各种影响因子对电解法预处理医药废水的影响研究

探讨了电解法预处理医药废水时停留时间、电解电压、废水初始浓度、温度和废水pH值等影响因子对去除色度、COD和提高废水可生化性等处理效果的影响，并考察了其应用于工业实际废水处理的可行性。实验结果表明：电解法更适合高浓度医药废水的处理，色度的去除率可达到90％以上；电解时间宜控制在40-60min；电解电压越高，废水COD和色度去除效果越好；在实验温度范围内，温度对色度和COD去除率的影响不大；废水pH值为7．5时电解效果最佳，工程运用宜控制在6—9之间。     

城市污水处理厂除臭技术

介绍了城市污水处理厂臭气来源、成分及产量。针对目前国内外除臭技术的研究和发展情况，分析了污水处理厂的各种物理、化学和生物除臭方法的技术原理、优缺点和应用现状。结合日本城市污水处理厂的运行实际，重点介绍了一种不产生臭气的新技术——腐殖活性污泥法的工艺流程、特点及其应用现状。     

Leaching of bisphenol A (BPA) to seawater from polycarbonate plastic and its degradation by reactive oxygen species

In this study, (1) change in the concentration of bisphenol A (BPA) leached from polycarbonate (PC) tube to control water (BPA free), seawater and river water at 20 and 37 degrees C as a function of time, (2) the fate of BPA caused by addition of H(2)O(2) and Fe(3+) to seawater containing BPA leached from PC tube were assessed. BPA leached from PC tube to all water samples increased with the ascendant of temperature and with the passage of time. The BPA leaching velocity in seawater was the fastest in three samples (11 ng/day for seawater, 4.8 ng/day for river water 0.8 ng/day for control water at 37 degrees C).BPA leaching velocity from PC tube was significantly high at pH 8 (50 mM Na(2)HPO(4)) and increased dose-dependently. There was no difference in the velocity of BPA among the 50 mM phosphate-buffers at pH 6.5, 7.0 and 7.5. BPA was leached three times higher by addition of Na(+) than K(+). However, the higher the K(+) concentration, the larger the BPA leached from PC tube. Na(+) mixed with PO(4)(-) was effective on BPA leaching from PC tube, but not with SO(4)(-) or Cl(-). The results suggested that BPA leaching from PC tube would be attributed to the concentration of bibasic phosphate such as Na(2)HPO(4) and K(2)HPO(4) in water samples. BPA was degraded in both control water and seawater in the presence of radical oxygen species, but the degradation rate was lower in seawater than in control water, suggesting that anti-oxidative system exists in seawater. Neo-synthesized substance in both control water and seawater in the presence of reactive oxygen species was identified as BPA-quinone by LC-MS.     

气-水联合反冲洗膜污染防治技术研究

采用气水联合反冲洗技术,考察了气水比(Qg/Ql)、反冲洗周期及其对膜污染的防治效果。结果表明,气水联合反冲洗较单独气或水反冲洗效果好;在过滤周期20min,反冲洗时间1min,气水比1.5时,气水联合反冲洗能够恢复膜通量到膜清水通量的80%以上。此法可大幅度清除沉积在膜表面的泥饼层,恢复膜通量,维持膜过滤性能的稳定,是一种较为有效的膜污染防治技术。     

二氧化氯的发生技术

本文对国内外ＣｌＯ２的发生技术进行了综合评述，详尽地介绍了作者自行研制的ＣｌＯ２发生技术和装置，认为我国推广应用ＣｌＯ２消毒处理饮用水的时机已经成熟。     

Dechlorination of pentachloroethane by commercial Fe and ferruginous smectite

Short-term experiments were conducted to investigate the effect of a commercial Fe and an iron-bearing clay mineral, ferruginuous smectite (SWa-1), on the degradation of pentachloroethane (PCA). After 3 h of contact time, SWa-1 catalyzed PCA dehydrochlorination to tetrachloroethene (PCE, 65% conversion), whereas commercial Fe promoted PCA stepwise dechlorination via dehydrochlorination (approximately 40% conversion) and subsequent PCE hydrogenolysis to trichloroethene (TCE). The addition of unaltered SWa-1 to commercial Fe led to a complete inhibition on TCE production, whereas the addition of reduced SWa-1 barely resulted in a 30% decrease.     

高速微涡活性污泥法提高氧利用效率的研究

概述了高速微涡活性污泥法的工艺特点，并对该法提高氧的转移及利用效率进行了研究和机理分析。     

米糠生物质解毒含铬(Ⅵ)水溶液的研究

农林生物质是一种成本低、环境友好的重金属废水处理材料,也是受重金属污染环境的修复材料之一.实验讨论了初始pH值、米糠用量、吸附时间对含铬(Ⅵ)水溶液解毒的影响.结果表明,米糠对Cr(Ⅵ)存在吸附作用,同时也有解毒还原能力.100 mL浓度为100 mg/L的含铬溶液,在初始pH为2、米糠用量为3 g、吸附-反应平衡时间7 h的条件下,生物质吸附去除溶液中的铬为14.4%,而原溶液中Cr(Ⅵ)解毒了57.2%,米糠生物质吸附总铬的能力为0.48 mg Cr/g(生物质).米糠生物质有潜在的吸附铬和修复受铬污染环境的利用价值.     

北京春节期间大气颗粒物污染及影响

利用2006年春节期间的大气颗粒物浓度及粒径谱分布资料,结合大气能见度及NO2监测数据,分析了北京市鞭炮燃放禁改限后大气颗粒物污染的变化规律,以及对大气消光作用的影响.结果表明:春节期间特别是除夕夜大量鞭炮的集中燃放导致了大气颗粒物浓度的急剧升高,主要以细粒子为主;颗粒物浓度的升高致使大气能见度明显降低,鞭炮燃放最集中的时段,能见度低于2 km;燃放鞭炮产生的颗粒物是造成大气消光作用的主要因素.估算了北京市鞭炮燃放的颗粒物排放量,2006年除夕0:00～1:00市区排放了大约3.0×104kg PM10,官园监测点PM10小时最高质量浓度超过了800 μg/m3.元宵节夜间燃放鞭炮产生的颗粒物半衰期为2.4 h.     

日本二噁英减排控制的历程、经验与启示

二噁英减排控制是《关于持久性有机污染物的斯德哥尔摩公约》的重要任务,是履行公约义务的难点.对日本二噁英减排控制20年来的实践历程进行了回顾和分析,总结出了其协调管理机制设立、法律法规标准建立、监测能力建设以及宣传教育等八个方面的成功经验,对中国二噁英减排控制工作有重要的借鉴意义.