Correction to: Preparation of GO/MIL-101(Fe,cu) composite and its adsorption mechanisms for phosphate in aqueous solution

Environmental Science and Pollution Research - A Correction to this paper has been published: https://doi.org/10.1007/s11356-021-15526-6     

纳米铁催化分解高氯酸盐废水的反应动力学

通过实验考察了酸性条件下纳米铁催化分解高氯酸盐过程中的影响因素,对其分解的动力学进行了研究,并对纳米铁催化剂结构及微观形貌进行SEM、EDS和XRD表征分析。利用阿仑尼乌斯方程和幂指数方程拟合反应动力学方程,获得了高氯酸盐分解动力学方程Ct=C0exp{-0.03773exp(-201.65/T)[H]0.191t},理论的计算值与实验值吻合较好,误差在15%以内。     

蒽醌修饰石墨毡电极预处理头孢合成废水

以钛涂钌电极为阳极、自制蒽醌修饰石墨毡电极为阴极,对头孢合成废水(COD=25 000~30 000 mg/L、ρ(NH3-N)=850~1 300 mg/L、色度为2 300~2 680度)进行了电化学氧化预处理,优化了电解条件,并对电化学体系的动力学和稳定性进行了分析。实验结果表明:蒽醌的存在可改善电化学氧化降解效果;在电解时间50 min、电流密度0.14 A/cm2、Na2SO4浓度0.1 mol/L、极板间距2 cm、初始废水p H 7.0的条件下,废水的COD、色度、NH3-N的去除率分别可达45.3%,66.9%,33.6%;BOD5/COD由处理前的0.27增至0.40,可生化性得到改善;COD、色度、NH3-N的电化学氧化降解过程均近似符合一级动力学方程;且该电化学体系的应用稳定性良好。     

活性炭吸附和两级Fenton氧化组合工艺处理高盐对氨基苯酚生产废水

采用活性炭吸附和两级Fenton氧化组合工艺对高盐度对氨基苯酚生产废水进行了处理实验研究。结果表明,p H值对活性炭去除有机物的影响较小。当活性炭投加量为4 g/L时,TOC去除率61%。分级加药可以有效提高Fenton氧化对有机物的去除效率。在温度为25℃、p H为3、30%H2O2投加量为3%(V/V)、Fe2+/H2O2摩尔比为0.05时,两级Fenton氧化处理后,出水TOC降至150 mg/L以下。此外,Fenton氧化后形成氢氧化铁污泥颗粒粒径为4.5μm,经过聚丙烯酰胺(PAM)絮凝之后,污泥的粒径明显增加,过滤特性改善。PAM絮凝效果依赖于溶液的p H值,当p H超过10后会失去作用,故在使用过程中需要严格控制溶液的p H值。     

Enhanced sludge solubilization by microbubble ozonation

A microbubble ozonation process for enhancing sludge solubilization was proposed and its performance was evaluated in comparison to a conventional ozone bubble contactor. Microbubbles are defined as bubbles with diameters less than several tens of micrometers. Previous studies have demonstrated that microbubbles could accelerate the formation of hydroxyl radicals and hence improve the ozonation of dyestuff wastewater. The results of this study showed that microbubble ozonation was effective in increasing ozone utilization and improving sludge solubilization. For a contact time of 80 min, an ozone utilization efficiency of more than 99% was obtained using the microbubble system, while it gradually decreased from 94% to 72% for the bubble contactor. The rate of microbial inactivation was obviously faster in the microbubble system. At an ozone dose of 0.02 g O₃ g⁻¹ TSS, about 80% of microorganisms were inactivated in the microbubble system, compared with about 50% inactivation for the bubble contactor. Compared to the bubble contactor, more than two times of COD and total nitrogen, and eight times of total phosphorus content were released from the sludge into the supernatant by using the microbubble system at the same ozone dosage. The application of microbubble technology in ozonation processes may provide an effective and low cost approach for sludge reduction.     

Distribution of elements in needles of Pinus massoniana (Lamb.) was uneven and affected by needle age

Macronutrients (P, S, K, Na, Mg, Ca), heavy metals (Fe, Zn, Mn, Cu, Pb, Cr, Ni, Cd,) and Al concentrations as well as values of Ca/Al in the tip, middle and base sections, and sheaths of current year and previous year needles of Pinus massoniana from Xiqiao Mountain were analyzed and the distribution patterns of those elements were compared. The results indicated that many elements were unevenly distributed among the different components of needles. Possible deficiency of P, K, Ca, Mn and Al toxicity occurred in needles under air pollution. Heavy metals may threaten the health of Masson pine. Needle sheaths were good places to look for particulate pollutants, in this case including Fe, Cu, Zn, Pb, Cr, Cd and Al.     

上流式多级厌氧反应器中厌氧颗粒污泥特性研究

高品质厌氧颗粒污泥是厌氧反应器实现高效、稳定运行的关键和基础.在实现上流式多级厌氧反应器(UMAR)处理木薯变性淀粉废水高效运行的基础上,对厌氧颗粒污泥的浓度分布、粒径分布、沉降速度、产甲垸活性,辅酶F420和生物相等作进一步的研究.根据在实验工艺条件下培养得到的厌氧颗粒污泥的性能,探讨厌氧颗粒污泥的可能形成机制.     

序批式反应器生物强化处理苯酚废水的研究

将4株高效苯酚分解菌湿菌体分3批投加于序批式反应器(SBR),对活性污泥进行生物强化试验,分析活性污泥状态与性能变化,测定生物强化后对苯酚的降解能力.结果表明,随着生物强化过程的进行,沉降性能改善,污泥颗粒化趋势明显;生物强化后,活性污泥对苯酚降解能力、降解速率及对苯酚的耐受性明显提高:苯酚质量浓度为730～960mg/L时,苯酚完全降解时间可由正常的6h缩短至2h;6h内可完全降解苯酚的质量浓度由原来的880mg/L提高到2080mg/L,处理能力提高了1.36倍;当进水苯酚质量浓度增加到2400mg/L时,6h内污泥对苯酚的降解率仍达到60.1%.     

溶胶凝胶法制备磷钨酸掺杂TiO2薄膜及其光催化性能

以钛酸四丁酯为前驱物,采用溶胶凝胶法制备了磷钨酸掺杂的二氧化钛薄膜.通过XRD、FT-TR对该薄膜进行了表征,研究了薄膜在对氯苯酚光降解中的催化活性.结果表明,当磷钨酸与二氧化钛摩尔比为0.01:1、薄膜烧结温度600℃、对氯苯酚溶液浓度30 mg/L(pH＝5)、光催化8 h的条件下,对氯苯酚的降解率超过90%,且薄膜可以重复使用.磷钨酸对二氧化钛的光催化活性具有明显的促进作用.     

生物絮凝剂MBFGA1预处理乳制品加工废水

用生物絮凝剂MBFGA1预处理乳制品加工废水（简称废水）。实验结果表明，废水处理的水力条件为：以150r／min的转速搅拌30S，再以30r／min的转速搅拌20min；MBFGA1的最佳加入量为15mg／L；废水pH为4．0时，MBFGA1对废水的絮凝处理效果最好；废水温度对浊度、COD去除率有一定的影响，在20～45℃时，废水浊度的去除率始终保持在85％以上；30℃时，COD去除率达到最大值65．0％。