注入式低温等离子体技术用于卷烟厂异味处理的效果研究

将注入式低温等离子体技术应用于烟厂制丝排潮和制丝除尘排放气体异味处理中,研究了注入式低温等离子体发生器参数对臭味浓度、非甲烷总烃和可检出典型有机物去除率的影响规律。结果表明:注入式低温等离子体发生器工作电压越高,注入处理烟道的氧化活性物种浓度越高,注入量越大,臭味浓度、非甲烷总烃和可检出典型有机物去除率也越高。选取合理的工作电压,臭味浓度去除率可达90%以上,非甲烷总烃去除率分别达到了83.8%(制丝排潮)和78.1%(制丝除尘)。     

A panel study on the relationship between biofuels production and sustainable development

Biomass is one of the renewable energy sources on which policy makers are greatly dependent on since it is a flexible feedstock capable of conversion into electricity, transport liquid fuels and heat by chemical and biological processes on demand. Though numerous publications have examined the relationship of economic growth with renewable energy and other parameters, biomass energy has never been included in these studies. Then, this study examines the causal relationship within a multivariate panel cointegration/error correction framework which combines the cross-section and time series data while allowing for heterogeneity across different provinces. After employing panel data regression model ranging from 2003 through 2012 to examine the relationships of biofuels production with sustainable development in China, the paper concludes that the development of biofuel energy production integrated with the consideration of the improvement of income per capita, and the attraction of more capital investment, does make a significant contribution to economic growth. However, some negative side effects including the increase of greenhouse emissions and the decrease of marginal land still coexist with the economic development. Of course, the importance of these findings lies on their implications and their adoption on strategic policies.     

环境监测用氮气中多组分VOCs标准物质的研制

介绍了采用称量法制备瓶装1μmol/mol氮气中42个组分挥发性有机物(VOCs)标准物质的研制方法。建立了选择离子模式,气相色谱-质谱联用的分析方法,对目标组分在气瓶中的长期稳定性进行了考察。所选择的42种目标组分完全满足中国环境保护标准《环境空气挥发性有机物的测定吸附管采样-热脱附/气相色谱-质谱法》(HJ 644—2013)和美国环保署《使用特殊处理的采样罐/气相色谱仪检测环境大气中的挥发性有机物》(EPA TO—14A)这2个方法标准中所规定的环境空气中挥发性有机有害成分的监测要求。将研制的气体标准物质与中国计量科学研究院(NIM)和英国国家物理实验室(NPL)分别进行了比对测试,取得了良好的比对结果与国际等效度。结果表明,1μmol/mol氮气中42种组分VOCs标准物质的有效期为一年,相对扩展不确定度为5.0%(包含因子k=2),并取得国家标准物质证书GBW(E)062231。     

机械活化煤气化细渣资源化利用及残碳燃烧反应动力学探究

随着我国煤气化技术的快速发展，气化渣的产生和排放量逐年增加.煤气化细渣的大量堆存，给当地的环境保护造成了巨大的压力，已经成为限制煤化工产业基地可持续发展急需解决的重大问题.本文针对气化细渣中残碳反应活性低和转化难度大的问题，研究了机械活化法对气化渣残碳反应动力学的影响.采用Coats-Redfern法分析了机械活化对残碳反应活化能的作用规律.结果表明，机械活化8 h，残碳燃烧反应活性显著提高，650℃下的活化能由63.2 k J·mol^-1降到28.4 k J·mol^-1.不添加其他化学试剂，1000℃烧制高强度轻质陶粒，其堆积密度为0.867 g·cm^-3，筒压强度为7.67 MPa.相关研究可以为我国气化细渣的资源化利用提供一定的数据和技术基础.     

长庆油田4731B型非金属集输管道老化特性实验研究

为推广非金属复合管在油田集输油领域的应用，明确其在集输环境中的老化特性是关键问题。基于集输油现场的工程条件，针对长庆油田试用的4731B型钢丝缠绕增强复合管，以采出原油、采出水为实验介质，通过挂片实验、水压爆破实验，借助电镜扫描、拉伸测试对复合管内衬层老化行为、拉伸性能以及复合管极限承压与老化特性进行研究。结果表明:采出原油与采出水均可渗透扩散进入内衬层内部，还会发生局部深入渗透；采出原油、采出水的局部渗透速率分别可达3.4，10.6 mm/a；在某些工况下，内衬层表面产生裂纹；短时间（168 h）内的介质渗透甚至裂纹对其机械性能影响较小，而光氧老化影响显著；现场服役813 d后，复合管极限承压下降2.79%，表明复合管承压性能稳定。     

