Deformation patterns in WorldSID 50th percentile dummy instrumented with IR-TRACC and RibEye™ in different loading configurations

Objective: The purpose of this study was to investigate the effect of different loading configurations on the WorldSID 50th percentile male dummy instrumented either with the Infra-Red Telescoping Rod for the Assessment of Chest Compression (IR-TRACC) or the RibEye? rib deflection measurement system.

Methods: The optical sensors of the RibEye system were used to capture the multipoint deformation of the dummy at frontal and rearward off-center locations in addition to the center of the rib location. The experimental setup consisted of 2 types of loadings: Low severity and high severity. Low-severity loading was performed by deploying a fixture-mounted side airbag on the dummy and high-severity loading was achieved by deploying a driver front airbag mounted in a similar fashion. The low-severity condition aimed at deforming the dummy’s ribs locally at off-center locations where the RibEye light emitting diodes (LEDs) were positioned to capture the deformations at those locations. The high-severity condition aimed at loading the dummy at high speed in lateral and oblique directions similar to what is experienced by dummies in side impacts.

Results: In the low-severity tests, the peak deflections, in terms of length change, were approximately 15–20?mm, whereas for the high-severity cases the peak deflections were in the range of 30–40?mm for both IR-TRACC and RibEye cases.

Conclusions: For similar physical insults, dummies with the IR-TRACC and RibEye systems showed varying results for both length changes and the shoulder forces depending on the severity and direction of loading. Under purely lateral loading, the mid-length changes with the RibEye and the 1D IR-TRACC were comparable. In the oblique loading conditions, more differences were seen with the 2 systems depending on the impact direction. The shoulder forces consistently differed between the 2 systems. In the frontal oblique low-severity cases, the ribs pivoted along the spine end and the length change was not found to be a suitable parameter to quantify rib deformation in such loading scenarios.     

Assessment of biomass and lipid productivity and biodiesel quality of an indigenous microalga Chlorella sorokiniana MIC-G5

Generation of biodiesel from microalgae has been extensively investigated; however, its quality is often not suitable for use as fuel. Our investigation involved the evaluation of biodiesel quality using a native isolate Chlorella sorokiniana MIC-G5, as specified by American Society for Testing and Materials (ASTM), after transesterification of lipids with methanol, in the presence of sodium methoxide. Total quantity of lipids extracted from dry biomass, of approximately 410–450 mg g^?1 was characterized using FTIR and ¹H NMR. After transesterification, the total saturated and unsaturated fatty acid methyl esters (FAMEs) were 43% and 57%, respectively. The major FAMEs present in the biodiesel were methyl palmitate (C16:0), methyl oleate (C18:1), and methyl linoleate (C18:2), and the ¹H NMR spectra matched with criteria prescribed for high-quality biodiesel. The biodiesel exhibited a density of 0.873 g cm^–3, viscosity of 3.418 mm² s^?1, cetane number (CN) of 57.85, high heating value (HHV) of 40.25, iodine value of 71.823 g I₂ 100 g^?1, degree of unsaturation (DU) of 58%, and a cold filter plugging point (CFPP) of –5.22°C. Critical fuel parameters, including oxidation stability, CN, HHV, iodine value, flash point, cloud point, pour point, density, and viscosity were in accordance with the methyl ester composition and structural configuration. Hence, C. sorokiniana can be a promising feedstock for biodiesel generation.     

Influence of culture media and environmental factors on mycelial growth and sporulation of Lasiodiplodia theobromae (Pat.) Griffon and Maubl

Lasiodiplodia theobromae, a common tea (Camellia sinensis) pathogen, usually does not sporulate or sporulates poorly in common media, which makes spore production difficult. In this study the effects of culture media, carbon source, nitrogen source, temperature, pH and light on mycelial growth and sporulation were evaluated. Among several carbon sources tested, glucose and sucrose were found superior for growth. Potassium nitrate supplemented media showed maximum growth amongst the tested inorganic nitrogen sources while peptone produced maximum growth among the tested organic nitrogen sources. Tea root extract supplemented potato dextrose agar medium was found to be the most suitable for mycelial growth and sporulation of L. theobromae. The fungus grow at temperatures ranging from 40 to 36 degrees C, with optimum growth at 28 degrees C and no growth was noted at 40 degrees C. There was no significant effect of different light period on growth of L. theobromae, but light enhanced sporulation. The fungus grow at pH 3.0-8.0 and optimum growth was observed at pH 6.0. Tea root extract supplemented potato dextrose agar medium with pH 6.0 was the most suitable for production of conidia of L. theobromae at 28 degrees C. Hence this media may be recommended for inoculum production for further studies.     

Screening of wheat varieties and associated bacterial population in old alluvial soil of Burdwan, West Bengal

In order to screen out the best variety of wheat (Triticum aestivum) out of eight varieties (viz., HP 1633, BW 11, NW 1014, Sonalika, HUW 468, K 9107, HP 1731 and HUW 234), a field experiment was conducted (from Dec. 2002 to April 2003) in a randomized block design replicated thrice at Crop Research and Seed Multiplication Farm, Burdwan University, West Bengal, India. Various morpho physiological parameters viz., plant population, length of shoot and root, leaf area index (LAI), crop growth rate (CGR), leaf area ratio (LAR), leaf area duration (LAD), net assimilation rate (NAR), yield attributes viz., length of panicles, number of grains per panicle, grain yield, straw yield, pigment content in flag leaf (chlorophyll a, b and total chlorophyll and carotenoid content) were estimated and analyzed statistically Soil bacterial populations were also estimated in the fallow land before sowing of seeds and after harvesting of crop. The HUW 468 variety records higher grain yield, maximum panicle length and maximum chlorophyll b and total chlorophyll content.     

