Yield and grain quality of spring wheat (Triticum aestivum L., cv. Drabant) exposed to different concentrations of ozone in open-top chambers

Spring wheat (Triticum aestivum L., cv. Drabant) was exposed to different concentrations of ozone in open-top chambers for two growing seasons, 1987 and 1988, at a site located in south-west Sweden. The chambers were placed in a field of commercially grown spring wheat. The treatments were charcoal-filtered air (CF), non-filtered air (NF) and non-filtered air plus extra ozone (NF(+)). In 1988, one additional ozone concentration (NF(++)) was used. Grain yield was affected by the ozone concentration of the air. Air filtration resulted in an increase in grain yield of about 7% in both years, compared to NF. The addition of ozone (NF(+), NF(++)) reduced grain yield and increased the content of crude protein of the grain in both years. Filtration of the air had no significant effect on the content of crude protein, compared to NF. The results showed a strong positive chamber effect on grain yield in the cold and wet summer of 1987. In 1988, there was no net chamber effect on grain yield. The relative differences between the CF, NF and NF(+) treatments with respect to grain yield were of the same magnitude in the two years, despite the very different weather conditions.     

Impact of sulphur dioxide exposure on conidial germination of powdery mildew fungi

The impact of sulphur dioxide, in two different concentrations (286 microg m(-3) and 571 microg m(-3)) for various exposure periods, on conidial germination of some powdery mildew fungi was investigated in artificial treatment conditions. SO(2) in general was inhibitory for conidial germination of all the studied powdery mildew fungi and the species did not differ much from each other in their sensitivity to SO(2). The per cent conidial germination was increasingly inhibited with an increase in the concentration of SO(2). The concentration of SO(2) and the exposure period were important determinants of the inhibitory effect.     

The influence of pH on cadmium toxicity to the green alga Stichococcus bacillaris and on the cadmium forms present in the culture medium

Cadmium toxicity to the green alga Stichococcus bacillaris was investigated in media of pH 3-9. A significant decrease of cadmium toxicity occurred in both the acidic and alkaline ranges of pH. In media of pH 3 and 9, cadmium did not affect the dry mass content substantially. Maximum toxicity of cadmium was noticed at pH 6-7. Voltametric investigations showed a significant effect of pH on electrochemically measured cadmium content in the culture media. Hydrolysis of the medium components and formation of cadmium complexes with OH(-) ions caused a considerable decrease in amounts of electrochemically measured cadmium in the alkaline range of pH.     

A Variance Estimator for Constrained Estimates of Change in Relative Categorical Frequencies

Consistent estimators of change and state becomes an issue when sample data come from a mix of permanent and temporary observation units. A joint maximum likelihood estimator of state and change creates estimates of state that depend on antecedent viz. posterior survey results and may differ from estimates of state derived from a single-date analysis of the sample data. A constrained estimator of change in relative categorical frequencies that eliminates this potential inconsistency is proposed and a model based estimator of their sampling variance is developed. The performance of the constrained estimator is quantified against six criteria and a joint maximum likelihood estimator in simulated sampling from 15 populations with three combinations of permanent and temporary samples, four to six categorical class attributes, and constant size between sampling dates. Bias of the constrained estimators was negligible but larger than for joint maximum likelihood estimators. Mean absolute deviations and variances of constrained estimators were generally at par with the joint estimators. Constrained estimators of root mean square errors and achieved coverage of nominal confidence intervals of constrained estimators were occasionally better. A generalized variance function for the constrained estimates of change is provided as a computational shortcut.     

Recycling of petroleum-contaminated sand

The environmental impact of using petroleum-contaminated sand (PCS) as a substitute in asphalt paving mixtures was examined. An appreciable component of PCS is oily sludge, which is found as the dregs in oil storage tanks and is also produced as a result of oil spills on clean sand. The current method for the disposal of oily sludge is land farming. However, this method has not been successful as an oil content of < 1% w/w is required, and difficulty was encountered in reaching this target. The reuse of the sludge in asphalt paving mixtures was therefore considered as an alternative. Standard tests and environmental studies were conducted to establish the integrity of the materials containing the recycled sludge. These included physical and chemical characterization of the sludge itself, and an assessment of the mechanical properties of materials containing 0%, 5%, 22% and 50% oily sludge. The blended mixtures were subjected to special tests, such as Marshall testing and the determination of stability and flow properties. The experimental results indicated that mixtures containing up to 22% oily sludge could meet the necessary criteria for a specific asphalt concrete wearing course or bituminous base course. To maximize the assay from the recycled material, the environmental assessment was restricted to the 50% oily sludge mixture. Leachates associated with this particular mixture were assayed for total organic residue and certain hazardous metal contaminants. The results revealed that the organics were negligible, and the concentrations of the metals were not significant. Thus, no adverse environmental impact should be anticipated from the use of the recycled product. Our research showed that the disposal of oily sludge in asphalt paving mixtures could possibly yield considerable savings per tonne of asphalt concrete, and concurrently minimize any direct impact on the environment.     

