A rare case of 68,XX triploidy diagnosed by amniocentesis

68,XX triploidy was found in the amniotic fluid cell culture of a 40-year-old patient. Elective termination of the pregnancy revealed a fetus with multiple congenital anomalies. While this case does show some common features with monosomy X, a greater similarity to the triploidy syndrome is observed.     

Atrazine distribution measured in soil and leachate following infiltration conditions

Atrazine transport through packed 10 cm soil columns representative of the 0-10 cm soil horizon was observed by measuring the atrazine recovery in the total leachate volume, and upper and lower soil layers following infiltration of 7.5 cm water using a mechanical vacuum extractor (MVE). Measured recoveries were analyzed to understand the influence of infiltration rate and delay time on atrazine transport and distribution in the column. Four time periods (0.28, 0.8, 1.8, and 5.5 h) representing very high to moderate infiltration rates (26.8, 9.4, 4.2, and 1.4 cm/h) were used. Replicate soil columns were tested immediately and following a 2-d delay after atrazine application. Results indicate atrazine recovery in leachate was independent of infiltration rate, but significantly lower for infiltration following a 2-d delay. Atrazine distribution in the 0-1 and 9-10 cm soil layers was affected by both infiltration rate and delay. These results are in contrast with previous field and laboratory studies that suggest that atrazine recovery in the leachate increases with increasing infiltration rate. It appears that the difference in atrazine recovery measured using the MVE and other leaching experiments using intact soil cores from this field site and the rain simulation equipment probably illustrates the effect of infiltrating water interacting with the atrazine present on the soil surface. This work suggests that atrazine mobilization from the soil surface is also dependent on interactions of the infiltrating water with the soil surface, in addition to the rate of infiltration through the surface soil.     

Correction to: Ecological restoration as a strategy for mitigating and adapting to climate change: lessons and challenges from Brazil

Mitigation and Adaptation Strategies for Global Change - The original version of the article unfortunately contained an error.     

Conversion of LDPE into transportation fuels by a two-stage process using Ni/Al-SBA-15 as catalyst

Ni/Al-SBA-15 catalysts with Si/Al atomic ratios within the 20–135 range were prepared by a post synthesis grafting procedure, having nickel contents between 6 and 11 %. The addition of Ni to the Al-SBA-15 support caused a decrease of the BET surface area and pore volume. Additionally, larger Ni particles were attained over the catalysts with higher Si/Al atomic ratios, indicating the existence of some interaction between aluminium species and nickel particles. Ni/Al-SBA-15 catalysts displayed remarkable properties for the preparation of diesel fuels in the hydroreforming of the oils obtained from the LDPE thermal cracking. On increasing the Si/Al atomic ratios of the Ni/Al-SBA-15 catalysts, higher share of light and heavy diesel were attained, the sum reaching a maximum (67.3 %) for Ni/Al-SBA-15(70). This was caused by the higher extent of oligomerization reactions on enhancing the Si/Al atomic ratio. Additionally, around 85–90 % of the starting olefins were successfully hydrogenated and the aromatic content was rather low (below 5 %), without almost any polyaromatic compound (<0.1 %).     

Swimming speed alteration of larvae of Balanus Amphitrite as a behavioural end-point for laboratory toxicological bioassays

In this study, we investigate the feasibility of developing a new behavioural toxicity bioassay (Swimming Speed Alteration test—SSA test) with larvae of Balanus amphitrite (Crustacea Cirripedia). This organism was chosen as a model for different reasons: it is present all over the world, simple to be reared, easily available, and also because barnacles play an important role in the coastal ecosystem. In addition, all the operations related to the rearing and test execution are comparatively cheap. This bioassay was performed with several classes of chemical pollutants (antifouling biocides, neurotoxic pesticides, and heavy metals) and with environmental samples (sediment elutriates). The measurement of swimming speed, by means of video-graphic techniques, proved to be a valid instrument in highlighting the sub-lethal levels of toxicity caused by the different tested samples. In conclusion, the SSA test is able to provide in a biomonitoring program a good behavioural integrated output, which is also repeatable, sensitive, easily interpretable, and truly representative of a broad range of toxic compounds and environmental toxic matrices which are, generally, very complex and difficult to analyse. For all of these reasons, it could be proposed as a non-specific behavioural end-point. Physical and Chemical Impacts on Marine Organisms, a Bilateral Seminar Italy-Japan held in November 2004.     

