Enhanced sludge solubilization by microbubble ozonation

A microbubble ozonation process for enhancing sludge solubilization was proposed and its performance was evaluated in comparison to a conventional ozone bubble contactor. Microbubbles are defined as bubbles with diameters less than several tens of micrometers. Previous studies have demonstrated that microbubbles could accelerate the formation of hydroxyl radicals and hence improve the ozonation of dyestuff wastewater. The results of this study showed that microbubble ozonation was effective in increasing ozone utilization and improving sludge solubilization. For a contact time of 80 min, an ozone utilization efficiency of more than 99% was obtained using the microbubble system, while it gradually decreased from 94% to 72% for the bubble contactor. The rate of microbial inactivation was obviously faster in the microbubble system. At an ozone dose of 0.02 g O₃ g⁻¹ TSS, about 80% of microorganisms were inactivated in the microbubble system, compared with about 50% inactivation for the bubble contactor. Compared to the bubble contactor, more than two times of COD and total nitrogen, and eight times of total phosphorus content were released from the sludge into the supernatant by using the microbubble system at the same ozone dosage. The application of microbubble technology in ozonation processes may provide an effective and low cost approach for sludge reduction.     

亲水性多孔载体在流化床中的生物膜形成过程分析

采用实验制备的一种新型亲水性多孔聚合物作为流化床反应器中生物膜附着生长的载体,实现流态化水力条件下的生物挂膜过程.在3个结构尺寸相同的流化床反应器中考察了接种污泥浓度、进水有机负荷及载体粒径对亲水性多孔载体生物挂膜量的影响,试验结果表明,接种污泥浓度为30 g VSS/L、进水TOC值为350 mg/L、载体粒径为5～8 mm时载体表面的附着生物量最大,反应器运行12 d的载体附着生物量达到4.45 g VSS/L,膜结构稳定,表现出较活性污泥法更高的活性.在进水TOC、氨氮浓度分别为350 ms/L、50 mg/L,HRT为6 h的情况下,两者的去除率分别达到了97.1%和64.3%,表明载体上的生物膜对污水中TOC及氨氮的去除表现出高效率.挂膜后载体表面上的微生物以丝状菌为主,孔壁上的微生物以球菌和杆菌为主要生物相,证明载体内外表面皆适宜微生物的生长,并且形成合理的生物相分布.     

由粉煤灰合成单一的沸石及其对Cr(Ⅵ)的吸附研究

以粉煤厌为原料采用两步法合成了2种单一沸石矿物种的NaA和NaX型沸石,并对产物的结构和性能进行了详细表征.2种沸石产物的吸附性能比较结果表明,NaA型沸石优于NaX型沸石.在静态吸附条件下,研究了NaA型沸石吸附水溶液中Cr(Ⅵ)的相关参数(溶液pH值、吸附温度和吸附时间),并用Langmuir和Freundlich等温吸附线对吸附结果进行拟和.结果表明:Cr(Ⅵ)的吸附行为符合Langmuir方程;饱和吸附量为47.78 mg/g.NaA型沸石对Cr(Ⅵ)的吸附是物理和化学吸附两种行为共同作用的结果.     

城市能源利用与环境保护的综合管理初探

能源短缺和环境污染已成为中国推行全面协调可持续发展的重要制约因素,作为能源消耗的主体和环境污染的控制重点,在城市层面推动能源发展战略的转变和强化环境保护是发展的基本要求.鉴于能源与环境之间的高度关联性,在管理方面要求对能源发展和环境保护进行统筹考虑和综合管理,充分强调能源经济效率和环境制约因素在能源发展中的作用.通过制定合理的产业能效标准和排放绩效标准,为城市经济、能源和环境的可持续性发展提供科学性、系统性决策支持.     

山梨酸废水在ABR中的基质降解行为

稳态条件下,采用厌氧折流板反应器(anaerobic baffled reactor,ABR)处理山梨酸废水并进行基质降解动力学研究.实验表明,在污泥负荷为0.54～1.63 kg COD/(kg VSS·d)的范围内,COD去除率随着负荷的增加从85%降到55%.各隔室出水COD沿程递减,前3个隔室承担了去除COD的重要作用,但随着污泥负荷的增加,后部承担的COD去除率比例增大.基于各串联隔室完全混合的假定,推导ABR中山梨酸废水的基质降解动力学方程,并通过实验确定相关动力学参数及相应的动力学方程.实测值与预测值基本吻合.     

