O3/H2O2降解Atrazine效能研究

利用O3/H2O2降解莠去津,对氧化产物进行了色谱分析,以评价该体系降解莠去津效能.莠去津初始浓度2 mg/L,7.5mg/L的O3单独氧化去除率为27.2%;相同O3投量下,H2O2/O3摩尔比0.75时,5 min莠去津的去除率最高可达96.5%,表明H2O2/O3体系对莠去津的去除效果良好,降解速度快.以离子色谱对产物的离子进行分析,莠去津浓度下降的同时,硝酸根和氯离子浓度增高.GC-MS检测的产物和对LC-MS谱图的分析表明,有机产物中存在脱乙基、脱异丙基和脱氯莠去津,说明H2O2/O3并不能彻底氧化莠去津,因此工程中作为主要去除单元或突发性污染事件的应急手段可能还需要与活性炭等单元联用.     

成都经济区土壤中HCH和DDT含量及其分布特点

通过对成都经济区土壤中HCH各异构体、DDT及其衍生物的含量及分布特点研究,得出成都经济区土壤中HCH和DDT都有较高的检出率,含量变化幅度也很大,含量较高点主要分布在化工厂附近。对比其他地区研究结果,成都经济区HCH含量较低,DDT含量较高。以西藏地区作为背景值,HCH有一定的污染,DDT污染较为严重。     

2010—2019年成都市机动车排污特征分析及防控措施减排效果评估

为评估2010—2019年成都市机动车防控措施的减排效果,以2010年为基准年,采用排放清单法计算了各减排措施下2019年的减排量,对比分析了4种控制措施的减排效益。结果表明：成都市机动车排污总量逐年下降,2019年PM_2.5、NO_x、VOCs、CO、SO₂和NH₃的排放量分别为0.27×10⁴、4.63×10⁴、1.70×10⁴、28.99×10⁴、0.21×10⁴和0.45×10⁴ t,主要分布在中心城区,其中重型货车对PM_2.5和NO_x贡献最大,小型客车对VOCs、CO、SO₂和NH₃贡献最大;措施中加严标准的综合减排量最大,重点减排车型为小型客车、轻型货车、公交车等,2019年6种污染物减排量分别为0.14×10⁴、2.27×10⁴、1.29×10⁴、6.77×10⁴、0.07×10⁴和0.38×10⁴ t;优化城市交通管理对小型客车和摩托车的减排效果显著,2019年6种污染物减排量分别为0.04×10⁴、0.81×10⁴、0.38×10⁴、2.55×10⁴、0.05×10⁴和0.04×10⁴ t;淘汰高排放车辆对小型客车、轻型货车等的减排较明显,2019年6种污染物减排放量分别为0.13×10⁴、0.98×10⁴、0.34×10⁴、2.62×10⁴、0.01×10⁴和0.007×10⁴ t;推广清洁能源汽车的重点减排车型为出租车和公交车,虽然可有效减少PM_2.5、NO_x的排放,但VOCs却有小幅增加,2019年6种污染物减排放量分别为0.12×10⁴、0.62×10⁴、−0.13×10⁴、0.30×10⁴、0.004×10⁴和0.000 5×10⁴ t。     

Polystyrene nanoplastics affect growth and microcystin production of Microcystis aeruginosa

Nanoplastics are widely distributed in freshwater environments, but few studies have addressed their effects on freshwater algae, especially on harmful algae. In this study, the effects of polystyrene (PS) nanoplastics on Microcystis aeruginosa (M. aeruginosa) growth, as well as microcystin (MC) production and release, were investigated over the whole growth period. The results show that PS nanoplastics caused a dose-dependent inhibitory effect on M. aeruginosa growth and a dose-dependent increase in the aggregation rate peaking at 60.16% and 46.34%, respectively, when the PS nanoplastic concentration was 100 mg/L. This caused significant growth of M. aeruginosa with a specific growth rate up to 0.41 d^?1 (50 mg/L PS nanoplastics). After a brief period of rapid growth, the tested algal cells steadily grew. In addition, the increase in PS nanoplastics concentration promoted the production and release of MC. When the PS nanoplastic concentration was 100 mg/L, the content of the intracellular (intra-) and extracellular (extra-) MC increased to 199.1 and 166.5 μg/L, respectively, on day 26, which was 31.4% and 31.1% higher, respectively, than the control. Our results provide insights into the action mechanism of nanoplastics on harmful algae and the potential risks to freshwater environments.

