Low-impact development for impervious surface connectivity mitigation: assessment of directly connected impervious areas (DCIAs)

Urbanization increases directly connected impervious area (DCIA), the impervious area that is hydraulically connected to downstream drainage by closed pipelines. Although the benefits of low-impact development (LID) have been examined in other studies, its effect on alleviating DCIA levels has seldom been assessed. This study measured the DCIA of urban watersheds in Houston, TX, USA. Five land-use types were categorized and the contribution of LID facilities to reducing DCIA in each type was estimated by using Sutherland's equations. The results showed (1) DCIA in commercial areas was greater than that in residential areas, especially for big-box retailers; (2) the percentage of DCIA reduction by LID varied by land-use type; and (3) optimal combinations of LID application could maximize the effectiveness of DCIA reduction. The results contribute to prioritizing land-use type for implementing LID practices and providing local governments with a useful measure to estimate runoff volume.     

Physicochemical parameters aid microbial community? A case study from marine recreational beaches,Southern India

A total of 176 (water and sediment) samples from 22 stations belonging to four different (urban, semi-urban, rural, and holy places) human habitations of Tamil Nadu beaches were collected and analyzed for physiochemical and microbial parameters during 2008–2009. Bacterial counts were two- to tenfold higher in sediments than in water due to strong bacterial aggregations by dynamic flocculation and rich organic content. The elevated bacterial communities during the monsoon explain rainfalls and several other wastes from inlands. Coliform counts drastically increased at holy and urban places due to pilgrimage and other ritual activities. Higher values of the pollution index (PI) ratio (>1) reveals, human fecal pollutions affect the water quality. The averaged PI ratio shows a substantial higher microbial contamination in holy places than in urban areas and the order of decreasing PI ratios observed were: holy places?>?urban areas?>?semi-urban areas?>?rural areas. Correlation and factor analysis proves microbial communities were not related to physicochemical parameters. Principal component analysis indicates 55.32 % of the total variance resulted from human/animal fecal matters and sewage contaminants whereas 19.95 % were related to organic contents and waste materials from the rivers. More than 80 % of the samples showed a higher fecal coliform and Streptococci by crossing the World Health Organization's permissible limits.     

Exploring the risks and benefits of flexibility in biodiversity offset location in a case study of migratory shorebirds

Biodiversity offsets aim to counterbalance the residual impacts of development on species and ecosystems. Guidance documents explicitly recommend that biodiversity offset actions be located close to the location of impact because of higher potential for similar ecological conditions, but allowing greater spatial flexibility has been proposed. We examined the circumstances under which offsets distant from the impact location could be more likely to achieve no net loss or provide better ecological outcomes than offsets close to the impact area. We applied a graphical model for migratory shorebirds in the East Asian–Australasian Flyway as a case study to explore the problems that arise when incorporating spatial flexibility into offset planning. Spatially flexible offsets may alleviate impacts more effectively than local offsets; however, the risks involved can be substantial. For our case study, there were inadequate data to make robust conclusions about the effectiveness and equivalence of distant habitat-based offsets for migratory shorebirds. Decisions around offset placement should be driven by the potential to achieve equivalent ecological outcomes; however, when considering more distant offsets, there is a need to evaluate the likely increased risks alongside the potential benefits. Although spatially flexible offsets have the potential to provide more cost-effective biodiversity outcomes and more cobenefits, our case study showed the difficulty of demonstrating these benefits in practice and the potential risks that need to be considered to ensure effective offset placement.     

Comparison of preservation values between Internet and interview survey modes: the case of Dokdo,South Korea

With the increase in employment of Internet surveys, there is a need to address how this survey mode affects inferences. Internet and interview modes are compared in estimating the preservation value of Dokdo, South Korea. Estimates of willingness to pay in the Internet survey are smaller than those in the interview survey. This may be attributable to the interview respondents being conscious of the presence of the interviewers, given the social importance of Dokdo to Koreans. Internet surveys may be effective in reducing overestimation of the willingness to pay in situations where potential social desirability is present.     

Case study of landfill leachate recirculation using small-diameter vertical wells

A case study of landfill liquids addition using small diameter (5 cm) vertical wells is reported. More than 25,000 m³ of leachate was added via 134 vertical wells installed 3 m, 12 m, and 18 m deep over five years in a landfill in Florida, US. Liquids addition performance (flow rate per unit screen length per unit liquid head) ranged from 5.6 × 10^?8 to 3.6 × 10^?6 m³ s^?1 per m screen length per m liquid head. The estimated radial hydraulic conductivity ranged from 3.5 × 10^?6 to 4.2 × 10^?4 m s^?1. The extent of lateral moisture movement ranged from 8 to 10 m based on the responses of moisture sensors installed around vertical well clusters, and surface seeps were found to limit the achievable liquids addition rates, despite the use of concrete collars under a pressurized liquids addition scenario. The average moisture content before (51 samples) and after (272 samples) the recirculation experiments were 23% (wet weight basis) and 45% (wet weight basis), respectively, and biochemical methane potential measurements of excavated waste indicated significant (p < 0.025) decomposition.     

Mercury flows in a zinc smelting facility in South Korea

To prepare for the international mercury convention, the characteristics of mercury emissions from a zinc smelting facility in South Korea have been reviewed and a material flow analysis (MFA) has been conducted in this research. As inputs into the mercury MFA study, zinc ores and sulfuric acid were examined, whereas wastewater sludge, effluence water, spent catalyst, and emissions from the casting and roasting processes were examined as outputs. Mercury concentrations extracted from end products like zinc ingots, cadmium ingots, and sulfuric acid were then analyzed. Our results showed that the wastewater sludge discharged from the zinc smelting process had a relatively higher concentration of mercury, indicating that the concentration of mercury was further enriched in the wastewater sludge. The wastes discharged through the zinc smelting process should be thoroughly controlled, as results of the MFA showed that approximately 89 % of the mercury contained in the original input was later found in the waste. According to this study, the higher the concentration of mercury within zinc ores at the input stage, the higher is the mercury concentration found in the wastewater sludge at the output stage.     