错流式生物滴滤床净化甲苯废气

采用焦化厂污泥为菌源驯化甲苯降解菌，接种错流式生物滴滤床，净化含甲苯废气。研究了生物滴滤床的挂膜启动和长期运行情况，填料和营养液对滴滤床去除能力的影响，并对长期运行的压降进行了观察分析。反应器挂膜启动需要6 d时间，稳定运行的平均去除效率为95％，单位体积最大去除负荷为251 g/(m³·h)。结果表明，采用错流式生物滴滤床可以有效去除甲苯废气；以比表面积大的生物陶粒作为填料以及定期适量更换营养液，均有助于提高生物滴滤床的去除能力；错流式生物滴滤床具有压降小、气液分布均匀的特点。     

锌精炼铅塔燃烧系统烟气温度模糊控制研究

针对锌精馏铅塔动态过程中的非线性、非最小相位特征、不稳定性、时滞和负荷干扰,基于模糊控制策略下给出了锌精馏铅塔燃烧系统新的控制方法.运用模糊控制系统对锌精馏铅塔的烟气温度进行仿真研究和实时控制结果表明,该研究所设计的模糊控制器能够克服许多干扰因素,产生了良好的控制效果.     

Fenton法氧化处理水中土霉素的研究

为了评价Fenton法预处理抗生素生产废水中残留的高浓度土霉素的可行性,对Fenton试剂(Fe2 -H2O2)法催化氧化降解水溶液中的土霉素进行了研究.探讨了H2O2与Fe2 投加比例、投加量以及起始pH值对降解效果的影响,同时考察了土霉素废水中大量共存的草酸根离子对氧化过程的影响.结果表明,当H2O2与Fe2 按照5:1的比例投加时降解效率最高,最佳初始pH值在3.0-4.0之间.在最佳投加比例下,H2O2投加量为0.9 mmol/L,100 mg/L的土霉素可在10 min内得到完全降解.最佳反应条件下经过处理后土霉素水溶液TOC的去除率达40%左右,可生化性(BOD5/COD)也得到明显的改善.水中共存的草酸根离子对氧化效率具有明显的影响,但通过增加亚铁离子的量可以消除草酸的影响.     

单体滑坡灾害风险预测

以重庆市万州区农机技校滑坡为例，讨论了单体滑坡灾害的风险预测方法。提出采用Monte-Carlo方法预测滑坡发生的概率，利用能量守恒原理和谢德格尔公式推算滑程；结合滑坡裂缝的展布方位，预测出滑坡灾害发生后的影响范围；根据承灾体自身特点和相对于滑坡所处的位置，确定出滑坡灾害影响范围内承灾体的易损性；利用GIS对空间数据的图形叠加功能，将滑坡危险性和灾害易损性叠加，并在考虑库区水位动态变化的基础上，动态预测滑坡灾害导致的经济损失，定量预测滑坡灾害风险大小。结果表明，该滑坡在坝前145m水位和50年一遇暴雨工况下可能的经济损失值最大为10260万元；而在滑坡危险性最大的工况下，滑坡灾害风险不一定最大。所得结果可为滑坡灾害防治工程或土地规划立项提供依据，使政府决策部门在防灾减灾工作中更有针对性。     

Processes involved in uptake and release of nitrogen dioxide from soil and building stones into the atmosphere

Atmospheric NO₂ was taken up by samples of various soils and building stones. The NO₂ uptake rate constants were highest in soil samples taken during the summer months. However, the NO₂ uptake rate constants of the soils and building stones were not significantly correlated with any of the following variables: moisture, pH, ammonium, nitrite, or nitrate. NO₂ uptake by soil and stone was not abolished by autoclaving indicating a chemical uptake process. NO₂ uptake by acidic and air-dry soils and stones resulted in nearly stoichiometric reduction of NO₂ to NO. This reduction was enhanced by the addition of ferrous iron and was further enhanced by incubation under 1 ppmv SO₂. The results suggest that NO₂ reduction may be coupled to oxidation of ferrous to ferric iron which may be reduced again by atmospheric SO₂ thus regenerating the ferrous iron content of the soil or stone. Conversion of NO₂ to NO was not observed in neutral or/and moist soils and stones. NO₂ was also taken up by purified and sterilized quartz sand moistend with water. This uptake was enhanced by addition of humic material but not by addition of bacteria which both had been extracted from genuine soil. Under most conditions, only uptake but no release of NO₂ was observed. However, NO₂ was released in air-dry soils that were heated to 45–65°C, or in ammonium-fertilized soil or stone that was drying up at room temperature. Under the latter conditions mimicking field practice, the NO₂ release reached rates that were similar to the NO release rates.