and oil droplets were important in the magnetization process, which was controlled by the structures and properties of the three components. Under the magnetic field, the magnetized flocculant–MNP–oil droplet composites were considerably accelerated and separated from water, and the sludge was simultaneously compressed. Thus, this study expands the applicability of magnetic separation techniques in the treatment of complex waste cutting emulsions.     

Development of a static test apparatus for evaluating the performance of three PM2.5 separators commonly used in China

PM_(2.5) separator directly affects the accuracy of PM_(2.5) sampling.The specification testing and evaluation for PM_(2.5) separator is particularly important,especially under China's wide variation of terrain and climate.In this study,first a static test apparatus based on polydisperse aerosol was established and calibrated to evaluate the performance of the PM_(2.5) separators.A uniform mixing chamber was developed to make particles mix completely.The aerosol concentration relative standard deviations of three test points at the same horizontal chamber position were less than 0.57%,and the particle size distribution obeyed logarithmic normal distribution with an R~2 of 0.996.The flow rate deviation between the measurement and the set point flow rate agreed to within ± 1.0% in the range of -40 to 50℃.Secondly,the separation,flow and loading characteristics of three cyclone separators(VSCC-A,SCC-A and SCC112) were evaluated using this system.The results showed that the 50% cutoff sizes(D_(50)) of the three cyclones were 2.48,2.47 and 2.44 μm when worked at the manufacturer's recommended flow rates,respectively.The geometric standard deviation(GSD) of the capture efficiency of VSCCA was 1.23,showed a slightly sharper than SCC-A(GSD = 1.27),while the SCC112 did not meet the relevant indicator(GSD = 1.2 ± 0.1) with a GSD = 1.44.The flow rate and loading test had a great effect on D_(50),while the GSD remained almost the same as before.In addition,the maintenance frequency under different air pollution conditions of the cyclones was summarized according to the loading test.     

Metabolomic modulations in a freshwater microbial community exposed to the fungicide azoxystrobin

An effective broad-spectrum fungicide, azoxystrobin (AZ), has been widely detected in aquatic ecosystems, potentially affecting the growth of aquatic microorganisms. In the present study, the eukaryotic alga Monoraphidium sp. and the cyanobacterium Pseudanabaena sp. were exposed to AZ for 7 days. Our results showed that 0.2–0.5 mg/L concentrations of AZ slightly inhibited the growth of Monoraphidium sp. but stimulated Pseudanabaena sp. growth. Meanwhile, AZ treatment effectively increased the secretion of total organic carbon (TOC) in the culture media of the two species, and this phenomenon was also found in a freshwater microcosm experiment (containing the natural microbial community). We attempted to assess the effect of AZ on the function of aquatic microbial communities through metabolomic analysis and further explore the potential risks of this compound. The metabonomic profiles of the microcosm indicated that the most varied metabolites after AZ treatment were related to the citrate cycle (TCA), fatty acid biosynthesis and purine metabolism. We thereby inferred that the microbial community increased extracellular secretions by adjusting metabolic pathways, which might be a stress response to reduce AZ toxicity. Our results provide an important theoretical basis for further study of fungicide stress responses in aquatic microcosm microbial communities, as well as a good start for further explorations of AZ detoxification mechanisms, which will be valuable for the evaluation of AZ environmental risk.