Development of conflict techniques for left-turn and cross-traffic at protected left-turn signalized intersections

To design comprehensive traffic safety measures, the risk of the occurrence of traffic accidents must be objectively evaluated. It is difficult, however, to evaluate the effects of traffic measures in terms of the change in the number of traffic accidents, because traffic accidents are unpredictable and rare events. Therefore, this study used a traffic conflict technique to objectively evaluate traffic safety at intersections. In this study, traffic conflicts that occur at the time of a signal violation were differentiated according to type, and a traffic conflict technology was developed that would consider the severity of each type of conflict. To apply this method, traffic images were collected from the Jungja intersection and the Naejung intersection in Sungnam City, Korea and were analyzed using traffic data by means of image procedure technology. The analyses showed that of the four levels of differentiated conflict conditions, the Level 1 condition occurred most often, followed by Level 2, which occurred much less frequently than Level 1. Level 3 (serious conflicts) and Level 4 (dangerous conflicts: accidents) conditions were not detected.     

A study on the reaction characteristics of vanadium-impregnated natural manganese oxide in ammonia selective catalytic reduction

This study investigated the effect of adding vanadium (V) to natural manganese oxide (NMO) in ammonia (NH3) selective catalytic reduction (SCR). The addition of V to NMO decreased the catalytic activity at low temperatures by blocking the active site. However, the enhancement of catalytic activity was achieved by controlling NH3 oxidation at high temperatures. From the NH3 temperature programmed desorption and oxygen on/off test, it was confirmed that the amount of Lewis acid site and active lattice oxygen of the catalyst affects the catalytic performance at low temperature.     

Sources of Fine Particulate Species in Ambient Air over Lake Champlain Basin,VT

Abstract

This study is a part of an ongoing investigation of the types and locations of emission sources that contribute fine particulate air contaminants to Underhill, VT. The air quality monitoring data used for this study are from the Interagency Monitoring of Protected Visual Environments network for the period of 2001–2003 for the Underhill site. The main source-receptor modeling techniques used are the positive matrix factorization (PMF) and potential source contribution function (PSCF). This new study is intended as a comparison to a previous study of the 1988–1995 Underhill data that successfully revealed a total of 11 types of emission sources with significant contributions to this rural site. This new study has identified a total of nine sources: nitrate-rich secondary aerosol, wood smoke, East Coast oil combustion, automobile emission, metal working, soil/dust, sulfur-rich aerosol type I, sulfur-rich aerosol type II, and sea salt/road salt. Furthermore, the mass contributions from the PMF identified sources that correspond with sampling days with either good or poor visibility were analyzed to seek possible correlations. It has been shown that sulfur-rich aerosol type I, nitrate aerosol, and automobile emission are the most important contributors to visibility degradation. Soil/dust and sea salt/road salt also have an added effect.     

A real-time monitoring and assessment method for calculation of total amounts of indoor air pollutants emitted in subway stations

Subway systems are considered as main public transportation facility in developed countries. Time spent by people in indoors, such as underground spaces, subway stations, and indoor buildings, has gradually increased in the recent past. Especially, operators or old persons who stay in indoor environments more than 15 hr per day usually influenced a greater extent by indoor air pollutants. Hence, regulations on indoor air pollutants are needed to ensure good health of people. Therefore, in this study, a new cumulative calculation method for the estimation of total amounts of indoor air pollutants emitted inside the subway station is proposed by taking cumulative amounts of indoor air pollutants based on integration concept. Minimum concentration of individual air pollutants which naturally exist in indoor space is referred as base concentration of air pollutants and can be found from the data collected. After subtracting the value of base concentration from data point of each data set of indoor air pollutant, the primary quantity of emitted air pollutant is calculated. After integration is carried out with these values, adding the base concentration to the integration quantity gives the total amount of indoor air pollutant emitted. Moreover, the values of new index for cumulative indoor air quality obtained for 1 day are calculated using the values of cumulative air quality index (CAI). Cumulative comprehensive indoor air quality index (CCIAI) is also proposed to compare the values of cumulative concentrations of indoor air pollutants. From the results, it is clear that the cumulative assessment approach of indoor air quality (IAQ) is useful for monitoring the values of total amounts of indoor air pollutants emitted, in case of exposure to indoor air pollutants for a long time. Also, the values of CCIAI are influenced more by the values of concentration of NO₂, which is released due to the use of air conditioners and combustion of the fuel. The results obtained in this study confirm that the proposed method can be applied to monitor total amounts of indoor air pollutants emitted, inside apartments and hospitals as well.

Implications: Nowadays, subway systems are considered as main public transportation facility in developed countries. Time spent by people in indoors, such as underground spaces, subway stations, and indoor buildings, has gradually increased in the recent past. Especially, operators or old persons who stay in the indoor environments more than 15 hr per day usually influenced a greater extent by indoor air pollutants. Hence, regulations on indoor air pollutants are needed to ensure good health of people. Therefore, this paper presents a new methodology for monitoring and assessing total amounts of indoor air pollutants emitted inside underground spaces and subway stations. A new methodology for the calculation of cumulative amounts of indoor air pollutants based on integration concept is proposed. The results suggest that the cumulative assessment approach of IAQ is useful for monitoring the values of total amounts of indoor air pollutants, if indoor air pollutants accumulated for a long time, especially NO₂ pollutants. The results obtained here confirm that the proposed method can be applied to monitor total amounts of indoor air pollutants emitted, inside apartments and hospitals as well.