封闭式芦苇湿地处理钻井泥浆的可行性研究

研究了现场中试条件下芦苇湿地处理钻井泥浆的可行性及钻井泥浆对土壤和芦苇等湿地介质的影响。研究结果表明：在7个月运行期内，单位面积钻井泥浆施入量5kg/m^2,20kg/m^2和40kg/m^2的芦苇湿地对矿物油的迁移降解率分别为75％－85％，78％－90％和65％－90％；钻进泥浆中的矿物油对湿地土壤的污染基本局限于表层，对深层土壤的污染趋势并不明显，一般40cm以下矿物含量已低于对照区表层土的背景值；钻井泥浆能增加芦苇的生物量，对芦苇品质指标的影响很小。     

Prenatal diagnosis of β-thalassaemia in Mediterranean populations by dot blot analysis with DNA amplification and allele specific oligonucleotide probes

In this study, we describe a simple strategy to detect β-thalassaemia mutations in prospective parents and to make prenatal diagnosis in pregnancies at risk in the Mediterranean population. Screening of prospective parents is carried out by dot blot analysis on enzymatically amplified DNA with a set of oligonucleotide probes complementary to the most common mutations in this population. Prenatal diagnosis is accomplished by the same procedure on enzymatically amplified amniocyte or trophoblast DNA. The main advantages of this procedure are the simplicity, sensitivity (0.05 μg of DNA), and rapidity (12–24 h). Further simplification is obtained by amplification of the DNA from crude amniotic cell lysate. The very low amount of fetal material necessary for this analysis eliminates the need to culture amniotic fluid cells and may decrease the fetal loss rate associated with trophoblast sampling. The number of specific DNA sequences obtained by the amplification procedure allowed us to use non-radioactive labelled oligonucleotide probes, which have several advantages compared to radioactive probes.     

煤矿轴流式局部通风机的降噪试验研究

煤矿局部通风机（简称“局扇”）的噪声是煤矿掘进中的主要噪声源，分析了局扇噪声的产生机理，提出了减少局扇的动叶叶顶与机壳间隙，在局扇入口加阻性消声器和在机壳涂上一层阻尼材料等方法来控制局扇的噪声方法，方法在JBT52－2型局扇的试验研究表明，实施上海降噪措施，局扇的噪声有大幅度降低，可使局扇的噪声达到工矿企业噪声卫生标准要求。     

移动床生物膜反应器充氧能力的试验研究

对移动床生物膜反应器的充氧能力进行了试验研究，结果表明：反应器充氧能力在添加填料比无填料时大；在悬浮载体能够均匀流化的填充率范围内，反应器充氧能力随着填充率的增大而增大；当填充率大于可以均匀流化的最大填充率时，反应器的充氧能力略有下降。     

伊宁市饮用水源地水质变化动态趋势分析

根据近10年的监测数据，对伊宁市饮用水源地水质变化进行动态趋势分析，无显著变化。     

A study on oxidative degradation of polyacrylamide in wastewater with UV/FENTON/C4H4O62−

The degradation of polyacrylamide (PAM) in simulate wastewater was studied in UV/Fenton/C₄H₄O₆^2? system. The factors such as molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2?, pH, and the dosage of Fenton reagent that could affect the PAM degradation in the UV/Fenton/C₄H₄O₆^2? system were investigated. The experimental results showed that adding C₄H₄O₆^2? to UV/Fenton system could form photosensitive ferrous complexes, which led to higher degradation efficiency of PAM. The degradation rate of PAM could be up to 95.2% under the following conditions: the concentration of H₂O₂, Fe²⁺, and C₄H₄O₆^2? were 22.5, 2.25, and 2.25 mmol/L, respectively (i.e., molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2? was 10:1:1), the pH value was 3.0.     

Comparison of the daily global solar radiation from different data sources in Northwest China climate

The solar radiation data are of high importance to the solar energy systems. Conventional methods to obtain the solar radiation data are from weather stations, solar radiation models, commercial software databases, and field measurements. In the present study, a new daily global solar radiation model is proposed, by combining the quadratic function of sunshine fraction and sine function of the day of the year. The solar radiation model calculated data are then compared with China Meteorological Data Sharing System (CMDSS) data, TRNSYS data, and field-measured data in Northwest China climate. It is found that the newly proposed solar radiation model has better performance than the other nine solar radiation models in the literature. The solar radiation model calculated data fit well with the CMDSS annually average data. The TRNSYS data are a bit larger than the CMDSS annually average data in summer half year and a little smaller than those in winter half year. The solar radiation model and the CMDSS annually average data have the best correlation, whereas the TRNSYS data and the field-measured data have the worst correlation. The solar radiation model calculated data have the best correlation with the other three data sources.     

