丁酸胁迫对产氢污泥以厨余为底物的产氢影响

采用丁酸对产氢污泥进行胁迫处理,经胁迫后的污泥接种厨余垃圾进行产氢实验,考察丁酸胁迫对提高产氢性能的影响。结果表明,低浓度胁迫能提高产氢污泥的耐丁酸性,从而提高产氢量,而胁迫浓度过高则抑制产氢污泥活性,胁迫浓度呈"horm esis"效应。实验采用的4 g/L胁迫浓度为最佳,反应结束后,丁酸浓度和产氢量分别为8 417.1 mg/L和63.72 mL/g VS,比空白提高了31.3%和114%。产氢过程中SCOD的主要来源是有机酸。对产氢污泥胞外多聚物(EPS)的测定表明,厨余垃圾酸化速率、氢气产生速率和EPS总量成正相关。     

Biohydrogen production through fermentation using liquid swine manure as substrate

In this paper, continuous production of hydrogen through fermentation with liquid swine manure as substrate was researched using a semi-continuously fed fermenter (8 L in total volume and 4 L in working volume). The pH and temperature for the fermenter were controlled at 5.3 +/- 0.1 and 35 +/- 1 degrees C, respectively, throughout the experiment. Three hydraulic retention times (16, 20, and 24 h) were investigated for their impact on the efficiency and performance of the fermenter in terms of hydrogen yields. The results indicate that hydraulic retention time (HRT) has a strong influence on the fermenter performance. An increasing HRT would increase the variation in hydrogen concentration in the offgas. To produce hydrogen with a fairly consistent concentration, the HRT of the fermenter should not exceed 16 h, which, however, did not appear to be short enough to control methanogenesis because the offgas still contained about 5% methane. When methane content in the offgas exceeded 2%, an inverse linear relationship between hydrogen and methane was observed with a correlation coefficient of 0.9699. To increase hydrogen content in the offgas, methane production has to be limited to below 2%. Also, keeping oxygen content in the fermenter below 1.5% would increase the hydrogen concentration to over 15%. The product to substrate ratio was found to be around 50% for the fermenter system studied, evidenced by the observation that for every 6 liters of manure fermented, 3 liters of pure hydrogen were produced, which was significant and encouraging.     

PAC-chitosan复合絮凝剂中铝形态

以不同碱化度(B)的聚合氯化铝(PAC)和不同粘度的壳聚糖为原料制备出一系列PAC-chitosan复合絮凝剂。采用Al-Ferron逐时络合比色法研究了PAC-chitosan复合絮凝剂中铝的形态分布，探讨了PAC的B值、壳聚糖的含量（C）和粘度（η）对复合絮凝剂中铝的形态分布的影响。结果表明：壳聚糖与PAC之间发生了一定的相互作用，通过试验结果推断出当B=1.5，壳聚糖粘度η=800 Pa·s，C=0.6 mg/mL絮凝效果最佳。并用某造纸废水进行了烧杯絮凝试验。絮凝试验结果与推断结果相一致。     

Climate change mitigation policy paradigms—national objectives and alignments

The aim of this paper is to assess how policy goals in relation to the promotion of green growth, energy security, pollution control and greenhouse gas (GHG) emissions reductions have been aligned in policies that have been implemented in selected countries during the last decades as a basis for discussing how a multi objective policy paradigm can contribute to future climate change mitigation. The paper includes country case studies from Brazil, Canada, China, the European Union (EU), India, Japan, Mexico, Nigeria, South Africa, South Korea and the United States covering renewable energy options, industry, transportation, the residential sector and cross-sectoral policies. These countries and regions together contribute more than two thirds of global GHG emissions. The paper finds that policies that are nationally driven and that have multiple objectives, including climate-change mitigation, have been widely applied for decades in both developing countries and industrialised countries. Many of these policies have a long history, and adjustments have taken place based on experience and cost effectiveness concerns. Various energy and climate-change policy goals have worked together in these countries, and in practice a mix of policies reflecting specific priorities and contexts have been pursued. In this way, climate-change mitigation has been aligned with other policy objectives and integrated into broader policy packages, though in many cases specific attention has not been given to the achievement of large GHG emission reductions. Based on these experiences with policy implementation, the paper highlights a number of key coordination and design issues that are pertinent to the successful joint implementation of several energy and climate-change policy goals.     

A novel use of anaerobically digested liquid swine manure to potentially control soybean cyst nematode

Experiments were carried out in two steps to determine the effect of anaerobically digested swine manure on soybean cyst nematode (SCN) egg control. In the first step, liquid swine manure underwent anaerobic digestion to search for the best digestion time for both volatile fatty acids (VFA) and ammonium nitrogen (NH₄ ⁺) enrichment. The results showed that about 17 and 28 days of incubation were needed, respectively, to reach the maximal levels of VFA and NH₄ ⁺ in the manure. In the second step, raw, VFA-enriched, and NH₄ ⁺-enriched manure were applied separately, at four different rates (25, 50, 100, and 200 mL/pot), to soil pots inoculated with nematode eggs in a greenhouse environment. Soil samples were collected 35 and 61 days after inoculation to determine the effect of such treated manure on SCN egg productivity. The data indicated that the SCN egg counts were inversely related to the manure application rates in a linear manner with correlation coefficients of 0.998, 0.967, and 0.900 for raw, NH₄ ⁺-enriched, and VFA-enriched manure for the 35-day samples. While no such relationships were found for the 61-day samples, implying that none of the treatments were still effective 61 days after application. At the four application rates, the VFA-enriched manure performed best in reducing SCN egg counts (by 18.1, 19.5, 34.3, and 18.6%) as compared to the raw manure treatment. In contrast, the NH₄ ⁺-enriched manure achieved mostly negative reductions. To achieve the best control of SCN egg growth, the VFA-enriched manure should be used and applied to soybean fields every 35 days.     