Assessment of uncertainty of NO2 measurements by the chemiluminescence method and discussion of the quality objective of the NO2 European Directive

Hereafter, an assessment of the ability of the chemiluminescence method to measure ambient NO2 with an accuracy within 15%, as requested by the data quality objective of European directive 1999/30/CE, is presented. In general, uncertainty is evaluated using the response to reference materials or by means of inter-comparisons used to determine some statistics like repeatability, reproducibility and calibration bias. These are incomplete approaches and the method of the Guide to the Expression of Uncertainty in Measurement, advised by the Directive, should be preferred. In fact, even if it requires a large data set, it allows the relative influence of all possible sources of uncertainty to be studied. The extent of NO2 uncertainty is mainly dependent on the level of NO. It is decreased by NOx and the correlation between NOx and NO. Furthermore, the uncertainty budget reveals that the contribution of accuracy of calibration standard, linearity, converter efficiency and drift of the analyser between calibration checks to the overall uncertainty is less important than the contribution of interference, mainly humidity and PAN in rural areas. The relative expanded uncertainty of the NO2 hourly average exceeds 30% for NO2 concentrations lower than 40 microg m(-3). Nevertheless, the data quality objective of 15% is reached for 200 microg m(-3), the hourly limit value of the European directive. On the contrary, at the limit value on the annual average, 40 microg m(-3), the data quality objective is not met if NO is higher than 100 microg m(-3). However, the data quality objective could be reached by correcting the measurements with the bias due to interference.     

Land Degradation Monitoring in Namibia: A First Approximation

This paper presents development of a first approximation of a Namibian, national level, land degradation monitoring system. The process involved a large number of stakeholders and led to the definition of four primary indicators that were regarded as related to land degradation in Namibia: population pressure, livestock pressure, seasonal rainfall and erosion hazards. These indicators were calculated annually for the period 1971–1997. Annual land degradation risk maps were produced for the same period by combining the indicators. A time series analysis of results generated by indicators was undertaken at two sites. The analysis revealed a general trend towards an increased land degradation risk over the period 1971–1997. A decrease in annual rainfall and an increase in livestock numbers caused this negative trend at one site, while decreased annual rainfall and increased human population were the causes at a second site. Evaluation of resulting maps through direct field observations and long-term monitoring at selected study sites with different conditions relevant for the indicators defined, is an essential next step.     

Plant Phenology in Western Canada: Trends and Links to the View From Space

One feature of climate change is the trends to earlier spring onset in many north temperate areas of the world. The timing of spring flowering and leafing of perennial plants is largely controlled by temperature accumulation; both temperature and phenological records illustrate changes in recent decades. Phenology studies date back over a century, with extensive databases existing for western Canada. Earlier spring flowering has been noted for many woody plants, with larger trends seen for species that develop at spring's start. Implications for ecosystems of trends to earlier spring arrival include changes in plant species composition, changes in timing and distribution of pests and disease, and potentially disrupted ecological interactions. While Alberta has extensive phenology databases (for species, years, and geographic coverage) for recent decades, these data cannot provide continuous ground coverage. There is great potential for phenological data to provide ground validation for satellite imagery interpretation, especially as new remote sensors are becoming available. Phenological networks are experiencing a resurgence of interest in Canada (www.plantwatch.ca) and globally, and linking these ground-based observations with the view from space will greatly enhance our capacity to track the biotic response to climate changes.     

Laboratory-polluted soils: a methodological approach to establish equilibrium conditions for different metal chemical forms in soils

An approach based on the number of extractions performed over time was applied to study the time necessary to attain equilibrium conditions between the different chemical forms present in two natural soils laboratory-loaded with heavy metals (Cu(II), Pb(II), Zn(II)). The influence of some soil parameters, such as pH value, cation exchange capacity and organic matter content, on the equilibrium time was evidenced both by the different nature of the soils and by the treatment of soils with paper mill sludge. Equilibrium conditions were determined by studying the metal partitioning in the soil on a case by case basis. The behaviour of the three metals was not the same, and the conditions of equilibrium among the different chemical forms were the result of the amount of heavy metals added as well as of the nature of the soil.     

Diffusive sampling of methyl isocyanate using 4-nitro-7-piperazinobenzo-2-oxa-1,3-diazole (NBDPZ) as derivatizing agent

A diffusive sampling method for the determination of methyl isocyanate (MIC) in air is introduced. MIC is collected using a glass fiber filter impregnated with 4-nitro-7-piperazinobenzo-2-oxa-1,3-diazole (NBDPZ). The urea derivative formed is desorbed from the filter with acetonitrile and analyzed by means of high-performance liquid chromatography (HPLC) using fluorescence detection (FLD) with lambdaex = 471 nm and lambdaex = 540 nm. Additionally, a method was developed using tandem mass spectrometric (MS-MS) detection, which was performed as selected reaction monitoring (SRM) on the transition [MIC-NBDPZ + H]+ (m/z 307) to [NBDPZ + H]+ (m/z 250). The diffusive sampler was tested with MIC concentrations between 1 and 35 microg m(-3). The sampling periods varied from 15 min to 8 h, and the relative humidity (RH) was set from 20% up to 80%. The sampling rate for all 15 min experiments was determined to be 15.0 mL min(-1) (using HPLC-FLD) with a relative standard deviation of 9.9% for 56 experiments. At 80% RH, only 15 min sampling gave acceptable results. Further experiments revealed that humidity did not affect the MIC derivative but the reagent on the filter prior to and during sampling. The sampling rate for all experiments (including long term sampling) performed at 20% RH was found to be 15.0 mL min(-1) with a relative standard deviation of 6.3% (N = 42). The limit of quantification was 3 microg m(-3) (LC-MS-MS: 1.3 microg m(-3)) for 15 min sampling periods and 0.2 microg m(-3) (LC-MS-MS: 0.15 microg m(-3)) for 8 h sampling runs applying fluorescence detection.