Effective photodegradation of methomyl pesticide in concentrated solutions by novel enhancement of the photocatalytic activity of TiO2 using CdSO4 nanoparticles

Annihilation of electrons–holes recombination process is the main remedy to enhance the photocatalytic activity of the semiconductors photocatalysts. Doping of this class of photocatalysts by foreign nanoparticles is usually utilized to create high Schottky barrier that facilitates electron capture. In the literature, because nonpolar nanoparticles (usually pristine metals, e.g., Ag, Pt, Au, etc.) were utilized in the doping process, the corresponding improvement was relatively low. In this study, CdSO₄-doped TiO₂ nanoparticles are introduced as a powerful and reusable photocatalyst for the photocatalytic degradation of methomyl pesticide in concentrated aqueous solutions. The utilized CdSO₄ nanoparticles form polar grains in the TiO₂ matrix due to the electrons leaving characteristic of the sulfate anion. The introduced nanoparticles could successfully eliminate the harmful pesticide under the sunlight radiation within a very short time (less than 1 h), with a removal capacity reaching 1,000 mg pesticide per gram of the introduced photocatalyst. Moreover, increase in the initial concentration of the methomyl did not affect the photocatalytic performance; typically 300, 500, 1,000, and 2,000 mg/l solutions were completely treated within 30, 30, 40, and 60 min, respectively, using 100 mg catalyst. Interestingly, the photocatalytic efficiency was not affected upon multiple use of the photocatalyst. Moreover, negative activation energy was obtained which reveals super activity of the introduced photocatalyst. The distinct photocatalytic activity indicates the complete annihilation of the electrons–holes recombination process and abundant existence of electrons on the catalyst surfaces due to strong electrons capturing the operation of the utilized polar CdSO₄ nanoparticles. The introduced photocatalyst has been prepared using the sol–gel technique. Overall, the simplicity of the synthesizing procedure and the obtained featured photocatalytic activity strongly recommend the introduced nanoparticles to treat the methomyl-containing polluted water.     

Impact of an educational program on knowledge and practice of health care staff toward pharmaceutical waste management in Gaza,Palestine

In health care facilities, pharmaceutical waste is generally discharged down the drain or sent to landfill. Poor knowledge about their potential downstream impacts may be a primary factor for improper disposal behavior. The objective of this study was to determine the impact of an intervention program on knowledge and practice of health care staff regarding pharmaceutical waste management. The study was designed as a pre/posttest intervention study. Total sample size was 530 in the pre-intervention phase, and then a subsample of 69 individuals was selected for the intervention and the post-intervention phases. Paired-sample t test was used to assess the difference between pretest and follow-up test results. A statistically significant improvement in knowledge and practice was achieved (P < 0.001). Poor knowledge and poor practice levels (scores <50%) were found to improve to satisfactory levels (scores ≥75%). Therefore, educational programs could be considered as an effective tool for changing health care staff practice in pharmaceutical waste management.

Implications: In health care facilities, pharmaceutical waste is generally discharged down the drain or sent to landfill. A lack of knowledge about the potential impacts of this type of waste may be a leading factor in improper disposal behavior. Following an educational program, statistically significant improvement in knowledge and practice of health care staff as regards to pharmaceutical waste management (PWM) was achieved. It is thus recommended that authorities implement training-of-trainers (TOT) programs to educate health care staff on PWM and organize refreshment workshops regularly.     

Assessment of heat-inactivated marine Aspergillus flavus as a novel biosorbent for removal of Cd(II), Hg(II), and Pb(II) from water

Environmental Science and Pollution Research - A novel marine fungus was isolated and classified as Aspergillus flavus strain EGY11. The heat-inactivated form of isolated Aspergillus flavus was...     

High-recycled-content hydraulic cements of alternative chemistry for concrete production

Sustainable hydraulic cements based on alkali aluminosilicate chemistry were developed with market-limited wastes acting as the primary aluminosilicate precursors. Two sets of formulations were developed with waste brick or impounded coal ash used at relatively large volume as aluminosilicate precursors. Supplementary materials were used to produce raw materials of viable chemistry. Blends of raw materials were transformed into hydraulic cements by input of mechanical energy without resorting to elevated temperatures. The resultant hydraulic cements exhibited viable strength development characteristics. FTIR, SEM, EDS and NMR analyses were conducted in order to gain insight into the structure of the hydraulic cements and their hydration products. The results pointed at the prevalence of calcium aluminosilicate hydrates among the products of hydration which thoroughly bound the non-hydrated cores of cement particles.     

