Effect of soil solids concentration in batch tests on the partition coefficients of organic pollutants in landfill liner-soil materials

 The effect of the soil solids concentration in batch tests on the measured values of the partition coefficient (K _p) of organic pollutants in landfill liner-soil material was investigated. Since this study was based on the results of batch and column tests conducted independently, there were limitations to the conclusions derived. The organic compounds tested were benzene, methylene chloride, toluene, trichloroethylene, and p-xylene. The results of this study showed that as soil solids concentrations increased, the measured K _p values of these organic compounds strongly decreased. The observed values of K _p stabilized when the soil solids concentration was above a certain value. Typical K _p values obtained from batch tests conducted under high soil solids concentrations were close to those obtained from column tests. It was concluded that the K _p values of organic compounds measured under low soil solids concentrations, i.e., less than 100 g/l, may not correctly simulate the field situation. Consequently, the values of K _p obtained with low soil solids concentrations can result in an overestimation of the retardation factor of the landfill liner material. Received: March 14, 2002 / Accepted: August 25, 2002     

STREAM DISCHARGE PREDICTION VIA A GRID BASED SOIL WATER ROUTING WITH PADDY FIELDS1

ABSTRACT: A grid based daily hydrologic model for a watershed with paddy fields was developed to predict the stream discharge. ASCII formatted elevation, soil, and land use data supported by the GRASS Geographic Information System are used to generate distributed results such as surface runoff and subsurface flow, soil water content, and evapotranspiration. The model uses a single flow path algorithm and simulates a water balance at each grid element. A linear reservoir assumption was used to predict subsurface runoff components. The model was applied to a 75.6 km² watershed located in the middle of South Korea, and observed stream flow hydrographs from 1995 and 1996 were compared to model predictions. The stream flow predictions of 1995 and 1996 generally agreed with the observed flow, resulting in a Nash‐Sutcliffe efficiency R² of 0.60 and 0.62, respectively. The hydraulic conductivity for percolating water through the saturated layer affected baseflow generation. The levee height of the paddy influenced the time and magnitude of the surface runoff, depending on irrigation management. The model will be used for making low flow management decisions by evaluating the role of each land use to stream flow, especially in case of paddy decrease by gradual urbanization of a watershed.     

Design of a representative and cost-effective sampling programs for industrial wastewater with examples from bleached kraft pulp and paper mills

The diagram constructed for selection of sampling methods indicates that, for a systematic error, E ≤ 13%, grab sampling (GS) may be used to characterize effluents with variation coefficient of flow ≤ 120% and of contaminant concentrations ≤ 10%. For the whole studied range of variation coefficient of contaminant concentrations (2–82%), time-proportional compositing (TC) method may be applied with E ≤ 10% for effluents characterized by variation coefficients in flow < 90%. The more complicated flow-proportional compositing (FC) method is required only for effluents with larger variation coefficients or to produce more precise results. The diagram constructed for selection of sampling frequencies indicates that sequential sampling at intervals of approximately 60 min may be applied with E ≤ 10% for effluents characterized by variation coefficients ≤ 30%. Practical application of the diagrams, constructed using normal series, was checked against monitoring data from two pulp and paper mills in Vietnam. The two diagrams provided results on sampling methods and frequencies in good agreement with those obtained from actual monitoring data with percentages of agreement cases of 80 and 75%, respectively. The approach was applied in design of a monitoring program at the Bai Bang integrated pulp and paper mill in Vietnam.     

Characteristics of large cooking oil pool fires and their extinguishment by water mist

Large cooking oil pool fires, occurring in industrial oil cookers, present a severe hazard to food processing plants due to their size and the large amount of hot oil involved. This paper reports a series of full-scale fire experiments conducted in a large industrial oil cooker mock-up. The characteristics of large cooking oil pool fires and the effect of oil depth and hood position in the oil cooker on fire growth were studied. The use of water mist for extinguishing large oil pool fires and their extinguishing performance under different discharge pressure and with different types of water mist systems were investigated. Experimental results showed that the cooking oil underwent a substantial expansion in volume during heating. The fires developed quickly once the oil auto-ignited. The fire growth rate was affected by the oil depth in the pan and the hood position in the oil cooker. The water mist fire suppression systems effectively extinguished large cooking oil fires and prevented them from re-igniting. Their extinguishing performance was determined by the type of water mist system, discharge pressure and hood position in the oil cooker.     

