新疆八一钢铁公司高炉喷吹烟煤安全措施

介绍了新疆八一钢铁公司高炉烟煤的特点，指出了喷煤系统存在的缺陷，总结了高炉喷吹烟煤所采取的安全措施。     

四川省酸性降水范围,趋势预测及其对农作物,蔬菜生长影响估损

本文在综述四川酸性降水范围、发展趋势预测的基础上，根据野外调查、现场考察和有关资料，阐述了酸雨形成的多种污染源及其对农业生态系统的危害。着重分析和论证了酸沉降（含酸雨、酸雾）对农作蔬菜的影响，并对酸沉降形成的主要几种污染影响范围和造成的经济损失采用分项估算法。估算公式为：Ｓ农损＝Ｄ粮损×ｇ×Ｊ＋Ｅ蔬损×ｇ×Ｊ＋Ｆ油损×ｇ×Ｊ，式中Ｄ、Ｅ、Ｆ分别代表粮食、蔬菜、油菜受酸沉降污染危害影响面积，ｇ为每亩面积减产数量，Ｊ为单位产量价格。根据公式估算，经济损失为０５９－０６６亿元／年，取平均值≈Ｓ农损，总共为０６３亿元／年。     

MODELING HYDROLOGIC IMPACT OF WITHDRAWING THE GREAT LAKES WATER FOR AGRICULTURAL IRRIGATION1

ABSTRACT: Growing interest in agricultural irrigation in the Great Lakes basin presents an increasing competition to other uses of Great Lakes water. This paper, through a case study of the Mud Creek Irrigation District in the Saginaw Bay basin, Michigan, evaluates the potential hydrologic effects of withdrawing water for agricultural irrigation to the Great Lakes. Crop growth simulation models for corn, soybeans, dry beans, and the FAO Penman method were used to estimate the difference in evapotranspiration rates between irrigated and nonirrigated identical crops, based on climate, soil, and management data. The simulated results indicate that an additional 70–120 mm of water would be evapotranspirated during the growing season from irrigated crop fields as compared to nonirrigated identical plantings. Dependent upon the magnitude of irrigation expansion, an equivalent of about 1 to 5 mm of water from Lakes Huron-Michigan could be lost to the atmosphere. If agricultural irrigation further expands in the entire Great Lakes basin, the aggregated potential of water loss to the atmosphere through ET from all five Great Lakes would be even greater.     

河流水质灾害中的S—P方程稳态分析和临界氧亏计算

污染物对水环境的影响主要发生在枯水期，此时水流状态处于稳态．Streeter－phelps（S－P）方程能预测简单稳态条件下的水质状况，并具有较高的计算织亏的精度．     

1978—1994年分省农业旱灾灾情的经验正交函数EOF分析

本文利用１９７８～１９９４年各省、市、自治区的农业旱灾受灾面积及播种面积的资料，以旱灾受灾率（即旱灾受灾面积与播种面积之比）作为刻划旱灾灾情的指标。对标准化的旱灾受灾率进行经验正交函数分析，发现前五个典型场方差贡献达７０．７％，可以概括我国旱灾灾情的空间分布主要类型。其中，前三个典型场的正负区域分界线的大体位置分别为长城一线、秦淮线和江南丘陵北缘     

紫外分光光度法在处理废水中的应用

根据二沉池出水特点，指出了以260nm紫外光(F260)评价处理二沉池出水的理论依据，然后确定了E260与COD的关系式为：E260=0．008COD 0．083。最后以E260为评价指标，比较了3种无饥混凝剂在不同pH值条件下对城市二沉池出水的COD去除效果，确定了最佳混凝剂为三氯化铁(FC)及混凝条件：pH4．5，投药量Fe^3 为32mg/L。     

Erratum to: Accumulation of Cr,Cd, Pb,Cu, and Zn by plants in tanning sludge storage sites: opportunities for contamination bioindication and phytoremediation

Environmental Science and Pollution Research -     

Research status,challenges and future prospects of renewable synthetic fuel catalysts for CO2 photocatalytic reduction conversion

Environmental Science and Pollution Research - In recent years, with global climate change, the utilization of carbon dioxide as a resource has become an important goal of human society to achieve...     

Pyrolysis technologies for municipal solid waste: A review

Pyrolysis has been examined as an attractive alternative to incineration for municipal solid waste (MSW) disposal that allows energy and resource recovery; however, it has seldom been applied independently with the output of pyrolysis products as end products. This review addresses the state-of-the-art of MSW pyrolysis in regards to its technologies and reactors, products and environmental impacts. In this review, first, the influence of important operating parameters such as final temperature, heating rate (HR) and residence time in the reaction zone on the pyrolysis behaviours and products is reviewed; then the pyrolysis technologies and reactors adopted in literatures and scale-up plants are evaluated. Third, the yields and main properties of the pyrolytic products from individual MSW components, refuse-derived fuel (RDF) made from MSW, and MSW are summarised. In the fourth section, in addition to emissions from pyrolysis processes, such as HCl, SO₂ and NH₃, contaminants in the products, including PCDD/F and heavy metals, are also reviewed, and available measures for improving the environmental impacts of pyrolysis are surveyed. It can be concluded that the single pyrolysis process is an effective waste-to-energy convertor but is not a guaranteed clean solution for MSW disposal. Based on this information, the prospects of applying pyrolysis technologies to dealing with MSW are evaluated and suggested.     

Chemical and process mineralogical characterizations of spent lithium-ion batteries: An approach by multi-analytical techniques

Mineral processing operation is a critical step in any recycling process to realize liberation, separation and concentration of the target parts. Developing effective recycling methods to recover all the valuable parts from spent lithium-ion batteries is in great necessity. The aim of this study is to carefully undertake chemical and process mineralogical characterizations of spent lithium-ion batteries by coupling several analytical techniques to provide basic information for the researches on effective mechanical crushing and separation methods in recycling process. The results show that the grade of Co, Cu and Al is fairly high in spent lithium ion batteries and up to 17.62 wt.%, 7.17 wt.% and 21.60 wt.%. Spent lithium-ion batteries have good selective crushing property, the crushed products could be divided into three parts, they are Al-enriched fraction (+2 mm), Cu and Al-enriched fraction (?2 + 0.25 mm) and Co and graphite-enriched fraction (?0.25 mm). The mineral phase and chemical state analysis reveal the electrode materials recovered from ?0.25 mm size fraction keep the original crystal forms and chemical states in lithium-ion batteries, but the surface of the powders has been coated by a certain kind of hydrocarbon. Based on these results a flowsheet to recycle spent LiBs is proposed.