高邮市基本农田环境质量监测与评价

根据近两年高邮市试点工作经验，介绍基本农田分等定级的环境监测与评价方法，认为积极开展农田环境监测并进行科学评价是基本农田保护的重要工作内容。     

Sensitivity experiments and assessment of climatic changes in China induced by greenhouse effect

Climatic changes can be separated into two parts: natural changes -and human activity influenced on climatic changes. The observed data could not only show the effects caused by human activity. Several simulated results as simulated by the GCMs induced by the greenhouse effects in China .have been analysed. It is shown that an obvious warming of about 3-6℃ in winter and 2-5℃ in summer in China as simulated by the GCMs induced by doubling CO2 have been found. There are getting drier or wetter regions in China due to doubled CO2 as simulated by most of models. Comparing the simulated results with the observed data in China, some simulated results are able to be believed. The GCMs should be improved, especially in the regional areas.     

Effects of environmental factors on the production and release of matrix-bound phosphine from lake sediments

Effects of pH, temperature, and oxygen on the production and release of phosphine in eutrophic lake sediments were investigated under laboratory tests. Results indicated that the elimination of matrix-bound phosphine was accelerated under initial pH 1 or 12. Phosphine levels could reach maximum under initial pH 10. The contents of phosphine increased with the addition of alkali under pH 4–12. The rates of phosphine production and release from lake sediments varied with temperature. 20°C was the most favorable temperature for the production of matrix-bound phosphine. Oxygen showed little effect on matrix-bound phosphine. Matrix-bound phosphine concentrations in lake sediments were concluded to be dependent on a balance of natural generation and depletion processes. Translated from Acta Scientise Circumstantiae, 2005, 25(5): 681–685 [译自: 环境科学学报]     

高强铝合金超塑挤压成形

主要介绍了工业牌号高强铝合金在供应态或经简单预处理后在通用油压机上超塑成形的实例,并分析探讨了非理想组织材料超塑成形中微观组织的变化。     

厌氧升流式污泥层反应器内污泥颗粒化对固液分离效果的影响

厌氧升流式污泥层反应器在较高的COD容积负荷和水力负荷下稳定运行的关键是要有良好的固液分离,而固液分离的必要条件是污泥的沉降速度大于混合液在三相分离器的沉降区的最小断面上的向上流速。通过小型装置的试验表明,污泥的沉降速度与污泥的性状和浓度有关,使反应器内的污泥颗粒化能改善污泥沉降性、提高固液分离效果,使反应器能在相当高的COD容积负荷(20—30kgCOD/m~3·d)和水力负荷(0.8m~3/m~2·h)下稳定运行。本文叙述了厌氧升流式污泥层反应器内的污泥颗粒化过程,并简要地讨论了培养颗粒污泥的基本条件。     

故障安全控制系统在催化裂化装置的应用

介绍霍尼韦尔公司故障安全控制系统FSC的技术特点以及在我厂重油催化裂化装置的应用情况，说明了该装置故障安全控制系统组成和操作界面，并总结了应用效果。     

Life cycle analysis and choice of natural gas-based automotive alternative fuels in Chongqing Municipality,China

Road transport produces significant amounts of emissions by using crude oil as the primary energy source. A reduction of emissions can be achieved by implementing alternative fuel chains. The objective of this study is to carry out an economic, environmental and energy (EEE) life cycle study on natural gas-based automotive fuels with conventional gasoline in an abundant region of China. A set of indices of four fuels/vehicle systems on the basis of life cycle are assessed in terms of impact of EEE, in which natural gas produces compressed natural gas (CNG), methanol, dimethylether (DME) and Fischer Tropsch diesel (FTD). The study included fuel production, vehicle production, vehicle operation, infrastructure and vehicle end of life as a system for each fuel/vehicle system. A generic gasoline fueled car is used as a baseline. Data have been reviewed and modified based on the best knowledge available to Chongqing local sources. Results indicated that when we could not change electric and hydrogen fuel cell vehicles into commercial vehicles on a large scale, direct use of CNG in a dedicated or bi-fuel vehicle is an economical choice for the region which is most energy efficient and more environmental friendly. The study can be used to support decisions on how natural gas resources can best be utilized as a fuel/energy resource for automobiles, and what issues need to be resolved in Chongqing. The models and approaches for this study can be applied to other regions of China as long as all the assumptions are well defined and modified to find a substitute automotive energy source and establish an energy policy in a specific region.     

南水北调中线不同调水方案下的汉江水华发生概率分析

为评估南水北调中线工程对汉江中下游水华的影响，从汉江水华的成因机理分析入手，提出了汉江水华发生概率的计算模型．该模型由河流一维水动力学模型、水体富营养化模型以及随机数生成模型组成，它不仅可以模拟汉江水华的发生机理，而且可以对诱发水华的各种因子进行随机抽样组合，从而求出中线调水不同方案实施后汉江水华的发生概率．计算结果表明，在现状情况下汉江水华的发生概率为9．2％，南水北调中线各调水方案（无引江济汉工程）实施后，汉江水华发生的概率将有一定程度的增加，而如果调水方案与引江济汉工程同时兴建将大大减少汉江水华发生的概率．最后提出建议，汉江自身的水污染治理是减少水华发生概率的最根本措施，而丹江口水库和引江济汉工程的联合调度将会减小汉江水华发生的概率．     

Turnover mechanisms of organic conformation on turbidity in drinking water

The turbidity variation in artificial water and samples from a water plant was investigated in the presence of organics with different relative molecular mass. The results show that recessive turbidity existed when water chemical conditions were changing. The formation of turbidity depended on organic relative molecular mass and their conformations on particles. At higher pH and lower ionic strength, the organic chains with a more extended conformation resulted in rising turbidity of the suspension. At lower pH, the reconformation of organics took place due to charge neutralization by the proton, resulting in a decline in turbidity. The addition of NaCl and MgCl₂ at pH 7.00 also resulted in a decrease of turbidity in the suspension. It is believed that the occurrence of recessive turbidity has a significant influence on the stability of water supply quality.     

金属板料成形摩擦机理研究

对不锈钢板料和碳钢在金属塑性成形时 (高接触压力 )的摩擦机理进行了实验研究 ,分析了压力对滑动阻力和摩擦系数的影响 ,得出了随压力增大摩擦系数逐渐变小的结论 ,从而为应用有限元法进行板料成形过程中塑性变形的计算机模拟提供真实的边界条件打下了基础。