Effect of start of main injection timing on performance,emission, and combustion characteristics of a VGT CI engine fueled with neem biodiesel

The performance of engine parameters is more influenced with fuel injection strategies namely start of main injection timing (SoMI). An experimental analysis was performed to find the optimum SoMI timing based on performance, emission, and combustion characteristics. Base fuel of diesel and neem biodiesel was used as test fuels. The neem biodiesel was prepared by esterification and transesterification process. It is found from literature that neem biodiesel blend NB20 with diesel gives optimum performance and emission characteristics; therefore, NB20 blend was used for experiments. A variable geometry turbocharger (VGT) compression ignition (CI) engine was used to conduct the experiments. Engine performance parameters were estimated and compared with a base fuel of diesel and with NB20 blends. In this experimentation, fuel injection pressure (FIP) of 800 bar and engine speed of 1700 rpm were considered. SoMI timing was varied from 2° to 10° bTDC with an increment of 2° bTDC timing. Cylinder pressure (CP) and heat release rate (HRR) were estimated and found that are higher for diesel fuel compared to NB20 blend at different SoMI timings. The addition of neem biodiesel NB20 blend to diesel fuel decreases the exhaust emissions except NOx emissions. The BSFC was considerably reduced and BTE was improved almost equivalent to the diesel fuel for NB20. From the results, it is concluded that 10° bTDC SoMI timing provides 13% improvement in BTE, 21% decrement in BSFC, and 7.5% reduction in CO₂ emissions.

     

Regulation of pesticide discharge into surface and groundwater under uncertainty: A model for environmental risk‐profitability tradeoffs and policy selection

The presence of contaminants in environmental media as well as the desire to maintain a high level of economic activity has led to an important and difficult decision‐making problem for both public policy decision makers and the general public. In one sense, all of the interested parties are likely to be concerned about the potential health risks posed by the presence of contaminants in environmental media and the need to design/implement policies for their mitigation and/or removal. At the same time, however, there also appear to be concerns about the cost of these policies. These costs could be measured in terms of the potential losses in economic activity that are likely to occur when a policy is adopted. The policy can be selected from a range of alternatives, with the choice being driven in part by the stakeholders represented in the policy decision problem. In this case, two general goals might be considered: minimizing environmental risk and minimizing the economic impact of the policy considered. These two objectives are likely to be viewed as conflicting goals, and the nature of the tradeoffs between them must be taken into account in the policy selection process. This paper presents the development of a zero–one weighted goal programming model that can be used to select a preferred policy that minimizes surface and groundwater contamination as well as the economic costs of environmental policy selection. A safety rule model is developed first and then extended to the zero–one weighted goal programming formulation. The stochastic aspects of these structures are emphasized throughout. The paper also addresses a number of issues related to implementation of the model.     

Environmental response to intentional dissemination of Bacillus anthracis spores in the United States–2001

The intentional dissemination of Bacillus anthracis (anthrax) spores at multiple locations in the United States in the fall of 2001 resulted not only in several deaths and illnesses (including psychological effects), but likely changed lifestyles and attitudes, and increased the public's awareness of individual vulnerability. While federal resources had previously been committed to preparing local public health agencies for counter‐terrorism activities and to enhance environmental and medical response, these release episodes have increased the consistency of environmental and medical response activities, and increased government resources for homeland security. This article abstracts current information from many sources that summarize the environmental responses to the anthrax releases. The article discusses the international agreements and the U.S. regulations concerning biological weapons, the characteristics of the anthrax organism, potential exposure pathways, adverse health conditions resulting from inhalation exposure, the environmental response to two specific release episodes, environmental sampling and analytical procedures, recommended personal protective equipment, and the subsequent federal efforts to improve response capabilities. © 2003 Wiley Periodicals, Inc.     

