Comparison of field-scale herbicide runoff and volatilization losses: an eight-year field investigation

An 8-yr study was conducted to better understand factors influencing year-to-year variability in field-scale herbicide volatilization and surface runoff losses. The 21-ha research site is located at the USDA-ARS Beltsville Agricultural Research Center in Beltsville, MD. Site location, herbicide formulations, and agricultural management practices remained unchanged throughout the duration of the study. Metolachlor [2-chloro--(2-ethyl-6-methylphenyl)--(2-methoxy-1-methylethyl) acetamide] and atrazine [6-chloro--ethyl--(1-methylethyl)-1,3,5-triazine-2,4-diamine] were coapplied as a surface broadcast spray. Herbicide runoff was monitored from a month before application through harvest. A flux gradient technique was used to compute volatilization fluxes for the first 5 d after application using herbicide concentration profiles and turbulent fluxes of heat and water vapor as determined from eddy covariance measurements. Results demonstrated that volatilization losses for these two herbicides were significantly greater than runoff losses ( < 0.007), even though both have relatively low vapor pressures. The largest annual runoff loss for metolachlor never exceeded 2.5%, whereas atrazine runoff never exceeded 3% of that applied. On the other hand, herbicide cumulative volatilization losses after 5 d ranged from about 5 to 63% of that applied for metolachlor and about 2 to 12% of that applied for atrazine. Additionally, daytime herbicide volatilization losses were significantly greater than nighttime vapor losses ( < 0.05). This research confirmed that vapor losses for some commonly used herbicides frequently exceeds runoff losses and herbicide vapor losses on the same site and with the same management practices can vary significantly year to year depending on local environmental conditions.     

A direct comparison of the consequences of plant genotypic and species diversity on communities and ecosystem function

Biodiversity loss is proceeding at an unprecedented rate, yet we lack a thorough understanding of the consequences of losing diversity at different scales. While species diversity is known to impact community and ecosystem processes, genotypic diversity is assumed to have relatively smaller effects. Nonetheless, a few recent studies suggest that genotypic diversity may have quantitatively similar ecological consequences compared to species diversity. Here we show that increasing either genotypic diversity of common evening primrose (Oenothera biennis) or species diversity of old-field plant species resulted in nearly equivalent increases (approximately 17%) in aboveground primary production. The predominant mechanism explaining this effect, niche complementarity, was similar for each type of diversity. Arthropod species richness also increased with both types of plant diversity, but the mechanisms leading to this effect differed: abundance-driven accumulation of arthropod species was important in plant genotypic polycultures, whereas resource specialization was important in plant species polycultures. Thus, similar increases in primary productivity differentially impacted higher trophic levels in response to each type of plant diversity. These results highlight important ecological similarities and differences between genotypic and species diversity and suggest that genotypic diversity may play a larger role in community and ecosystem processes than previously realized.     

A one year investigation of the occurrence of illicit drugs in wastewater from Brussels, Belgium

Daily 24 hour composite influent wastewater samples were collected from the wastewater treatment plant of Brussels-North (Belgium) for eight months to study variations in the concentrations and mass loads of nine illicit drugs and metabolites: cocaine (COC) and its metabolites benzoylecgonine (BE) and ecgonine methyl ester (EME), amphetamine (AMP), methylenedioxymethamphetamine (MDMA), methamphetamine (METH), methadone (MTD) and its metabolite 2-ethylidene-1,5-dimethyl-3,3-diphenylpyrrolidine (EDDP) and the specific metabolite of heroin, 6-monoacetylmorphine (6-MAM). Samples were analyzed using a validated analytical method based on solid-phase extraction and hydrophilic interaction liquid chromatography coupled to tandem mass spectrometry. The selected compounds could be detected and quantified in all samples. The measured concentrations were in agreement with earlier published concentrations, when available. All illicit drugs showed significant differences in mass loads between months. Daily variations were observed for MDMA, AMP and COC and metabolites, with higher mass loads observed during the weekend. This is probably related to their recreational consumption pattern and was further confirmed when holiday periods (New Year's Eve, Belgian national holiday) were in detail investigated. For METH, 6-MAM, MTD and EDDP, stable and consistent amounts were observed during the week. In all samples, the ratio of the concentration of the parent compound to its metabolite(s) was calculated to evaluate whether measured concentrations reflect human excretion of the illicit drugs. For MTD, the ratio of parent compound/metabolite was in agreement with the excretion pattern, while for COC some deviations were observed, resulting from excretion pattern uncertainties, and stability and discharge issues.     

