内配燃料垃圾焚烧飞灰烧结无害化处理实验研究

研究了一种垃圾焚烧飞灰烧结无害化处理的工艺,该工艺是将飞灰与不同比例煤粉混合并添加助熔剂进行造粒烧结。通过对试样进行热流和热重测量,分析了飞灰试样在加热过程中热重变化的规律,并利用XRD、扫描电镜、氮吸附分析仪等仪器分析手段对烧结试样的物相、微观形态和孔隙特性等物理化学性质进行了研究。最后采用电感耦合等离子体发射光谱仪对烧结试样重金属浸出性进行了分析。实验结果为飞灰烧结炉的设计和内配燃料烧结工艺运行参数的制定提供了依据。     

环氧化PVA载体固定漆酶的最佳工艺条件研究

在T=35℃,HAc-NaAc缓冲溶液pH为4的条件下,用环氧化PVA载体对漆酶进行固定化,固定后酶活为游离酶活的95%。用该固定化漆酶处理制浆造纸废水,反复使用6次后,酶活仍保持为初始酶活的45%,且每次COD去除率在40%以上,处理后的废水BOD增大了50%,废水可生化性得到很大提高。     

Morphology and composition of particles emitted from a port fuel injection gasoline vehicle under real-world driving test cycles

Traffic vehicles, many of which are powered by port fuel injection (PFI) engines, are major sources of particulate matter in the urban atmosphere. We studied particles from the emission of a commercial PFI-engine vehicle when it was running under the states of cold start, hot start, hot stabilized running, idle and acceleration, using a transmission electron microscope and an energy-dispersive X-ray detector. Results showed that the particles were mainly composed of organic, soot, and Ca-rich particles, with a small amount of S-rich and metal-containing particles, and displayed a unimodal size distribution with the peak at 600?nm. The emissions were highest under the cold start running state, followed by the hot start, hot stabilized, acceleration, and idle running states. Organic particles under the hot start and hot stabilized running states were higher than those of other running states. Soot particles were highest under the cold start running state. Under the idle running state, the relative number fraction of Ca-rich particles was high although their absolute number was low. These results indicate that PFI-engine vehicles emit substantial primary particles, which favor the formation of secondary aerosols via providing reaction sites and reaction catalysts, as well as supplying soot, organic, mineral and metal particles in the size range of the accumulation mode. In addition, the contents of Ca, P, and Zn in organic particles may serve as fingerprints for source apportionment of particles from PFI-engine vehicles.     

A laboratory study on migration of K+ in a two-layer landfill liner system.

Contaminant transport through the clay liner and the underIying secondary leachate drain layer (SLDL) in landfills was studied through a laboratory test, and analysis method on the transport of K+ in a two-layer soil system. The soils used for this study were Ariake clay and the underlying layer, Shirasu soil from the Kyushu region of Japan, representing the clay liner material and SLDL material, respectively. The effective diffusion coefficients (De) of the selected target chemical species, potassium (K+) for the Ariake clay and Shirasu soil were back-calculated using a computer program, and it was found that values of De derived from this study were consistent with those previously published. The hypothesis that the mechanical dispersion process can be negligible has been proved to be reasonable based on both the observation that the predicted values fit the experimental data and the analyses of two dimensionless parameters. Parametric analysis showed the transport of K+ through the soils is controlled by advection-diffusion rather than diffusion only, whereas at low Darcy velocity (i.e. < or = 10(-9) m s(-1)), transport of K+ would be controlled by diffusion. The test results and parametric analysis may be applied in design of landfill liners and SLDLs, particularly in coastal areas.     