Fate of Triclosan and Methyltriclosan in soil from biosolids application

This study investigates the persistence of Triclosan (TCS), and its degradation product, Methyltriclosan (MeTCS), after land application of biosolids to an experimental agricultural plot under both till and no till. Surface soil samples (n = 40) were collected several times over a three years period and sieved to remove biosolids. Concentration of TCS in the soil gradually increased with maximum levels of 63.7 ± 14.1 ng g(-1) dry wt., far below the predicted maximum concentration of 307.5 ng g(-1) dry wt. TCS disappearance corresponded with MeTCS appearance, suggesting in situ formation. Our results suggest that soil incorporation and degradation processes are taking place simultaneously and that TCS background levels are achieved within two years. TCS half-life (t(0.5)) was determined as 104 d and MeTCS t(0.5), which was more persistent than TCS, was estimated at 443 d.     

A Comparative Study Between Bio-composites Obtained with Opuntia ficus indica Cladodes and Flax Fibers

This work is aimed to study the suitability of the wooden backbone of Opuntia ficus indica cladodes as reinforcement for the production of bio-composites. The wooden backbone can be extracted from O. ficus indica cladodes, which constitute a very relevant agricultural scrap, and is characterized by a thick walled cellular structure. In view of its potential in poly-lactic acid (PLA) matrix bio-composite production, two different possible applications were examined. In the first alternative, the wooden backbone was used in replacement of flax fibers for the production of fully consolidated bio-composites. Results obtained have shown that, though being characterized by lower properties compared to those of flax fiber composites, the opuntia actually works as an efficient reinforcement for PLA/wood flour matrix, increasing the flexural strength and elongation at break. In the second alternative, the cellular structure was used for the production of a sandwich bio-composite with a PLA/wood flour skin. In this case, the very high interlaminar adhesion strength between the skin and the core was considered as an indication of the potentiality of this material for the production of high strength sandwich structures. As a confirmation of this, no interlaminar debonding was observed during short beam tests.     

Spatial Heterogeneity of Water Quality in a Highly Degraded Tropical Freshwater Ecosystem

Awareness of environmental heterogeneity in ecosystems is critical for management and conservation. We used the Xochimilco freshwater system to describe the relationship between heterogeneity and human activities. This tropical aquatic ecosystem south of Mexico City is comprised of a network of interconnected canals and lakes that are influenced by agricultural and urban activities. Environmental heterogeneity was characterized by spatially extensive surveys within four regions of Xochimilco during rainy and dry seasons over 2 years. These surveys revealed a heterogeneous system that was shallow (1.1 m, SD = 0.4 ), warm (17°C, SD = 2.9), well oxygenated (5.0 mg l⁻¹, SD = 3), turbid (45.7 NTU SD = 26.96), and extremely nutrient-rich (NO₃–N = 15.9 mg l⁻¹, SD=13.7; NH₄–N = 2.88 mg l⁻¹, SD = 4.24; and PO₄–P =  8.3 mg l⁻¹, SD = 2.4). Most of the variables were not significantly different between years, but did differ between seasons, suggesting a dynamic system within a span of a year but with a high resilience over longer periods of time. Maps were produced using interpolations to describe distributions of all variables. There was no correlation between individual variables and land use. Consequently, we searched for relationships using all variables together by generating a combined water quality index. Significant differences in the index were apparent among the four regions. Index values also differed within individual region and individual water bodies (e.g., within canals), indicating that Xochimilco has high local heterogeneity. Using this index on a map helped to relate water quality to human activities and provides a simple and clear tool for managers and policymakers.     

Carbon Monoxide Trend,Meteorology, and Three-Way Catalysts in Mexico City

ABSTRACT

From the analysis of data of the Inspection/Maintenance (I/M) program, and of the long-term trend of ambient CO concentrations in Mexico City, it is inferred that three-way catalysts (TWCs) have a 45% efficiency, well below the expected 90% value. The most probable causes are sulfur poisoning, lead contamination, and ceramic breakage due to bumps and potholes on the streets. Also, we have found a ratio between the average daily peak value of atmospheric CO and gasoline consumption: (11 ± 1) ppbCO/MLm (million liters of gasoline per month) in 1988 decaying to (10 ±1) in 1991 for Mexico City before the introduction of TWCs. In addition, we found a correlation between the monthly averages of CO daily peak and meteorological variables, explaining most of the seasonal changes using only the intensity of the inversion layer and surface wind speed.