Utilization of agricultural waste biomass and recycling toward circular bioeconomy

Environmental Science and Pollution Research - The major global concern on energy is focused on conventional fossil resources. The burning of fossil fuels is an origin of greenhouse gas emissions...     

Groundwater Quality Monitoring in Shallow and Deep Aquifers in Saidabad Tahsil Area, Mathura District, India

Water availability in arid regions is both sporadic and highly variable in quantity. If the water quality shows large variations of salinity and concentration of other chemical constituents with depth and time span, it has considerable effect on the entire hydrological set up of the area. In the Saidabad tahsil area, the deep aquifers that supply water to borewells in the alluvial plain of the Mathura region, Uttar Pradesh, have higher salinity than those of the dugwells from the shallow aquifers. The excessive drilling of tubewells and high yield tubewells are resulting in deterioration of water quality of the shallow aquifers. On the contrary, the chemical constituents such as, Na⁺, K ⁺, Cl ^-, andHCO ₃ ^- show higher concentration in shallow aquifers than deep aquifers. A study carried out to monitor water quality in this region reveals that the groundwater quality varies with depth and time span in shallow and deep aquifers. Factors controlling variations in salinity and concentration of chemical constituents of the water in the two types of aquifers are discussed. The relative merits of the shallow water for potability are pointed out with respect to salinity concentrations and public health.     

Validation of a QuEChERS-based gas chromatographic method for analysis of pesticide residues in Cassia angustifolia (senna)

A simple multi-residue method based on modified QuEChERS (Quick, Easy, Cheap, Effective, Rugged and Safe) approach was established for the determination of 17 organochlorine (OC), 15 organophosphorous (OP) and 7 synthetic pyrethroid (SP) pesticides in an economically important medicinal plant of India, Senna (Cassia angustifolia), by gas chromatography coupled to electron capture and flame thermionic detectors (GC/ECD/FTD) and confirmation of residues was done on gas chromatograph coupled with mass spectrometry (GC-MS). The developed method was validated by testing the following parameters: linearity, limit of detection (LOD), limit of quantification (LOQ), matrix effect, accuracy–precision and measurement uncertainty; the validation study clearly demonstrated the suitability of the method for its intended application. All pesticides showed good linearity in the range 0.01–1.0 μg mL^?1 for OCs and OPs and 0.05–2.5 μg mL^?1 for SPs with correlation coefficients higher than 0.98. The method gave good recoveries for most of the pesticides (70–120%) with intra-day and inter-day precision < 20% in most of the cases. The limits of detection varied from 0.003 to 0.03 mg kg^?1, and the LOQs were determined as 0.01-0.049 mg kg^?1. The expanded uncertainties were <30%, which was distinctively less than a maximum default value of ±50%. The proposed method was successfully applied to determine pesticide residues in 12 commercial market samples obtained from different locations in India.     

Microbial siderophores and their potential applications: a review

Siderophores are small organic molecules produced by microorganisms under iron-limiting conditions which enhance the uptake of iron to the microorganisms. In environment, the ferric form of iron is insoluble and inaccessible at physiological pH (7.35–7.40). Under this condition, microorganisms synthesize siderophores which have high affinity for ferric iron. These ferric iron-siderophore complexes are then transported to cytosol. In cytosol, the ferric iron gets reduced into ferrous iron and becomes accessible to microorganism. In recent times, siderophores have drawn much attention due to its potential roles in different fields. Siderophores have application in microbial ecology to enhance the growth of several unculturable microorganisms and can alter the microbial communities. In the field of agriculture, different types of siderophores promote the growth of several plant species and increase their yield by enhancing the Fe uptake to plants. Siderophores acts as a potential biocontrol agent against harmful phyto-pathogens and holds the ability to substitute hazardous pesticides. Heavy-metal-contaminated samples can be detoxified by applying siderophores, which explicate its role in bioremediation. Siderophores can detect the iron content in different environments, exhibiting its role as a biosensor. In the medical field, siderophore uses the “Trojan horse strategy” to form complexes with antibiotics and helps in the selective delivery of antibiotics to the antibiotic-resistant bacteria. Certain iron overload diseases for example sickle cell anemia can be treated with the help of siderophores. Other medical applications of siderophores include antimalarial activity, removal of transuranic elements from the body, and anticancer activity. The aim of this review is to discuss the important roles and applications of siderophores in different sectors including ecology, agriculture, bioremediation, biosensor, and medicine.     

Effects of technical and allocative inefficiencies on energy and nonenergy elasticities: an analysis of energy-intensive industries in China

Elasticity of substitution is traditionally estimated while ignoring technical and allocative inefficiencies, which could bias the estimates. We estimate elasticity of substitution for Chinese energy-intensive sectors by incorporating these inefficiencies. The results show most of the sectors are low substitutes between input factors and stress important differences among energy-intensive sectors. Concerning the cross-price elasticity for energy, with respect to capital (labor), the sectors are mainly characterized by weak substitutability or complementary. These imply the production structure is quite rigid and capital cannot be so readily used as a substitute for energy.