Increased risk of non-Hodgkin lymphoma and serum organochlorine concentrations among neighbors of a municipal solid waste incinerator

Organochlorine chemicals may contribute to an increased risk of non-Hodgkin lymphoma (NHL) within non-occupationally exposed populations. Among these chemicals, dioxins and furans were mainly released by municipal solid waste incinerators (MSWIs) until a recent past in France, a source of exposure that is of public concern. We investigated organochlorines and the risk of NHL among neighbors of a French MSWI with high levels of dioxin emissions (Besan?on, France), using serum concentrations to assess exposure. The study area consisted of three electoral wards, containing or surrounding the MSWI. Pesticides, dioxins, furans, and polychlorinated biphenyls (PCBs) were measured in the serum of 34 newly diagnosed NHL cases (2003-2005) and 34 controls. Risks of NHL associated with each lipid-corrected serum concentration were estimated using exact logistic regression. The pesticides β-hexachlorocyclohexane (odds ratio [OR]=1.05, 95% confidence interval [CI]=1.00-1.12, per 10 ng/g lipid) and p,p' dichloro-diphenyl-trichloroethane (DDT) (OR=1.20, 95% CI=1.01-1.45, per 10 ng/g lipid) were associated with NHL risk. Evidence indicated an increased NHL risk associated with cumulative WHO(1998)-toxic equivalency factor (TEQ) concentrations (dioxins, OR=1.12, 95% CI=1.03-1.26; furans, OR=1.16, 95% CI=1.03-1.35; dioxin-like PCBs, OR=1.04, 95% CI=1.00-1.07; and total TEQ, OR=1.04, 95% CI=1.01-1.05), as well as with non dioxin-like PCBs (OR=1.02, 95% CI=1.01-1.05, per 10 ng/g lipid). Most congener-specific associations were statistically significant. This study provides strong and consistent support for an association between serum cumulative WHO(1998)-TEQ concentrations, at levels experienced by people residing in the vicinity of a polluting MSWI, and risk of NHL.     

Study of engine performance,emission and combustion characteristics fueled with diesel-like fuel produced from waste engine oil and waste plastics

Utilizing oil extracted from waste engine oil and waste plastics, by pyrolysis, as a fuel for internal combustion engines has been demonstrated to be one of the best available waste management methods. Separate blends of fuel from waste engine oil and waste plastic oil was prepared by mixing with diesel and experimental investigation is conducted to study engine performance, combustion and exhaust emissions. It is observed that carbon monoxide (CO) emission increases by 50% for 50% waste plastic oil (50WPO:50D) and by 58% for 50% waste engine oil (50WEO:50D) at full load as compared to diesel. Unburnt hydrocarbon (HC) emission increases by 16% for 50WPO:50D and by 32% for 50WEO:50D as compared to diesel at maximum load. Smoke is found to decrease at all loading conditions for 50WPO:50D operation, but it is comparatively higher for 50WEO:50D operation. 50WPO:50D operation shows higher brake thermal efficiency for all loads as compared to 50WEO:50D and diesel fuel operation. Exhaust gas temperature is higher at all loads for 50WPO:50D and 50WEO:50D as compared to diesel fuel operation.

Open image in new window

     

Remediation of contaminated lands: a decision methodology for site owners

Deciding how to remediate and redevelop contaminated lands should involve more than just selecting remediation techniques to clean a site to meet regulations for a predetermined site use. Owners and their consultants also need to understand aspects such as alternative site uses and liability, and how issues such as uncertainty can affect them. A methodology has been developed that provides a framework for current site owners when making decisions. It clarifies the above issues and details the type of information that is needed. It offers a step-by-step approach to improve decision making when contemplating remediation of contaminated sites by identifying the site use and remedial action combination that maximizes the current owner's net benefits. It examines various factors in decision making--with special emphasis on the timely issues of liability and uncertainty--and how expert opinion can be used to address diverse or incomplete data. Future research should include developing a complementary methodology that incorporates community and ecological objectives, resulting in a unified decision framework.     