     

Exploring the spatial-temporal variations and policy-based driving force behind groundwater contamination and remediation research in past decades

Environmental Science and Pollution Research - Groundwater has been recognized as one of the most critical and vulnerable natural sources which is utilized in potable water supply, agricultural...     

Urban carbon emission intensity under emission trading system in a developing economy: evidence from 273 Chinese cities

Environmental Science and Pollution Research - The international community has generally recognized the key role of developing countries’ cities in reducing carbon emissions, an elemental way...     

Effect of lubricant sulfur on the morphology and elemental composition of diesel exhaust particles

This work investigates the effects of lubricant sulfur contents on the morphology, nanostructure, size distribution and elemental composition of diesel exhaust particle on a light-duty diesel engine. Three kinds of lubricant (LS-oil, MS-oil and HS-oil, all of which have different sulfur contents: 0.182%, 0.583% and 1.06%, respectively) were used in this study. The morphologies and nanostructures of exhaust particles were analyzed using high-resolution transmission electron microscopy (TEM). Size distributions of primary particles were determined through advanced image-processing software. Elemental compositions of exhaust particles were obtained through X-ray energy dispersive spectroscopy (EDS). Results show that as lubricant sulfur contents increase, the macroscopic structure of diesel exhaust particles turn from chain-like to a more complex agglomerate. The inner cores of the core-shell structure belonging to these primary particles change little; the shell thickness decreases, and the spacing of carbon layer gradually descends, and amorphous materials that attached onto outer carbon layer of primary particles increase. Size distributions of primary particles present a unimodal and normal distribution, and higher sulfur contents lead to larger size primary particles. The sulfur content in lubricants directly affects the chemical composition in the particles. The content of C (carbon) decreases as sulfur increases in the lubricants, while the contents of O (oxygen), S (sulfur) and trace elements (including S, Si (silicon), Fe (ferrum), P (phosphorus), Ca (calcium), Zn (zinc), Mg (magnesium), Cl (chlorine) and Ni (nickel)) all increase in particles.     

On the effect of Fe(III) on proliferation of Microcystis aeruginosa at high nitrate and low chlorophyll condition

The impact of Fe concentrations on the growth of Microcystisaeruginosa in aquatic systems under high nitrate and low chlorophyll conditions was studied. The responses of cell density, total and cell chlorophyll-a intracellular Fe content and organic elemental composition of M. aeruginosa to different concentration gradients of Fe(III) in the solutions were analysed. The results showed that the proliferation speeds of M. aeruginosa were: (1) decelerated when the Fe(III) concentration was lower than 50 μg/L in the solutions, (2) promoted and positively related to the increase of Fe(III) concentration from 100 to 500 μg/L in the solutions over the experimental period, and (3) promoted in the early stage but decelerated in later stages by excess adsorption of Fe by cells when the Fe(III) concentration was higher than 500 μg/L in the solutions. The maximum cell density, total and cell chlorophyll-a were all observed at 500 μg Fe(III)/L concentration. The organic elemental composition of M. aeruginosa was also affected by the concentration of Fe(III) in the solutions, and the molecular formula of M. aeruginosa should be expressed as C_7–7.5H₁₄O_0.8–1.3N_3.5–5 according to the functions for different Fe(III) concentrations. Cell carbon and oxygen content appeared to increase slightly, while cell nitrogen content appeared to decrease as Fe(III) concentrations increased from 100 to 500 μg/L in the solutions. This was attributed to the competition of photosynthesis and nitrogen adsorption under varying cell Fe content.     

HAZOP分析在编制操作规程上的应用

结合实例分析,介绍如何将HAZOP分析方法引入到操作规程的编写过程当中,从而提升操作规程的有效性。     

浓盐水处理技术研究进展

海水淡化技术是解决中国水资源危机的一种具有根本性的举措之一.然而随着海水淡化产业规模的增大,其产生的浓盐水的排放成了本身面临解决的问题之一.本文阐述了浓盐水的特性及其对环境的各种危害性,并对浓盐水直接排放问题进行了详细分析.介绍了国内外近年来主要处理浓盐水的方法-真空膜蒸馏浓缩技术、正渗透技术、喷雾蒸发技术、冷冻法浓缩技术.对各种处理技术的原理和特点进行了详细综述,并对其研究进展进行了归纳总结.最后对各项处理技术的应用前景提出了展望.