基于加速度限控制策略的振动试验过载停机实验研究

西门子Simcenter Testlab振动控制采集分析系统在航天振动试验领域应用十分广泛,但是在实际工程应用中常常由于对软件工作机制理解不到位,参数设置不合理造成试验异常中断,这不仅给产品带来了巨大的安全隐患,而且也增加了试验时间和成本,严重影响研制进度。因此,本文针对某航天产品正弦振动试验的过载停机故障,从软件加速度限控制功能的角度分析了潜在原因,并且开展了实验验证。首先描述了振动试验过程和过载停机现象,排除了硬件原因,然后对可能的加速度限控制功能设置和通道量程过小等原因设计了三组实验进行分析验证,得出了此次试验过载停机①与加速度限控制(频域)设置无关,②而与通道量程(时域)设置有关,③通过忽略限幅通道过载设置可使试验正常进行的分析结论,最后针对Simcenter Testlab加速度限控制功能和通道量程设置提出了使用建议,为后续航天产品振动试验提供参考。     

南海湖非冰封期浮游植物群落生态特征及其与环境因子关系

分别于2017、2018年的非冰封期(5—10月)对南海湖的浮游植物群落和环境因子进行了调查。共发现浮游植物7门80属157种(含变种),其中绿藻门种数最多,其次是硅藻门和蓝藻门,时间上7月最多、10月最少,空间上呈东高西低、南高北低的趋势。浮游植物密度为23.35×10~6～126.00×10~6个/L,平均值为66.78×10~6个/L。主要优势种有微小平裂藻(Merismopedia tenuissima)、水华束丝藻(Aphanizomenon flosaquae)和螺旋弓形藻(Schroederia spiralis)。南海湖水质总体处于中污染状态。冗余分析表明,TN、TP、pH和温度是影响浮游植物分布的主要环境因子,绿藻门与TN关系密切,蓝藻门与TP、温度关系密切,硅藻门与pH关系密切。     

TSLCDM长袋低压脉冲布袋除尘器及其应用

为了使电炉烟气治理过程中污染源的排放达到国家排放标准,提出一种TSLCDM长袋低压脉冲除尘器(简称TSLCDM除尘器)。通过对该除尘器结构、除尘原理以及不同工况下除尘效率和过滤阻力的分析,得到该除尘器的除尘效率>99.9%,压力损失<1200 Pa,最终排出的烟气含尘质量浓度约5.54 mg/m3,满足了国家的超低排放要求,以泉州某公司电炉项目除尘系统为研究对象,证明了该新型脉冲布袋除尘器在电炉烟气治理除尘系统的应用效果,具有很好的经济和环境效益。     

Precursors and potential sources of ground-level ozone in suburban Shanghai

• Air masses from Zhejiang Province is the major source of O₃ in suburban Shanghai. • O₃ formation was in VOC-sensitive regime in rural Shanghai. • O₃ formation was most sensitive to propylene in rural Shanghai. A high level of ozone (O₃) is frequently observed in the suburbs of Shanghai, the reason for this high level remains unclear. To obtain a detailed insight on the high level of O₃ during summer in Shanghai, O₃ and its precursors were measured at a suburban site in Shanghai from July 1, 2016 to July 31, 2016. Using the Hybrid Single-Particle Lagrangian Integrated Trajectory (HYSPLIT) model and concentration weighted trajectories (CWT), we found that Zhejiang province was the main potential source of O₃ in suburban Shanghai. When the sampling site was controlled by south-western winds exceeding 2 m/s, the O₃-rich air masses from upwind regions (such as Zhejiang province) could be transported to the suburban Shanghai. The propylene-equivalent concentration (PEC) and ozone formation potential (OFP) were further calculated for each VOC species, and the results suggested that propylene, (m+p)-xylene, and toluene played dominant roles in O₃ formation. The Ozone Isopleth Plotting Research (OZIPR) model was used to reveal the impact of O₃ precursors on O₃ formation, and 4 base-cases were selected to adjust the model simulation. An average disparity of 18.20% was achieved between the simulated and observed O₃ concentrations. The O₃ isopleth diagram illustrated that O₃ formation in July 2016 was in VOC-sensitive regime, although the VOC/NO_x ratio was greater than 20. By introducing sensitivity (S), a sensitivity analysis was performed for O₃ formation. We found that O₃ formation was sensitive to propylene, (m+p)-xylene, o-xylene and toluene. The results provide theoretical support for O₃ pollution treatment in Shanghai.     

交联剂TAIC反应风险评估分析

利用全自动反应量热仪和绝热加速量热仪等相关实验仪器检测出TAIC(三烯丙基异氰尿酸酯)合成反应的反应热、比热容及热稳定性等数据,依据绝热温升、工艺温度、技术最高温度、最大反应速率到达时间及失控体系可能达到的最高温度这5个温度参数按照评估标准从分解热、严重度、可能性、矩阵、工艺危险度这5个方面分别进行评估。通过对热参数及实验过程进行分析提出降低工艺危险等级的工艺优化方法。根据最终评估结果对TAIC生产装置的安全性进行评价,提出相应的整改措施及建议。