Removal of organic matter and nitrogen from river water in a model floodplain

A significant improvement in river water quality cannot be expected unless nonpoint-source contaminants are treated in addition to the further treatment of point-source contaminants. If river water is sprayed over a floodplain, the consequent water filtration through the sediment profile can simultaneously remove organic matter and nitrogen in the water through aerobic and denitrifying reactions. This hypothesis was tested using lysimeters constructed from polyvinyl chloride (PVC) pipe (150 cm long, 15 cm in diameter) packed with loamy sand floodplain sediment. Water was applied to the top of the lysimeters at three different flow rates (48, 54, and 68 mm d(-1)). Concentrations of NO3 and dissolved oxygen (DO), chemical oxygen demand (COD), and redox potential (Eh) in the water were measured as functions of depth after the system reached steady states for both water flow and reactions. At the rate of 68.0 mm d(-1), a reducing condition for denitrification developed below the 5-cm depth due to the depletion of O2 by organic matter degradation in the surface oxidizing layer; Eh and DO were below 205 mV and 0.4 mg L(-1), respectively. At a depth of 70 cm, COD and NO3-N concentration decreased to 5.2 and 3.8 mg L(-1) from the respective influent concentrations of 17.1 and 6.2 mg L(-1). Most biodegradable organic matter was removed during flow and further removal of NO3 was limited by the lack of an electron donor (i.e., organic matter). These results indicate that the floodplain filtration technique has great promise for treatment of contaminated river water.     

Relationships between spatial and temporal variabilities in airborne metal distributions in Won Ju City, Korea

The relationship between temporal and spatial factors in controlling the metal distribution characteristics was investigated using the monthly metal concentration data collected from four distinctive sampling sites (grassland, residential, commercial, and industrial site) of Won Ju City, Kang Won province for approximately 4-year periods between 1991 and 1995. In order to compare the relative role of spatial and temporal factors, two-factor analysis of variance (ANOVA) was applied to these data sets. For the application of this method, temporal factors were investigated in terms of both annual and seasonal basis. The results of our data analysis indicated several interesting aspects of metal-to-metal distribution behavior such that: (1) Pb, Fe, and Cu tend to exhibit strong variabilities in both spatial and temporal scale, (2) the distribution variabilities for Mn are almost negligible in both temporal and spatial scale, (3) Cd is more variable in temporal, rather than spatial, sense, and (4) Cr and Ni can exhibit more variable patterns depending on temporal scale selected for data analysis. On the basis of this study, the relative roles of spatial and temporal factors are described in relation to each other and to different metal species.     

The adsorption characteristics of heavy metals by various particle sizes of MSWI bottom ash

The incineration rate of municipal solid waste (MSW) has been increased because of difficulty in securing a proper disposal site for MSW in Korea. The advantage of incineration is reduction of the volume of waste; however, significant amounts of bottom ash and fly ash were generated in the incineration process. Their treatment has attracted growing interest because of the potential toxicity of hazardous heavy metals. Generally, heavy metals are less released from bottom ash than from fly ash. In this study the adsorption characteristics of heavy metals were investigated using various particle sizes of MSWI bottom ash. Since bottom ash has a broad particle size distribution, it was sieved to size classes of +20, -20, -48, -80, -100 mesh. Cation exchange capacity (CEC) was analyzed by the ammonium acetate method to evaluate the potential as an adsorbent. The CEC values and surface areas increase as the range of particle size becomes finer. The adsorption experiment was conducted using synthetic (Cu and Ni) and plating rinse water as a function of reaction time (10-180 min), liquid/solid ratio (2-100) and particle size (+20 to -100 mesh), respectively. The adsorption rate increased with decreasing particle size and with increasing liquid/solid ratio; however, the removal efficiency of Cu was higher than that of Ni. In the case of plating rinse water, the adsorption rate decreased sharply at high liquid/solid ratio, and it showed over 80% of adsorption rates for Cu and Ni at an initial pH of 3.     