Predictors of poor outcomes among patients of acute methanol intoxication with particular reference to Sequential Organ Failure Assessment (SOFA) score

Environmental Science and Pollution Research - Methanol intoxication is a global problem with serious morbidities and mortalities. Apart from the lifelong disabilities experienced by methanol...     

Assessment of Trace Metals in the Sediments From the Coastal Zone of Alexandria, Egypt

Freshly deposited surface sediments from the Alexandria coastal zone were collected and analysed in 1995 for their trace metal concentrations. Metal concentrations in the sediments vary between sites within a wide range for copper, zinc, iron, lead, chromium and cadmium. the statistical analysis between the metal concentrations and the different constituents (organic carbon, total nitrogen, silt, clay and total iron) showed significant correlations. the enrichment factors for the sediments ranged between 3 and 4-fold for copper, chromium and zinc and reached up to 9-fold for lead and 113-fold for cadmium. the highest index for cadmium and lead may be attributed to the anthropogenic inputs from the surrounding area, where they are highest in lower discharge areas.     

Report: The assessment of hospital waste management:a case study in Tehran

Hospital waste management is an important process that must be dealt with diligently. The management of hazardous waste material requires specific knowledge and regulations and it must be carried out by specialists in the field. In this cross-sectional study, we assessed the main stages of hospital waste management including separation, containment, removal and disposal of waste materials in public hospitals affiliated with Tehran University of Medical Sciences (TUMS). We selected 108 units of six hospitals (three general hospitals and three subspecialty hospitals) from those hospitals supervised by TUMS using the cluster sampling method. The measurement was conducted through a questionnaire and direct observation by researchers. Association analysis was done by statistical tests; Fisher exact test and chi-squared using SPSS software. According to the results obtained by the questionnaire, most of the studied wards scored moderately in terms of quality of their performance in all stages of waste management. About one-fifth of the wards were suffering from poor management of their medical waste and only a minority of wards obtained good scores for managing their waste materials. The findings also revealed significant associations between temporary waste storage and collection and the level of education of the managers (P = 0.040, P = 0.050, respectively). In summary, the study indicated a moderate management in all processes of separation, collection, containment, removal and disposal of waste materials in hospitals with several observed problems in the process.     

Chemical composition and antimicrobial activities of the essential oil from the seeds of Enterolobium contortisiliquum (leguminosae)

Seeds of Enterolobium contortisiliquum were subjected to steam distillation to obtain a light yellow essential oil in a yield of 3 ml/kg of seeds. The major components of the oil were identified using gas chromatography/mass spectrometry (GC-MS) and were furfural, limonene, linalool, estragole, carvone, and apiole with carvone representing more than 50% of the total composition. Antimicrobial activities of the essential oil were determined against four species of gram positive bacteria (Bacillus subtilis, Bacillus cereus, Staphylococcus aureus, Micrococcus luteus) and two gram negative bacteria (Klebsiella pneumoniae, Serratia Marcescencs). The essential oil inhibited the growth of all tested bacteria but was most effective against the gram positive bacteria. Chemicals that are responsible for the antibacterial effect of the essential oil were determined using the bio-autography thin layer chromatography (TLC) technique. The active compounds responsible for the activity were found to be carvone and estragole.     

The impact of age-related sub-chronic exposure to chlorpyrifos on metabolic indexes in male rats

Chlorpyrifos (CPF), an organophosphorus pesticide (OP), has been implicated in metabolic diseases; however, the data are controversial. Rising age has been     

Road Dust Resuspension in the Vicinity of Limestone Quarries in Jordan

Abstract

Many areas in Jordan suffer from elevated levels of coarse particulate matter (PM₁₀). One potentially significant source of the observed PM is the resuspension of road dust in the vicinity of limestone quarries. To obtain data to assess the impact from this source, PM₁₀ road dust resus-pension factors near Abusiiah, a town to the north east of Amman surrounded by many quarries and brick factories, were measured. Measurements included PM₁₀ mass, particle size distributions, wind speed, and wind direction.The results showed that PM₁₀ concentrations could be as high as 600 µg/m³, and most of the airborne PM is in the coarse fraction. Loading trucks play a major role in resus-pending road dust, with an observed PM₁₀ emission rate of >6000 mg/km.