Hexabromocyclododecanes in limnic and marine organisms and terrestrial plants from Tianjin,China: Diastereomer- and enantiomer-specific profiles,biomagnification, and human exposure

To interpret the distribution of hexabromocyclododecanes (HBCDs) in various organisms, we measured the concentrations and diastereomer and enantiomer profiles of HBCDs in 21 different species of limnic and marine cohorts from Tianjin, China. The concentration ranges of HBCDs in limnic and marine organisms were 64.3–1111 ng g⁻¹ lw and 85.5–989 ng g⁻¹ lw, respectively. Living habitat and feeding habits had important impacts on HBCD diastereomer distribution. Most of the species appeared to preferentially select (+)-α-, (−)-β- and (−)-γ-HBCD. There is a tendency that the total and α-HBCDs were magnified as trophic level increased with trophic magnification factors (TMFs) around 2. The concentrations of HBCDs in the limnic and marine fishes were highest in the liver, followed by the gill, skin, and muscle. In terrestrial plants, the highest concentrations of HBCDs were observed in the leaf, followed by the root and the rhizosphere soil. Plants showed enantioselectivity for HBCD enantiomers, which varied with plant species and organs (leaf vs. root) of the same plant. Higher estimated daily intakes (EDIs) of HBCDs were observed from fish than from wheat.     

Photoelectrocatalytic degradation of pentachlorophenol in aqueous solution using a TiO2 nanotube film electrode

Titanium dioxide (TiO2) nanotube film electrodes are fabricated by the anodic oxidation method. Scanning electron microscopy (SEM) showed that these tubes were well aligned and organized into high-density uniform arrays. XRD analysis showed the TiO2 nanotubes to be in the anatase crystal form. The TiO2 nanotube film electrode exhibited increased photoelectrocatalytic (PEC) capability compared to a traditional TiO2 film electrode fabricated using the anodizing method for pentachlorophenol (PCP) degradation in aqueous solution. The bias potential, pH value, and electrolyte concentration were shown to be important factors influencing the degradation of PCP by the PEC method using the TiO2 nanotube film electrode as the working electrode.     

China''''s CDM Policies and Their Development Implications:Major Concerns for CDM Implementation

Most CDM (Clean Development Mechanism) opportunities exist in some large industrializing developing countries. For instance, China is estimated to take 48% of the world potential for CDM project activities. In reality, however, the share by China over the CDM projects registered and CDM projects in the pipeline is less than 10% as of Auguest 2005. This paper will examine the reasons behind, as reflected in China's CDM policies. Further investigation will be made into the use of these policies to boost the country's sustainable development, the sustainable development implications and effects of these policies. In addition, it is noted that incompatibility of some other Chinese laws and policies can be responsible for the low level and slow pace of CDM implementation in China and some suggestions are offered for promoting CDM project activities in China. There also exist barriers at the international level that impedes implementation of CDM project activities. A conclusion is drawn that CDM policies in a developing country like China aim mainly at promotion of sustainable development and to a lesser extent the generation of CERs.     

Effect of preparation methods on the performance of CuFe-SSZ-13 catalysts for selective catalytic reduction of NOx with NH3

CuFe-SSZ-13 catalyst showed excellent performance in the selective catalytic reduction of NO_x with NH₃ (NH₃-SCR) for diesel engine exhaust purification. To investigate the effect of preparation methods on NH₃-SCR performance, Fe was loaded into one-pot synthesized Cu-SSZ-13 catalysts through solid-state ion-exchange (SSIE), homogeneous deposition precipitation (HDP) and liquid ion-exchange (IE), respectively. Three CuFe-SSZ-13 catalysts showed similar SO₂ resistance, which was better than that of Cu-SSZ-13. The improvement was attributed to the protection of Fe species. Hydrothermal stability of three CuFe-SSZ-13 catalysts was significantly different, which was attributed to the state of active species caused by different preparation methods. Compared with the other two catalysts, more active species existed inside the zeolite pores of CuFe-SSZ-13_SSIE. During hydrothermal aging, the aggregation of these active species in the pores caused the collapse of catalyst structure, ultimately leading to the deactivation of CuFe-SSZ-13_SSIE. In contrast, Fe species was dispersed better on the surface over CuFe-SSZ-13_IE, enhancing the hydrothermal stability of catalysts. Consequently, Fe loading effectively improved the resistance of SO₂ and H₂O over Cu-SSZ-13. For CuFe-SSZ-13, large amounts of active species located inside the zeolite pores are not beneficial for the hydrothermal stability.