EMMC process for combined removal of organics, nitrogen and an odor producing substance

In order to improve the process performance regarding the removal of organics, nitrogen, and an odor-causing compound (sulfide) contained in domestic wastewater, an entrapped-mixed-microbial cell (EMMC) with and without humic substances for both fixed and moving carrier reactors and conventional suspended growth culture (i.e. conventional activated sludge process) were investigated simultaneously. Both synthetic (simulated to the organics concentration of general domestic sewage) and actual domestic wastewater were investigated under operational conditions of 12 h of hydraulic retention time (HRT) with 1 h of aeration and 1 h of non-aeration, and 6 h of HRT with continuous aeration, at a room temperature of 25 +/- 2 degrees C. It was found that entrapping humic substances in the EMMC carriers had no impact on the removal of organics, nitrogen, and the odor-producing compound. Additionally, the performance of the EMMC moving carrier system for the removal of these pollutants is similar to that of the EMMC fixed carrier system. In general, the EMMC associated systems which provide high solids retention time achieve a better removal of chemical oxygen demand (COD), nitrogen, and the odor-producing substance than the suspended growth system for both HRTs of 6 h (continuous aeration) and 12 h (1 h of aeration and 1 h of non-aeration). Both the fixed and moving carrier EMMC processes, therefore, have the potential for improvement or replacement of the existing conventional activated sludge process with regard to improving the effluent qualities (such as COD, nitrogen and odor-producing compound) for reuse/disposal.     

Treatment of 2,4-dichlorophenol polluted soil with free and immobilized laccase

Enzyme treatment is currently considered for remediation of terrestrial systems polluted with organic compounds. In this study, two soils from Pennsylvania with 2.8 or 7.4% organic matter contents (Soils 1 and 2, respectively) were amended with 14C-labeled 2,4-dichlorophenol (2,4-DCP) and incubated with a laccase from Trametes villosa (free or immobilized on montmorillonite). 2,4-DCP was either transformed to methanol-soluble polymeric products (11-32%) or covalently bound to soil organic matter (53-85%); unaltered 2,4-DCP could be recovered from soil by methanol extraction (0-38%) at the completion of a 14-d incubation period. In Soil 1, both free and immobilized laccase removed 100% of 2,4-DCP without regard for moisture conditions. In Soil 2, immobilized laccase removed more 2,4-DCP (about 95%, regardless of moisture conditions) than free enzyme (55, 75, and 90% at 30, 55, and 100% of maximum water-holding capacity, respectively). Binding of 2,4-DCP in the humin fraction was nearly the same for free and immobilized laccase. More 2,4-DCP, however, was bound to humic and fulvic acids in the presence of immobilized laccase than in the presence of free laccase. In general, immobilized laccase performed better than free laccase. However, for practical applications, the higher activity of immobilized laccase is offset by a 23% loss in enzyme activity during immobilization, which approximates the 30% increase in free laccase needed to achieve the same level of remediation. Furthermore, immobilized laccase is more costly than free T. villosa laccase.     

Selective leaching of valuable metals from waste printed circuit boards

This study was carried out to recover valuable metals from the printed circuit boards (PCBs) of waste computers. PCB samples were crushed to smaller than 1 mm by a shredder and initially separated into 30% conducting and 70% nonconducting materials by an electrostatic separator. The conducting materials, which contained the valuable metals, were then used as the feed material for magnetic separation, where it was found that 42% of the conducting materials were magnetic and 58% were nonmagnetic. Leaching of the nonmagnetic component using 2 M H2SO4 and 0.2 M H2O2 at 85 degrees C for 12 hr resulted in greater than 95% extraction of Cu, Fe, Zn, Ni, and Al. Au and Ag were extracted at 40 degrees C with a leaching solution of 0.2 M (NH4)2S2O3, 0.02 M CuSO4, and 0.4 M NH4OH, which resulted in recovery of more than 95% of the Au within 48 hr and 100% of the Ag within 24 hr. The residues were next reacted with a 2 M NaCl solution to leach out Pb, which took place within 2 hr at room temperature.     

Fluctuations of exposure rate at regional radiation monitoring stations in Korea

Based on hourly means of exposure rate between August 2000 and July 2001 at nine Regional Radiation Monitoring Stations (RRMS) in Korea, we analyzed spatio-temporal characteristics of exposure rate. The mean and fluctuations of exposure rates were 99 and 3.8 nGy h(-1), respectively. The hourly exposure rate over 9 RRMS indicated a diurnal pattern with the exposure rates reaching a maximum between 5:00 and 8:00 a.m. in the early morning and a broad minimum between 4:00 and 10:00 p.m. in the afternoon. The fluctuations of exposure rate in the inland areas were less than 3.2 nGy h(-1), and those of exposure rate in coastal areas were larger than 3.9 nGy h(-1). The frequency distribution of exposure rates had one peak around the mean and was to be skewed to the right or positively skewed and its tails were fatter than those of a normal distribution. The interrelations of exposure rates at each station generally decreased with the distance between the stations. Empirical orthogonal function (EOF) analysis showed that almost all (99.9%) of exposure rate fluctuations were described by simultaneous variations. The spatial distribution of the first EOF modes of actual, low-pass (periods longer than one month) and high-pass (periods shorter than one month) exposure rate series were similar to each other.     