森林对生态环境的作用

一、引言发展林业,保护森林,当代受益,造福子孙,这是我们的国策。环境是人类赖以生存的场所和索取生活资料的来源。但如对自然资源不合理地开发利用,必然要破坏生态平衡,破坏环境。则将受到大自然的严励惩罚,后患无穷。     

Comparison of VOC and ammonia emissions from individual PVC materials, adhesives and from complete structures

Emission rates of volatile organic compounds (VOCs) and ammonia measured from six PVC materials and four adhesives in the laboratory were compared to the emission rates measured on site from complete structures. Significantly higher specific emission rates (SERs) were generally measured from the complete structures than from individual materials. There were large differences between different PVC materials in their permeability for VOCs originating from the underlying structure. Glycol ethers and esters from adhesives used in the installation contributed to the emissions from the PVC covered structure. Emissions of 2-ethylhexanol and TXIB (2,2,4-trimethyl-1,3-pentanediol diisobutyrate) were common. High ammonia SERs were measured from single adhesives but their contribution to the emissions from the complete structure did not appear as obvious as for VOCs. The results indicate that three factors affected the VOC emissions from the PVC flooring on a structure: 1) the permeability of the PVC product for VOCs, 2) the VOC emission from the adhesive used, and 3) the VOC emission from the backside of the PVC product.     

Adding virtual measuring stations to a network for urban air pollution mapping

Maps of pollutants concentration are usually generated by means of interpolation and extrapolation methods. The quality of the results depends mainly of the number of permanent or temporary measuring stations. This paper deals with a method for the virtual densification of the network of stations. The method creates "virtual measuring stations". It aims at improving the quality of interpolation by increasing the number of data on pollutant concentration. The virtual stations are determined by the means of a classification method applied to each pixel of the area under concern. Discriminating elements are pollutants emission classes, land cover types, urban morphological indicators created to this purpose and distance to major roads. A first implementation was made for particulate matter (PM) for the city of Strasbourg (France) using thin-plates spline interpolation method in Arcview 9 GIS. The relative Root Mean Square Error decreases from 49% for five input stations down to 15% for the virtual stations.     

Temperature and feed strategy effects on sulfate and organic matter removal in an AnSBB

The objective of this work was to analyze the interaction effects between temperature, feed strategy and COD/[SO(4)(2-)] levels, maintaining the same ratio, on sulfate and organic matter removal efficiency from a synthetic wastewater. This work is thus a continuation of Archilha et al. (2010) who studied the effect of feed strategy at 30 °C using different COD/[SO(4)(2-)] ratios and levels. A 3.7-L anaerobic sequencing batch reactor with recirculation of the liquid phase and which contained immobilized biomass on polyurethane foam (AnSBBR) was used to treat 2.0 L synthetic wastewater in 8 h cycles. The temperatures of 15, 22.5 and 30 °C with two feed strategies were assessed: (a) batch and (b) batch followed by fed-batch. In strategy (a) the reactor was fed in 10 min with 2 L wastewater containing sulfate and carbon sources. In strategy (b) 1.2 L wastewater (containing only the sulfate source) was fed during the first 10 min of the cycle and the remaining 0.8 L (containing only the carbon source) in 240 min. Based on COD/[SO(4)(2-)] = 1 and on the organic matter (0.5 and 1.5 gCOD/L) and sulfate (0.5 and 1.5 gSO(4)(2-)/L) concentrations, the sulfate and organic matter loading rates applied were 1.5 and 4.5 g/L.d, i.e., same COD/[SO(4)(2-)] ratio (=1) but different levels (1.5/1.5 and 4.5/4.5 gCOD/gSO(4)(2-)). When reactor feed was 1.5 gCOD/L.d and 1.5 gSO(4)(2-)/L.d, gradual feeding (strategy b) showed to favor sulfate and organic matter removal in the investigated temperature range, indicating improved utilization of the electron donor for sulfate reduction. Sulfate removal efficiencies were 87.9; 86.3 and 84.4%, and organic matter removal efficiencies 95.2; 86.5 and 80.8% at operation temperatures of 30; 22.5 and 15 °C, respectively. On the other hand, when feeding was 4.5 gCOD/L.d and 4.5 gSO(4)(2-)/L.d, gradual feeding did not favor sulfate removal, indicating that gradual feeding of the electron donor did not improve sulfate reduction.     

Heavy metals in water, sediment and tissues of Leuciscus cephalus from a stream in southwestern Turkey

Concentrations of heavy metals (Cd, Cr, Cu, Pb and Zn) were measured in water, bottom sediment and tissues (muscle and gills) of Leuciscus cephalus from the Dipsiz stream in the Yatagan basin (southwestern Turkey), the site of a thermal power plant. Results for levels in water were compared with national and international water quality guidelines, as well as literature values were reported for streams and rivers. Comparisons were made of metal concentrations in water and sediment with those in the muscle and gills of L. cephalus caught from the Dipsiz stream. We found that there was metal accumulation in the gills compared to the muscle. Concentrations of Cd, Pb, Zn and Cr in the gills were higher than that in the muscle; however, Cu levels were higher in muscle than that in gills. Concentrations of heavy metals in L. cephalus muscle were below the legal limits for human consumption, although Cr, Pb and Zn levels in the gills were above the limits in the fish taken from the Dipsiz stream. On the other hand, no correlation was found between metal concentrations in water and sediment or between metal concentrations in water and muscle and gills of L. cephalus. A positive correlation was found between concentrations of Cu and Zn in the sediment and in fish tissue, whereas there was no relationship between other metal concentrations in the sediment and water, and muscle and gills of L. cephalus. As with water, Pb and Cd concentrations in particular were higher in sediment than that in background levels. The results show that the pollutants from the thermal power plant may be a source of these elements.