Current status and research on E-waste issues in Asia

Rapid economic growth in Asia and the increasing transboundary movement of secondary resources will increasingly require both 3R endeavors (reduce, reuse, recycle) in each country and appropriate control of international material cycles. Recently, managing electrical and electronic waste (E-waste) has become an important target for domestic and international material cycles from the viewpoints of environmental preservation and resource utilization efficiency. To understand the current status of E-waste issues in the context of international material cycles and to discuss the future tasks related to achieving 3R in the region, we organized the National Institute for Environmental Studies (NIES) E-waste Workshop in December 2004. This article reviews past studies on E-waste and briefly describes the topics presented and discussions held at the workshop. The topics at the workshop included E-waste generation, recycling systems, international trade, and environmental impacts. In addition, we discussed various issues such as terminology, current environmental concerns, and possible solutions. Transboundary shipments of E-waste should be conducted taking into consideration the concept of sustainable development. The direction of future research and possible collaborations are also discussed.     

Facile Preparation of Chitosan Films for High Performance Removal of Reactive Blue 19 Dye from Aqueous Solution

This study aimed at finding effective strategies for high-performance removal of reactive blue 19 (RB19) dye from aqueous solution. Chitosan (CS) films had been prepared by using solvent casting with mild drying for this purpose. The CS films were characterized by X-ray diffraction, field-emission scanning electron microscopy, and Fourier transform infrared (FTIR) spectroscopy. The performance of RB19 removal using CS were evaluated by varying contact time, solution pH, initial dye concentration, and adsorbent dosage. Adsorption isotherms, kinetics, and desorption were investigated by batch experiments. Results showed that CS films exhibited the optimal adsorption performance for RB19 removal and high maximum adsorption capacities of RB19, which were 799 and 822.4 mg g^?1 at 20 and 40 °C, respectively. Adsorption kinetic data were well described by the pseudo-second-order kinetic model. FTIR analyses further indicated that interactions between RB19 and the CS film occurred during adsorption. The CS films also exhibited satisfactory desorption of RB19 at about 80 % after 30 min of desorption at pH 11. Our study demonstrated that the CS films can be easily prepared and applied for effective removal of RB19 in treatment of wastewater.     

Concentration of trace elements in feathers of waterfowl,Korea

Cadmium (Cd), lead (Pb), chromium (Cr), copper (Cu), manganese (Mn), zinc (Zn), and iron (Fe) were analyzed in the breast feather of white-fronted geese (Anser albifrons, n?=?15), mallards (Anas platyrhynchos, n?=?4), and spot-billed ducks (Anas poecilorhyncha, n?=?13) found dead in Gimpo, Korea. All of the mallards and eight of the 13 spot-billed ducks had embedded shot. Concentrations of Pb, Cr, Cu, Mn, Zn, and Fe were significantly different among waterfowl species. Mallards with embedded shot had relatively higher Pb, Cr, Mn, and Fe concentrations than the other species. Cd and Cr in feathers of waterfowl species were within the range reported for other birds, and no specimen exceeded the tentative threshold effect levels of Cd (2 μg/g dry weight (dw)) and Cr (2.8 μg/g dw) for birds. However, Pb in feathers of all four mallards and two spot-billed ducks exceeded the threshold for deleterious effects (>4 μg/g dw). Essential elements such as Cu, Mn, Zn, and Fe in the feather of waterfowl species were not at toxic levels and within the background or normal range for the homeostatic mechanisms.     

Lead and cadmium contaminations in feathers of heron and egret chicks

In birds, concentrations of heavy metal contaminants were associated with their diet and environmental quality. This study presents concentrations of lead and cadmium in feathers and the relationship between concentrations in the feather and stomach content of three species of heron and egret chicks. Cadmium concentrations were higher in the Little Egret (geomean 0.75 μg/g dry weight) and Black-crowned Night Heron (geomean 0.88 μg/g dry weight) chicks than in Grey Heron chicks (geomean 0.48 μg/g dry weight). Lead and cadmium concentrations had significant correlations between feathers and stomach contents of heron and egret chicks. The mean lead and cadmium concentrations in feathers were within the background levels for wild birds. Heron and egret species forage around breeding colony (4–7 km). Lead and cadmium concentrations in heron and egret chicks were moderately associated with those of prey concentrations. These results suggest that contaminant concentrations such as lead and cadmium in feathers of heron and egret chicks can reflect local heavy metal contaminations and serve as a great biological indicator for monitoring heavy metal contamination. In addition, the feathers can be a routine monitoring tool over time and space without harming the wild birds.