湖北省湖泊水环境化学特征及其与人类活动的关系

通过对湖北省近３０个湖泊水环境化学的分析，探讨了湖北省湖泊水质状况和湖水的化学稳定性，指出远离工业区和居民生活区的湖泊水质一般较好，城区或城效型湖泊在不同程度上受到了工业废水和生活污水的影响。控制，消除湖泊污染是今后经济、社会和环境建设不可忽视的重要工作。     

陕西省雷电灾害易损性分析、评估及易损度区划

根据2002～2007年陕西省10个市的雷暴日和雷电灾害统计资料,结合陕西各市的经济和人口密度特征,提出了雷暴日数、雷电灾害频度、生命易损模数及经济易损模数作为各市雷电灾害易损性评估指标,并在此基础上,给出了陕西各市雷电灾害易损度评估结构.采用四级分区法对上述雷电灾害易损性评估指标进行了分级,并赋予各等级如下定值:极高级为1.0、高级为0.8、中级为0.5、低级为0.2.将陕西省10市按照四个雷电灾害易损性评估指标的所属等级获取相应等级值,将各市四个评估指标的等级值累加得到平均值作为雷电灾害易损性评估的评价指数,并利用上述四级分区法形成陕西省雷电灾害易损度区划.     

Metal accumulation in intertidal litter through decomposing leaf blades, sheaths and stems of Phragmites australis

Metal contents of decomposing leaf blades, leaf sheaths and stems of common reed (Phragmites australis) were monitored by a litter bag method on the sediment of an intertidal brackish marsh in the Scheldt estuary (The Netherlands). On monthly intervals, two litter bags were retrieved from the marsh during 9 months for both leaf blades and sheaths and during 16 months for stems. All samples were dried, weighed and analysed for ash and Cd, Cu, Cr, Ni, Pb and Zn contents. Most concentrations increased considerably during the decomposition. Generally, also a very important net metal inflow into the litter bags could be observed. The inflow was highest for leaf blades. High correlations between ash contents and metal concentrations for leaf blades suggest that the increase of leaf blade metal contents can be due to physicochemical sorption of dissolved metals and an important infiltration of mud particles, which were not removed by rinsing the leaf blades with distilled water preceding the analyses. For stems, smaller amounts of inflowing ash and even outflowing ash amounts were found, which suggests that inflow of inorganic particles is not the major factor determining metal accumulation by stems on medium term. Ergosterol concentrations in stem tissue however proved to be correlated with metal contents, which suggests a significant role of fungal litter colonizers in metal accumulation. For leaf sheaths, the effects of physicochemical sorption, infiltration of mud particles and incorporation by microbial litter colonizers do not seem to be as pronounced as for stems and leaf blades.     

GB/T 7702-2008《煤质颗粒活性炭试验方法》标准的研究

通过对GB/T 7702-2008《煤质颗粒活性炭试验方法》的修订,研究了国际上先进国家的ASTM、JIS、ГОСТ同类标准内容。本系列标准除等同采用部分国际先进标准外,还结合本国特点增加了部分国外标准没有的内容,同时着重对碘吸附值测定进行了深入研究,确定了国际先进的碘吸附值试验方法。     

环境模型参数识别与不确定性分析

在对水文模型实例的参数不确定性分析基础上,分别采用传统灵敏度分析方法、HSY算法、线性回归等方法对模型参数特性进行了识别与比较研究.结果表明参数优化算法与传统灵敏度分析方法不能解释模型结构复杂性特征,采用不确定性分析方法对环境模型参数进行识别提供了深入分析与理解模型系统的有效途径.     

A new approach to spatial source apportionment of haze pollution in large scale and its application in China

Long-lasting expansion of haze pollution in China has already presented a stern challenge to regional joint prevention and control. There is an urgent need to enlarge and reconstruct the coverage of joint prevention and control of air pollution in key area. Air quality models can identify and quantify the regional contribution of haze pollution and its key components with the help of numerical simulation, but it is difficult to be applied to larger spatial scale due to the complexity of model parameters. The time series analysis can recognize the existence of spatial interaction of haze pollution between cities, but it has not yet been used to further identify the spatial sources of haze pollution in large scale. Using econometric framework of time series analysis, this paper developed a new approach to perform spatial source apportionment. We applied this approach to calculate the contribution from spatial sources of haze pollution in China, using the monitoring data of particulate matter (PM_2.5) across 161 Chinese cities. This approach overcame the limitation of numerical simulation that the model complexity increases at excess with the expansion of sample range, and could effectively deal with severe large-scale haze episodes.