STABLE HYDROGEN AND OXYGEN ISOTOPE COMPOSITION OF PRECIPITATION IN NORTHEASTERN COLORADO1

ABSTRACT: Where data are available, hydrologic studies may use precipitation's stable oxygen and hydrogen isotope composition to investigate streamflow, ground water/surface water interaction, and ground water recharge. Paleoclimate studies utilize the δ¹⁸O_{precipitation}‐T_air relationship, in conjunction with lake sediments, fossils, or old ground waters, for example, to estimate pale‐otemperatures. Ecological studies utilize precipitation and soil water isotope composition to track moisture uptake in plants, and to trace species migration patterns. Such studies require that the isotopic composition of precipitation be known. Oxygen‐18 (δ¹⁸O) and deuterium (δ²H) data for precipitation are lacking in the semi‐arid portion of the north‐central U.S. Great Plains, and thus there is a need to establish additional meteoric water lines as isotope input functions across the region, as well as to develop better understanding of the isotopic climate linkages that control oxygen and hydrogen isotope ratios in precipitation. This study determined the δ¹⁸O and δ²H composition of precipitation in the Pawnee Grasslands of northeastern Colorado from 1994 through 1998 using archived National Atmospheric Deposition Program samples. The resulting local water line follows the relationship δ²H = 7.86 δ¹⁸O‐7.66, and the data show a δ¹⁸O_weekly ‐ T_weekly relationship of δ¹⁸O = 0.560‐T (°C)‐18.8.     

Diversity of soft-bottom benthos in a tropical estuary: Gulf of Nicoya,Costa Rica

The community structure of soft-bottom infauna is described for the Gulf of Nicoya, Costa Rica, Central America, with special reference to the relationship between diversity and a tropical estuary. Of the 205 species of invertebrates collected in July, 1980, polychaetes comprised 58.6% by number of species and 68.1% by number of individuals. Density ranged from zero to 8 744 m^-2 with a mean of 1 269 m^-2 per station, and biomass ranged from zero to 10.986 g m^-2 with a mean of 2.010 g m^-2. Numerical analysis indicated considerable faunal homogeneity, characterized by polychaetes. Five major polychaete feeding guilds were recognized. From measures of diversity we concluded that the soft-bottom community of the Gulf of Nicoya was not rich for a tropical estuary. Physical processes (riverine runoff and frontal systems) mainly influenced community structure and function in the lower Gulf whereas biological processes (predation) seemed to prevail in the upper Gulf.Southern California Ocean Studies Consortium Contribution No. 23     

Seasonal variations in Delaware Bay phytoplankton community structure

Whole-water phytoplankton samples were obtained from 3 stations in Delaware Bay on a once- or twice-monthly basis from June 13, 1974 to May 28, 1975. The flora was composed primarily of small flagellates during the summer and early fall, while diatoms dominated from October to May. Peak cell numbers occurred during fall and early spring blooms. Evenness diversity was lowest during periods of maximum diatom abundance and highest when microflagellates predominated. There was a gradual shift in dominance, except during the early spring Skeletonema costatum bloom. Cluster analysis allowed the separation of the flora into 3 time groups and 8 recurrent species groups. The species composition and community structure of Delaware Bay phytoplankton is compared with other USA east-coast estuaries where comparable sampling techniques have been used.Contribution No. 129 from the Ira C. Darling Center and No. 129 from the College of Marine Studies.     

Effect of alum addition on the performance of submerged membranes for wastewater treatment.

The effect of aluminum sulfate (alum) addition on membrane performance was investigated, with a particular focus on membrane fouling. During initial operation, alum was added and the performance monitored. After terminating alum addition, the transmembrane pressure (TMP), which is indicative of membrane resistance to flow or fouling, increased. Accompanying the increase in TMP was an increase in the organic nonsettleable fraction (colloidal + dissolved) content of the mixed liquor and deterioration of permeate quality and floc strength. Permeate polysaccharide concentrations increased significantly, suggesting a preferential binding of solution polysaccharides by alum. Upon reinitiating alum addition, the TMP only partially recovered, indicating some irreversible fouling, while mixed liquor nonsettleable organic material, permeate quality, and floc strength returned to initial levels. These results suggest that direct alum addition to membrane bioreactors can improve membrane performance by reducing the organic fouling material and improving floc structure and strength. It appears that bulk liquid polysaccharides may contribute to irreversible membrane fouling, and this fraction can be efficiently controlled through the alum addition.