Pollution characteristics and ecological risk assessment of heavy metals in three land-use types on the southern Loess Plateau,China

The accumulation of heavy metals in agricultural soils has been the subject of great concern because these metals have the potential to be transferred to soil solutions and subsequently accumulate in the food chain. To study the persistence of trace metals in crop and orchard soils, representative surface soil samples were collected from terrace farmland that had been cultivated for various numbers of years (3, 8, 12, 15, and >20 years), terrace orchard land that had been cultivated for various numbers of years (4, 7, 10, 12, 15, 18, 25, and >30 years), and slope farmland with various gradients (3°, 5°, 8°, 12°, 15°, and 25°) and analyzed for heavy metals (As, Cr, Cu, Hg, Ni, and Zn). These samples were collected from Nihegou catchment of Chunhua county in the southern Loess Plateau of China. The six heavy metals demonstrated different trends with time or gradient in the three land-use types. The Cu and Zn contents of the soil were higher than the referee background values of the loessal soil, and the contents of Cr and Ni, and especially those of As and Hg, were lower. Cu was the only heavy metal that just met the Grade III Environmental Quality Standard for Soils of China, while the others reached grade I. Cu and Hg were considered contaminant factors and Hg was a moderate potential ecological risk factor in the catchment. Of the sites investigated, 89.5% fell into the category with a low degree of contamination (C _d ) and rest were moderate, while all three land-use types had low potential ecological risk (RI). Changes of C _d and RI were consistent with the cultivated time in the terrace farmland and terrace orchard land. Values of RI increased while C _d decreased with the increasing of slope gradient in the slope farmland. Evaluating the ecological risk posed by heavy metals using more soil samples in a larger study area is necessary on the Loess Plateau of China.     

US-UV-Fenton降解硝基苯

采用超声波(US)、紫外光(UV)和Fenton联合降解硝基苯,初步探讨了其作用规律。研究结果表明,UV可以促进双氧水转化自由基的效率,而US同时具有强化传质作用和超声氧化作用,两者均能够强化Fenton氧化硝基苯的降解过程。正交实验结果表明,H2O2初始浓度是硝基苯降解和矿化的最显著影响因素,反应时间和超声功率是矿化的显著影响因素。最佳反应条件为:H2O2500 mg/L、Fe2+10 mg/L、反应时间60 min、超声波功率100 W,此时,硝基苯完全降解,TOC去除率达到73.0%。Fenton、UV/Fenton和US/UV/Fenton降解硝基苯过程均符合伪一级反应动力学模式,反应速率常数分别为3.37×10-2、3.81×10-2和5.10×10-2min-1。     

Carbon dioxide emissions from cities in China based on high resolution emission gridded data

Based on the China high resolution emission gridded data (1 km spatial resolution), this article is aimed to create a Chinese city carbon dioxide (CO₂) emission data set using consolidated data sources as well as normalized and standardized data processing methods. Standard methods were used to calculate city CO₂ emissions, including scope 1 and scope 2. Cities with higher CO₂ emissions are mostly in north, northeast, and eastern coastal areas. Cities with lower CO₂ emissions are in the western region. Cites with higher CO₂ emissions are clustered in the Jing-Jin-Ji Region (such as Beijing, Tianjin, and Tangshan), and the Yangtze River Delta region (such as Shanghai and Suzhou). The city per capita CO₂ emission is larger in the north than the south. There are obvious aggregations of cities with high per capita CO₂ emission in the north. Four cities among the top 10 per capita emissions (Erdos, Wuhai, Shizuishan, and Yinchuan) cluster in the main coal production areas of northern China. This indicates the significant impact of coal resources endowment on city industry and CO₂ emissions. The majority (77%) of cities have annual CO₂ emissions below 50 million tons. The mean annual emission, among all cities, is 37 million tons. Emissions from service-based cities, which include the smallest number of cities, are the highest. Industrial cities are the largest category and the emission distribution from these cities is close to the normal distribution. Emissions and degree of dispersion, in the other cities (excluding industrial cities and service-based cities), are in the lowest level. Per capita CO₂ emissions in these cities are generally below 20 t/person (89%) with a mean value of 11 t/person. The distribution interval of per capita CO₂ emission within industrial cities is the largest among the three city categories. This indicates greater differences among per capita CO₂ emissions of industrial cities. The distribution interval of per capita CO₂ emission of other cities is the lowest, indicating smaller differences of per capita CO₂ emissions among this city category. Three policy suggestions are proposed: first, city CO₂ emission inventory data in China should be increased, especially for prefecture level cities. Second, city responsibility for emission reduction, and partitioning the national goal should be established, using a bottom-up approach based on specific CO₂ emission levels and potential for emission reductions in each city. Third, comparative and benchmarking research on city CO₂ emissions should be conducted, and a Top Runner system of city CO₂ emission reduction should be established.