Benefits-based analysis of visitor use of Sorak-san National Park in Korea

Benefits-based management seeks to provide recreation benefits for recreation participants by managing the physical environments in which recreation occurs. This study investigates the relationship between benefits desired by visitors and the physical, social, and managerial characteristics of settings that facilitate realization of recreation benefits. Data such as perceived benefits from recreation experiences, setting attributes that significantly influenced perceived benefits, and sociodemographic variables were collected from 376 visitors to Sorak-san National Park in the eastern part of the Korean peninsula. Cluster analysis was used to group visitors' desired benefits into 12 domains: relationship with nature/scenery, escaping pressure, learning about nature, family togetherness, introspection, exploration, autonomy/achievement, being with friends, leading others, skills/learning, risk taking, and meeting/observing new people. Multiple regression was used to link benefit domains with the characteristics of settings. The social attribute of recreation settings was linked to eight of the ten benefit domains. There were two statistically strong multiple regression correlations: (1) between domain of “relationship with nature /scenery” and the attributes “forest/water,”“attractive nature,” and “facility/maintenance” and (2) between the domain of “escaping pressure” and the attributes “attractive nature” and “social.” The results of this study are useful to managers in their efforts to provide recreation opportunities for visitors to achieve beneficial outcomes.     

Cultured human-cell-based bioassay for environmental risk management

Among bioassays for evaluating various impacts of chemicalson humans and ecosystems, those based on culturedmammalian-cells can best predict acute lethal toxicity to humans. Weexpect them to be employed in the future in environmentalrisk management alongside mutagenicity tests and endocrine-disrupting activity tests. We recently developed adisposable bioassay device that immobilizes humanhepatocarcinoma cells in a small micropipette tip. Thisenables very quick (within 2 h) evaluation of acute lethaltoxicity to humans. For bioassay-based environmentalmanagement, 2 promising approaches have been demonstrated bythe US-EPA: toxicity identification evaluation (TIE) andtoxicity reduction evaluation (TRE). The Japanese Ministryof Environment has been supporting a multi-center validationproject, aimed at assembling a bioassay database. To makefull use of these resources, we present a numerical modelthat describes contribution of individual chemical toobserved toxicity. This will allow the selection of the mosteffective countermeasure to reduce the toxicity. Bioassay-based environmental risk management works retrospectively,whereas impact assessment using substance flow models andtoxicity databases works prospective. We expect that these 2approaches will exchange information, act complementarily,and work effectively in keeping our environment healthy inthe 21st century.     

Status of recycling end-of-life vehicles and efforts to reduce automobile shredder residues in Korea

The present end-of-life vehicle (ELV) recycle rate and management status during the dismantling stage were investigated to aid the establishment of policies for the management of ELVs by surveying information and using the results gained from questionnaires given to dismantlers. The average recycle rate at the dismantling stage was 44% of the mass of a new vehicle and the rest of the ELV was then compressed and transported to shredding companies to recover mainly the iron content, which averaged 38.7% of the mass of a new vehicle. Nonferrous metals such as copper, antimony, zinc, and aluminum accounted for only 1.5%. The automobile shredder residues (ASRs) were composed of light and heavy fluffs and soil/dust and amounted to 15.8% based on the mass of a new vehicle. The dumping of fluff and inorganic residues in landfill sites, however, will be restricted when new regulations are implemented to reduce the disposal amount to less than 5% of a new car, as has been done in European countries and in Japan. The detailed characteristics of ASR were investigated to suggest appropriate means of treatment such as volume reduction or the utilization of thermal technologies to meet future expected enforcement. Also, some concerns on hazardous pollutant release such as that of dioxins while utilizing such thermal treatment methods were considered. The present on-going research and development projects to meet such future management targets are also introduced.